MINI Hardtop 4 Door 2018 Owner's Manual

The wire is long enough to guide the socketdown and through between any heat shield
that may be installed and the bumper.4.Replace nonworking bulb.5.To install the new bulb, proceed in reverse
order of removal.
Right fog light:
1.Turn the bulb socket counterclockwise and
remove.
The wire is long enough to guide the socket down and through between any heat shield
that may be installed and the bumper.2.Replace nonworking bulb.3.To install the new bulb, proceed in reverse
order of removal.
Side
turn
signal,
bulb
replacement
Follow the general instructions on lights and
bulbs, refer to page 234.
Bulbs:
'

Vehicle
batteryMaintenance
The battery is maintenance-free.
The added amount of acid is sufficient for the
service life of the battery.
More information about the battery can be re~
quested from a dealer

Fuses
Safety
information WARNING
Incorrect and repaired fuses can overload
electrical lines and components. There is a risk of fire. Never attempt to repair a blown fuse.Do not replace a nonworking fuse with a sub~stitute of another color or amperage rating. '

Breakdown
assistanceVehicle
features
and
op

Safety
informationDANGER
Contact with live components can lead to
an electric shock. There is a risk of injuries or danger to life. Do not touch any components
that are under voltage. '

If the first starting attempt is not successful,wait a few minutes before making anotherattempt in order to allow the dischargedbattery to recharge.3.Let both engines run for several minutes.4.Disconnect the jumper cables in the reverseorder.
Check the battery and recharge, if needed.
Tow-starting
and
towing
Safety
information WARNING
Due to system limits, individual functions
can malfunction during tow-starting/towing
with the Intelligent Safety systems activated.
There is a risk of an accident. Switch all Intelli~
gent Safety systems off prior to tow-starting/
towing. '

needs to be applied when braking andsteering.'

Tow
fitting
General
information
The screw-in tow fitting should always be car~ ried in the vehicle.
The tow fitting can be screwed in at the front or rear of the vehicle.
The tow fitting and the onboard vehicle tool kit,
refer to page 233, are together in the cargo
area.
Use of the tow fitting:
'

5.Stop at a suitable location, remove the towbar or rope, and switch off the hazard
warning system.6.Have the vehicle checked by a dealer

CareVehicle
features
and
op