oil capacity MITSUBISHI LANCER EVOLUTION IV 1998 Workshop Manual

ENGINE LUBRICATION – Lubricants / Engine Oil Cooler12-2
TSB Revision
LUBRICANTS
ItemsCapacity dm3 {
}
Engine oilQuantity in oil filter0.3 {0.3}
Quantity in oil cooler0.16 {0.16}
Total quantity5.1 {5.1}
BrandDIA QUEEN MOTOR OIL (Grade SG or higher); or engine oil in
a can marked with ILSAC certification.
ENGINE OIL COOLER
REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operation
(1) Engine Oil Removal and Refilling
(2) Front Bumper Removal and Installation
(Refer to GROUP 51.)
3
Unit: Nm {kgfm}
12 {1.2}
39 – 44
{4.0 – 4.5} 29 – 34
{3.0 – 3.5}
2 1
39 – 44
{4.0 – 4.5} 12 {1.2}
12 {1.2}
Removal steps
1. Engine oil cooler

A2. Feed hose assembly

A3. Return hose assembly
INSTALLATION SERVICE POINT

AFEED HOSE ASSEMBLY / RETURN HOSE
ASSEMBLY INSTALLATION
Fit the hose joint positioning tab into the hole in oil cooler
to secure the hose assembly in position.

REAR AXLE – Service Specifications / Lubricant / Sealant27-2
SERVICE SPECIFICATIONS
<Vehicles with AYC>
ItemsStandard valueLimit
Rear axle total backlash mm–5
Pressure generated by hydraulic unit MPa {kgf/cm2}0 – 1.6 {10.0 – 16.0}–
Wheel bearing axial play mm–0.05
Wheel bearing rotation starting torque Nm {kgf
cm}–1.0 {10.5} or less
<Vehicles without AYC>
ItemsStandard valueLimit
Right-to-left difference in combined thickness of friction plate and fric-
tion disc mm0 – 0.05–
Clearance between spring plate and differential case mm0.06 – 0.25–
LSD differential torque
Nm {kgf
m}
When new clutch plate is installed5 – 19 {0.5 – 1.9}–
Nm {kgf
m}
When existing clutch plate is installed2 – 19 {0.2 – 1.9}–
Distortion of friction plate and friction disc mm–0.08
Difference in thickness between friction plate, friction disc, and spring
plate mm–0.1
LUBRICANT
<Vehicles with AYC>
ItemsSpecified lubricantCapacity
Gear oilTorque
transfer
differential
DifferentialMITSUBISHI GENUINE DIA QUEEN SUPER
HYPOID GEAR OIL (GL-5)0.41 ± 0.02 dm3
{0.41 ± 0.02 }
differentialTorque transfer
mechanismMITSUBISHI GENUINE DIA QUEEN AYC FLUID0.700
0.05dm3
{0.700
0.05}
Hydraulic piping fluidMITSUBISHI GENUINE DIA QUEEN ATF-SPII1 dm3 {1 }
Torque transfer mechanism oil seal lipsVaselineAs required
SEALANT
<Vehicles with AYC>
ItemsSpecified sealant
Torque transfer differential vent plugSemi-drying sealant: THREEBOND 1281B (460 g)
Torque transfer mechanism cover