MERCEDES-BENZ EQS SUV 2023 Owners Manual

Page 171 of 558

The front-passenger outside mirror will swiveldownwards in the direction of the rear wheel on
the front passenger\bs side when:
= The parking position is stored (  page 169).
= The front-passenger mirror is selected.
= Reverse gear is engaged.
The front-passenger outside mirror will move back
to its original position when:
= You shis the transmission to another transmis-
sion position.
= You are traveling at a speed greater than
9 mph (15 km/h).
= You press the button for the outside mirror on
the driver\bs side.Storing the parking position of the front-
passenger outside mirror using reverse gear
Storing
Select the front-passenger outside mirror using button 2.Engage reverse gear.Move the front-passenger outside mirror into
the desired parking position using button 1.Calling upSelect the front-passenger outside mirror
using button 2.Engage reverse gear.
The front-passenger outside mirror will move into the stored parking position.
Activating/deactivating the automatic mirror fold-
ing function
Multimedia system:
4 © 5
Settings 5
Vehicle
5 Open/Close
Activate or deactivate Automatic Mirror Fold-
ing .Light and visibility169

Page 172 of 558

Area permeable to radio waves on the wind-
shield
Radio-controlled equipment such as toll systems
can be mounted only on areas 1 of the wind-
shield that are permeable to radio waves.
Areas permeable to radio waves 1 are best visi-
ble from outside the vehicle when the windshield
is illuminated with an external light source.
Note this position for vehicles with: = Windshield heater
= Infra-red reOective windshield
*nfrared-reOective windshield function
The infrared-reOective windshield is coated and
reduces the build-up of heat in the vehicle interior.
The coating shields the vehicle interior from radio
waves.170Light and visibility

Page 173 of 558

Overview of climate control systems
Notes on climate control
An interior air Nlter in combination with the preNl-
ter in the engine compartment must always be
used so that the air conditioning system, pollution level monitoring and the air Nltration work cor-
rectly. Use Nlters recommended and approved by
Mercedes-Benz. Always have maintenance work
carried out at a qualiNed specialist workshop.
Overview of the THERMATIC climate bar
The indicator lamps indicate that the correspond-
ing functions are activated.
Front climate bar on the central display
(example)1~ Increases the temperature2Upper display area of the climate bar with the
examples of O switching climate control
on/oM ( page 174) and  synchronisa-
tion function (  page 177)3d Defrosts the windshield (  page 175)4Z Switches the A/C function on/oM
(  page 175) or¯ Fine particle preNlter status display
(  page 174)5l Switches the rear window defroster
on/oM6} Reduces the temperature7Depending on vehicle equipment and set-
tings: temperature display, display for the
defrost function, airOow, pre-entry climate
control or climate mode8r Switches air-recirculation mode on/oM
(  page 177, 178)9

Page 174 of 558

\bThe climate bar will remain visible even whenthe vehicle is parked or the air conditioning is switched oM ( page 174).\bThe availability of individual functions depends
on the country and equipment.
Overview of the THERMOTRONIC climate bar
The indicator lamps indicate that the correspond- ing functions are activated.
Front climate bar on the central display
(example)1~ Increases the temperature2Upper display area of the climate bar with the
examples of O switching oM climate con-
trol (  page 174), r switching air-recir-
culation mode on/oM ( page 177, 178) and
 synchronisation function (  page 177)3d Defrosts the windshield4Z Switches the A/C function on/oM
(  page 175) or¯ Fine particle preNlter status display
(  page 174)5l Switches the rear window defroster
on/oM6Depending on vehicle equipment and set-
tings: temperature display, display for pre-
entry climate control or climate mode7

Page 175 of 558

\bThe availability of individual functions depends
on the country and equipment.
Overview of the rear operating unit
The rear operating unit is available only for vehi-
cles with the THERMOTRONIC air conditioning
control panel.
Example: USA1Sets air distribution to the center and side air
vents in the rear passenger compartment, les2Sets the temperature in the rear passenger
compartment, les3Sets the airOow in the rear passenger com-
partment, les, or switches climate control
on/oM ( page 174)4Switches climate control on/oM
(  page 174)5Sets the airOow in the rear passenger com-
partment, right, or switches climate control on/oM ( page 174)6Sets the temperature in the rear passenger
compartment, right7Sets air distribution to the center and side air
vents in the rear passenger compartment, right8Sets rear climate control to automatic mode,
right9Sets the air distribution to the right rear foot-
well ventsASynchronization is activated (  page 177)BSets the air distribution to the rear les foot-
well ventsCSets rear climate control to automatic mode,
les
The settings for the second row of seats can be
conNgured via the rear operating unit or the multi-
media system (  page 177) depending on the
vehicle\bs equipment.
Climate control173

Page 176 of 558

Operating the climate control system
Switching climate control on/oM
Switching on climate control
Set the airOow to level 1 or higher via

Page 177 of 558

Jumping directly to the $Lr4uDlLt\ menuSelect the ¯ Nne particle preNlter status
display in the air conditioning bar. The Air Quality menu is opened. An animation
of the automatic air cleaning taking place is
shown.\bThe Nne particle preNlter status display is on
the home screen next to the temperature dis-
play on the right and it informs you of the cur-
rent particulate levels inside and outside of
the vehicle.
The measurement values are shown with the
ug/m 3
units (micrograms per cubic meter).
Defrosting the windshield via the climate bar
Switching on
Press d on the climate bar on the central
display.
Switching oM
Press d, X or O on the climate bar
on the central display
or
set the airOow to 0.\bWhen the defrost function is activated, some
functions (e.g. the temperature setting) will
automatically be deactivated.
Activating/deactivating the A/C function via the air conditioning menu
Multimedia system:
4 Climate Menu 5
First Row of Seats
Depending on the external conditions, support for
improved cooling and dehumidiNcation of the inte-
rior air will be provided when the A/C function is
activated. If it is not possible to operate the A/C
function on the climate bar on the central display, switch the function on or oM in the climate menu
of the central display.
Select A/C (A/C).Setting climate control to automatic mode via the
climate bar
In automatic mode, the set vehicle interior tem- perature is controlled automatically and main-
tained at a constant level by the air supply.
Press AUTO on the climate bar on the central
display.\bYou can increase or reduce the airOow by
pressing

Page 178 of 558

If ECO or ECO\f mode is activated, certain climate
control functions will be restricted to conserve
energy and extend the vehicle\bs range.
The following modes are available on the Climate menu:
= Comfort: maximum climate comfort
= ECO: while heating and cooling output are
limited, it remains possible to operate climate
control without restriction. If you activate d , the system will automatically switch to
Comfort mode.
= ECO\f: mode using only the blower and waste
heat, if applicable. The temperature can no
longer be adjusted. If you activate d, the
system will automatically switch to Comfort
mode.\bThe windows may fog up more when ECO or
ECO\f mode is activated.\bECO\f climate mode can also be switched on
and oM via the range maximization button in
the EQ menu under Range. When the range
maximization function is deactivated, the sys- tem will automatically switch to the last selec-ted climate mode. Pressing the temperature
or blower display on the climate bar of the
central display allows direct access to the air conditioning menu when ECO or ECO\f modeis active. The climate mode can be changed
by pressing the ECO button.\bThe vehicle\bs climate control automatically
detects seat occupancy. When the system switches to ECO or ECO\f mode, the climatecontrol functions of the unoccupied seats are
further restricted. If you activate d, the
system will automatically switch to Comfort
mode.\bIf the vehicle is parked for a short time while
in ECO or ECO\f mode, the previously selec-
ted mode is still activated the next time the vehicle is started. If the vehicle is parked in
ECO or ECO\f mode for a longer time, it will automatically switch to Comfort mode the
next time it is started.Tap on ECO.Select Comfort , ECO or ECO+ .
If an ECO mode is selected via the air condition-
ing menu, two LEDs will appear on the tempera-
ture display on the climate bar. When ECO mode
is switched on, one LED will light up green on the
temperature display. When ECO\f mode is
switched on, both LEDs will light up green and the
ECO\f display will appear.
Setting air distribution using the air conditioning menu
Multimedia system:
4 Climate Menu
Select First Row of Seats or Second Row of
Seats .To set the air distribution: select a,

Page 179 of 558

\bWhen the air conditioning system is switchedon, at least one zone is always active. How-
ever, several air distribution options can be selected at the same time, for example to set
the climate control for the interior and the
footwells simultaneously. In doing so, the
a climate control for the windshield can
only be selected for the Nrst seat row. When
automatic mode is active, the buttons for set-
ting the air distribution are automatically
deactivated. When the air conditioning system is switched oM, the buttons remain operable
and the last setting is saved.
Setting rear climate control using the air condi- tioning menu
Multimedia system:
4 Climate Menu
Setting the temperature
Select Second Row of Seats .Set the temperature.Sets the airOowSelect Second Row of Seats .Set the air Oow with ~ or } .
Controlling rear climate control automatically
Select AUTO.\bWhen the defrost function is activated, some
functions (e.g. the temperature setting) will
automatically be deactivated. To deactivate
the defrost function, press either d, X
or O set the air Oow to level 0
(  page 175).
Switching the synchronization function on/oM via
the air conditioning menu
Multimedia system:
4 Climate Menu 5
First Row of Seats
The synchronization function controls the climate control centrally. The driver\bs settings for temper-ature, airOow and air distribution are automatically
adopted for each climate zone.
Select SYNC (SYNC).Removing condensation from the windows
Windows fogged up on the inside
Press X on the climate bar on the central
display.If the windows remain fogged up: press d
on the climate bar on the central display.
Windows fogged up on the outside
Switch on the windshield wipers.Press X on the climate bar on the central
display.
Switching the air-recirculation mode on/oM via
the air conditioning menu
Requirements: = The THERMATIC air conditioning control panel
with Nne particle preNlter is available.
= The THERMOTRONIC air conditioning control
panel with or without Nne particle preNlter is
available.
Climate control177

Page 180 of 558

Multimedia system:4 Climate Menu 5
First Row of SeatsPress r in the upper display area of the
climate bar.
The interior air will be recirculated.
Air-recirculation mode will automatically switch to
fresh air mode aser a while.
\bIf air-recirculation mode is switched on, the
windows may fog up more quickly. Switch on
air-recirculation mode only brieOy.\bBy selecting the Nne particle status display
G on the climate bar, you can jump
directly to the air quality menu.
Switching air-recirculation mode on/oM via the
climate bar
Requirements: = The THERMATIC air conditioning control panel
without Nne particle preNlter is available.
Press r on the climate bar on the central
display.
The interior air will be recirculated.Air-recirculation mode will automatically switch to
fresh air mode aser a while.\bIf air-recirculation mode is switched on, the
windows may fog up more quickly. Switch on
air-recirculation mode only brieOy.
Activating or deactivating ionization via the air
conditioning menu
Multimedia system:
4 Climate Menu 5
Air Quality
When ionization is activated, the indoor air is enriched with negatively charged oxygen ions.
This can promote the well-being of the vehicle
occupants.
Select Ionization .\bThe function can only be performed if the
AUTO mode is activated or the air distribution is set to the side air vent. The function isrestricted if the side air vent on the driver\bsside is closed.Fragrance system
q Activating/deactivating the fragrance system
using the multimedia system
Requirements
= Automatic climate control is activated.
= The glove box will close.
= A Oacon is inserted.
Multimedia system: 4 Climate Menu 5
Air Quality
The fragrance system distributes a pleasant fra-
grance throughout the vehicle interior from a Oa-
con located in the glove box.
Navigate down until the climate control bar is
active.Select Fragrance .Activate or deactivate fragrancing.
qSetting the fragrance system using the multi-
media system
Requirements
= A Oacon is inserted.
178Climate control

Page:   < prev 1-10 ... 131-140 141-150 151-160 161-170 171-180 181-190 191-200 201-210 211-220 ... 560 next >