check oil OPEL COMBO 2010 User Guide

Page 183 of 212

177
Opel Service, maintenance
Diesel fuel filter On the event of engine oil change, have
fuel filter checked for possible water
residue by a workshop.
Illumination of A indicates water in the
fuel filter 3.
Have fuel filter checked at shorter intervals
if the vehicle is subjected to extreme
operating conditions such as high humidity
(primarily in coastal areas), extremely high
or low outside temperatures and
substantially varying daytime and
night-time temperatures.
Coolant The coolant provides anti-freeze
protection down to approx. -28 C. .
Picture no: 11676s.tif
Antifreeze and corrosion protection
Have the concentration of the radiator
contents tested by a workshop before
winter starts. The amount of antifreeze
must provide protection down to approx.
-28 C. A lower antifreeze concentration
will reduce the amount of protection from
frost and corrosion. Add antifreeze if
necessary.
If coolant loss is topped up with water,
have concentration checked and add
antifreeze if necessary. Caution
Only use approved anti-freeze.
Coolant additives for additional
corrosion protection and sealing small
leaks can cause operation problems. No
liability is accepted for damage caused
by using coolant additives.
9 Warning
Antifreeze is a danger to health; it must
therefore be kept in the original
container and out of the reach of
children.

Page 187 of 212

181
Opel Service, maintenance
Laying the vehicle up for a long
period of time If the vehicle is to be laid up for several
months, the following work should be
undertaken to prevent damage.
zWash and wax the vehicle 3161.
zHave the wax in the engine
compartment and underbody checked.
zClean and preserve rubber seals.
zChange engine oil.
zCheck anti-freeze and corrosion
protection 3177.
zCheck the coolant level; top up
anti-freeze if necessary 3178.
zDrain the windscreen washer system.
zIncrease tyre pressure to the value
specified for full load 3121, 3191. zPark the vehicle in dry and
well-ventilated place. With manual
transmission select first or reverse gear;
with manual transmission automated 3
move the selector lever to the centre
position before switching the ignition off.
Use chocks or the like to prevent the
vehicle from rolling.
zDo not apply hand brake.
zDisconnect the clamp from the negative
terminal of the vehicle battery.
Putting the vehicle back into
servicePerform the following work before
recommissioning the vehicle:
zConnect the clamp to the negative
terminal of the vehicle battery.
zCheck tyre pressure 3121, 3191.
zTop up the windscreen washer system
3180.
zCheck engine oil level 3175.
zCheck coolant level 3178.
zFit the number plate if necessary.

Page:   < prev 1-10 11-20