MITSUBISHI ASX 2019 (in English) Repair Manual

NOTEzThe function will be activated again if the
following operation is performed.

Alarm activation
When the system is in the system armed
mode, the alarm will be activated as follows
if the vehicle is unlocked or if any of the doors, tailgate or bonnet is opened using a method other than the keyless entry system orthe keyless operation function. 1. The alarm will be activated for approxi-
mately 30 seconds.
The turn-signal lamps will blink, and the siren will sound intermittently.
2. The alarm will resume if unlawful ac-
tions are taken again, even if the alarm has stopped.
NOTEz During an alarm operation, the alarm is dis-
played on the information screen in the mul-
ti-information display.
Type 1
Type 2
Cancelling the alarm
It is possible to halt the activation of an alarm
using the following methods:
z Pressing the LOCK or UNLOCK switch
on the remote control switch.
(After pressing the LOCK switch, the
vehicle will lock if all the doors and the tailgate are closed, after which the sys-
tem preparation mode will once again go into effect.)
z Turning the ignition switch to the “ON”
position (except for vehicles equipped
with the keyless operation system).
z Putting the operation mode in ON (vehi-
cles equipped with the keyless operation
system).
z Holding the keyless operation key and
locking and unlocking the doors and the
tailgate using the keyless operation func- tion (vehicles equipped with the keylessoperation system).NOTEz When the ignition switch is turned to the
“ON” position or the operation mode is put in ON, the buzzer sounds 4 times. This oper-
ation indicates that the alarm was activated while the vehicle was parked.
Please check the inside of the vehicle to con-
firm that nothing was stolen.
z Even if the battery is disconnected, the alarm
activation memory will not be erased.Electric window control
The electric windows can only be operated
with the ignition switch in the “ON” position
or the operation mode in ON.
:ARN,NGz Before operating the electric window con-
trol, make sure that nothing can get trap- ped (head, hand, finger, etc.).
Electric window control
3-382*$((Locking and unlocking3

:ARN,NGzNever leave the vehicle without removing
the key.
z Never leave a child (or other person who
might not be capable of safe operation of
the electric window control) in the vehicle alone.
z The child may tamper with the switch at
the risk of its hands or head being trap- ped in the window.Electric window control switch
Each door window opens or closes while the
corresponding switch is operated.
1- Driver

To unlock, press it once again.
1- Lock
2- Unlock
:ARN,NGz A child may tamper with the switch at the
risk of its hands or head being trapped in the window. When driving with a child in
the vehicle, please press the window lock switch to disable the passenger

:ARN,NGzDo not bring your head, hand, finger, etc.
near the opening edge of the sunshade re-
ceptacle while the vehicle is in motion.
It may cause injury to your head, hand, finger, etc. in the event of sudden braking.CAUT,ONz Do not place heavy luggage on the panoram-
ic glass roof. Doing so could damage the glass roof.
z Do not hang heavy luggage from, allow a
person to hang onto, or apply any other strong force to the opening of the sunshade receptacle or the parts between the ceiling
and the sunshade opening on either side. Do- ing so could damage the sunshade.NOTEz Release the switch as soon as the sunshade
reaches the fully open or fully closed posi-
tion.
z If the sunshade does not operate when the
sunshade switch is operated, release the
switch and check whether something is trap- ped by the sunshade. If nothing is trapped,
we recommend you to have the sunshade checked.
z Operating the sunshade repeatedly with the
engine stationary will run down the battery.
Operate the sunshade while the engine is running.NOTEz Close the sunshade when parking the vehicle
for a long time. Parking in the hot sun with
the sunshade open will make the vehicle in-
side extremely hot.
The sunshade can only be operated with the
ignition switch or the operation mode in ON.
1- Open
2- Close
3- Stop
To open, press the switch (1).
Press and hold the switch (1), the sunshade automatically opens. Release the switch once
the sunshade starts moving automatically.
To stop the moving sunshade, press the
switch (1), (2) or (3).

To close, press the switch (2).
Press and hold the switch (2), the sunshade
automatically closes. Release the switch once
the sunshade starts moving automatically.
To stop the moving sunshade, press the
switch (1), (2) or (3).
Safety mechanism
If a hand or head is trapped in the closing
sunshade, it will reopen automatically.
Nonetheless, make sure that nobody brings
their head or hand near the sunshade when opening or closing.
The opened sunshade will become operation-
al after a few seconds.
CAUT,ONz The safety mechanism is cancelled just be-
fore the sunshade is fully closed. This allows the sunshade to close completely.
Therefore be especially careful that no fin-
gers are trapped in the sunshade.NOTEz The safety mechanism can be activated if the
driving conditions or other circumstancescause the sunshade to be subjected to a phys-
ical shock similar to that caused by a trapped
hand or head.
Sunshade*
3-412*$((Locking and unlocking3

2*$((

Seat...................................................................................................... 4-02
Seat adjustment................................................................................... 4-03 Front seat............................................................................................. 4-03
Rear seat.............................................................................................. 4-06
Head restraints.....................................................................................4-07
Making a luggage compartment..........................................................4-08 Seat belts............................................................................................. 4-09
Pregnant women restraint....................................................................4-14
Seat belt pretensioner system and force limiter system...................... 4-14
Child restraint......................................................................................4-15 Seat belt inspection............................................................................. 4-23Supplemental restraint system (SRS) - airbag.................................... 4-246eatandseatbelts
2*$((4

Seat1-Front seat
zTo adjust forward or backward
o p. 4-03
z To recline the seatback
o p. 4-04
z To adjust seat height (driver

Seat adjustment
Adjust the driver

Power type
Adjust the seat by operating the switch as in-
dicated by the arrows.
1- Adjustment forward
2- Adjustment backward
NOTEz To prevent the battery from discharging, use
the power seat while the engine is on.To recline the seatback
Manual type
In order to recline the seatback, lean forward
slightly, pull the seatback lock lever up, and then lean backward to the desired position
and release the lever. The seatback will lock in that position.
CAUT,ONz The reclining mechanism of the seatback is
spring loaded, causing it to return to the ver- tical position when the lock lever is operat- ed. When using the lever, sit close to the
seatback or hold it with your hand to control its return motion.Power type
Adjust the seatback angle by operating the
switch as indicated by the arrows.
1- To move to forward direction
2- To recline rearward
NOTEz To prevent the battery from discharging, use
the power seat while the engine is on.
Front seat
4-042*$((Seat and seat belts4