MERCEDES-BENZ CLA SHOOTING BRAKE 2022 Owners Manual

Mercedes-Benz recommends having the oil
c
hanged at a qualiNed specialist workshop.
Only use engine oils approved for your vehicle by
Mercedes-Benz.
Petrol engines: for certain countries, diMerent
engine oils can be used in conjunction with
reduced maintenance intervals. Further informa-
tion on diMerent engine oils can be obtained at a
qualiNed specialist workshop.
Engine oil quality and Nlling capacity
Not for plug-in hybrid:
Engine oil speciNcation (petrol engines)Model
MB-Freigabe or MB-
Appr
oval
All models 229.51, 229.52,
229.61, 229.71,
229.72 1)
1) Recommended for lowest possible fuel consumption (lowest SAE
viscosity class in eac
h case; observe possible restrictions of the
approved SAE viscosity classes) Engine oil speciNcation
(diesel engines) Model
MB-Freigabe or MB-
Appr
oval
All models 229.52, 229.61,
229.71, 229.72 1)
1) Recommended for lowest possible fuel consumption (lowest SAE
viscosity class in eac
h case; observe possible restrictions of the
approved SAE viscosity classes) To achieve the lowest possible fuel consumption,
it is r
ecommended to use the engine oil speciNca-
tions marked in the table for the lowest SAE vis-
cosity class. Observe any possible restrictions of
the approved SAE viscosity classes.
% If the engine oils listed in the table are not
a

vailable, you may add a maximum of 1.0 litre
of the following engine oils once only.
Vehicles with petrol engines: MB-Freigabe or
MB-Approval 229.31 or ACEA C3
Vehicles with diesel engines: ACEA C3
Not for plug-in hybrid: Engine oil Nlling
capacity Model
Capacity
CLA 180, (manual and
aut
omatic transmis-
sion)
CLA 200, (manual and
automatic transmis-
sion) 5.1 litres
CLA 250
CL
A 250 4MATIC 5.5 litres
All other models 6.8 litres The speciNed
Nlling capacity r
efers to an oil
change with the oil Nlter.408
Technical data

Engine oil speciNcation
(plug-in h ybrid)Model
MB-Freigabe or MB-
Appr
oval
CLA 250 e 229.51, 229.52,
229.61, 229.71,
229.72 1)
1) Recommended for lowest possible fuel consumption (lowest SAE
viscosity class in eac
h case; observe possible restrictions of the
approved SAE viscosity classes) To achieve the lowest possible fuel consumption,
it is r
ecommended to use the engine oil speciNca-
tions marked in the table for the lowest SAE vis-
cosity class. Observe any possible restrictions of
the approved SAE viscosity classes.
% If the engine oils listed in the table are not
a

vailable, you may add a maximum of 1.0 litre
of engine oils with MB-Freigabe or MB-
Approval 229.31 or ACEA C3 once only. Engine oil Nlling
capacity (plug-in h
ybrid) Model
Capacity
CLA 250 e 5.1 litres The speciNed
Nlling capacity r
efers to an oil
change with the oil Nlter. Notes on brake
Ouid Observe the notes on operating
Ouids
(  pag

e 401). &
WARNING Risk of an accident due t
o
vapour pockets forming in the brake sys-
tem
The brake Ouid cons
tantly absorbs moisture
from the air. This lowers the boiling point of
the brake Ouid. If the boiling point is too low,
vapour pockets may form in the brake system
when the brakes are applied hard.
This impairs the braking eMect. 
Have the brake Ouid r
enewed at the
speciNed intervals. Have the brake
Ouid r
egularly replaced at a quali-
Ned specialist workshop.
Only use a brake Ouid approved by Mercedes-
Benz according to MB-Freigabe or MB-Approval
331.0. Coolant
Notes on coolant
Obser

ve the notes on operating Ouids
(  page 401). &
WARNING Risk of Nr
e

*
NOTE Damag e caused by incorrect cool-
ant 
Only use coolant that has been premixed
wit
h the required antifreeze protection.
Information on coolant is available at the fol-
lo
wing locations:
= In the Mercedes-Benz SpeciNcation for
Operating Fluids 320.1
- At https://bevo.mercedes-benz.com
- In the Mercedes-Benz BeVo App
= At a qualiNed specialist workshop *
NOTE Ov
erheating at high outside temper-
atures If an inappropriate coolant is used, the cooling
sy

stem is not suPciently protected against
overheating and corrosion at high outside
temperatures. 
Only use coolant approved for
Mer

cedes-Benz. 
Observe the instructions in the
Mer
cedes-Benz SpeciNcations for Oper-
ating Fluids 320.1. Have the coolant regularly replaced at a
q
ualiNed
specialist workshop.
Proportion of antifreeze concentrate in the cool-
ing system:
= A minimum of 50% (antifreeze protection down
to about -37°C)
= A maximum of 55% (antifreeze protection
down to -45°C) Notes on windscreen washer
Ouid Observe the notes on operating
Ouids
( pag
e 401). &
WARNING !

Recommended windscreen washer
Ouid:
= abo
ve freezing point: e.g. MB SummerFit
= below freezing point: e.g. MB WinterFit
For the correct mixing ratio, refer to the informa-
tion on the antifreeze container.
Mix washer Ouid with windscreen washer Ouid all
year round. Vehicle data
Vehicle dimensions
The heights
speciNed ma
y vary as a result of the
following factors:
= tyres
= load
= condition of the suspension
= optional equipment Not for plug-in hybrid:
Height when opened
Model
1 Height when
opened
All models 2004 mm Vehicle dimensions
All models
Vehicle length
4688 mm
Vehicle width includ-
ing e
xterior mirrors 1999 mm All models
Vehicle width exclud-
ing e

xterior mirrors 1830 mm
Vehicle height 1447 mm
Wheelbase 2729 mm Height when open (plug-in hybrid)
Model
1 Height when open
CLA 250 e 2005 mm Vehicle dimensions (plug-in hybrid)
CLA 250 e
Vehicle length
4688 mm
Vehicle width includ-
ing e
xterior mirrors 1999 mm
Vehicle width exclud-
ing e
xterior mirrors 1830 mm Technical data
411

CLA 250 e
Vehicle height
1453 mm
Wheelbase 2729 mmWeights and loads
Please observe the following notes for the speci-
Ned
v
ehicle data:
= Items of optional equipment increase the unla-
den weight and reduce the payload.
= Vehicle-speciNc weight information can be
found on the vehicle identiNcation plate.
Roof load Model
Maximum roof load
All models 100 kgMaximum design speeds
Not for Mercedes-AMG vehicles:
Missing v

alues were not available at the time of
going to press. Maximum permissible speed
All models High-voltage battery (plug-in hybrid)
Notes on the power supply for vehicles with a
high-v
oltage battery
In accordance with European standard
EN 17186:2019 vehicle identiNers are located on
the vehicle in the following places:
= On the inside of the socket Oap
= On the charging cable connector
In addition, charging stations in European coun-
tries are equipped with energy supply identiNers.
You can recharge your vehicle at charging stations
where the charging station identiNer corresponds
to the vehicle identiNer.
For further information on charging the high-volt-
age battery, refer to the "Charging the high-volt-
age battery" section ( page 199). 1
Supply type: AC
Standard: EN 62196-2
Style: type 2
Plug type: charging cable socket and vehicle
plug
Voltage range: 480 V RMS
2 Supply type: DC
Standard: EN 62196-3
Style: FF
Plug type: charging cable socket and vehicle
plug
Voltage range: 50 V to 500 V
3 Supply type: DC 412
Technical data

Standard: EN 62196-3
Style: FF
Plug type: charging cable socket and vehicle
plug
Voltage range: 200 V to 920 V
Missing values were not available at the time of
going t o press.
Maximum battery capacity and charging times CLA 250 e (Coup

Mounting dimensions of the trailer hitch
1
Fastening points
2 Overhang dimension
3 Rear axle centre line The overhang dimension and fastening points are
v
alid for a trailer hitch installed at the factory.
Overhang dimension length Model
2 Ov
erhang dimen-
sion
All models 1153 mm Towing capacity
%
The tongue weight is not included in the tow-
ing capacity
.
The values for the trailer load, braked apply
with a minimum start-oM climbing ability of
12 %.
Not for plug-in hybrid: Towing capacity, braked Model
CLA 180, (manual and
aut

omatic transmis-
sion)
CLA 180 d 1400 kg
CLA 200 d 4MATIC
CL
A 220 d 4MATIC
CLA 250 4MATIC 1800 kg
All other models 1600 kg Towing capacity, unbraked
Model
CLA 180, manual
tr

ansmission
CLA 200, manual
transmission 720 kg
CLA 180, automatic
tr
ansmission 725 kg414
Technical data

Model
CLA 200, automatic
tr
ansmission 730 kg
All other models 750 kgTrailer load, braked (plug-in hybrid)
Model
CLA 250 e
1600 kgTrailer load, unbraked (plug-in hybrid)
Model
CLA 250 e
750 kgMaximum tongue weight !

Trailer operation axle load
Model
Axle load
CLA 180, automatic
tr ansmission 1085 kg
CLA 180, manual
tr
ansmission
CLA 200, (manual and
automatic transmis-
sion) 1090 kg
CLA 180 d, automatic
tr
ansmission
CLA 200 d, automatic
transmission 1110 kg
CLA 200 d 4MATIC 1145 kg
CLA 220 d 1100 kg
CLA 220 d 4MATIC 1135 kg
CLA 250 1075 kg
All other models 1115 kg Axle load trailer operation (plug-in hybrid)
Model
Axle load
CLA 250 e 1250 kg416
Technical data

Display messages
Introduction
Information about display messages
Displa y messages appear on the instrument dis-
play.
Display messages with graphic symbols are sim-
pliNed in the Owner's Manual and may diMer from
the symbols on the instrument display. The instru-
ment display shows high-priority display messages
in red. Certain display messages are accompa-
nied by a warning tone.
Please act in accordance with the display mes-
sages and follow the additional notes in the Own-
er's Manual.
For some display messages, symbols will also be
shown:
=