fuse box MITSUBISHI LANCER EVOLUTION IX 2005 Workshop Manual

GENERAL INFORMATION - HOW TO READ THE WIRING DIAGRAMS0-4
Reading Circuit Diagrams
These diagrams show the circuits for each system, from the fuse or fusible link to the earth. In principle, the power supply is
shown at the top and the earth at the bottom, to make it easier to understand the flow of current in the circuit.
The circuit diagrams show a state where none of the switches, etc. are operating.
Indicates power take-out
point.Indicates connector No. The same number is used in the layout
diagrams. Connector numbers shown inside a rounded box indicate
connector symbols that are listed together at the bottom of the page.
Connector numbers that are not shown inside a rounded box indicate
components that are incorporated into the harness.
Indicates that the terminal is
connected via a plate inside
the relay box.
Each circuit diagram is divided into
blocks shown on separate pages.
This number indicates the block.
Indicates the harness branch
point. This number matches the
branch numbers in the other
circuit diagrams.
Indicates the number of the circuit
to which the branch connects.
Indicates the power supply
within the control unit. If no
voltage is indicated, then it is
the battery voltage.
An "X" at the end of a connector
number shows that it is part of the
centralized relay. For more
information, refer to the section
covering the Centralized Junction.
Indicates that circuit diagram
continues at [A] in Block [2].
Indicates the connector symbol,
listed in the order of the connector
numbers in the circuit diagram.
Indicates the operating
conditions of the coolant
temperature switch, etc.Indicates shield
wire.An upward arrow indicates that
the current flows from bottom to
top in the diagram.
RegisterRelayMotor Relay boxFusible link
Fusible link
Diode
Sensor Switch
headlightsignition

CIRCUIT DIAGRAMS - J/B3-5
Note : The triangle symbols in the J/B and relay boxes show the positions that coincide with the triangle marks engraved
on the relays.
Front sideRear side
To instrument panel
Power window relay
Fuel pump relay 1
Intercooler water
spray relay
Fuel pump relay 2
Dummy connector
Dummy connector
To roof harnessTo instrument panel
Blower relay
Demister relay
Generic fuses
To floor harness (RH)

CIRCUIT DIAGRAMS - CENTRAL JUNCTION3-11
CENTRAL JUNCTION
Fusible Links (relay box inside engine compartment and fuse box connected directly to battery)
Relay box in engine compartment
Fuse box connected directly to battery
Front of vehicle
Front of vehicle

CIRCUIT DIAGRAMS - CENTRALISED JUNCTIONS3-12
Generic fuses (fuse box inside J/B)

CIRCUIT DIAGRAMS - CENTRAL JUNCTION3-13
Fuse box inside J/B

CIRCUIT DIAGRAMS - CENTRAL JUNCTION3-15
Dedicated Fuses (relay box in engine compartment and fuse box installed in J/B)
-

CIRCUIT DIAGRAMS3-17
Relay box in engine compartment
Front of vehicle
Fuse box installed in J/B