Data link connector MITSUBISHI 3000GT 1995 2.G Repair Manual

Downloaded from www.Manualslib.com manuals search engine CHASSIS ELECTRICAL - Lighting System54-75
IGNITIONSWITCH(IG1)
J/B
GNDV
. ,.
R-BB-LB
BR-G
,,4 (c-34116 945AAhA
R-GR-GDATA LINK
CONNECTOR
,,l,,l(c-79)
OFF--ON2B
(E-15)I(E-21)
NOTEYz
:l:VEHICLES WITHOUTTHEFT-ALARM SYSTEM(RH)(LH)\I%2:VEHICLES WITHTHEFT-ALARM SYSTEMDOOR SWITCH
A=
IIIIIIIIII1II
(c-34)(c-65) :Iic-65) ?;2(c-66):1 (C-66)$OFRONT sm 0
HROBMlPAB
1 TSB Revision

Downloaded from www.Manualslib.com manuals search engine CHASSIS ELECTRICAL - Lighting System54-77 i
IGNI’SWIT(
J/B2B-b
i/
2B-bB-W
NOT '
CHAkGING
52-------------------------------~
------j p?"
R-Gr
4(c-34)
R-G
R-C
(RH)
10(c-66)
EC$gAk;GHT AND
E#+RTMENT
-J
J/BR-G
A
R-B
i
B-L
16(E-21)
X
(LH)
DOOR TWITCH
C
54
DATA LINK
CONNECTOR
(c-79)
2B
(c-34)(c-651ic-66)OFRONT sIBi5 (C-80)(c-82) (E?(m)
ilR08M13AB
1 TSB Revision1

Downloaded from www.Manualslib.com manuals search engine CHASSIS ELECTRICAL - Lighting System54-79 ~
Data link connector
<From 1994 modelsrL!l
\Y16FO498 1
TSB RevisionI

Downloaded from www.Manualslib.com manuals search engine With voltmeterData link connector
’‘:’ ’ ’- Data linkGround ETA,CS 21~33300002230
54-80CHASSIS ELECTRICAL - Lighting System
INPUT SIGNAL
<Up to 1993 models>
When using the scan tool (MUT) or voltmeter
Using the scan tool or voltmeter, check whether or not the
input signals from each switch are being input to the ETACS
unit.
(1) Connect the scan tool to the data link connector located
at the right side of the junction block or connect the voltme-
ter between the ETACS terminal and the ground terminal.
(2) Check if the buzzer of the scan tool sounds or the needleof the voltmeter moves when each switch is operated.
If the buzzer sounds or the needle moves, the input signalsare being input to the ETACS unit, so that switch can
be considered to be functioning normally. If not, the switch
or switch input circuit is faulty. Check the switch and the
switch input circuit.
When using the MUT-II
cup to 1993 models>
Y2OFOl6400002231
#\,I kQwnd\ \U2OFO163
<All models>
When using the scan tool (MUT-II)
(1) Connect the scan tool to the data link connector. When
connecting the scan tool to a vehicle up to 1993 models,
use the adapter harness supplied together.
Caution
Turn off the ignition switch beforehand whenever thescan tool is connected or disconnected.
(2) If the scan tool makes a peep sound when each switchis operation (turned ON/OFF), the input signal to ECU
is normally sent from the switch circuit system.
<From 1994 models>When using the voltmeter
(1)Connect a voltmeter to the ETACS terminal and the ground
terminal of the data link connector using the special tool.
(2) If the voltmeter pointer deflects once when each switchis operated (turned ON/OFF), the input signal to ECU
is normally sent from the switch circuit system.
Ii3
\ ~
id ~
!Lj
[ TSB Revision

Downloaded from www.Manualslib.com manuals search engine CHASSIS ELECTRICAL - Rear Window Defogger54-193
8,TROUBLESHOOTINGCIRCUIT DIAGRAM
(UP TO 1993 MODELS)
3R-B
5
;&iL#GHT
I
LI IG-WI
- t
8=
i nF;2B-RG-W
REMOTE
CONTROLLED
MIRROR
(HEATER>
3B
DEFOGGER
nZ
+j m
DATA LINK
CONNECTOR
:l:VEHICLES WITHOUTTHEFT-ALARM SYSTEMX2:VEHICLES WITHTHEFT-ALARM SYSTEM
(c-65):1(c-65)
ILL
J I1 \L\I II“1I
B(B-Y)4 IIII0II
2BIB-Y
(i&y,2 ---------- - ---- ----1
f
RHEOSTAT
HR13MOOAA
TSB Revision

Downloaded from www.Manualslib.com manuals search engine CHASSIS ELECTRICAL - Rear Window Defogger
ii
2W-B
5W-BHORN
‘J/B,.1 (c-68)
(F>R-B(F>R-I
DOOR LIGHT AND LUGGAGE
COMPARTMENT LIGHT
:I,
,HEADLIGHT.FOG LIGHT.TAILLIGHT.PARKING/SIDE
MARKER LIGHT
AND LICENSE
PLATE LIGHT
69
10A\/
11------ A/1R-Y
r R
(c-70)
/L-R
cc-65)
f
i
I
,E
2B
FUSIBLE LINKa
I
1,,2 ,,l/\,--(A-11X) (
2B-F
IOD OR STRAGE
CONNECTOR
DEFOGGER
SWITCH
iD-os)
i
my54
B-L
R-B
9I16"AA\(
45 DATA LINK CONNECTOR
B(c-79)
i
L-R
V
1'4
:;fE-$;T (B-Y).$;;EESAND
2B
,(D-41)B-Y
27
RHEOSTAT
2B
h
n
NOTE:l:VEHICLES WITHOUTTHEFT-ALARM SYSTEM.:2:VEHICLES WITHTHEFT-ALARM SYSTEM.
2B-k
\6
IND(UN
TAILLIGHT RELAY
q-
:;&"A'""
J/B
7L IIG-W
I
8cc-71)
p@
G-W4
Ed.ELC-4A/T
'i;$$SAND (G-W)
2,,3
HR13M02AB
TSB Revision

Downloaded from www.Manualslib.com manuals search engine CHASSIS ELECTRICAL - Rear Window Defogger54-199
LJ
FUSIBLE LINKa
I
(c-83)L
(F>R-B(F>R-i
DOOR LIGHT AND LUGGAGECOMPARTMENF
.HEADLIGHT,FOG LIGHT.TAILLIGHT.PARKING/SIDE
MARKER LIGHT
AND LICENSE
PLATE LIGHTr
IL-R
(C-65)112P
$
4
B
E
F
2B=
/ - 12B-
IOD OR STRAGE
CONNECTOR
DEFOGGER
SWITCH
(D-06)i
Al
5 DATA LINK CONNECTOR
)FF ‘T[
2B
2B
2B-
6
IN
I
TAILLIGHT RELAY
I1.25R-W
l&&CATED
0%
15A
G-W,,6 (c-69)
J/B\
,\,G-W8 (c-71)
W8(D-44)
1
(D-41).ELC-4A/T
'&;&AND (G-W)),,31
:aFRONT SIDE (c-83)
B-Y
RHEOSTAT
HR13M03AB
TSB Revision

Downloaded from www.Manualslib.com manuals search engine 54-200CHASSIS ELECTRICAL - Rear Window Defogger
OPERATIONl
If the defogger switch is turned to “ON” when the generator is generating electricity (L terminal exceeds
10 V.) with the ignition switch at the “ON” position, the timer circuit in the ETACS unit will be operated
to keep the transistor “on” for 11 minutes to close the contact point of the defogger relay. When the
defogger relay is “on”,the defogger and mirror heater will be activated. Moreover, the indicator lightof the defogger switch is lit to inform that the defogger and mirror heater are activated.
lWhen 11 minutes have passed, the defogger and mirror heater will stop activating even if the defoggerswitch is at “ON”. When the defogger and mirror heater are activated (the timer is activated), they
will also stop activating even if the defogger switch is set at “ON” again or if the generator stops
generating electricity (the terminal is 3.5 V or less.)
NOTE
The light automatic shut-off system is valid for the illumination light of the defogger switch. (Refer to
P.54-37.)
TROUBLESHOOTING HINTS
NOTE
For the troubleshooting hints of the automatic light shut-OFF system, refer to P.54-38.
COMPONENT LOCATION
Datalink. connector
216FO125
Data link connector
<From 1994 models>
\V16FO496 1
es.-‘) blocky,6Fww
1 TSB Revision

Downloaded from www.Manualslib.com manuals search engine 54-202CHASSIS ELECTRICAL - Rear Window Defogger
With voltmeterData link connector
When using the MUT-IICUD to 1993 models>
Y2OFO16400002231
Ground
INPUT SIGNAL
<Up to 1993 models>
When using the scan tool
(MUT) or voltmeter
Using the scan tool or voltmeter, check whether or not the
input signals from each switch are being input to the ETACS
unit.
(1) Connect the scan tool to the data link connector located
at the right side of the junction block or connect the voltme-
ter between the ETACS terminal and the ground terminal.
(2) Check if the buzzer of the scan tool sounds or the needle
of the voltmeter moves when each switch is operated.
If the buzzer sounds or the needle moves, the input signalsare being input to the ETACS unit, so that switch can
be considered to be functioning normally. If not, the switch
or switch input circuit is faulty. Check the switch and the
switch input circuit.
<All models>
When using the scan tool (MUT-II)
(1) Connect the scan tool to the data link connector. When
connecting the scan tool to a vehicle up to 1993 models,
use the adapter harness supplied together.
Caution
Turn off the ignition switch beforehand whenever thescan tool is connected or disconnected.
(2) If the scan tool makes a peep sound when each switchis operated (turned ON/OFF), the input signal to ECU
is normally sent from the switch circuit system.<From
1994 models>
When using the voltmeter
(1)Connect a voltmeter to the ETACS terminal and the ground
terminal of the data link connector using the special tool.
(2) If the voltmeter pointer deflects once when each switchis operated (turned ON/OFF), the input signal to
.ECU
is normally sent from the switch circuit system.
U2OFO163
TSB Revision

Downloaded from www.Manualslib.com manuals search engine 54-212CHASSIS ELECTRICAL - Theft-alarm System
CIRCUIT DIAGRAM (CONTINUED)
IGNITIONSWITCH(ST)
KEYLIGHT&y+;;ERAUTOMATIC
SHUT-OFF UNIT
rA/T yM/T
1B-LI
Y-B
7
M/T y A/T/
20-Y -4
STARTER/\
RELAY,Io oft--,--------------------------- _______I
!a
III
2B-Yr2B-L
r11/T ! A/T1t--
-B
b-B 2
LUTD-CRUISE CONTROL IMFI SYSTEM
LG-B2B-k
2B-Y
EE”pSOU;&ON
'(c-64)SUPPLEMENTALl$&gJ& I NT
MFI SYSTEMSYSTEM
J/BJ;B j "7$I
v c&i--9B-----v my9----- =54=54
R-B R-B00B-L B-LB B B B
16 164 4-5-5 99AAA h *A h *4
DATA LINK CONNECTOR
(c-79)
BATTERYJm
20B-R3B-RJ(B-23) ,.l(B-24)/\
%ERER
(c-65)(c-66)(c-79) FRONT SIDE
HRlBMOlBA
1 TSB Revision