clock MAZDA MODEL RX 8 2005 (in English) Owner's Manual
Page 271 of 364
Black plate (271,1)
qReplacing a Bulb (Interior)
Overhead light/Map lights (Front)
1. Remove the screws with a Phillips
screwdriver.
2. Wrap a flathead screwdriver with a soft
cloth to prevent damage to the trim and
gently insert it in the overhead light as
shown in the figure, and then remove
the overhead light unit.
3. Turn the socket and bulb assembly
counterclockwise and remove it.
4. Disconnect the bulb from the socket.
5. Install the new bulb in the reverse order
of removal.
Overhead light (Rear), Courtesy lights,
Vanity mirror lights
1. Wrap a small flathead screwdriver with
a soft cloth to prevent damage to the
lens and remove the lens by carefully
prying on the edge of the lens with the
screwdriver.
2. Disconnect the bulb by pulling it out.
Edge
Overhead light (Rear)
Courtesy lights
Edge
Maintenance and Care
Owner Maintenance
8-37
RX-8_8T69-EA-04G_Edition1 Page271
Wednesday, June 9 2004 2:13 PM
Form No.8T69-EA-04G
Page 272 of 364
Black plate (272,1)
Vanity mirror lights
Edge
3. Install the new bulb in the reverse order
of removal.
Trunk light
1. Press both sides of the lens cap to
remove it.
2. Disconnect the bulb by pulling it out.
3. Install the new bulb in the reverse order
of removal.
qReplacing a Bulb (Rear)
Rear turn signal lights, Brake lights/
Taillights, Reverse lights
1. Pull the center section of the plastic
retainer and remove the retainers and
partially open the trunk side trim.
Removal
Installation
2. Turn the socket and bulb assembly
counterclockwise and remove it.
3. Disconnect the bulb from the socket.
Brake lights/Taillights Rear turn signal lights
Reverse lights
4. Install the new bulb in the reverse order
of removal.
Rear side-marker lights
Due to the complexity and difficulty of
the procedure, the bulbs should be
replaced by an Authorized Mazda Dealer.
8-38
Maintenance and Care
Owner Maintenance
RX-8_8T69-EA-04G_Edition1 Page272
Wednesday, June 9 2004 2:13 PM
Form No.8T69-EA-04G
Page 273 of 364
Black plate (273,1)
High-mount brake light
1. Turn the center section of the plastic
retainer counterclockwise and remove
the retainers and trunk rear trim.
Removal
Installation
2. Turn the socket and bulb assembly
counterclockwise and remove it.
3. Disconnect the bulb from the socket.
4. Install the new bulb in the reverse order
of removal.
License plate light
1. Press the front of the lens to detach the
front tabs.2. Wrap a flathead screwdriver with a soft
cloth to prevent damage to the lens and
remove the lens by carefully prying on
the edge of the lens with a flathead
screwdriver.
3. Disconnect the bulb by pulling it out.
Edge
4. Install the new bulb in the reverse order
of removal.
Maintenance and Care
Owner Maintenance
8-39
RX-8_8T69-EA-04G_Edition1 Page273
Wednesday, June 9 2004 2:13 PM
Form No.8T69-EA-04G
Page 316 of 364
Black plate (316,1)
A
Accessory Socket .............................. 6-50
Add-On Non-Genuine Parts and
Accessories ....................................... 9-13
Air Bag Systems ............................... 2-29
Air Filter ............................................ 8-22
Ambient Temperature Display .......... 6-43
Antenna ............................................. 6-10
Anti-Lock Brake System (ABS) ......... 5-7
Warning light ............................... 5-7
Appearance Care ............................... 8-45
Ashtray .............................................. 6-45
Audio System ................................... 6-10
Audio control switch .................. 6-36
Operating tips for audio
system ........................................ 6-10
Safety certification ..................... 6-38
Automatic Transmission
Driving tips ................................ 5-16
Fluid ........................................... 8-19
Manual shift mode ..................... 5-12
Shift-lock system ........................ 5-11
Transmission ranges ................... 5-10
B
Battery
Emergency starting .................... 7-20
Maintenance ............................... 8-26
Specifications ............................. 10-4
Beep Sounds
Engine overrev warning beep .... 5-48
Ignition key reminder ................. 5-48
Lights-on reminder ..................... 5-48
Seat belt warning beep ............... 5-48
Tire inflation pressure warning
beep ............................................ 5-48
B
Before Starting the Engine .................. 4-6
After getting in ............................. 4-6
Before getting in .......................... 4-6
Body Lubrication .............................. 8-22
Brake/Clutch
Fluid ........................................... 8-18
Brakes
Anti-lock brake system (ABS) ..... 5-7
Foot brake .................................... 5-4
Pad wear indicator ........................ 5-8
Parking brake ............................... 5-5
Warning light ............................... 5-6
Break-In Period ................................... 4-7
Bulb Replacement ............................. 8-33
C
Capacities .......................................... 10-5
Carbon Monoxide ............................... 4-5
Catalytic Converter ............................. 4-3
Cell Phones ....................................... 9-14
Center Console .................................. 6-48
Child Restraint
Child restraint precautions ......... 2-20
Installing child-restraint
systems ....................................... 2-23
LATCH child-restraint
systems ....................................... 2-27
Cigarette Lighter ............................... 6-44
Climate Control System ...................... 6-2
Gas specifications ...................... 10-5
Clock ................................................. 6-43
Coin Box ........................................... 6-47
Courtesy Lights ................................. 6-41
Cruise Control ................................... 5-17
Cup Holder ........................................ 6-46
Customer Assistance ........................... 9-2
11-2
Index
RX-8_8T69-EA-04G_Edition1 Page316
Wednesday, June 9 2004 2:13 PM
Form No.8T69-EA-04G
Page 318 of 364
Black plate (318,1)
H
Hazard Warning Flasher .................... 5-56
Hazardous Driving .............................. 4-8
Headlight Washer .............................. 5-54
Headlights
Control ....................................... 5-49
Flashing ...................................... 5-50
High-low beam .......................... 5-49
Leveling ..................................... 5-50
On reminder ............................... 5-49
HomeLink Wireless Control
System .............................................. 5-56
Hood Release .................................... 3-21
Horn .................................................. 5-55
I
Ignition
Keys ............................................. 3-2
Switch .......................................... 5-2
Illuminated Entry System ................. 6-39
Immobilizer System .......................... 3-24
Indicator Lights ................................. 5-36
Cruise main ................................ 5-46
Cruise set .................................... 5-46
DSC OFF .................................... 5-45
Headlight auto-leveling
malfunction ................................ 5-47
Headlight high-beam .................. 5-44
power steering malfunction ........ 5-46
Security ...................................... 5-44
Shift position .............................. 5-45
TCS/DSC ................................... 5-45
Turn-signal/hazard warning ....... 5-47
I
Information Display .......................... 6-42
Ambient temperature display ..... 6-43
Audio display ............................. 6-44
Climate control display .............. 6-44
Clock .......................................... 6-43
Information display functions .... 6-42
Instrument Cluster ............................. 5-30
Interior Care ...................................... 8-50
Interior Lights ................................... 6-39
J
Jump-Starting .................................... 7-21
K
Keyless Entry System ......................... 3-3
Keys .................................................... 3-2
L
Label Information ............................. 10-2
Lane-Change Signals ........................ 5-51
Light Bulbs
Replacement ............................... 8-33
Specifications ............................. 10-6
Lighter ............................................... 6-44
Lighting Control ............................... 5-49
Lubricant Quality .............................. 10-4
M
Maintenance
Introduction .................................. 8-2
Owner maintenance precautions ... 8-9
Owner maintenance schedule ....... 8-8
Scheduled ..................................... 8-3
11-4
Index
RX-8_8T69-EA-04G_Edition1 Page318
Wednesday, June 9 2004 2:13 PM
Form No.8T69-EA-04G
Page 352 of 364
Setu
1
Open th
screen
How to
asE
J
ME
ENT
ENT
30
Setup
2
Restoring
defaults
Map setting ( page 31)
On : Icons on a map.Off : No icon on a map.
The setting is a variable to suit your preferences.
Route setting ( page 32)
System setting ( page 33)
( page 9)
Map area, Map disc (DVD) version and software
version appear.
You can check your route from the starting point to the
destination.
This function is available after route setup is performed.
You can change and delete marked points.
( page 28)
( page 28)
Change the vehicle position.
Change the vehicle direction.
: Rotation in a clockwise direction by 11.25°.
: Rotation in a counterclockwise direction
by 11.25°.
Stop your vehicle before the following operationsDo not change the settings and destination locations while driving. Minimize the time spent viewing the
monitor screen and listening to the voice guidance while driving. Operating the system will
distract the driver from looking ahead of the vehicle and may cause an accident.
Always stop the vehicle in a safe location and put the parking brake on before operating the system.
Warning
Open
[Setup Menu]
When the actual position of your
vehicle is different from the vehicle
position on a mapUser setting
: Default
1selectMENUENTERENTERENTER
ENTER
ENTER
ENTER
ENTER
Page 355 of 364
33
Open the
[System Setup]
screenVolume control (5 levels)
Beep
On : Beep activated when pressing buttons in the
remote control.
Off : Beep inactivated when pressing buttons in the
remote control.
On : Activates voice feedback.Off : Cancels voice feedback.
Language
Changeover meter/mile
Metric : MetersEnglish : Miles
Voice Feedback*
Clock
: Default
How to exit
Daylight Saving Time(Summer Time)
On : Daylight saving time mode is enabled.
(The navigation internal clock gains 1 hour).
Off : Daylight saving time mode is disabled.
SetupSystem
User setting
1
2select3
selectMENUENTER
ENTER
ENTER
ENTERENTER
ENTER
ENTER
ENTER
Sets the volume for voice guidance and voice feedback*.
When the volume is set to 0, the voice is turned off.
* The operation status is announced by voice.
(e.g. changing the map orientation, starting or terminating
the route calculation, staring or terminating the simulation,
displaying the maneuver list.)
nt go back
om it.
atically
proaching
ENTER