MITSUBISHI OUTLANDER PHEV 2019 Owner's Manual (in English)

NOTEzThe foot/face air flow ratio can be adjusted with the mode selection in the “” position and the foot/demister air flow ratio can be adjusted with the mode
selection in the “
” position.
For further information, we recommend you to consult a MITSUBISHI MOTORS Authorized Service Point.
On vehicles equipped with the Smartphone Link Display Audio or the MITSUBISHI Multi-Communication System (MMCS), screen operations can be used
to make the adjustment. Refer to the separate owner’s manual for details.

Ventilators
8-052**((For pleasant driving8

Automatic climate control air conditionerE00702402026
Cooling or heating can only be performed when ready indicator is illuminating. When the operation mode is ON, only the blower is available.NOTEz If the drive battery level display indicates 0, the cooling performance cannot be obtained even the air conditioner is turned on.
Refer to “Drive battery level display screen” on page 6-11.
z If the engine cannot be started due to fuel shortage, etc., the heating performance cannot be obtained even the air conditioner is turned on.
z While the drive battery is being charged, you can use the air conditioner.

Control panel
E00702502984
Automatic climate control air conditioner
8-062**((For pleasant driving8

1- Driver’s side temperature control switch(LHD vehicles)
Passenger’s side temperature control switch (RHD vehicles)
2- Air conditioning switch
3- Blower speed selection switch
4- MODE switch
5- Passenger’s side temperature control switch (LHD vehicles)
Driver’s side temperature control switch (RHD vehicles)6- Air selection switch
7- Demister switch
8- AUTO switch
9- Rear window demister switch o p. 6-74
10- OFF switch 11- Driver’s side temperature display (LHD vehicles) o p. 8-09
Passenger’s side temperature display (RHD vehicles) o p. 8-09
12- DUAL indicator13- Mode selection display
14- Passenger’s side temperature display (LHD vehicles) o p. 8-09
Driver’s side temperature display (RHD
vehicles) o p. 8-09
15- Air conditioning indicator
16- Blower speed display
Automatic climate control air conditioner
8-072**((For pleasant driving8

NOTEzThere is an interior air temperature sensor (A) in the illustrated position.
Never place anything on top of the sensor, since doing so will prevent it from functioning properly.
z While the EV priority mode is activated, except when pressing the demister switch, the engine does not start.
Therefore, if your vehicle is not equipped with the electric heater, the heating performance cannot be obtained while the EV priority mode is activated.
Also, if your vehicle is equipped with the electric heater, the heating performance may not be sufficiently obtained while the EV priority mode is activated.
In such case, cancel the EV priority mode. Refer to “EV switch” on page 7-25.
z Since the air conditioning operation is controlled while the ECO mode is operating, you may feel that effectiveness of the air conditioner is weak.
Also, on vehicles without electric heater, the heating performance cannot be obtained while the ECO mode is operating since engine starting is controlled. In such case, cancel ECO mode. Refer to “ECO mode switch” on page 6-68.
z Even if the ECO mode is operating, you can select normal operation of the air conditioner.
On vehicles equipped with the Smartphone Link Display Audio or the MITSUBISHI Multi-Communication System (MMCS), screen operations can be used
to change the setting. Refer to the separate owner’s manual for details.
z In extreme cold, the air conditioning control panel screen may operate sluggishly. This does not indicate a problem.
It will disappear when the vehicle interior temperature rises to a normal temperature.

Blower speed selection switch
E00702801515
Press of the blower speed selection
switch to increase the blower speed.
Press
of the blower speed selection
switch to decrease the blower speed.
Automatic climate control air conditioner
8-082**((For pleasant driving8

The selected blower speed (A) will be shownin the display.
1- Increase
2- Decrease
Temperature control switch
E00703001963
Press or of the temperature control
switch to the desired temperature.
The selected temperature (A) will be shown
in the display.
NOTEz The temperature value of air conditioning is
switched in conjunction with outside temper-
ature display unit of the multi information display.
Refer to “Changing the temperature unit” on
page 6-20.
z While the engine coolant temperature is low,
the temperature of the air from the heater will not change instantly, even if you have selected warm air with the switch.
To prevent the windscreen and windows
from fogging up, the ventilator mode will be
changed to “
” and the blower speed will
be reduced while the system is operating in the AUTO mode.
z When you feel that it is hot or cold to the
setting temperature, it is possible to adjust so that you can feel more comfortable.
For further information, we recommend you
to consult a MITSUBISHI MOTORS Au-
thorized Service Point.
z When the temperature is set to the highest or
the lowest, the air selection and the air con-
ditioning will be automatically changed as follows.
Also, if the air selection is operated manual-
ly after an automatic changeover, manual operation will be selected.

Synchronized mode and dual mode
The driver’s side and the passenger’s sidetemperature can be controlled independently.
At this time, the “DUAL” indicator (A) will
be shown in the display.
z Synchronized mode
If the driver’s side temperature control switch is pressed, the passenger’s side
temperature will also be controlled to the
same setting temperature as the driver’s side.
z Dual mode
If the passenger’s side temperature con-
trol switch is pressed under synchron-
ized mode, the system will switch to du- al mode. In dual mode, the driver’s side
and the passenger’s side temperature can be set separately by using each tempera-
ture control switch.
Press the AUTO switch to return to synchronized mode.
Air selection switch
E00703401808
To change the air selection, simply press the
air selection switch.
z Outside air: Indication lamp (A) is OFF
Outside air is introduced into the passen- ger compartment.
z Recirculated air: Indication lamp (A) is
ON
Air is recirculated inside the passenger
compartment.CAUT,ONz Use of the recirculation position for exten-
ded time may cause the windows to fog up.NOTEz Normally, use the outside position to keep
the windscreen and side windows clear and
quickly remove fog or frost from the wind- screen.
If high cooling performance is desired, or if
the outside air is dusty or otherwise contami- nated use the recirculation position. Switch
to the outside position periodically to in- crease ventilation so that the windows do notbecome fogged up.
z When the engine coolant temperature rises
to a certain level, the air selection is auto- matically switched to the recirculation posi-
tion and the indication lamp (A) comes on. At this time, the system will not switch tothe outside position even if the air selection
switch is pushed.
z When the outside air temperature is high, the
system will not switch to the outside posi- tion even if the air selection switch is press-
ed or the air conditioner is operating. This is to protect the air conditioner compressor and is not a failure.Customizing the air selection
E00739600136
Functions can be changed as desired, as sta-
ted below.
z Enable automatic air selection control
When the AUTO switch is pressed, the air selection switch is also controlled au-
tomatically.
Automatic climate control air conditioner
8-102**((For pleasant driving8

zDisable automatic air selection control
Even when the AUTO switch is pressed, the air selection switch is not controlled
automatically.
z Setting change method
Hold down the air selection switch for
approximately 10 seconds or more.

zEnable automatic air conditioning con-
trol
When the AUTO switch is pressed, or the temperature control switch is set to
the minimum temperature, the air condi- tioning switch is controlled automatical-
ly.
z Disable automatic air conditioning con-
trol
The air conditioning switch is not con-
trolled automatically as long as the air
conditioning switch is not operated.
z Setting change method
Hold down the air conditioning switch
for approximately 10 seconds or more.

Demister switch
E00703901340
When this switch is pressed, the mode
changes to the “
” mode. The indication
lamp (A) will come on. The selected mode (B) is shown in the display. (Refer to
“Changing the mode selection” on page 8-04.)
NOTEz When the demister switch is pressed, the air
conditioning system automatically operates and outside air (as opposed to recirculated air) is selected. This automatic switching control is carried out to prevent misting of
the windows even if “Disable automatic air conditioning control” or “Disable automaticair selection control” is set. (Refer to “Cus-
tomizing the air conditioning switch” on page 8-11, “Customizing the air selection”
on page 8-10.)NOTEz To ensure a clear view, the engine may start
when the demister switch is pressed evenwhile the EV priority mode is activated.
Refer to “EV switch” on page 7-25.Operating the system in auto-
matic mode
E00704102649
In normal conditions, use the system in the
AUTO mode and follow these procedures: 1. Push the AUTO switch.
2. Set the temperature control switch to the
desired temperature.

The mode selection, blower speed ad- justment, recirculated/outside air selec-tion, temperature adjustment, and air
conditioner ON/OFF status are all con- trolled automatically.
NOTEz If the blower speed selection switch, air con-
ditioning switch, MODE switch, or air selec- tion switch is operated while the system is
operating in the AUTO mode, the activated function overrides the corresponding func-
tion of automatic control. All other functions
remain under automatic control.Operating the system in man-
ual mode
E00704201308
Blower speed and ventilator mode will be
controlled manually by setting the blower speed selection switch and the MODE switchto the desired positions.
To return to automatic operation, press the AUTO switch.
Demisting of the windscreen
and door windows
E00704302016
CAUT,ONz For safety, make sure you have a clear view
through all the windows.
Automatic climate control air conditioner
8-132**((For pleasant driving8

For ordinary demisting
1. Set the air selection switch to the outsideposition.
2. Set the MODE switch to the “
” posi-
tion.
3. Select your desired blower speed by pressing the blower speed selection
switch.
4. Select your desired temperature by pressing the temperature control switch.
5. Push the air conditioning switch.
For quick demisting
1. Push the demister switch to change to the “
” position.
2. Set the blower to the maximum speed.
3. Set the temperature to the highest posi- tion.
NOTEz To demist effectively, direct the air flow
from the side ventilators towards the door
windows.
z Do not set the temperature to the max. cool
position. Cool air will blow against the win-
dow glasses and prevent demisting.Important operation tips for
the air conditioner E00708302388
z Park the vehicle in the shade.
Parking in the hot sun will make the ve-
hicle inside extremely hot, and it will re-
quire more time to cool the interior.
If it is necessary to park in the sun, open
the windows for the first few minutes of air conditioning operation to expel the
hot air.
z Close the windows when the air condi-
tioner is in use. The entry of outside air
through open windows will reduce the cooling efficiency.
z Too much cooling is not good for the
health. Keep the difference between the
vehicle interior temperature and outside
temperature at 5 to 6