display OPEL CORSA 2009 User Guide

76 Seats, InteriorActivation
with the vehicle stationary and ignition off:
zSwitch on ignition, control indicator *
flashes, the LEDs in the button display
the current status 375.
z Press button * within 15 seconds and
hold down.
z After about 2 seconds, you will hear a
confirmation buzzer. Release button *
after another 4 seconds at the latest.
Picture no: 18296s.tif
The airbag systems for the front passenger
are now activated. To indicate this, LEDs in
the button * and the control indicator *
must not be on.
If the LEDs or control indicator * are on,
the airbag systems for the front passenger
will not be triggered in the event of an
impact.
Picture no: 18297s.tif
Control indicator
*
, front passenger
airbag systems which can be deactivated
When the ignition is switched on, * flashes
for approx. 15 seconds. The airbag
systems for the front passenger can only be
activated or deactivate d during this time.
LEDs illuminated in the button * and
illumination of the control indicator *
indicate deactivated airbags, but if the
LEDs and control indicator * are not on,
the airbags are activated.
Starting the engine terminates changing of
the setting.
The setting can then only be changed once
the ignition has been switched off and then
back on again.
Back to overview

84 Instruments, controlsInstruments,
controls
Control indicators ................................ 84
Instrument display ............................... 90
Trip computer display in instrument panel 3.............................................. 92
Information display in the centre console ................................... 94
Warning buzzers.................................. 105
Windscreen wipers ............................... 106
Picture no: 18468s.tif
Control indicators The control indicators described here are
not present in all vehicles. The description
applies to all instrument versions.
The colours of the control indicators mean:
Picture no:
w
Deflation detection system 3
Warning light is red or yellow.
Control indicator lights up redDeflation detected, stop immediately and
check tyre pressure
Control indicator lights up yellowFault in system. Contact a workshop for
assistance.
Deflation detection system 3164
z
Red
Danger, important reminder,
z Yellow
Warning, information, fault,
z Green
Switch-on confirmation,
z Blue
Switch-on confirmation.
Back to overview

86 Instruments, controls
Picture no: 18469s.tif
A

Engine electronics, transmission
electronics 3, immobiliser,
diesel fuel filter 3
Control indicator lights up and/or flashes
yellow.
It illuminates for a few seconds when the
ignition is switched on.
Illuminates when the engine is running

Fault in engine electronics or transmission
electronics. Electronics switches to
emergency running program, fuel
consumption may increase and driveability
of vehicle may be affected 3156. If the
fault is still there when the engine is started
again, contact a workshop for assistance.
Picture no:
Lamps
together with InSP4 on the service
display: Diesel fuel filter needs to be
drained of water 3244.
Flashes when the ignition is on

Fault in the electronic immobiliser system;
the engine cannot be started 327.
S

Engine oil level 3
Control indicator lights up yellow.
The engine oil level is checked
automatically.
Illuminates when the engine is running

Engine oil level too low. Check engine oil
level and top up engine oil if necessary
3 242.
I

Engine oil pressure
Control indicator lights up red.
It illuminates when the ignition is switched
on and goes out shortly after the engine
starts.
Illuminates when the engine is running
1. Depress clutch.
2. Shift manual transmission or manual
transmission automated 3 into neutral;
for automatic transmission 3, set
selector lever to N.
3. Move out of the flow of traffic as quickly as possible without impeding other
vehicles.
4. Switch off ignition.
Contact a workshop for assistance. Caution
Engine lubrication may be interrupted.
This may result in damage to the engine
and/or locking of the drive wheels.
9
Warning
When the engine is off, considerably
more force is needed to brake and steer.
Do not remove key until vehicle has
come to a standstill, otherwise the
steering column lock could engage
unexpectedly.
Back to overview

88 Instruments, controls
Picture no: 18469s.tif
* Airbag systems which can be deactivated
for the front passenger
Symbol is lit, or flashes in the kilometre
display.
Illuminatedtogether with the LEDs in the button *:
airbag deactivated 376.
FlashesThe system can be activated or
deactivated within 15 seconds of switching
on the ignition 376.
Picture no:
T
Winter setting for automatic
transmission 3 or manual
transmission automated 3
Symbol lights up on the transmission
display if the Winter program is selected
3 140, 3146. 1
Manual transmission automated SPORT
mode 3
Symbol lights up on the transmission
display if the Sport program is selected
3 139.
q Headlamp range adjustment
Symbol is lit in the kilometre display
together with the setting.
It comes on for 4 seconds when dipped
beam is switched on, as well as when the
headlamp range has been adjusted.>

Fog lamps 3
Control indicator lights up green
This comes on when the front fog lamps
are switched on 3110.
8

Exterior lights
Control indicator lights up green
Illuminates when the exterior lighting is on
3 108.
r
Fog tail lamp
Control indicator lights up yellow.
This comes on when the fog tail lamp is
switched on 3110.
Back to overview

90 Instruments, controls
Picture no: 18240s.tif
Instrument display On some versions, the pointer of the
tachometer, speedometer and fuel gauge
briefly moves to its end position when the
ignition is switched on.
Tachometer
Displays the engine rpm.
Drive in a low engine speed range for each
gear as much as possible.
Picture no:
Speedometer
Speed display.
Caution
If the pointer is in the warning zone, the
maximum permitted engine speed is
exceeded. Engine at risk.
Picture no: 18241s.tif
Fuel gauge

Fuel tank level display.
If the fuel level is too low, a warning lamp
lights up Y. When the light flashes, refuel as
soon as possible.
Never run the tank dry!
Because of the fuel remaining in the tank,
the amount of fuel requ ired to fill the tank
may be less than the specified tank
capacity.
Back to overview

91
Instruments, controls
Picture no: 18405s.tif
Kilometre display
Top line:
Trip odometerDisplays the number of kilometres since the
gauge was reset.
To reset, hold down the setting knob for
approx. one second when the ignition is on,
see previous page.
Bottom line:
OdometerRecords the number of kilometres.
Picture no: 18239s.tif
Service display
On vehicles with check control 3, a
corresponding message is shown on the
info display instead of InSP2 and InSP3 .
Picture no: 18232s.tif
Transmission display 3
Display of gear selected for automatic
transmission 3 or current gear or mode for
manual transmission automated 3.
InSP Service interval display. Display of
remaining driving distance until
next service. For additional
instructions 3231.
InSP2 Bulb defective 33212.
InSP3 Remote control battery voltage
too low 3332.
InSP4 Drain water from diesel fuel filter 3.
Contact a workshop for assistance.
ESPoff Electronic stability 3 switched
off 33159.
P Automatic transmission park
position.
R Reverse gear.
N Neutral.
A Manual transmission automated
automatic mode.
D Drive.
1, 2, 3 Selected gear, automatic
transmission.
1 - 5 Current gear, manual transmission
automated, manual mode.
Back to overview

92 Instruments, controls
Picture no: 18401s.tif
Speed warning
With the "Personalised key" function, P6,
3 39, 341, a particular top speed can be
assigned to each vehicle key. When this
speed is exceeded, a warning buzzer
sounds.
This function is programmed in the
kilometre display:
z ignition off, key in ignition switch,
z pull turn signal stalk and wiper stalk
simultaneously to the steering wheel
until you hear a confirmation signal
(approx. 3 seconds),
z the kilometre display shows P1,
z push down the turn signal stalk (left) until
P6 appears,
Picture no: 18402s.tif
zpush the wiper stalk (right) up until the
desired speed appears in increments
of 10,
z to reduce the speed or switch off ( OFF),
push the wiper stalk down,
z pull turn signal st alk and wiper stalk
simultaneously to the steering wheel
until you hear a confirmation signal
(approx. 3 seconds).
This function can be programmed
differently for each vehicle key.
Personalised key 339, cruise control 3160.
Picture no: 18406s.tif
Trip computer display in
instrument panel
3
The trip computer provides information on
driving data, which is continually recorded
and evaluated electronically.
After switching on the ignition, the last
function displayed appears. To select a
different function, rotate the rotary switch
on the wiper stalk briefly up i or down
h and then let go. The functions will be
called one after the other.
To reset a value or confirm a warning
message, press the button 0 on the wiper
stalk.
Back to overview

93
Instruments, controls
Picture no: 18436s.tif
Functions:
zRange
z Instantaneous consumption
z Distance travelled
z Average speed
z Effective consumption
z Average consumption
z Stop watch
To select, rotate the rotary switch on the
wiper stalk briefly up i or down h for
each function and then let go. The
functions will be called one after the other. Range
Range is calculated fr
om current fuel tank
content and instantaneous consumption.
The display shows average values.
After refuelling, the vehicle updates the
range automatically after a brief delay.
When there is insufficient fuel in the tank
for more than 30 km, the warning REFILL
appears on the display.
Confirm the warning message by pressing 0
on the wiper stalk.
Instantaneous consumption
Display of current consumption. At low
speeds, consumption per hour is displayed.
Distance travelled
Display of distance travelled. The
measurement can be reset at any time.
Average speed
Display of aver age speed. The
measurement can be reset at any time.
Stoppages in the journey with the ignition
off are not included in the calculations. Effective consumption
Display of fuel consumed. The
measurement can be reset at any time.
Average consumption
Display of average
consumption. The
measurement can be reset at any time.
Restart trip computer information
Select the desired trip computer function:
rotate the rotary switch on the wiper stalk
briefly up i or down h for each function
and then let go. To reset a value to zero,
hold down the button 0 on the wiper stalk
for more than three seconds: this restarts
measurement. To reset all functions at the
same time, hold down the button 0 for
more than 6 seconds.
All trip computer information, apart from
range and instantaneous consumption,
can be reset.
Stop watch
Select function using rotary
switch iorh ,
push button 0: start/stop
for longer than
three seconds: reset to zero
Back to overview

94 Instruments, controls
Picture no: 17913s.tif
Information display in the
centre console Triple information display
Display of time, outside temperature and
date/infotainment system (when it is on).
When the ignition is off, the time, date
and outside temperature can be presented
for 15 seconds by briefly pressing one of
the two buttons below the display.
Picture no: 17344t.tif
Graphical information display 3,
Colour information display 3
Display of time, outside temperature,
date/infotainment system (when it is on)
and climate control system 3.
The graphical information display presents
the information in monochrome. The colour
information display presents the
information in colour. The information that is displayed and the
format thereof depend on the vehicle
equipment and the setting of the
Infotainment system
3, the trip
computer 3 and the climate control
system 3.
Some information appears in the display in
an abbreviated form.
Infotainment system, see Infotainment
system instructions. Climate control
system 3128.
12:01 17
,0
°C
FM 3
90,6
MHz
REG AS RDSTP
Ü
Board Computer 19,5° 19:36
BC 1 All values
BC 2
257.0
km
Timer
Ø40
km/h
31.0
Ltr.
Ø
7.0
L/100km
1
8
Back to overview

95
Instruments, controls
Picture no: 17913s.tif
Outside temperature A fall in temperature is indicated
immediately and a rise in temperature
after a time delay.
If outside temperature drops below 3 C,
the symbol : appears in the triple
information display as a warning for icy
road conditions. When temperature
increases to at least 5 C, the : symbol
goes out.
Picture no: 17338t.tif
In vehicles with graphical information
display 3 or colour information display 3, a
warning message appears in the display as
a warning for icy road surfaces. There is no
message below -5 C.
:
8:56
-5
,5
°C
07.05.2008
Slippery road-2,5°C
OK
9
Warning
Caution: The road surface may already
be icy even though the display indicates
a few degrees above 0 C.
Back to overview