clock MITSUBISHI MIRAGE 2017 6.G Owner's Manual

Replacement of light bulbs 9-32 Vehicle care and maintenance
9
4. Turn the bulb counterclockwise to remove it. 5. To install the bulb, perform the removal steps in reverse.
N00943701569
1. Open the liftgate.(Refer to “Liftgate” on page 5-27.) 2. Remove the screws (A) that hold the lightunit. 3. Move the light unit toward the rear of the vehicle to unfix the notch (B) and pin (C).
4. Turn the socket counterclockwise to remove it. 5. Remove the bulb from the socket as fol- lows.
NOTE
 When refitting each of the clips, first insert part (E) of the clip into the hole and thenpress part (F) into it.Ty p e 1 Ty p e 2
Rear combination lights
D- Back-up light E- Rear turn signal lightF- Rear side-marker
light, and tail and
stop light (LED) - Do not touch the socket because repl
acing this light is
carried out by an authorized Mitsubishi Motors dealer or a repair facility of your choice.NOTE
 The rear side-marker li
ght, and tail and stop
light use an LED instead of the bulb. Check with an authorized Mitsubishi Motors dealer or a repair fa
cility of your choice
when the light needs to be repaired or replaced.
BK0235100US.book 32 ページ ２０１５年１１月２０日　金曜日　午後３時１２分

Vehicle care precautions
Vehicle care and maintenance 9-33
9
• Back-up light bulb
Pull the bulb out.
• Rear turn signal light bulb
Turn the bulb counterclockwise while pressing in.
6. To install the bulb, perform the removal steps in reverse.
N00944001426
1. Push the light unit (A) toward the left sideof the vehicle to remove it. 2. Turn the socket (B) counterclockwise to remove it, and then pull the bulb out fromthe socket.
3. To install the bulb, perform the removal steps in reverse.
N00945100166
In order to maintain the value of your vehicle,perform regular mainte
nance using the proper
materials and procedures
. Be sure to use only
those materials and proc
edures that meet your
local environmental pollution control regula- tions. Choose the materials you will use care- fully, to be sure that they do not containcorrosives. If you are
not sure, contact an
authorized Mitsubishi Motors dealer for help in choosing these materials.
NOTE
 When mounting the lamp unit, align the notch (G) and pin (H) on the lamp unit withthe clip (I) and hole (J) in the body.Back-up light bulb Rear
turn signal light
bulb
License plate lights
NOTE
 When installing the light unit, first insert the tab (C) into the hole on the body, and then push on the light unit to fit it into place.
Vehicle care precautions
BK0235100US.book 33 ページ ２０１５年１１月２０日　金曜日　午後３時１２分