Program mode selector MERCEDES-BENZ C230 2006 W203 Owner's Manual

Contents
Trip computer menu..................... 155
TEL menu* ................................... 157
Manual transmission ......................... 160
Shifting into reverse ..................... 161
Automatic transmission* ................... 162
Gear selector lever position ......... 164
Driving tips ................................... 165
Gear ranges ................................. 166
Automatic shift program .............. 167
One-touch gearshifting................. 168
Emergency operation
(Limp Home Mode) ...................... 169
Good visibility .................................... 170
Headlamp cleaning system* ........ 170
Rear view mirrors ......................... 170
Sun visors .................................... 173
Rear window sunshade* .............. 174
Rear window defroster ................. 175
Climate control .................................. 176
Deactivating the climate control
system ......................................... 179
Operating the climate control
system in automatic mode ........... 179
Setting the temperature ............... 180Adjusting air distribution and
volume .......................................... 180
Adjusting air volume ..................... 181
Front defroster.............................. 181
Air recirculation mode .................. 182
Air conditioning............................. 183
Rear passenger compartment
adjustable air vents....................... 184
Automatic climate control*
(Canada only) ..................................... 186
Deactivating the automatic climate
control system .............................. 189
Operating the climate control
system in automatic mode............ 189
Setting the temperature................ 190
Adjusting air distribution............... 190
Adjusting air volume ..................... 191
Front defroster.............................. 191
Maximum cooling MAXCOOL ........ 192
Air recirculation mode .................. 192
Charcoal filter ............................... 194
Air conditioning............................. 196
Residual heat and ventilation ........ 197
Rear passenger compartment
adjustable air vents....................... 197Audio system...................................... 199
Audio and telephone, operation .... 199
Operating safety ........................... 199
Operating and display elements ... 200
Button and soft key operation ...... 202
Operation...................................... 202
Radio operation ............................ 207
Introduction to satellite radio*
(USA only) ..................................... 211
CD mode....................................... 216
GSM network phones ................... 225
TDMA or CDMA network phones .. 231
Emergency calls “911” ................. 237
Power windows .................................. 240
Opening and closing the windows 240
Synchronizing power windows ...... 242
Summer opening feature .............. 243
Convenience closing feature......... 243
Power tilt/sliding sunroof* ................ 244
Opening and closing the power
tilt/sliding sunroof........................ 244
Synchronizing the power
tilt/sliding sunroof........................ 246
Driving systems .................................. 247
Cruise control ............................... 247

25 At a glance
Instrument cluster
Item
Page
1
Speedometer with:vElectronic Stability
Program (ESP
®)
warning lamp
89,
354
;Brake warning lamp,
USA only
50, 58,
351
3Brake warning lamp,
Canada only
50, 58,
351
BLow beam headlamp
indicator lamp
52,
118
2
LLeft turn signal
indicator lamp
53
3
Multifunction display
with:
130
Trip odometer
128
Main odometer
130
Gear selector lever
position*
49,
130,
164
Item
Page
Program mode*
167
Status indicator (outside
temperature/digital speed-
ometer
129,
144
Digital clock
130
4
KRight turn signal
indicator lamp
53
5
Tachometer with:
129
-Antilock Brake
System (ABS)
indicator lamp
87,
350
úEngine malfunction
indicator lamp,
USA only
352,
353
±Engine malfunction
indicator lamp,
Canada only
352,
353
1Supplemental
Restraint System
(SRS) indicator lamp
62,
355
Item
Page
<Seat belt telltale
69,
355
AHigh beam head-
lamp indicator lamp
52,
122
6
Fuel gauge with:Fuel reserve warning lamp
354
4The arrow indicates
that the fuel filler cap
is on the rear
right-hand side.
7
Coolant temperature gauge
128
8
Reset button for:
127


Resetting trip odometer
128


Resetting all settings
140


Instrument cluster
illumination
127

28 At a glanceCenter consoleLower part
Item
Page
1
Ashtray
261
Cigarette lighter
262
2
Gear selector lever for
automatic transmission*
49,
164
Gearshift lever for manual
transmission
48,
160
3
Cup holder
259
4
Armrest
258
5
Program mode selector
switch for automatic
transmission*
167

130 Controls in detailControl systemThe control system is activated as soon as
the SmartKey in the starter switch is
turned to position1. The control system
enables you to

call up information about your vehicle


change vehicle settings
For example, you can use the control
system to find out when your vehicle is
next due for service, to set the language
for messages in the instrument cluster
display, and much more.
The control system relays information to
the multifunction display.
Multifunction display
1Trip odometer
2Main odometer
3Current program mode (automatic
transmission*)
4Current gear selector lever
position/gear range (automatic trans-
mission*)
5Digital clock
6Status indicator (outside tempera-
ture/digital speedometer)
iThe displays for the audio systems
(radio, CD player) will appear in English,
regardless of the language selected.
Warning!
G
A driver’s attention to the road and traffic
conditions must always be his/her primary
focus when driving.
For your safety and the safety of others,
selecting features through the multifunction
steering wheel should only be done by the
driver when traffic and road conditions
permit it to be done safely.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet
(approximately 14 m) every second.

162 Controls in detailAutomatic transmission*Automatic transmission is standard
equipment on select models and available
as optional equipment on select other
models.
For more information on driving with an
automatic transmission see “Automatic
transmission*” (
page 49).
Your vehicle’s transmission adapts its gear
shifting process to your individual driving
style by continually adjusting the shift
points up or down. These shift point adjust-
ments are performed based on current
operating and driving conditions.
If the operating conditions change, the
automatic transmission reacts by
adjusting its shift program.
Gearshift pattern for automatic
transmission
The automatic transmission selects indi-
vidual gears automatically, depending on:

the gear selector lever
positionD(
page 164) with
gear ranges (page 166)


the selected program mode (C/S)
(page 167)


the position of the accelerator pedal
(page 165)


the vehicle speed
iDuring the brief warm-up, transmission
upshifting is delayed. This allows the
catalytic converter to heat up more
quickly to operating temperature.

163 Controls in detail
Automatic transmission*
1Current gear range/gear selector lever
position
2Current program mode
The current gear range/gear selector lever
position and program mode (
C/S) appear
in the multifunction display.An additional indication of the current gear
selector lever position can be found on the
cover of the shifting-gate.
The indicators come on when you activate
a switch (e.g. unlocking the vehicle or
opening a door) and go out after approxi-
mately 15 minutes.
When the gear selector lever is in
positionD, you can influence transmission
shifting by:


limiting the gear range


changing gears manually
Warning!
G
It is dangerous to shift the gear selector
lever out ofP orN if the engine speed is
higher than idle speed. If your foot is not
firmly on the brake pedal, the vehicle could
accelerate quickly forward or reverse. You
could lose control of the vehicle and hit
someone or something. Only shift into gear
when the engine is idling normally and when
your right foot is firmly on the brake pedal.
!Allow engine to warm up under low
load use. Do not place full load on the
engine until the operating temperature
has been reached.
Shift into reverse gearR or parking
positionP only when the vehicle is
stopped.
Avoid spinning of a drive wheel for an
extended period when driving off on
slippery road surfaces. This may cause
serious damage to the drivetrain which
is not covered by the Mercedes-Benz
Limited Warranty.

167 Controls in detail
Automatic transmission*
Automatic shift program
The program mode selector switch is
located on the lower part of the center
console.
1Program mode selector switch
C Comfort For comfort driving
S Sport For standard driving
The current gear selector lever position
and the selected program mode (
C/S) are
indicated in the multifunction display
(
page 163).
Effect
ï
The transmission shifts through
sixth gear only (applies to
vehicles with 7-speed automatic
transmission only).
î
The transmission shifts through
fifth gear only (applies to
vehicles with 7-speed automatic
transmission only).
é
The transmission shifts through
fourth gear only.
è
The transmission shifts through
third gear only.
With this selection you can use
the braking effect of the engine.
Effect
ç
The transmission shifts through
second gear only.
Allows the use of engine’s
braking power when driving:

on steep downgrades


in mountainous regions


under extreme operating
conditions
æ
The transmission operates in
first gear only.
For maximum use of engine’s
braking effect on very steep or
lengthy downgrades.

168 Controls in detailAutomatic transmission*

Press program mode selector
switch1 repeatedly until the letter of
the desired program mode appears in
the multifunction display.
SelectCfor comfort driving:

The vehicle starts out in second
gear (both forward and reverse) for
gentler starts. This does not apply if
full throttle is applied or gear
range1 is selected.


Traction and driving stability are
improved on icy roads.


Upshifts occur earlier even when
you give more gas. The engine then
operates at lower rpms and the
wheels are less likely to spin.
One-touch gearshifting
Even with an automatic transmission, you
can change the gears manually and limit or
extend the gear range for automatic
shifting with the gear selector lever in
positionD.
!Never change the program mode when
the gear selector lever is out of
positionP. This could result in a
change of driving characteristics for
which you may not be prepared.iThe last selected program
mode (CorS) is switched on when the
engine is restarted.
!Allow engine to warm up under low
load use. Do not place full load on the
engine until the operating temperature
has been reached.
Shift into reverse gearR or parking
positionP only when the vehicle is
stopped.
Avoid spinning of a drive wheel for an
extended period when driving off on
slippery road surfaces. This may cause
serious damage to the drivetrain which
is not covered by the Mercedes-Benz
Limited Warranty.

169 Controls in detail
Automatic transmission*
Downshifting
Briefly press the gear selector lever to
the left in theD-direction.
The transmission will shift from the current
gear to the next lower gear as permitted by
the shift program. This action simulta-
neously limits the gear range of the
transmission (
page 166).Upshifting

Briefly press the gear selector lever to
the right in theD+direction.
The transmission will shift from the current
gear to the next higher gear as permitted
by the shift program. This action simul-
taneously extends the gear range of the
transmission.
Canceling gear range limit

Press and hold the gear selector lever
in theD+direction until
D reappears in
the multifunction display.
The transmission will shift from the current
gear range directly to gear rangeD.
Shifting into optimal gear range

Press and hold the gear selector lever
in theD-direction.
The transmission will automatically select
the gear range suited for optimal
acceleration and deceleration. This may
involve shifting down one or more gears.Emergency operation (Limp Home
Mode)
If vehicle acceleration worsens or the
transmission no longer shifts, the trans-
mission is most likely operating in limp
home (emergency operation) mode. In this
mode only second gear and reverse gear
can be activated.
Stop the vehicle in a safe location.

Move gear selector lever toP.

Turn off the engine.

Wait at least 10 seconds before
restarting.

Restart the engine.

Move gear selector lever to positionD
(for second gear) orR.

Have the transmission checked at an
authorized Mercedes-Benz Center as
soon as possible.
Warning!
G
On slippery road surfaces, never downshift
in order to obtain braking action. This could
result in drive wheel slip and reduced
vehicle control. Your vehicle’s ABS will not
prevent this type of loss of control.iTo avoid overrevving the engine when
the gear selector lever is moved to
theD-direction, the transmission will
not shift to a lower gear if the engine’s
max. speed would be exceeded.

282 OperationIn the “Operation” section you will find
detailed information on operating, main-
taining and caring for your vehicle.The first 1 000 miles (1 500 km)
The more cautiously you treat your vehicle
during the break-in period, the more satis-
fied you will be with its performance later
on.

Drive your vehicle during the first
1 000 miles (1 500 km) at varying but
moderate vehicle and engine speeds.


During this period, avoid heavy loads
(full throttle driving) and excessive
engine speeds (no more than
2/3 of
maximum rpm in each gear).


Shift gears in a timely manner.


Avoid accelerating by kick-down.


Do not attempt to slow the vehicle
down by shifting to a lower gear using
the gear selector lever.


Select positions3,2 or1 only when
driving at moderate speeds (for hill
driving).


SelectC as the preferred shift program
(page 167) for the first 1 000 miles
(1 500 km). After 1 000 miles (1 500 km) you may
gradually increase vehicle and engine
speeds to the permissible maximum.
All of the above instructions, as may apply
to your vehicle type, also apply when
driving the first 1 000 miles (1 500 km)
after the engine or the rear differential has
been replaced.
iAlways obey applicable speed limits.