MITSUBISHI OUTLANDER PHEV 2019 (in English) Workshop Manual

:ARN,NGzIf the POWER or CHARGING indicator does not illuminates or the FAULT indicator blinks or illuminates during normal charging, please contact
a MITSUBISHI MOTORS Authorized Service Point.
z Do not charge when the EV charging cable is coiled up.
The cable may be heated abnormally and resulting in fire.
z Do not alter or disassemble the EV charging cable. Doing so could cause fire, an electric shock or injury.
z Be sure to install the cap to the normal charge connector and store the EV charging cable in a place where the cable is not exposed to water or dust.
Entry of foreign matter such as water or dust in the metal terminal of the normal charge connector or charging cable plug may cause a fire or
malfunction.
z Never force the connection if the EV charging cable or connector shows damage or is not easily connected due to foreign material entering the
connector or the outlet. And never use an outlet that is worn, damaged, or will not hold the plug firmly. Doing so could cause fire, an electric shock,
or short circuit.
z Pay attention to the following for handling the EV charging cable.
Damage to the cable could cause fire, an electric shock, or short circuit.

Handling and storing the con-trol box
E08301201093
CAUT,ONz While charging, prevent damage to the con-
trol box by attaching a rope as shown in the following illustration.NOTEz Use a hook with a load capacity over 4 kg.
z Check that the rope and hook have no dam-
age and are not loose before use.HookRope
Cleaning the EV charging cable
E08301301065
1. Lightly wipe these off with a soft cloth
soaked in a mild soap and water solu-
tion.
2. Wipe off all the detergent with a soft
cloth dipped in fresh water and thor-
oughly wrung out.
3. Wipe all moisture off and dry in a sha-
ded, well-ventilated area.:ARN,NGz When cleaning, be sure to remove the
charging cable plug and the normal charge connector from the outlet. Do not
connect or disconnect the plug and the
connector with wet hands. Doing so could cause an electric shock.
z Do not expose the metal terminal of the
normal charge connector or the charging cable plug to water or neutral detergent.
Using in wet with water could cause a fire or an electric shock.CAUT,ONz Never use benzine, petrol, or other organic
solvents, or acid or alkaline solvents. Doing
so could cause deformation, discolour, or malfunction. Also, these substances may be
present in various cleaners, so check careful- ly before using.Normal charging (charging
method with rated AC220-240V outlet) E08300901312:ARN,NGzFor safety, do not allow children or people
who are not familiar with charging to
charge for themselves. Also, do not use
the normal charge connector within reach
of children.
z Persons who use electro-medical appara-
tus such as implantable cardiac pacemak-
er or implantable cardioverter defibrilla- tor must check effect from charging with
the manufacturer of electro-medical ap- paratus. Electro-medical apparatus oper-
ations could be affected by charging.
z If you use electro-medical apparatus such
as implantable cardiac pacemaker or im- plantable cardioverter-defibrillator, be
careful the following precautions.

:ARN,NG

NOTEzWhen connecting or disconnecting the nor-
mal charge connector, insert/pull out the
connector straight.
Also, do not incline or twist the connector.
Doing so could cause a bad connection or malfunction.
z Make sure to lock the doors to prevent theft,
etc. during charging.
z Do not push the rear portion of the charging
lid when the charging lid is locked.
There is a possibility that the charging lid
opens unexpectedly when the doors are un- locked while using the central door locks,keyless entry system or keyless operation function.Charging from rated AC
220-240 V outlet
E08301001411
1. Firmly apply the parking brake, press the electrical parking switch to shift into the
“P” (PARK) position and put the opera- tion mode of the power switch in the
“OFF” position.
2. Unlock the driver’s door to unlock the
charging lid.
3. Push the rear portion of the charging lid
(A) until it clicks, and open the charging lid.
NOTEz The charging lid is unlocked in conjunction
with unlocking of the driver’s door as the
following condition.

5.Insert the charging cable plug into an
outlet.:ARN,NGz Make sure that the plug is inserted all the
way into the outlet before use. If charging is continued in the state where it is notfully inserted the plug, there is a possibili- ty of generating abnormal heat and re-
sulting in a fire.
z To prevent an electric shock or fire due to
an electric leak, perform charging using a waterproofed outlet with earthing which
is connected to an earth leakage circuit breaker.
z To reduce the risk of electric shock or fire
due to electric leak, always use an earthed
outlet protected by a residual current de-
tector, rated for amperage equal to or
greater than the value specified by MITSUBISHI MOTORS , and that is con-
nected to a dedicated branch circuit. If
the circuit is shared, and another electri- cal device is being used at the same time
as the vehicle is charging, the circuit may heat abnormally, the breaker may trip
and the circuit may cause adverse inter-
ference on the household electrical appli- ances such as TVs and audio systems.:ARN,NGz Never use an extension cable, multi-plug
adapter or conversion adapter. Using
them may cause abnormal overheating re- sulting in a fire.
z Do not use a multi type outlet to prevent
an electric shock or fire. There is no guar- antee of safety because you cannot make
an earth connection in some multi type outlet and it is not a dedicated type outlet.
:ARN,NGz Use an outlet for EV charging with water-
proofing processing installed if the instal- led position is outdoors or may get wet by
rain etc.CAUT,ONz Use the outlet that is installed approximately
1 meter above the ground. If the outlet posi-tion is too low, the control box may touch
the ground, which may lead to troubles such
as submersion in water or getting trampled on.NOTEz The shape of the charging cable plug and
outlet may differ from country to country as shown in the illustration.
z Use the following outlets.
z Check if the outlet on your vehicle corre-
sponds with an outlet that is installed in the
following places.

6.Remove the cap (E) on the normal
charge connector (F) and make sure that there is no foreign matter such as dust at
the end of the normal charge connector and the normal charge port.
7. Connect the normal charge connector
until a click sound is heard without pressing the release button (G).
CAUT,ONz Do not clasp the top of normal charge con-
nector. It could cause injury to touch the pro- trusion on the charging lid.NOTEz If the operation mode of the power switch is
ON with the EV charging cable remains con-
nected to the normal charge port, the plug-in
hybrid EV system does not turn ON.
z Do not connect or disconnect the normal
charge connector repeatedly in a short peri- od. Charging may not be started.
z If you want to turn the operation mode to
“OFF” from the “ACC” or “ON” position in
order to use an electrical device such as au- dio during charging, make sure that the se-lect position is in “P”, and press the power
switch to turn “OFF” without depressing the brake pedal.
8. Make sure that the charging indicator
(H) on the instrument cluster is illumina-
ted.
Normal charging (charging method with rated AC 220-240V outlet)
3-142**((Charging3Switzerland 250 V/10 A
Italy 250 V/10 A
Denmark 250 V/13 A UK, Ireland 250 V/13 A
Germany, Spain, France, Sweden, etc.
250 V/16 A
IEC 60309-2/CEE17 (220-250 V/16 A)AA2002211B

If the charging indicator is not illumina-
ted, charging has not started.
Make sure that the normal charge port and the plug are correctly connected, and
perform charging from Step 5 again.
NOTEz When the normal charge connector is con-
nected to the charge port, the charging indi-
cator will blink. When charging is started, the charging indicator illuminates and the
charging port courtesy lamp blinks 3 times.
z If you want to confirm the drive battery level
or the predicted charging time during charg- ing, one of the doors is opened or the multi
information display switch is operated, the drive battery level display (I) appears and
the predicted charging time display (J) ap- pears on the information screen in the multi
information display.
In addition, when the remaining time is less than 1 hour, the predicted charging time dis-
play (J) appears --:-- and does not indicate a
malfunction.
When an electrical component is used during
charging, the charging time may become
longer.
9. Charging is complete if the charging in-
dicator goes off. Pull out the normal charge connector while pressing the re-
lease button (K).
CAUT,ONz Be sure to check the normal charge connec-
tor is removed from the normal charge port.
The vehicle can be driven with the charge connector inserted when it is not lockedcompletely which may result in a serious ac-
cident.
Be sure the charge connector is removed completely from the vehicle after the charg- ing is completed.NOTEz Charging can be stopped half way. In this
case, also pull out the normal charge connec-
tor while pressing the release button. Press- ing the manual stop button on the controlbox can also stop charging.
Refer to “EV charging cable*” on page 3-07.
10. Close the inner lid and press the rear of
the charging lid until it clicks to close it.
Normal charging (charging method with rated AC 220-240V outlet)
3-152**((Charging3

:ARN,NGzAfter charging, be sure to close the inner
lid and charging lid completely.
Be careful that water or dust does not en-
ter in the normal charge port, inner lid and normal charge connector.
Entry of water or dust could cause an
electric leak, resulting in a fire or electric shock.NOTEz Make sure that the inner lid is completely
closed.
If the charging lid is forcibly closed without completely closing inner lid, the hinge on
the inner lid may be broken.
z While the charging lid is open, if the doors
and tailgate are locked with the central door
lock, the keyless entry system or the keyless
operation system, the charging lid will lock when the charging lid is closed.
z When the operation mode is switched to ON
while the charging lid is not completely closed, a warning may be displayed on the
information screen in the multi information display.
Refer to “Warning display list” on page
6-26.
z If the charging lid is closed while the driv-
er’s door is locked, the charging lid will be locked.
11. Remove the charging cable plug from
the outlet.
12. Install the cap on the normal charge con-
nector.:ARN,NGz After charging, be sure to disconnect the
charge connector from the charge port.
If the charge connector is only partially
engaged and the connector latch is un-
locked, you could put the operation mode of the power switch in ON and the vehiclecould start moving. It could lead to an un-
expected accident.NOTEz Make sure that the charging lid is completely
closed before using an automatic car wash.
There is a possibility that the charging lid will be damaged if the lid is open.If the charging lid cannot be
unlocked
E08304400031
When the charging lid cannot be unlocked even if the driver’s door is unlocked, take the
following measure to open the charging lid. 1. Press the tab (A) of the lid located on the
right side of the luggage compartment to
remove the lid.
2. Pull the rod (B) in the arrow direction to
unlock the charging lid.
NOTEz After taking the emergency measure, please
inspect at a MITSUBISHI MOTORS Au-
thorized Service Point immediately.
Normal charging (charging method with rated AC 220-240V outlet)
3-162**((Charging3

Drive battery warming system*
E08304600020
You cannot start the Plug-in Hybrid EV Sys-
tem and drive when the ambient temperature
is -30

NOTEzThe quick charger might be installed in the
public parking space, some chargers are notsuitable for this vehicle. Check the manual of each quick charger when charging.
z The charge connector and the EV charging
cable stick out of the vehicle body while
charging, so be careful that your body does
not get stuck with them or they do not touch the next vehicle.
z The vehicle equipped with a quick charge
port is compatible with most CHAdeMO *1
connectors on charging stations.
z Make sure to lock the doors to prevent theft,
etc. during charging.
z When using a quick charger, make sure that
the time available is enough so that the quickcharging can be finished in the time availa- ble.
If the power supply of the quick charger is
shut off during quick charging, it could lead to a vehicle failure.
1. Firmly apply the parking brake, press the
electrical parking switch to shift into the
“P” (PARK) position and put the opera-
tion mode of the power switch in the “OFF” position.
2. Unlock the driver’s door to unlock the
charging lid.
*1 CHAdeMO is a standard for quick charging of
electric vehicle originally started in Japan, andthe contents have also become an internationalstandard.3. Push the rear portion of the charging lid
(A) until it clicks, and open the charging lid.NOTEz The charging lid is unlocked in conjunction
with unlocking of the driver’s door as the
following condition.