MITSUBISHI ASX 2019 (in English) Owner's Guide

Procedure for replacing the re-mote control switch battery
Before replacing the battery, remove static electricity from your body by touching a met-
al part such as doorknob of the room.
:ARN,NGz Danger of explosion if battery is incor-
rectly replaced.
Replace only with the same battery or an equivalent type.CAUT,ONz When the remote control switch case is
opened, be careful to keep water, dust, etc. out. Also, do not touch the internal compo-
nents.NOTEz You may purchase a replacement battery at
an electric appliance store.
z A
MITSUBISHI MOTORS Authorized
Service Point can replace the battery for you
if you prefer.1. Remove the screw (A) from the remote
control switch.
2. With the MITSUBISHI mark facing you, insert the cloth-covered tip of a straight
blade (or minus) screwdriver into the notch in the remote control switch case
and use it to open the case.
NOTEz Be sure to perform the procedure with the
MITSUBISHI mark facing you. If the
MITSUBISHI mark is not facing you when
you open the remote control switch case, the switches may come out.
3. Remove the old battery.
4. Install a new battery with the + side (B)
up.
5. Close the remote control switch case
firmly.
6. Attach the screw (A) removed in step 1.
7. Check the keyless entry system to see
that it works.
Keyless entry system*
3-072*$((Locking and unlocking3 + side - side Coin type battery
CR1620

Keyless operation system*
The keyless operation system allows you to lock and unlock the doors and tailgate, start
the engine and change the operation mode simply by carrying the keyless operation key
with you.
The keyless operation key can also be used as the keyless entry system remote control
switch.
Refer to “Keyless operation system: Keyless
entry system” on page 3-21.

The driver should always carry the keyless
operation key. This key is necessary for lock- ing and unlocking the doors and tailgate,
starting the engine and otherwise operating the vehicle, so before locking and leaving the vehicle, be sure to check that you have the
keyless operation key.:ARN,NGz People with implantable cardiac pace-
makers or implantable cardiovascular-de-
fibrillators should not go near the exterior
transmitters (A) or the interior transmit- ters (B). The radio waves used by the key-
less operation system could adversely af- fect implantable cardiac pacemakers orimplantable cardiovascular-defibrillators.:ARN,NGz When using electro-medical devices other
than implantable cardiac pacemakers or implantable cardiovascular-defibrillators,
contact the electromedical device manu- facturer ahead of time to determine theaffects of radio waves on the devices. Elec-
tromedical device operations could be af-
fected by radio waves.
You can limit the possible operations of
the keyless operation system in the fol-
lowing ways. (The keyless operation system can be used as a keyless entry system.) Consult a MITSUBISHI
MOTORS Authorized Service Point.

NOTEzBecause the keyless operation key receives
signals in order to communicate with the transmitters in the vehicle, the battery con-tinually wears down regardless of keylessoperation key use. The battery life is 1 to 3
years, depending on usage conditions. When the battery wears out, please consult aMITSUBISHI MOTORS Authorized Serv-
ice Point.
If you replace the battery yourself, refer to “Procedure for replacing the remote control
switch battery” on page 3-23.
z Because the keyless operation key continual-
ly receives signals, strong radio wave recep-
tion could affect battery wear. Do not leave
the key near a TV, personal computer, or
other electronic device.Operating range of the keyless
operation system
If you are carrying the keyless operation key,
enter the operating range of the keyless oper- ation system, and press the driver

NOTEzEven if the keyless operation key is within
70 cm of the driver

NOTEzFor vehicles equipped with the mirror retrac-
tor switch, the outside rear-view mirrors au-
tomatically retract when all the doors and
tailgate are locked using the keyless opera- tion function.
Refer to “Starting and driving: Outside rear- view mirrors” on page 6-09.
z With a vehicle that has a Dead Lock System,
pressing the driver

NOTEzFor vehicles equipped with the mirror retrac-
tor switch, the outside rear-view mirrors au-
tomatically extend when all the doors and tailgate are unlocked using the keyless oper-
ation function.
Refer to “Starting and driving: Outside rear- view mirrors” on page 6-09.
z Except for vehicles equipped with a Dead
Lock System, the keyless operation functioncan be set so that only the driver

NOTEzIf you lose one of the keyless operation
keys, contact a MITSUBISHI MOTORS
Authorized Service Point as soon as possi- ble.
To obtain a replacement or extra spare key,
take your vehicle and all remaining keys to
your MITSUBISHI MOTORS Authorized
Service Point. All the keys have to be re-reg- istered in the immobilizer computer unit. The immobilizer can register up to 4 differ-
ent keys.Engine switch
In order to prevent theft, the engine will not
start unless a preregistered keyless operation
key is used. (Engine immobilizer function) If you are carrying the keyless operation key,
you can start the engine.
Also refer to “Starting and driving: Starting the engine” on page 6-14.
CAUT,ONz The indication lamp (A) will flash orange
when there is a problem or malfunction inthe keyless operation system. Never drive if
the indication lamp on the engine switch is
flashing orange. Immediately contact a
MITSUBISHI MOTORS Authorized Serv-
ice Point.
z If the engine switch operation is not smooth
and feels like it is sticking, do not operate
the switch. Immediately contact a
MITSUBISHI MOTORS Authorized Serv-
ice Point.NOTEz When operating the engine switch, press the
switch all the way in. If the switch is not fully pressed, the engine may not start or theoperation mode may not change. If the en-
gine switch is pressed correctly, there is no need to hold the engine switch down.
z When the battery in the keyless operation
key has worn out, or the keyless operationkey is out of the vehicle, a warning displaywill appear.Operation mode of the engine
switch and its function
OFF
The indication lamp on the engine switch
turns off. The operation mode cannot be put
in OFF when the selector lever is in any posi- tion other than the “P” (PARK) position
(CVT).
ACC
The audio system and other electric devices can be operated.
The indication lamp on the engine switch il-
luminates orange.
ON
All electric devices can be operated.
The indication lamp on the engine switch il-
luminates green.
The indication lamp turns off when the en-
gine is running.
NOTEz Your vehicle is equipped with an electronic
immobilizer. To start the engine, the ID codetransmitted by the transponder inside the key must match the code registered in the immo-
bilizer computer.
(Refer to “Electronic immobilizer (Anti-theft
starting system)” on page 3-12.)
Keyless operation system*
3-132*$((Locking and unlocking3

Changing the operation mode
If you press the engine switch without de-
pressing the brake pedal ( CVT) or the clutch
pedal ( M/T), you can change the operation
mode in the order of OFF, ACC, ON, OFF.
CAUT,ONz When the engine is not running, put the op-
eration mode in OFF. Leaving the operation mode in ON or ACC for a long time when
the engine is not running may cause the bat- tery to be discharged, making it impossible
to start the engine, lock and unlock the steer- ing wheel.
z When the battery is disconnected, the cur-
rent operation mode is memorized. After re- connecting the battery, the memorized mode
is selected automatically. Before disconnect- ing the battery for repair or replacement,
make sure to put the operation mode in OFF. Be careful if you are not sure which opera- tion mode the vehicle is in when the battery
is run down.CAUT,ONz The operation mode cannot be changed from
OFF to ACC or ON if the keyless operation
key is not detected to be in the vehicle. Refer
to “Keyless operation system: Operating range for starting the engine and changing
the operation mode” on page 3-10.
z When there is the keyless operation key in
the vehicle and the operation mode is not
changed, the battery in the keyless operation key may have worn out.
Refer to “Warning activation” on page
3-14.NOTEz If the operation mode cannot be changed to
OFF, perform the following procedure.
1
. Move the selector lever to the “P”
(PARK) position, and then change the operation mode to OFF. (For ve-hicles with CVT)
2 . One of the other causes could be low
battery voltage. If this occurs, the
keyless entry system, keyless opera- tion function and steering lock will also not operate. Contact a
MITSUBISHI MOTORS Authorized
Service Point.ACC power auto-cutout func-
tion
After approximately 30 minutes has elapsed
with the operation mode in ACC, the func- tion automatically cuts out the power for the
audio system and other electric devices that
can be operated with that mode.
When the engine switch is pressed while the operation mode is in ACC, the power is sup-
plied again to those devices.
NOTEz It is possible to modify functions as follows:

If a warning is activated, always check thevehicle and the keyless operation key. The warning is also displayed if there is a fault in
the keyless operation system.
If any of the following warnings are activa-
ted, please contact a MITSUBISHI
MOTORS Authorized Service Point.There is a fault in the keyless operation system.The battery in the keyless opera- tion system key has worn out.Put the operation mode in OFF and then start the engine again.
If the warning is not cancelled, there is a fault in the electronic
immobilizer (Anti-theft starting
system).
Please contact a MITSUBISHI
MOTORS Authorized Service
Point.
In the following cases, a warning is activated,
but it can be cancelled if the correct actions are followed.
z The ID codes for the keyless operation
key and vehicle do not match.
You could be carrying another
keyless operation key with a dif- ferent code, or the keyless oper-
ation key could be outside the operating range.Refer to “Keyless operation key
take-out monitoring system” on
page 3-15.
z Even though you press the driver

Key lock-in prevention system
When the operation mode is in OFF, if you
close all the doors and the tailgate with the keyless operation key left in the vehicle and
you try to lock the doors and tailgate by
pressing the driver