MERCEDES-BENZ GLE 2020 Owners Manual

Page 511 of 650

UniformTireQualityGradingStandards: a
uniform standard to grade the quality of tires with regard to tread quality, tire traction and
temperature characteristics. The quality grading assessment is made by the manufacturer follow

Page 512 of 650

these are installed on the vehicle, but does not
include passengers or luggage.
Maximumtireload: the maximum tire load is
the maximum permissible weight in kilograms or
lbs for which a tire is approved.
Maximumpermissibletirepressure: maxi

Page 513 of 650

Changingawheel
Notesonselecting,installingandreplacingtires
Mercedes-AMGvehicles: observe the notes in
the Supplement. Otherwise, you may fail to rec

Page 514 of 650

Only use tires, wheels and accessories that
have been checked and recommended by
Mercedes-Benz.*NOTE Risk to driving safety from retrea

Page 515 of 650

Observe the following when selecting, installing
and replacing tires:
= Only use tires and wheels of the same type
(summer tires, winter tires, MOExtended tires) and the same make.
= Only install wheels of the same size on one
axle (left and right).
It is only permissible to install a different
wheel size in the event of a flat tire in order to drive to the specialist workshop.
= Only install tires of the correct size onto the
wheels.
= Vehicleswithatirepressuremonitoring
system: All installed wheels must be equip

Page 516 of 650

The wear patterns on the front and rear wheelsdiffer:
= Front wheels wear more on the shoulder of
the tire
= Rear wheels wear more at the center of the
tire
Do not drive with tires that have too little tread depth. This significantly reduces traction on wet roads (hydroplaning).
On vehicles that have the same size front and
rear wheels, rotate the wheels according to the
intervals in the tire manufacturer's warranty
book in your vehicle documents. If this is not
available, rotate the tires every 3,000 to 6,000 miles (5,000 to 10,000 km),depending on the wear. Ensure that the direction
of rotation is maintained.
Observe the instructions and safety notes on
"Changing a wheel" when doing so
(  page 515).Notesonstoringwheels
When storing wheels, observe the following
notes:
= After removing wheels, store them in a cool,
dry and preferably dark place.
= Protect the tires from contact with oil, grease
or fuel.
Overviewofthetire-changetoolkit
Apart from some country-specific variants, vehi

Page 517 of 650

Settingupthefoldingchock
Preparingthevehicleforawheelchange
Requirements:= The required tire-change tool kit is available.
If your vehicle is not equipped with the tire-change tool kit, consult a qualified specialistworkshop to find out about suitable tools.
= The vehicle is not on a slope.
= The vehicle is on solid, non-slippery and level
ground.Apply the electric parking brake manually.Move the front wheels to the straight-ahead
position.Vehicleswithautomatictransmission:
Shift into position 005D.Vehicleswithlevelcontrolsystem: Set the
normal vehicle level (  page 231).Switch off the engine.Make sure that the engine cannot be started.Place chocks or other suitable items under
the front and rear of the wheel that is diago

Page 518 of 650

%The socket can be found in the tire-change
tool kit.Position wheel wrench 3 on socket 2.Using wheel wrench 3, turn hub cap 1
counter-clockwise and remove it.Toinstall: position hub cap 1 and turn until
it is completely flush with the wheel.Position socket 2 on hub cap 1.Attach wheel wrench 3 to socket 2 and
tighten the hub cap clockwise.
Specifiedtighteningtorque: 18 lb-ft
(25 Nm).
Raisingthevehiclewhenchangingawheel
Requirements:
= There are no persons in the vehicle.
= The vehicle has been prepared for a wheel
change (  page 515).
Important notes on using the jack:
= Use only a vehicle-specific jack that has
been approved by Mercedes-Benz to raise the vehicle.
= The jack is only designed for raising and
holding the vehicle for a short time while a
wheel is being changed and not for mainte

Page 519 of 650

Position of jack support points&WARNING Risk of injury from incorrect
positioning of the jack
If you do not position the jack correctly at
the appropriate jacking point of the vehicle,
the jack could tip with the vehicle raised.
Only position the jack at the appropri

Page 520 of 650

Removingawheel
Requirements:= The vehicle is raised (  page 516).
Mercedes-AMGvehicles: observe the notes in
the Supplement. Otherwise, you may not recog

Page:   < prev 1-10 ... 471-480 481-490 491-500 501-510 511-520 521-530 531-540 541-550 551-560 ... 650 next >