MINI Countryman 2017 Owner's Manual

Adding1.Let the engine cool.2.Turn the lid of the coolant reservoir slightly
counterclockwise to allow any excess pres~
sure to dissipate, then open it.3.If the coolant is low, slowly add coolant up
to the specified level; do not overfill.4.Close cap.5.Have the cause of the coolant loss elimi~
nated as soon as possible.
Disposal
Comply with the relevant environmen~tal protection regulations when dispos~ ing of coolant and coolant additives.
Seite 221CoolantMOBILITY221
Online Edition for Part no. 01 40 2 976 603 - X/16

MaintenanceVehicle
features
and
op

dealer

Replacing
componentsVehicle
features
and
op

Rear
wiper
blade1.Fold up and hold the wiper arm firmly.2.Pull the wiper blade out of the wiper arm.3.Attach a new wiper blade. The wiper blade
must engage audibly.4.Fold down the wiper arm.
Light/bulb
replacement
General
information
Lights
and
bulbs
Lights and bulbs make an essential contribution
to vehicle safety.
The manufacturer of the vehicle recommends that you have appropriate work performed by a dealer

Headlight
settingThe headlight adjustments can be affected by
changing lights and bulbs. After the headlight
adjustment was changed, have it checked and,
if necessary, corrected by a dealer

Bulbs: H71.Turn the steering wheel.2.Turn the cover counterclockwise, and re~
move it.3.Unscrew the inner lid counterclockwise, and remove it.4.Tilt the bulb holder down, arrow 1, and pullit downward out of the headlight, arrow 2.5.Pull the bulb out of the bulb holder.6.Install the new bulb with the bulb holder in
reverse order of removal. In doing so, en~
sure that the bulb tab is correctly posi~ tioned in the headlight housing and the
bulb holder perceptibly engages.7.Check the position of the bulb through the
headlight glass.8.Install the covers. Make sure that the covers engage.
Turn
signal
Follow the general instructions on lights and
bulbs, refer to page 225.
Bulbs: PWY24W
1.Turn the steering wheel.2.Turn the cover counterclockwise, and re~
move it.3.Unscrew the inner lid counterclockwise, and remove it.Seite 227Replacing
componentsMOBILITY227
Online Edition for Part no. 01 40 2 976 603 - X/16

4.Turn the bulb holder counterclockwise, ar~
row 1, and remove, arrow 2.5.Press the bulb gently into the bulb holder,
turn counterclockwise and remove.6.Insert the new bulb and install the covers in the reverse order. Make sure that the cov~ers engage.
Parking
lights/fog
lights/daytime
running
lights
Follow the general instructions on lights andbulbs, refer to page 225.
Bulbs:
'

4.Pull the bulb out of the fixture.5.Insert the new bulb and install the cover in
the reverse order.
The daytime running lights bulb holder en~
gages audibly, first below, then above.
LED
front
lights,
bulb
replacement
General
information
The following lights feature LED technology:
'

4.Press the bulb gently into the bulb holder,
turn counterclockwise and remove.5.Insert the new bulb and install the cover in
the reverse order.
Tail
lights,
bulb
replacement
Overview
1Side tail lights2Center brake light3License plate light
Side
tail
lights
1Brake lights/tail lights2Turn signal3Reversing lightsSide
LED
tail
lights1Brake light2Tail lights3Turn signal4Reversing lights
Side
tail
lights
Follow the general instructions on lights and
bulbs, refer to page 225.
'