trunk release MITSUBISHI LANCER EVOLUTION IV 1998 Workshop Manual

BODY – Fender / Trunk Lid <EVOLUTION-V>42-4
REMOVAL SERVICE POINT
ASIDE TURN SIGNAL LAMP REMOVAL
Using a flat-tip screwdriver or similar tool, release the lock
from the fender panel and remove the side turn signal lamp.
INSTALLATION SERVICE POINT
ASIDE TURN SIGNAL LAMP INSTALLATION
Fit the hook into the fender panel to secure the side turn
signal lamp into position.
TRUNK LID <EVOLUTION-V>
The conventional procedures shall be used except for
followings.
INSTALLATION SERVICE POINT
TRUNK LID TORSION BAR INSTALLATION
(1) Torsion bars are color-coded, as indicated at their center.
Torsion bar <LH> ID colorTorsion bar <RH> ID color
White greenOrange
(2) Fit the end of the torsion bar into the mounting hole.
(3) As you did during removal, mount the special tool to
the torsion bar and twist the torsion bar to hook it onto
the link; then, hook it onto the holder.
Caution
Make sure that the special tool is positively mounted
to the torsion bar. If the torsion bar comes off the
special tool, it can damage the body and other parts.
Fender panel
Lock
Hook
Fender panel
Front of vehicle

EXTERIOR – Mark <EVOLUTION-V>51-16
2. brembo MARK
Application tape edge
Rear bumper lineTrunk lid opening line
3. EVOLUTION-V MARK (REAR)
Trunk lid opening line
Rear bumper line
(2) Installation procedure
1. Using unleaded gasoline, degrease the surface of the body on which the marks are mounted.
2. Peel off the release paper from the back side of the mark and affix the mark, ensuring the specified
dimensions are met.
Caution
(1) Perform the procedure in a dust-free place with an ambient temperature ranging from
20 to 38C.
(2) If the ambient temperature is below 20C, heat the mark and mounting position to 20
to 30C.
(3) Be sure to press each mark positively, as a low pressure results in the mark being
separated easily.