MITSUBISHI ASX 2020 (in English) Manual Online

NOTEzIf the seat belt (A) or ring (B) becomes dirty,
the belt may not retract smoothly. If the seat
belt and ring are dirty, clean them with a
mild soap or detergent solution.Driver

Raise or lower the seat belt anchor (A) while
pressing the lock knob (B).DownUp
:ARN,NGz When adjusting the seat belt anchor, set it
at a position that is sufficiently high so
that the belt will make full contact with your shoulder but will not touch your
neck.3-point type seat belt with 2
buckles
3-point type seat belt with 2 buckles is fitted
in the rear centre seating position.
NOTEz You can check if the belt locks by pulling it
forward quickly.To fasten
1. Pull the seat belt out slowly and pass it
through the seat belt guide (A).
NOTEz When the seat belts cannot be pulled out in a
locked condition, pull the belt once forceful-
ly and then return it.
After that, pull the belt out slowly once
again.
2. After making sure that the seat belt is
not twisted, insert the latch plate (B) into
the buckle (C) aligning the marks (D) on
the plate and buckle until a “click” is heard.
:ARN,NGz When using the seat belt, make sure to se-
curely connect the latch plate (B) with the
buckle (C). Failing to do so could signifi- cantly reduce the amount of protection
and cause serious injures in a collision or a sudden stop.
Seat belts
4-122*$(20(1Seat and seat belts4

3.Insert the latch plate (E) into the buckle
(F) until a “click” is heard.
4. Make sure the lap belt is positioned as
low as possible on the hips and pull the shoulder belt to adjust the slackness of
the lap belt.
To unfasten
1. Hold the latch plate (E) and push the
button on the buckle (F).
2. Push the button (G) on the buckle (C)
using the latch plate (E) to disconnect
the seat belt from the buckle.
3. Retract the seat belt and remove it from
the seat belt guide (A).
4. After the seat belt is retracted complete-
ly, insert the latch plate (E) into the up-
per slit (H) and the latch plate (B) into the lower slit (I).
Seat belts
4-132*$(20(1Seat and seat belts4

Pregnant women restraint:ARN,NGzSeat belts work for everyone, including
pregnant women. Pregnant women should
use the available seat belts. This will re- duce the likelihood of injury to both thewoman and the unborn child. The lap belt
should be worn across the thighs and as snug against the hips as possible, but not
across the waist. Consult your doctor if you have any additional questions or con-
cerns.Seat belt pretensioner
system and force limiter system
The driver

Child restraint
When transporting children in your vehicle, some type of child restraint system should al-
ways be used according to the size of the child. This is required by law in most coun-
tries.
The regulations concerning driving with chil- dren in the front seat may differ from country
to country. You are advised to comply with the relevant regulations.:ARN,NGz When possible, put children in the rear
seat. Accident statistics indicate that chil-
dren of all sizes and ages are safer when properly restrained in the rear seat rather than in the front seat.
z Holding a child in your arms is no substi-
tute for a restraint system. Failure to use
a proper restraint system can result in se-
vere or fatal injury to the child.
z Each child restraint device or fixing is to
be used only by one child.
z When attaching a child restraint system
to the rear seat, prevent the front seat-
backs from touching the child restraint system.
Otherwise, the child could be seriously in-
jured in the event of hard braking or a collision.Caution for installing the child
restraint on vehicles with afront passenger airbag
The label shown here is attached on vehicles with a front passenger airbag.
:ARN,NGz Extreme Hazard!
NEVER use a rearward facing child re- straint on a seat protected by an ACTIVEAIRBAG in front of it, DEATH or SERI-
OUS INJURY to the CHILD can occur.NOTEz The labels may be in different positions de-
pending on the vehicle model.Use rearward facing child restraints in the
rear seat or turn off the front passenger

Infants and small children
When transporting infants and small childrenin your vehicle, follow the instruction given below.
Instruction:
z For small infants, an infant carrier
should be used. For small children whose height when seated allows the shoulder belt to lie in contact with the
face or the throat, a child seat should be used.
z The child restraint system should be ap-
propriate for the child

Suitability for various ISOFIX positionsMass groupSize classFixtureVehicle ISOFIX positionsRear outboardCarrycotFISO/L1XGISO/L2X0- Up to 10 kg
(0-9 months)EISO/R1IL0+- Up to 13 kg
(0-2 years)EISO/R1IL—ISO/R2XILDISO/R2IL, IL 1CISO/R3ILI- 9 to 18 kg
(9 months-4 years)—ISO/R2XILDISO/R2ILCISO/R3ILBISO/F2IUFB1ISO/F2XIUF, IL 2AISO/F3IUFII & III- 15 to 36 kg
(4-12 years) XCAUT,ONz When installing a child restraint system, remove the head restraint from the seat.
Child restraint
4-172*$(20(1Seat and seat belts4

Key of characters to be inserted in the table above:
zIUF- Suitable for ISOFIX forward child restraints systems of universal category approved for use in the mass group.
z IL- Suitable for ISOFIX child restraint systems of semi-universal category approved for use in the mass group.
z IL
- Suitable for particular ISOFIX child restraint systems given in the following list (MITSUBISHI MOTORS genuine parts).
z X- ISOFIX position not suitable for ISOFIX child restraint systems in this mass group.IL 
(Genuine part information) Genuine part No.UN-R44
Approval No.UN-R129
Approval No.IL 1MZ315055 (BABY-SAFE i-SIZE),
MZ315056 (BABY-SAFE i-SIZE FLEX BASE)

Suitability for various seating positions
Mass group
Seating positionFront passenger
Rear outboardRear centre
Activated air-bagDeactivated Air-
bag*10- Up to 10 kg
(0-9 months)XXUX0+- Up to 13 kg
(0-2 years)XL 1U, L 1L1I-9 to 18 kg
(9 months-4 years)XL 2U, L 2L2II & III-15 to 36 kg
(4-12 years)XL 3U *2
, L 3X
*1
: With front passenger

L
(Genuine part information) Genuine part No.UN-R44
Approval No.UN-R129
Approval No.L 1MZ315055 (BABY-SAFE i-SIZE)