ESP MITSUBISHI GRANDIS 2008 (in English) Owner's Guide
Page 396 of 458
8-40 Maintenance
8
●Some fuses may not be installed on your vehicle, depend-
ing on the vehicle model or specifications.
●The table above shows the main equipment corresponding
to each fuse.Identification of fuse
Fuse replacement 1. Before replacing a fuse, always turn off the electrical cir-
cuit concerned and place the ignition switch in the
“LOCK” position.
No.
Symbol
Electrical system
Capacity
1 Condenser fan 30 A
2 Engine control 30 A
3 Control flap 10 A
4 Glow relay 10 A
5 Valve block 10 A
6 Immobilizer 7.5 A
7 Heating pipe 10 A
7.5 A Brown
10 A Red
15 A Blue
20 A Yellow
25 A Transparent
30 A Green (fuse type) / Pink (fusible link type)
40 A Green
50 A Red
60 A Yellow (fusible link type)
LHD
BK-XP08E1ENUK.en-uk.book Page 40 Monday, August 13, 2007 2:20 PM
Page 398 of 458
8-42 Maintenance
8
[RHD vehicles]
Open the personal box and pull the personal box towards
you while lifting it up to remove.
Remove the fuse puller (B) from the personal box lid (A).3. Referring to the fuse load capacity table, check the fuse
pertaining to the problem.
NOTE●If any system does not function but the fuse corresponding
to that system is normal, there may be a fault in the system
elsewhere. We recommend you to have your vehicle
checked.
RHD
C- Fuse is OK
D- Blown fuse
BK-XP08E1ENUK.en-uk.book Page 42 Monday, August 13, 2007 2:20 PM