NISSAN ROGUE HYBRID 2017 2.G Dismantling Guide

• Follow the procedure below to connect the DC/DC converter harness connector.
17. Disconnect DC/DC converter high-voltage harness
connector (A), then remove harness clamps (B).DANGER
Touching high-voltage components without wearing
appropriate

Personal Protective Equipment (PPE) will
cause electrocution. DANGER
Immediately protect the terminals of the disconnected
high-voltage

harness connector socket using insulated
tape so that they are not exposed.
18. Release clips and pawls, then remove air duct A (1).: Clip
: Pawl
19.

Release clip and remove air duct B (1).: Clip AAYIA0555ZZ
AAYIA0556ZZ
AAYIA0557ZZ
AAYIA0558ZZ
DG–51

20. Remove gas vent hose
(A)from floor panel(B). If gas vent hose is disconnected at the high-voltage
battery

assembly side, this allows easy access to the
inside of high-voltage battery assembly. To prevent this,
always disconnect gas vent hose at the insertion part
on the vehicle body side.
21. Remove bolts (A, B)and high-voltage battery (1). : Vehicle front
DANGER
Touching high-voltage components without wearing
appropriate

Personal Protective Equipment (PPE) will
cause electrocution. To avoid personal injury, when removing
the

high-voltage battery, two people are required.
22. Confirm that the insulated tape is still securely in place on the high-voltage battery.
23. Dismantling the remainder of the Rogue HYBRID may be performed like conventional Nissan vehicles once the
high-voltage system is properly shut down and
discharged.
6-3 High-voltage Battery Recycling
The high-voltage battery is recyclable. For information regarding recycling of the high-voltage battery, it is
recommended you contact the nearest NISSAN dealer or Nissan Consumer Affairs at: United States:
1-800-647-7261 or in Canada: 1-800-387-0122. AAYIA0559ZZ
AAYIA0560ZZ
DG–52

© 2016 Nissan North America, Inc.
All
rights reserved.
This document may not be altered without the written permission of Nissan North America, Inc.
Pub. No. DG17EAT32HU0