turn signal MAZDA MODEL PROTÉGÉ 2003 (in English) User Guide

6-10
Interior Comfort
Form No. 8Q94-EA-02G
Audio System

Manual Type
The manual antenna must be raised and
lowered by hand.

Detachable Type
To remove the antenna, turn it
counterclockwise.
To install the antenna, turn it clockwise.
Make sure the antenna is security
installed.

Rear Window Antenna
The rear window antenna receives both
AM and FM signals.
Antenna
To prevent from damaging the antenna,
retract it before entering a car wash
facility or passing beneath a low
overhead clearance.
CAUTION
To prevent damage to the antenna,
remove it before entering a car wash
facility or passing beneath a low
overhead clearance.
NOTE
When leaving your vehicle unattended,
we recommend that you remove the
antenna and store it inside the vehicle.
When washing the inside rear window,
use a soft cloth dampened in lukewarm
water, gently wiping the antenna lines.
Use of glass cleaning products could
damage the antenna.
CAUTION
CAUTION
J39L_EA.book Page 10 Saturday, June 8, 2002 5:35 PM

6-22
Interior Comfort
Au di o S ys t em
Form No. 8Q94-EA-02G

Operating the Radio
Radio ON
Press a band selector button ( or
) to turn the radio on.
Band selection
Choose AM by pressing the AM button
( ) and FM by pressing the FM1/2
button ( ).
The selected mode will be indicated. If
FM stereo is being received, "ST" will be
displayed.Tu n i n g
The radio has the following tuning
methods: Manual, Seek, Scan, Preset
channel, and Auto memory tuning. The
easiest way to tune stations is to set them
on preset channels.
Manual tuning
Turning the manual tuning knob will
change the frequency higher or lower.
Band selector buttons Display
Channel preset buttonsScan button
Auto memory
button
Manual tunin
g knob Seek tuning:
Higher
frequency
Lower
frequency
NOTE
If the FM broadcast signal becomes
weak, reception automatically changes
from STEREO to MONO for reduced
noise, and the "ST" indicator will go
out.
NOTE
If the power supply is interrupted (fuse
blows or the battery is disconnected),
the preset channels will be canceled.
J39L_EA.book Page 22 Saturday, June 8, 2002 5:35 PM

6-30
Interior Comfort
Au di o S ys t em
Form No. 8Q94-EA-02G

Operating the In-Dash CD Changer
Inserting the CD
The CD must be label-side up when
inserting. The auto-loading mechanism
will set the CD and begin play. There will
be a short lapse before play begins while
the player reads the digital signals on the
CD.
The disc number and the track number
will be displayed.Normal insertion
1. Press the load button ( ).
2. When "In" is displayed, insert the CD.
Inserting CDs into desired tray number
1. Press and hold the load button ( )
for about 2 seconds until a beep is
heard.
2. Press the channel preset button for the
desired tray number within 5 seconds
after the beep is heard.
3. When "In" is displayed, insert the CD.
Display CD slot
Disc-in indicator
CD eject
button CD play button
Random button
Repeat button Disc up buttonScan
button Fast-forward button
Reverse
button Track up
button
Track down
button
Disc down
button
Load button
Power/Volume knob
NOTE
A CD cannot be inserted while the
display reads "WAIT". A beeping
sound can be heard during this waiting
time. Simultaneously pressing the
power/volume knob and the load
button ( ) for about 2 seconds will
turn this beeping sound ON or OFF.
NOTE
The CD cannot be inserted to the
desired tray number if the number is
already occupied.
J39L_EA.book Page 30 Saturday, June 8, 2002 5:35 PM

7-2
In Case of an Emergency
Form No. 8Q94-EA-02G
Parking in an Emergency
The hazard warning lights should always
be used when you stop on or near a
roadway.
The hazard warning lights warn other
drivers that your vehicle is a traffic hazard
and that they must take extreme caution
when near it.
Depress the hazard warning switch and all
four turn signals will flash at once.
Parking in an Emergency
NOTE
•The turn signals don’t work when
the hazard warning lights are on.
•Check local regulations about the
use of hazard warning lights while
the vehicle is being towed. They
may forbid it.
Hazard warning flasher switch
J39L_EA.book Page 2 Saturday, June 8, 2002 5:35 PM

8-29
Maintenance and Care
Owner Maintenance
Form No. 8Q94-EA-02G
Light Bulbs
License plate lights Front side-marker lights
Overhead lights/Map lights Sedan
Headlights
Front turn signal lights/
Parking lights
Brake lights/Taillights
Rear turn signal lights
Reverse lights
Taillights
High-mount brake light
Trunk light
Rear side-marker lights
Side turn signal lights
J39L_EA.book Page 29 Saturday, June 8, 2002 5:35 PM

8-30
Maintenance and Care
Owner Maintenance
Form No. 8Q94-EA-02G
License plate lightsFront side-marker lights
Overhead lights/Map lights
Headlights
Front turn signal lights/
Parking lights
Reverse lights
Rear turn signal lights
Brake lights/TaillightsHatchback
Side turn signal lights
J39L_EA.book Page 30 Saturday, June 8, 2002 5:35 PM

8-34
Maintenance and Care
Owner Maintenance
Form No. 8Q94-EA-02G

Replacing a Bulb (Front)
To replace the fog light bulbs, contact an Authorized Mazda Dealer.
To replace the front side-marker light bulbs (Hatchback), contact an Authorized Mazda
Dealer.
Front turn signal lights/Parking lightsFront side-marker lights
Sedan
Side turn signal lights
J39L_EA.book Page 34 Saturday, June 8, 2002 5:35 PM

8-36
Maintenance and Care
Owner Maintenance
Form No. 8Q94-EA-02G

Replacing a Bulb (Rear)
Rear bulb access
(Sedan)
To replace the turn signal light, brake
light/taillight, side-marker light or reverse
light bulb, the trunk end trim must be
removed and the inside cover must be
partially opened.
1. Pull the center section of the plastic
retainer and remove the retainers and
the trunk end trim.
2. Remove the inside cover’s plastic
retainers and partially open the inside
cover.(Hatchback)
To replace the turn signal light, brake
light/taillight or reverse light bulb, remove
the caps and the cover.
Jack cover
J39L_EA.book Page 36 Saturday, June 8, 2002 5:35 PM

8-37
Maintenance and Care
Owner Maintenance
Form No. 8Q94-EA-02G
Brake lights/Taillights
Rear side-marker lights
Reverse lights
Taillights
Rear turn signal lights
High-mount brake light (Sedan) License plate lights
Trunk light (Sedan)
Sedan
Sedan
Hatchback
Hatchback Brake lights/Taillights
Rear turn signal lights
Reverse lights
Sedan
To replace the high-
mount brake light bulb,
contact an Authorized
Mazda Dealer.
J39L_EA.book Page 37 Saturday, June 8, 2002 5:35 PM

10-7
Specifications
Form No. 8Q94-EA-02G

Light Bulbs
Light bulb Wattage
HeadlightsSedan 60/55
HatchbackHi 60
Lo 55
Front turn signal/Parking lights 27/8
Side turn signal lights 5
Fog lights55
Rear turn signal lights 21
Front side-marker lights 5
Rear side-marker lights (Sedan) 3.8
Taillights (Sedan) 3.8
Brake lights/Taillights 21/5
High-mount brake lightSedanType A 21
Type B 5.8
Hatchback 5.8
Reverse lights21
License plate lights 5
Trunk light (Sedan) 5
Luggage compartment light (Hatchback) 5
Overhead lightTy p e A 1 0
Ty p e B 8
Map lights5
J39L_EA.book Page 7 Saturday, June 8, 2002 5:35 PM