NISSAN 350Z 2007 Z33 Power Supply, Ground And Circuit Manual PDF
Page 71 of 86
ELECTRICAL UNITS LOCATION
PG-71
C
D
E
F
G
H
I
J
L
MA
B
PG
Revision: 2006 November2007 350Z
PASSENGER COMPARTMENT
CKIT0860E
Page 72 of 86
PG-72
ELECTRICAL UNITS LOCATION
Revision: 2006 November2007 350Z
CKIT0875E
Page 73 of 86
ELECTRICAL UNITS LOCATION
PG-73
C
D
E
F
G
H
I
J
L
MA
B
PG
Revision: 2006 November2007 350Z
CKIT0349E
Page 74 of 86
PG-74
ELECTRICAL UNITS LOCATION
Revision: 2006 November2007 350Z
LUGGAGE COMPARTMENT
Coupe Models
CKIT0878E
Page 75 of 86
ELECTRICAL UNITS LOCATION
PG-75
C
D
E
F
G
H
I
J
L
MA
B
PG
Revision: 2006 November2007 350Z
Roadster Models
CKIT0350E
Page 76 of 86
PG-76
HARNESS CONNECTOR
Revision: 2006 November2007 350Z
HARNESS CONNECTOR PFP:00011
Description NKS004SA
HARNESS CONNECTOR (TAB-LOCKING TYPE)
The tab-locking type connectors help prevent accidental looseness or disconnection.
The tab-locking type connectors are disconnected by pushing or lifting the locking tab(s). Refer to the fig-
ure below.
CAUTION:
Never pull the harness or wires when disconnecting the connector.
[Example]
SEL769DA
Page 77 of 86
HARNESS CONNECTOR
PG-77
C
D
E
F
G
H
I
J
L
MA
B
PG
Revision: 2006 November2007 350Z
HARNESS CONNECTOR (SLIDE-LOCKING TYPE)
A new style slide-locking type connector is used on certain systems and components, especially those
related to OBD.
The slide-locking type connectors help prevent incomplete locking and accidental looseness or discon-
nection.
The slide-locking type connectors are disconnected by pushing or pulling the slider. Refer to the figure
below.
CAUTION:
Never pull the harness or wires when disconnecting the connector.
Be careful not to damage the connector support bracket when disconnecting the connector.
[Example]
SEL769V
Page 78 of 86
PG-78
HARNESS CONNECTOR
Revision: 2006 November2007 350Z
HARNESS CONNECTOR (LEVER LOCKING TYPE)
Lever locking type harness connectors are used on certain control units and control modules such as
ECM, ABS actuator and electric unit (control unit), etc.
Lever locking type harness connectors are also used on super multiple junction (SMJ) connectors.
Always confirm the lever is fully locked in place by moving the lever as far as it will go to ensure full con-
nection.
CAUTION:
Always confirm the lever is fully released (loosened) before attempting to disconnect or connect these
connectors to avoid damage to the connector housing or terminals.
LKIA0670E
1. Control unit with single lever
A. Fasten
B. Loosen
C. Lever2. Control unit with dual levers
A. Levers
B. Fasten
C. Loosen3. SMJ connector
A. Lever
B. Fasten
C. Loosen
Page 79 of 86
ELECTRICAL UNITS
PG-79
C
D
E
F
G
H
I
J
L
MA
B
PG
Revision: 2006 November2007 350Z
ELECTRICAL UNITS PFP:00011
Terminal ArrangementNKS004SB
CKIT0876E
Page 80 of 86
PG-80
ELECTRICAL UNITS
Revision: 2006 November2007 350Z
CKIT0647E