MITSUBISHI OUTLANDER XL 2010 Repair Manual

2-36 Seat and restraint systems
2
3. Slide the front seats fully forward, then recline their seat-
backs backward to achieve a flat surface.
(Refer to “To adjust the seat forward or backward” on
page 2-7 and “To adjust the seatback” on page 2-8.)4. Recline the seatbacks of the second row seats.
(Refer to “To adjust the seatback” on page 2-13.)
BK0115300US.book 36 ページ ２００９年７月１６日　木曜日　午前９時１３分

Seat and restraint systems
2-37
2
5. The flat seat configuration is now complete.
To return the seats to the normal position, reverse the
above procedure.
Seat belts
N00406000426
Seat belts are installed in your vehicle to help reduce the risk of
injury to the driver and passenger in the event of an accident.
Always use the provided seat belts.
Carefully review the following information for proper seat belt
usage.
WA R N I N G
!

To help reduce the risk of injury or death in an acci-
dent, seat belts and child restraints must always be
used. Refer to “Child restraints” on page 2-49 for
additional information.


Never use one seat belt for more than one person.


Never carry more people in your vehicle than there
are seat belts.


Always adjust the seat belt for a snug fit.


Always place the shoulder belt over your shoulder
and across your chest. Never put it behind you or
under your arm.


Always wear the lap belt as low as possible across
your hips, not around your waist.


Never modify or alter the seat belts in your vehicle.


To reduce the risk to the driver of serious injury or
death during deployment of the driver’s airbag,
always properly wear the seat belt and adjust the
driver’s seat as far back as possible while maintain-
ing a position that still enables you to fully apply the
pedals, easily control the steering wheel, and safely
operate the vehicle.
BK0115300US.book 37 ページ ２００９年７月１６日　木曜日　午前９時１３分

2-38 Seat and restraint systems
2
Seat belt instructions
N00406200314
All seats are equipped with a seat belt which uses one com-
bined lap-and-shoulder belt with an emergency locking retrac-
tor.
This system is designed to provide both comfort and safety. It
permits full extension and automatic retraction of the belts dur-
ing normal vehicle operation. A sensing device inside the belt
retractor is designed to lock the retractor in the event of a sud-
den change in the vehicle’s motion.NOTE

For instructions on installing a child restraint system using
a seat belt, refer to “Installing a child restraint system
using the seat belt” on page 2-56.


To reduce the risk to a front seat passenger of seri-
ous injury or death from a deploying airbag, make
sure the passenger always wears the seat belt prop-
erly, remains seated all the way back and upright in
their seat, and moves the seat as far back as possible.
Refer to “Supplemental Restraint System (SRS) -
airbag” on page 2-60 for additional information.


Never hold an infant or child in your arms or on
your lap when riding in this vehicle even when you
are wearing your seat belt. Never place any part of
the seat belt you are wearing around an infant or
child. Failure to follow these simple instructions cre-
ates a risk of serious injury or death to your child in
the event of an accident or sudden stop.


Children 12 years old and under should always ride
in the rear seat and be properly restrained. This
reduces their risk of serious injury or death in an
accident, especially due to a deploying front passen-
ger airbag. Refer to “Child restraints” on page 2-49
for additional information.


Any child who is too small to properly wear a seat
belt must be properly restrained in an appropriate
child restraint system.


Infants MUST be placed in a rear-facing child safety
seat and positioned in the rear seat.


In the event of an accident, all seat belt assemblies,
including retractors and attachment hardware,
should be inspected by an authorized Mitsubishi
Motors dealer to determine whether replacement is
necessary.WA R N I N G
!
BK0115300US.book 38 ページ ２００９年７月１６日　木曜日　午前９時１３分

Seat and restraint systems
2-39
2
1. Occupants should always sit back in their seats with their
backs against the upright seatback. To reduce the risk of
serious injury or death during deployment of the air bag,
adjust the driver’s seat as far back as possible while main-
taining a position that still enables you to fully apply the
pedals, easily control the steering wheel, and safely oper-
ate the vehicle. The front passenger seat should also be
moved as far back as possible. Refer to “Supplemental
Restraint System (SRS) - air bag” on page 2-60. Also
refer to “To adjust the seat forward or backward” on page
2-7.
WA R N I N G
!

To reduce the risk of serious injury or death in the
event of an accident or sudden stop, all seatbacks
should be kept in the upright position while the vehi-
cle is in motion.
Seat belt performance during an accident can be
adversely affected if the seatbacks are reclined. The
more a seatback is reclined, the more likely seat belt
performance will be adversely affected. If the seat
belt is not properly positioned against the body dur-
ing an accident, there is increased risk you will slide
under the belt and receive serious injury or death.
BK0115300US.book 39 ページ ２００９年７月１６日　木曜日　午前９時１３分

2-40 Seat and restraint systems
2
2. Grasp the latch plate and slide it up the webbing so that it
easily pulls across your body. 3. Pull the seat belt out slowly while holding the latch plate.
Push the latch plate into the buckle until you hear a
“click”. Pull up on the belt to be sure the latch plate is
locked securely in the buckle.
NOTE

If the seat belt locks up and cannot be pulled out, pull it
once with force and let it retract all the way.
Then, pull the belt out slowly once again.
BK0115300US.book 40 ページ ２００９年７月１６日　木曜日　午前９時１３分

Seat and restraint systems
2-41
2
4. The lap part of the belt must always be worn low and snug
across the hips. Pull up on the shoulder portion of the belt
to take up any slack in the lap belt.
NOTE

With the exception of the seat belt for the driver, the seat
belts in all other seating positions are equipped with an
Automatic Locking Retractor (ALR) function. If you pull
the seat belt fully out of the retractor, the retractor will
switch to its ALR child restraint installation function (see
page 2-56).
When the ALR function has been activated, the seat belt
will only retract. If this happens, let the belt fully retract,
then pull the seat belt back out, repeating steps 1 through
4.
5. To release the belt, press the button on the buckle and
allow the belt to retract.
If the belt does not retract smoothly, pull it out and check
for kinks or twists in the webbing. Then make sure it
remains untwisted as it retracts.
WA R N I N G
!

Be sure the lap belt portion fits snugly and is worn
as low as possible across the hips, not around the
waist. Failure to follow this instruction will increase
the risk of serious injury or death in the event of an
accident.


Be sure the seat belt webbing is not twisted when
worn. Twisted webbing may adversely affect seat
belt performance.
BK0115300US.book 41 ページ ２００９年７月１６日　木曜日　午前９時１３分

2-42 Seat and restraint systems
2
Driver’s seat belt reminder/warning light and
display
N00418400313
Warning light
Warning display type 1
Warning display type 2
A tone and warning light are used to remind the driver to fasten
the seat belt.
If the ignition switch is set to the “ON” position without the
driver’s seat belt being fastened, a warning light will come on
and a tone will sound for approximately 6 seconds to remind
you to fasten your seat belt.
If you then drive with the seat belt unfastened for longer than a
minute from when the ignition switch was turned on, the warn-
ing light will come on and blink repeatedly and the tone will
sound intermittently.
The warning light and the tone will stop after approximately 90
seconds.If you then repeatedly stop and start your vehicle with the seat
belt unfastened, the warning light/display and tone will remind
you to fasten your seat belt every time the vehicle starts mov-
ing. You will also be reminded to fasten your seat belt in this
way when you remove your seat belt while driving. The warn-
ing light and the tone go off when the seat belt is fastened.
NOTE

At the same time, “FASTEN SEAT BELT” will be dis-
played on the information screen in the multi-information
display.
WA R N I N G
!

In order to reduce the risk of serious injury or death
in an accident, always fasten your own seat belt. Do
not allow anyone to ride in your vehicle unless he or
she is also seated and fastening a seat belt. Children
should additionally be restrained in a secure child
restraint system.
BK0115300US.book 42 ページ ２００９年７月１６日　木曜日　午前９時１３分

Seat and restraint systems
2-43
2
Front passenger seat belt warning light
N00418300181
The front passenger seat belt warning light is located in the
instrument panel.
When the key is turned to the “ON” position, this indicator nor-
mally comes on and goes off a few seconds later.
The light comes on when a person sits on the front passenger
seat but does not fasten the seat belt. It goes off when the seat
belt is subsequently fastened.
Adjustable seat belt shoulder anchor (front seats)
N00406300298
To move the anchor (A) down, press the lock knob (B) and
slide the anchor down to the desired position.
WA R N I N G
!

Do not install any accessory or sticker that makes
the light difficult to see.
Anchor down Anchor up
BK0115300US.book 43 ページ ２００９年７月１６日　木曜日　午前９時１３分

2-44 Seat and restraint systems
2
Storing the second row and third row seat belts
N00406500098
When a second row seat belt (except for the center seat belt) or
a third row seat belt is not in use, store it as shown in the illus-
tration.
WA R N I N G
!

Always adjust the shoulder belt anchor so that the
shoulder belt is positioned across the center of your
shoulder without touching your neck. The shoulder
belt should not be able to fall off your shoulder. Fail-
ure to follow this instruction can adversely affect
seat belt performance and increase the risk of seri-
ous injury or death in the event of an accident.


Adjust the shoulder belt anchor only when the vehi-
cle is not in motion.


Make sure the anchor is securely locked in position
after adjusting it.
A- Second row seat belt
B- Third row seat belt (Seating 7 passengers)
BK0115300US.book 44 ページ ２００９年７月１６日　木曜日　午前９時１３分

Seat and restraint systems
2-45
2
Store the second row and third row seat belt webbing in the clip
slot (C) and the latch plate in the slot (D) as shown in the illus-
tration.
Storing a second row seat belt buckle
N00406600073
When a second row seat belt is not in use, insert the buckle in
the slit on the seat cushion.
BK0115300US.book 45 ページ ２００９年７月１６日　木曜日　午前９時１３分