heating MITSUBISHI MONTERO 2000 Service Repair Manual

DIESEL FUEL <4M4> -Troubleshooting13C-11
ENGINE-ECU CHECK
TERMINAL VOLTAGE TABLE
Terminal No.Check itemInspection conditions (engine status)Normal condition
14Throttle body assembly (1)Ignition switch: ON (Engine stops)9 V or more
17EGR motorIgnition switch: ON (Engine stops)System voltage
18Throttle body assembly (2)Ignition switch: ON (Engine stops)9 V or more
19Throttle body assembly (3)Ignition switch: ON (Engine stops)9 V or more
20Throttle body assembly (4)Ignition switch: ON (Engine stops)9 V or more
33A/C load signalEngine: Idle
A/C switch: ONDuring weak cooling or
heatingSystem voltage
During normal cooling0-1V
During strong coolingChanges repeatedly
between 0 V and 12 V
37Clutch switch <M/T>Clutch pedal depressed0-1V
Inhibitor switch <A/T>Ignition switch:
ON (Engine stops)Move selector lever to N
or P0-1V
Move selector lever to D,
2, L or RSystem voltage
38Control relay (no immobi-
lizer)
Ignition switch: ON0-1V
lizer)
Ignition switch: ON→OFF (after approx. 8
seconds)System voltage
41Select switch <M/T>Ignition switch:
ON (Engine stops)Move shift lever to 4st or
RSystem voltage
421st - 2nd switch <M/T>Ignition switch:
ON (Engine stops)Move shift lever to 1st or
2ndSystem voltage
433rd - 4th switch <M/T>Ignition switch:
ON (Engine stops)Move shift lever to 3rd or
4thSystem voltage
445th - R switch <M/T>Ignition switch:
ON(Enginestops)
Move shift lever to 5th0-1V
ON(Engine stops)
Move shift lever to RSystem voltage
58TachometerDuring idlingChanges repeatedly
between 0 V and 12 V
90EGR valve sensorDuring racingChanges between 0.5
V and 4.5 V


www.WorkshopManuals.co.uk


Purchased from www.WorkshopManuals.co.uk