MERCEDES-BENZ SLK280 2007 R171 Owner's Manual

360 Practical hints
What to do if …
Display messagePossible cause/consequencePossible solution
SRSRestraint system malfunction
Visit workshopThere is a malfunction in the supple-
mental restraint systems. The air bags
or emergency tensioning devices
(ETDs) could deploy unexpectedly or
fail to activate in an accident.Drive with added caution to an
authorized Mercedes-Benz Center
and have the system checked
immediately.
TransmissionVisit workshopVehicles with automatic transmis-
sion*:
The provided operating safety of the
automatic transmission is reduced.Drive with added caution to the
nearest authorized Mercedes-Benz
Center.
Warning!G
In the event a malfunction of the SRS is
indicated as outlined above, the SRS may
not be operational. For your safety, we
strongly recommend that you contact an
authorized Mercedes-Benz Center immedi-
ately to have the system checked; otherwise
the SRS may not be deployed when needed
in an accident, which could result in serious
or fatal injury, or it might deploy
unexpectedly and unnecessarily which
could also result in an accident and/or
injury to you or to others.

361 Practical hints
What to do if …
Display message Possible cause/consequencePossible solution
Front passenger
airbag enabled
See Operator’s
ManualThe passenger front air bag and the
passenger-side knee bag are
activated while driving even though a
child, small individual, or object below
the system’s weight threshold is on
the passenger seat, or the passenger
seat is empty. Objects on the seat or
forces acting on the seat may make
the system sense supplemental
weight.Stop the vehicle in a safe location as soon as possible and check the
passenger seat for the following:
Switch off the ignition (page 37).
Apply the parking brake (page 59).
Remove child and child restraint from passenger seat.
Make sure that no objects which are applying supplemental weight
onto the seat are present. The system may recognize such supple-
mental weight and sense that an occupant on the passenger seat is
of a greater weight than actually present.
Keep the seat unoccupied, close the passenger door and switch on
the ignition (
page 37).
Monitor the 75indicator lamp on the center console
(
page 29) and the multifunction display in the instrument cluster
(
page 121) for the following:
(Continued on next page)

362 Practical hints
What to do if …
Display messagePossible cause/consequencePossible solution
With the seat unoccupied and the ignition switched on,

the 75indicator lamp on the center console
should illuminate and remain illuminated, indicating that the
OCS (
page 71) has deactivated the passenger front air bag and the
passenger-side knee bag.

the message Front passenger airbag enabled See Operator’s
Manual
or the message Front passenger airbag disabled See
Operator’s Manual
should not appear in the multifunction display at
any time the seat is unoccupied. Wait at least 60 seconds for the sys-
tem to complete the necessary check cycles and to make sure neither
message appears in the multifunction display.
If above conditions are met, you can occupy the passenger seat again.
Depending on the passenger classification sensed by the
OCS (
page 71), the 75indicator lamp will remain
illuminated or go out.
If above conditions are not met, the system is not working properly. Have
the system checked as soon as possible by an authorized Mercedes-Benz
Center.
Warning!G
If the 75indicator lamp
remains illuminated with an adult occupant
on the passenger seat even after performing
the above corrective steps, do not have any passenger use the passenger seat until the
system has been repaired.

363 Practical hints
What to do if …
Display messagePossible cause/consequencePossible solution
Front passenger
airbag disabled
See Operator’s
ManualThe passenger front air bag and the
passenger-side knee bag are
deactivated while driving even though
an adult or someone larger than a
small individual is occupying the front
passenger seat. Forces acting on the
seat may make the system sense a
decrease in weight.Stop the vehicle in a safe location as soon as possible and check the
passenger seat for the following:
Switch off the ignition (page 37).
Apply the parking brake (page 59).
Have the passenger vacate the seat and exit the vehicle.
Keep the seat unoccupied, close the passenger door and switch on
the ignition (
page 37).
Monitor the 75indicator lamp on the center console
(
page 29) and the multifunction display in the instrument cluster
(
page 121) for the following:
(Continued on next page)

364 Practical hints
What to do if …
Display messagePossible cause/consequencePossible solution
With the seat unoccupied and the ignition switched on,

the 75indicator lamp on the center console
should illuminate and remain illuminated, indicating that the OCS has
deactivated the passenger front air bag and the passenger-side knee
bag.

the message Front passenger airbag enabled See Operator’s
Manual
or the message Front passenger airbag disabled See
Operator’s Manual
should not appear in the multifunction display at
any time the seat is unoccupied. Wait at least 60 seconds for the sys-
tem to complete the necessary check cycles and to make sure neither
message appears in the multifunction display.
If above conditions are met, you can occupy the passenger seat again.
Depending on the passenger classification sensed by the
OCS (
page 71), the 75indicator lamp will remain
illuminated or go out.
If above conditions are not met, the system is not working properly. Have
the system checked as soon as possible by an authorized Mercedes-Benz
Center.
Warning!G
If the 75indicator lamp
remains illuminated with an adult occupant
on the passenger seat even after performing
the above corrective steps, do not have any passenger use the passenger seat until the
system has been repaired.

365 Practical hints
What to do if …
Display messagePossible cause/consequencePossible solution
Run Flat
IndicatorinoperativeThe Run Flat Indicator* is malfunc-
tioning.Have the Run Flat Indicator* checked by an
authorized Mercedes-Benz Center.
The Run Flat Indicator* has been
switched off due to a malfunction.
Tire pressureCheck tiresThe Run Flat Indicator* indicates
that the pressure is too low in one or
more tires.Carefully bring the vehicle to a halt, avoiding
abrupt steering and braking maneuvers. Observe
the traffic situation around you.
Check and adjust the tire inflation pressure as
required (
page 314).
If necessary, change the wheel (page 401).
Restart the Run Flat Indicator* after adjusting the
tire inflation pressure values (
page 314).
Check tiresThen restart
Run Flat IndicatorThere was a warning message about
a loss in tire inflation pressure and
the Run Flat Indicator* has not been
restarted yet.Make sure that the correct tire inflation pressure
is set for each tire.
Then restart the Run Flat Indicator*
(
page 316).
Warning!G
Do not drive with a flat tire. A flat tire affects
the ability to steer or brake the vehicle.
You may lose control of the vehicle. Contin-
ued driving with a flat tire will cause exces-
sive heat build-up and possibly a fire.

366 Practical hints
What to do if …
Symbol messages
Display symbolDisplay messagePossible cause/consequencePossible solution
#The battery is no longer charging.
Possible causes:

Alternator malfunctioning

Broken poly-V-belt
Do not forget that the brake system
requires electrical energy and may
be operating with restricted capa-
bility. Considerably greater brake
pedal force is required and the stop-
ping distance is increased.
Stop the vehicle immediately in a safe loca-
tion and check the poly-V-belt.
If it is broken:
Do not continue to drive.
Otherwise, the engine will overheat due
to an inoperative water pump which may
result in damage to the engine. Contact
an authorized Mercedes-Benz Center.
If it is in order:
Contact an Mercedes-Benz Center
immediately. Adjust driving to be consis-
tent with reduced braking responsive-
ness.
USA only:
;
Canada only:
!
Release
parking brakeYou are driving with the parking
brake set.Release the parking brake (page 53).

367 Practical hints
What to do if …
Display symbolDisplay messagePossible cause/consequencePossible solution
USA only:
;
Canada only:
3
Check
brake fluid levelThere is insufficient brake fluid in
the reservoir.Risk of accident!
Stop the vehicle in a safe location or as soon as
it is safe to do so.
Turn off the engine.
Apply the parking brake (page 59).
Do not drive any further.
Contact an authorized Mercedes-Benz Center.
Do not add brake fluid! This will not solve the
problem.
2Brake wearThe brake pads have reached their
wear limit.Have the brake pads replaced as soon as
possible.
Warning!G
Driving with the message Check brake
fluid level
displayed can result in an
accident. Have your brake system checked
immediately. Do not add brake fluid before
checking the brake system.
Overfilling the brake fluid reservoir can
result in spilling brake fluid on hot engine
parts and the brake fluid catching fire. You
can be seriously burned.!If you find that the brake fluid in the brake
fluid reservoir has fallen to the minimum mark or
below, have the brake system checked for brake
pad thickness and leaks.
!Brake pad thickness must be visually
checked by a qualified technician at the intervals
specified in the Maintenance Booklet.

368 Practical hints
What to do if …
Display symbolDisplay messagePossible cause/consequencePossible solution
•Coolant
Stop, turn engine
offThe coolant is too hot.
Among other possible causes,
the poly-V-belt could be broken.Stop the vehicle in a safe location or as soon as it is
safe to do so.
Turn off the engine.
Apply the parking brake (page 59).
Check the poly-V-belt.
If it is broken:
Do not continue to drive. Otherwise, the engine will
overheat due to an inoperative water pump which
may result in damage to the engine. Contact an
authorized Mercedes-Benz Center.
If it is intact:
Wait for the message to disappear before restarting
the engine.
Doing otherwise could result in serious engine
damage that is not covered by the Mercedes-Benz
Limited Warranty.
(Continued on next page)

369 Practical hints
What to do if …
During severe operating conditions, e.g.
stop-and-go traffic, the coolant tempera-
ture may rise close to 248°F (120°C).
Display symbolDisplay messagePossible cause/consequencePossible solution
Observe the coolant temperature display
(
page 127).
If the temperature rises again:
Contact an authorized Mercedes-Benz
Center immediately.
Warning!G
Driving when your engine is overheated can
cause some fluids which may have leaked
into the engine compartment to catch fire.
You could be seriously burned.
Steam from an overheated engine can cause
serious burns and can occur just by opening
the hood. Stay away from the engine if you
see or hear steam coming from it.
Turn off the engine, get out of the vehicle
and do not stand near the vehicle until the
engine has cooled down.
!The engine should not be operated with the
coolant temperature above 248°F (120°C).
Doing so may cause serious engine damage
which is not covered by the Mercedes-Benz
Limited Warranty.