Peugeot 1007 Dag 2005.5 Owners Manual

90 -Comfort
01-10-2005
91
-Comfort
01-10-2005
Press this button to switch
off the air conditioning.
Automatic operation of
the air conditioning is re-
sumed when the button is
pressed again. The symbol "A/C" is
displayed.
4. Air conditioning on/off
Pressing this button sev-
eral times in succession
enables the air low to be
directed in turn towards:
- the windscreen and the side win- dows (de-icing or demisting),
- the windscreen, the side windows, the vents and the footwells,
- the windscreen, the side windows and the footwells,
5. Air distribution
adjustment Press buttons
"+" or
"-" respectively to in-
crease or reduce the
air low.
The air low symbol,
the fan, ills progressively in relation
to the value requested.
6. Air low adjustment
Press the air low
"-" button 6 until
the fan symbol is empty.
This action switches off all of the
functions of the air conditioning sys-
tem, with the exception of the rear
screen demisting 9.
Avoid driving with the air conditioning
switched off for long periods.
Pressing the air low "+" button 6
again or the "AUTO" button reacti-
vates the system with the values set
before it was switched off.
7. Switching the system off
Control using the manual
buttons
It is possible to adjust one or more
functions manually while leaving the
other functions in automatic mode.
The
"AUTO" button indicator light
switches off.
Switching to manual mode may result
in discomfort (temperature, humidity,
odour, condensation) and does not
provide optimum comfort.
To return to automatic mode, press
the "AUTO" button. Press this button for recir-
culation of the interior air.
The air recirculation symbol
8
is displayed.
Air recirculation enables
the passenger compartment to be
isolated from exterior odours and
smoke.
Avoid prolonged recirculation of inte-
rior air (risk of condensation or dete-
rioration of the air quality).
Press this button again or press the
"AUTO" button to resume automatic
management of the intake of air.
8. Air intake/Air recirculation
With the engine running,
press this button to demist
the rear screen and the ex-
terior mirrors. The indicator
light on button 9 comes on.
Demisting switches off automatically
in relation to the exterior temperature
and to prevent an excessive con-
sumption of current.
It is possible to stop operation of the
demisting before it is switched off
automatically by pressing the button
again.
If the engine is switched off before
the demisting is switched off auto-
matically, the demisting will resume
the next time the engine is switched
on.
9. Demisting the rear screen and
the mirrors
- the footwells,
- the centre vents, the side vents and
the footwells,
- the centre and side vents.

92 -Comfort
01-10-2005
93
-Comfort
01-10-2005
MIRRORS
Exterior mirrors
Folding/Unfolding
When parked, the mirrors can be
folded back and unfolded manually.
If your vehicle is itted with electric
folding/unfolding (ignition on):
F
turn switch A downwards to fold
back the mirrors,
F turn switch A to the central posi-
tion to unfold them.
Manual interior mirror
The interior mirror has two positions:
- day (normal),
- night (anti-dazzle).
To change from one to the other,
push or pull the lever on the lower
edge of the mirror.
STEERING WHEEL HEIGHT
AND DEPTH ADJUSTMENT
When the vehicle is stationary, un-
lock the steering wheel by pulling
handle A.
Adjust the height and depth of the
steering wheel.
Lock it by pushing handle A down
fully.
Demisting
To demist the mirrors, with the en-
gine running, press the rear screen
demisting button.
Electric adjustment
F Turn switch A to the right or to the
left to select the corresponding
mirror.
F Move this switch in all four direc-
tions to adjust.
F Return switch A to the centre
position.

92 -Comfort
01-10-2005
93
-Comfort
01-10-2005
FRONT SEATS
2 - Driver's seat height
adjustment
Pull the control upwards.
Take your weight off the seat to raise
it or press on the seat to lower it. 3 - Seat back angle adjustment
Turn the knob to adjust the angle of
the seat back.
1 - Forwards-backwards
adjustment
Lift the control and slide the seat for-
wards or backwards.

94 -Comfort
01-10-2005
95
-Comfort
01-10-2005
4 - Access to the rear seats
If necessary, detach the seat belt
from the handle and position it along
the door pillar.
Lift control
A with one hand and
guide the movement of the seat for-
wards with the other hand (keeping
the control in the lifted position).
The driver has a courtesy handle
B , located on the inner side of the
passenger seat, for tilting the seat to
allow a child access to the rear for
example.
When it is put back in place, the seat
returns to its initial position. 5 - Head restraint height and
angle adjustment
To raise the head restraint, pull it
upwards.
To lower it, it is necessary to push
simultaneously:
- the button, located on the left guide at the base of the head restraint
frame,
- the head restraint downwards.
No person or object should
prevent the seat from re-
turning to its initial position;
the return to this position is
necessary in order for it to
be secured. The head restraint is itted with a
frame which has notches which
prevent it from lowering; this is an
impact safety device.
To adjust the angle of the head re-
straint, tilt it.
To remove it, press the lug and pull
it upwards.
Never drive with the head
restraints removed; they
must be in place and cor-
rectly adjusted.
The adjustment is correct
when the upper edge of
the head restraint is level
with the top of the head.

94 -Comfort
01-10-2005
95
-Comfort
01-10-2005
6 - Heated seats control
Press the switch. The temperature is
controlled automatically.
Pressing the switch again switches
the function off. 7 - Storage drawer
Your vehicle has a storage drawer
with one or two compartments.
To open it, lift it and pull.
To remove it, bring it to the end of its
travel, press the ends of the slides
and lift it, then pull it fully.
To put it back in place, at the end
of its travel, press on the top of the
drawer to secure it.
Do not place objects weigh-
ing more than 1 kg in the
drawers. 8 - Placing the passenger seat in
the table position
Use one of the two red controls lo-
cated at the base, on each side of
the seat.
To place the seat in the table posi-
tion, lift this control with one hand
and guide the seat back to the table
position with the other hand.
To return the seat to the upright
position, carry out exactly the same
procedure in reverse (always lift the
red control).
As a safety precaution, a
passenger sitting in the
rear of the vehicle must not
place his feet on the front
seat when placed in the
table position.

96 -Comfort
01-10-2005
97
-Comfort
01-10-2005
REAR SEATS
Forwards-backwards
adjustment
Lift the bar
A and slide the seat for-
wards or backwards.
From the boot, you can press the red
handle B and slide the seat forwards
or backwards.
This manoeuvre makes folding of the
seat when loading the boot easier.
Seat back angle adjustment
Tilt the control C and adjust the angle
to the comfort or loading position.
Release the control to lock.
Folding/Placing in the "fully
folded" position
Place the head restraint in the low
position.
Position the seat belt buckle as close
as possible to the strap return.
Move the seat as far back as possi-
ble using the bar A or the handle B.
Fold the seat back onto the seat
cushion tilting control C fully.
Note: you can lock the seat back in
this position by pressing on it.
Push the control D upwards to re-
lease the rear feet.
Place the seat in the "fully folded"
position.
When driving, the seat is retained in
this position by the side strut.
Table position
Place the head restraint in the low
position.
Fold the seat back onto the seat
cushion tilting control C fully.
Note: you can lock the seat back in
this position by pressing on it.

96 -Comfort
01-10-2005
97
-Comfort
01-10-2005
Never drive with the head
restraints removed, they
must be in place and cor-
rectly adjusted.
Locked Released
In order to ensure that the
seat covers have a long
service life, do not leave
the seat in the table or
"fully folded" position after
loading.
Avoid placing luggage on the seats
when they are in the table position.
REAR HEAD RESTRAINTS
The rear head restraints can be re-
moved and have two positions;
- high, position for use
- low, storage position
To raise a head restraint, pull it
upwards.
To lower it, press the lug then the
head restraint.
To remove it, place it in the high
position, push the lug and pull it
upwards.
To reit it, engage the head restraint
rods in the holes taking care to re-
main in the centreline of the seat
back.
Repositioning the seat
Press the control D upwards to check
that the rear feet are released.
Tilt the folded seat rearwards.
The rear feet are secured automati-
cally.
Check that the seat is secured cor-
rectly.
Raise the seat back, releasing it irst
by pulling the control C.

98 -Comfort
01-10-2005
99
-Comfort
01-10-2005
SEAT MODULARITY AND
THE VARIOUS SEAT
CONFIGURATIONS
The design of your vehicle and of its
seats offers several conigurations. Examples of various arrangements
combining convenience and
conviviality:
The various operations
which lead to modiication
of the existing coniguration
must be carried out when
stationary.

98 -Comfort
01-10-2005
99
-Comfort
01-10-2005

100 -Comfort
01-10-2005
101
-Comfort
01-10-2005
Although one of PEUGEOT's main
criteria when designing your vehicle,
the safety of your children also de-
pends on you.
INSTALLING A CHILD SEAT
USING A THREE POINT SEAT
BELT
Intermediate longitudinal
position
* According to current legislation in
the country.
** According to model.
GENERAL POINTS RELATING
TO CHILD SEATS
"Forwards-facing"
When a "forwards-facing" child seat
is installed on the front passenger
seat , adjust the vehicle's seat to the
intermediate longitudinal position
with the seat back upright and leave
the passenger air bag armed**.
"Rearwards-facing"
When a "rearwards-facing"
child seat is installed on
the front passenger seat ,
it is essential that the pas-
senger air bag** is disarmed. Oth-
erwise, the child would risk being
seriously injured or killed if the air
bag were to inlate .
For maximum safety, please
follow these precautions:
- since 1992, and in accordance with Directive 2000/3, all children un-
der the age of 12 must travel in
approved child seats* suited to
their weight , on seats itted with a
seat belt or ISOFIX mountings**,
- statistically, the safest seats in
your vehicle for the transpor-
tation of children are the rear
seats,
- a child weighing less than 9 kg
must travel in the "rearwards-
facing" position both in the front
and in the rear.
PEUGEOT recommends that chil-
dren should travel in the rear seats
of your vehicle:
- "rearwards-facing" up to the age
of 2,
- "forwards-facing" over the age of 2.