warning Mercury Villager 1998 s Manual Online

Windshield Washer Fluid
Check the level of the windshield washer fluid every time you
stop for fuel, or when the warning light indicates low washer fluid.
The reservoir for washer fluid is located in the engine
compartment. This reservoir contains the fluid for both the
windshield and liftgate washers.
WARNING
Do not put windshield washer fluid in the container for
the engine coolant.
If sprayed to clean the glass, engine coolant or antifreeze could
make it difficult to see through the windshield.
Windshield washer fluid reservoir
284

Adding Engine Coolant
WARNING
Do not put engine coolant in the container for the
windshield washer fluid.
When the engine is cool, add a 50/50 mixture of engine coolant
and water to the engine coolant recovery reservoir Ð DO
NOT ADD DIRECTLY TO THE RADIATOR. Add straight water
only in an emergency, but you should replace it with a 50/50
mixture of coolant and distilled water as soon as possible.
Engine coolant recovery reservoir
286

Check the coolant level in the coolant recovery reservoir the next
few times you drive the vehicle. If necessary, add enough of a
50/50 mixture of coolant and water to bring the liquid level to the
fill line on the reservoir.
WARNING
Never remove the coolant recovery cap while the engine is
running or hot.
If you must remove the coolant recovery cap, follow these steps
to avoid personal injury caused by escaping steam or engine
coolant:
1. Before you remove the cap, turn the engine off and let it cool.
2. When the engine is cool, wrap a thick cloth around the
cap. Slowly turn cap counterclockwise to the first stop.
3. Step back while the pressure releases.
4. When you are sure that all the pressure has been released, use
the cloth to press the cap down, turn it counterclockwise, and
remove it.
Use Ford Premium Engine Coolant E2FZ-19549-AA (in Canada,
Motorcraft CXC-8-B) or an equivalent premium engine coolant that
meets Ford Specification ESE-M97B44-A. Ford Premium Engine
Coolant is an optimized formula that will protect all metals and
rubber elastomers used in Ford cooling systems for 4 years or
50,000 miles (80,000 km).
Do not use alcohol or methanol antifreeze or any engine coolants
mixed with alcohol or methanol antifreeze. Do not use
supplemental coolant additives in your vehicle. These additives
may harm your engine cooling system.The use of an improper coolant
may void the warranty of your vehicle's engine cooling system.
Maintenance and Care
287

When checking fluid at normal operating temperature, the
fluid level should be within the crosshatched area on the dipstick.
When the vehicle has not been driven, and outside temperature
is above 50É F (10É C), the fluid level should be between the notches
on the dipstick.
WARNING
Your vehicle should not be driven if the transmission
fluid level is below the bottom notch on the dipstick.
Adding Automatic Transmission Fluid
The fluid type is stamped on the dipstick. Before adding any
fluid, be sure that the correct type will be used.
Add fluid in 1/2 pint (0.25 liter) increments through the filler
tube to bring the level to the correct area on the dipstick. If an
overfill occurs, excess fluid should be removed by a qualified
technician.
Engine compartment main fuse panel
292

WARNING
The gases around the battery can explode if exposed to
flames, sparks, or lit cigarettes. An explosion could result
in injury or vehicle damage.
WARNING
To protect yourself when charging a battery, always shield
your face and eyes. Make sure that you can breathe
fresh air.
WARNING
Batteries contain sulfuric acid which burns skin, eyes, and
clothing.
If the acid touches someone's skin, eyes, or clothing, immediately
flush the area with water for at least 15 minutes. If someone
swallows the acid, have him or her drink lots of milk or water
first, then Milk of Magnesia, a beaten egg, or vegetable oil. Call a
doctor immediately.
WARNING
Applying too much pressure on the ends when lifting a
battery could cause acid to spill. Lift the battery with a
carrier or with your hands on the opposite corners.
Maintenance and Care
295

Air Filter
The air filter should not be cleaned and reused. Replace it according
to the maintenance intervals shown in theMaintenance Schedule
booklet. When replacing the filter, unclip the four clamps and
remove the filter. Wipe the inside of the air filter housing with
a damp cloth when replacing the filter.
WARNING
Never pour fuel in the throttle body or attempt to start the
engine with the air cleaner removed. Doing so could
result in fire and personal injury.
Air filter housing
296

Tires
Look at your tires each time you fill your fuel tank. If one tire
looks lower than the others, check the pressure in all of them.
Always follow these precautions:
mUse an accurate tire pressure gauge.
mStay within the recommended load limits. SeeDriving with a
heavy loadin the Index.
mMake sure the weight of your load is evenly distributed.
mAdjust tire pressure to recommended specifications found on
the Tire Pressure Decal, located in the glove compartment.
If you do not take these precautions, your tires may fail or go
flat.
WARNING
Always obey posted speed limits. If you drive too fast for
road conditions, you could lose control of your vehicle.
Under some circumstances, driving at very high speeds for
extended periods of time may damage vehicle
components, creating a risk of component failure and a
potential loss of vehicle control. Any time you lose control
of your vehicle, it may result in injury.
At least once a month, check the pressure in all your vehicle's
tires, including the spare. Use an accurate tire pressure gauge.
Check the tire pressure when tires are cold, after the vehicle
has been parked for at least one hour or has been driven less than
3 miles (5 km). You can find the proper cold tire pressure on
the Tire Pressure Decal, located in the glove compartment.
Maintenance and Care
299

WARNING
Improperly inflated tires can affect vehicle handling and
can fail suddenly, possibly resulting in loss of vehicle
control.
Tire Inspection and Maintenance
Inspect the tire treads and remove stones, nails, glass or other
objects that may be wedged in the tread grooves. Check for holes
or cuts that may permit air to leak from the tire and make the
necessary repairs.
Inspect the tire sidewalls for cuts, bruises and other damage. If
you suspect internal damage to the tire, have it removed and
checked. You may need to repair or replace it.
Tire Rotation
Because your vehicle's front and rear tires perform different jobs,
they often wear differently. To make sure your tires wear
evenly and last longer, rotate them as indicated in the following
diagram.
In situations where the tires differ from front to rear
(snow/traction), simply rotate using a side to side pattern.
300

After each rotation, adjust individual tire pressure as specified
on the Tire Pressure Decal. Tighten wheel lug nuts to the required
torque specification and retighten again after 500 miles (800
km).
If your vehicle has the optional full-size spare tire, you may
rotate the spare tire into the rotation pattern.
WARNING
If you use the temporary spare tire continuously or do not
follow these precautions, the tire could fail, causing
you to lose control of the vehicle.
If your vehicle has aluminum wheels, you may remove the full-
size spare tire from the wheel and remount it on an
aluminum wheel to rotate the spare tire into your vehicle's
rotation pattern.
Replacing the Tires
Replace tires that show wear bands. When your tire shows a
wear band, it has only 1/16 of an inch (1.59 mm) of tread left.
Rotating the tires
Maintenance and Care
301

Because your vehicle's tires may wear unevenly, you may need
to replace them before a wear band appears across the entire tread.
Your wheels and tires are match-mounted for improved ride.
Before you begin to repair a tire, mark the wheel and tire so that
they are properly aligned when remounted. This will ensure
that the tires will continue to give you the same ride level.
WARNING
When replacing full size tires, never mix radial,
bias-belted, or bias-type tires. Use only the tire sizes that
are listed on the tire pressure decal. Make sure that all
tires are the same size, speed rating, and load-carrying
capacity. Use only the tire combinations recommended
on the decal. If you do not follow these precautions, your
vehicle may not drive properly and safely.
WARNING
Make sure that all replacement tires are of the same size,
type, load-carrying capacity, and tread design (e.g. ªAll
Terrainº, etc.), as originally offered by Ford.
A worn-out tire
302