PEUGEOT 1007 DAG 2008 Manual Online

4
82
Behaviour in the case of a
steep slope
It is possible to open and close the
doors electrically up to a gradient of
20 %. In the case of a steep slope,
the door may be driven by its
own weight and as a conse-
quence may open or close
sharply. Therefore:

4
83
TAILGATE
Tailgate release
This enables the tailgate to be un-
locked in the event of a central locking
fault.
- Fold back the rear seats to gain access to the lock from inside
the boot,
- Insert a small screwdriver into hole A of the lock to unlock the
tailgate.
"Tailgate open" warning
In this case, or following reconnection
of the battery, with the doors open, it
may be necessary to close the doors
manually, in order to reinitialise them,
and start the engine. If the tailgate is not closed
properly, you are warned:
-
with the engine running,
by lighting of the "door open"
warning light, accompanied by a
message displayed briefl y on the
multifunction display.
- when the vehicle is moving,
by lighting of the "door open"
warning light, accompanied
by an audible signal and a
message displayed briefl y on the
multifunction display.
The tailgate locks automati-
cally when the vehicle speed
reaches 6 mph (10 km/h).
It unlocks when one of the
doors is opened if the speed is below
3 mph (5 km/h) or when the central
locking button on the centre console
is pressed.

When the door has stopped in an
intermediate position (neither fully
open nor fully closed), only the re-
mote control or the controls per-
mit electric operation of the door.
When closing requests are made
when the door is in a partially open
position, the door may open slightly
before closing.
When closing a door electrically when
the battery is low, you are advised to
guide the door manually. Recharge
the battery as soon as possible.
If the electric controls (remote control
or controls) no longer operate, reini-
tialise the door(s) as follows:

1. Start the engine.

2. Manually open the door(s) fully.

3. Close the door(s) fully.
On completion of this procedure,
electric operation of the doors is
restored.
However, if a problem persists
following this procedure, contact a
PEUGEOT dealer. Simultaneous locking
or unlocking of the tailgate
and the doors
The tailgate is locked or unlocked by
the remote control or from the driver's
door lock.
To open, press the control
1 and lift
the tailgate.

4
83
TAILGATE
Tailgate release
This enables the tailgate to be un-
locked in the event of a central locking
fault.
- Fold back the rear seats to gain access to the lock from inside
the boot,
- Insert a small screwdriver into hole A of the lock to unlock the
tailgate.
"Tailgate open" warning
In this case, or following reconnection
of the battery, with the doors open, it
may be necessary to close the doors
manually, in order to reinitialise them,
and start the engine. If the tailgate is not closed
properly, you are warned:
-
with the engine running,
by lighting of the "door open"
warning light, accompanied by a
message displayed briefl y on the
multifunction display.
- when the vehicle is moving,
by lighting of the "door open"
warning light, accompanied
by an audible signal and a
message displayed briefl y on the
multifunction display.
The tailgate locks automati-
cally when the vehicle speed
reaches 6 mph (10 km/h).
It unlocks when one of the
doors is opened if the speed is below
3 mph (5 km/h) or when the central
locking button on the centre console
is pressed.

When the door has stopped in an
intermediate position (neither fully
open nor fully closed), only the re-
mote control or the controls per-
mit electric operation of the door.
When closing requests are made
when the door is in a partially open
position, the door may open slightly
before closing.
When closing a door electrically when
the battery is low, you are advised to
guide the door manually. Recharge
the battery as soon as possible.
If the electric controls (remote control
or controls) no longer operate, reini-
tialise the door(s) as follows:

1. Start the engine.

2. Manually open the door(s) fully.

3. Close the door(s) fully.
On completion of this procedure,
electric operation of the doors is
restored.
However, if a problem persists
following this procedure, contact a
PEUGEOT dealer. Simultaneous locking
or unlocking of the tailgate
and the doors
The tailgate is locked or unlocked by
the remote control or from the driver's
door lock.
To open, press the control
1 and lift
the tailgate.

4
84
PANORAMIC SUNROOF
This sunroof is a panoramic assembly
which provides maximum brightness
and visibility in the passenger com-
partment.
It consists of two parts:
- a fi xed rear part,
- a moving front part.
Each part has an independent manual
shutter.
The sunroof is controlled electrically
by a dial with 9 opening positions. Operation

To open: turn the dial to the left (nine
possible settings).
Once the roof is open, the front shutter
cannot be closed.

To close: return the control to the
initial position "O" . Reinitialisation
Following reconnection of the bat-
tery, in the event of a malfunction or
in the event of unwanted opening of
the roof on closing, the safety auto-
reverse must be reinitialised:
- place the dial in the fully closed
position (initial position "O" ),
- press the dial immediately,
- continue to press until the roof is fully closed.
Always remove the ignition
key when leaving the vehi-
cle, even for a short time.
In the event of contact during
operation of the roof, the movement
of the roof must be reversed. To do
this, operate the control concerned.
When the driver operates the roof
control, he must ensure that no one
is preventing the roof from closing
correctly.
The driver must ensure that the pas-
sengers use the sunroof correctly.
Be aware of children when operating
the roof.
Check that the slides are clean to en-
sure that the sunroof slides correctly.
Safety auto-reverse
When the roof meets an obstacle
while closing, it partially opens again.
You can close the sunroof
using the remote control
when locking (refer to the
corresponding chapter).

The safety auto-reverse function is
not operational during this operation.

4
85
The tank must be fi lled with fuel with

the engine off .

 Open the fuel fi ller fl ap.

 Insert the key then turn it to the
left.

 Remove the cap and attach it to
the clip located on the inside of
the fl ap.
A label on the inside of the fl ap indi-
cates which type of fuel to use.
If you fi ll your tank, do not continue
after the third cut-off of the pump
nozzle. This could result in vehicle
malfunctions.

The capacity of the tank is approxi-
mately 9 gallons (40 litres).

 After fi lling the tank, lock the cap
and close the fl ap.

You have enough fuel left to cover
approximately 30 miles (50 km).
The electric opening of the
left-hand door is inhibited
when the fuel fi ller fl ap is
open.
The key cannot be removed from the
cap's lock until the cap is refi tted on
the tank. FILLING THE FUEL TANK
When the tank's minimum
level is reached, this warning
light comes on, accompanied
by a message on the multi-
function display.
Low fuel level

5
86
LIGHTS STALK
Lights off Automatic switching on
of lights.
Side lights Dipped/main beam
headlamps Dipped/Main beam change
Pull the stalk fully towards you.
Front fog lamps and rear
fog lamp
Rotate the ring
B or C forwards to
switch on and backwards to switch
off. The status is displayed by the in-
dicator light on the instrument panel.
Vehicles fi tted with a rear fog
lamp (ring B)
Rear fog lamp
Vehicles fi tted with front fog
lamps and a rear fog lamp (ring C) Front fog lamps (1st rotation
of the ring forwards)
These operate with the side lights
and dipped headlamps.
Lights on
With the ignition off, a buzzer sounds
when the driver's door is opened, if
you have left your lights on.
If the dipped headlamps remain
on, with the ignition off, they will
be switched off automatically after
thirty minutes maximum to prevent
discharging of the battery.
This can only operate with the dipped
and main beam headlamps.
Front and rear lights
Selection is by turning ring
A .

5
87
Front fog lamps and rear
fog lamp (2nd rotation of
the ring forwards).

Note : to switch off the
rear fog lamp and the front fog
lamps, turn the ring backwards twice
in succession.
Notes:
When the main beam headlamps are
switched on, the front fog lamps are
switched off.
When the lights are switched off au-
tomatically, with the engine running,
the front fog lamps and the side lights
will remain on (turn the ring back-
wards to switch the fog lamps off).
Direction indicators (fl ashers)

Left
: downwards.

Right
: upwards.
When the lights are switched
off automatically or when
the dipped headlamps are
switched off manually, with
the engine running, the fog
lamps and the side lights
will remain on.
In good or rainy weather, both day
and night, the front fog lamps and
the rear fog lamp are dazzling and
are prohibited.
Do not forget to switch them off when
they are no longer needed. Follow me home lighting
Leaving the dipped headlamps on
temporarily, after switching off the
ignition, facilitates the driver's exit
from the vehicle when the light is
poor.
Switching on

 With the ignition off, "fl ash" the
headlamps.

 A second "headlamp fl ash"
switches the function off.
Switching off
The follow me home lighting is
switched off automatically following
locking of the doors, after a specifi ed
time.

5
88
Daytime lights *
On vehicles which are equipped with daytime lights, the dipped headlamps come on when the vehicle is started.
Automatic switching on of
lights
The side lights and dipped beam headlamps switch on automatically if the light is poor and when the wind-screen wipers operate continuously. They switch off when the light be-comes bright enough or the wind-screen wipers are switched off.
In foggy weather or in snow, the brightness sen-sor can detect suffi cient light, the lights will not come on automatically.
Do not cover the brightness sensor, coupled with the rain sensor, located in the centre of the windscreen behind the interior mirror. It is used for automatic switching on of the lights.
Coupling with the Follow Me
Home lighting
The association with the automatic lighting function provides the follow me home lighting with the following additional options:
- selection of maintaining of the lighting for a duration of 15, 30 or 60 seconds in the vehicle parameters of the multifunction display confi guration menu (except in the case of the monochrome display A for which the duration is pre-set),
- automatic activation of the follow me home lighting when the automatic lighting function is in operation.
Activation
Turn the lighting control to the " AUTO " position.
Disarming
Turn the lighting control to a position other than " AUTO ".
Operating fault
If the brightness sensor does not function correctly, the lights come on accompanied by the service warning light, an audible signal and a message on the multifunction display.
Consult a PEUGEOT dealer.
Operating fault
If the brightness sensor does not function correctly, the lights come on accompanied by the service warning light, an audible signal and a messa-ge on the multifunction display.
Contact a PEUGEOT dealer.
Do not cover the brightness sensor, coupled with the rain sensor, located in the centre of the windscreen behind the interior mirror; the as-sociated functions would no longer be controlled.
This warning light comes on on the instrument panel.
The instruments and controls (ins-trument panel, multifunction display, air conditioning control panel, ...) are only lit on switching to the automa-tic switching on of the lights mode or when the lights are switched on ma-nually.
* According to country.

5
88
Daytime lights *
On vehicles which are equipped with daytime lights, the dipped headlamps come on when the vehicle is started.
Automatic switching on of
lights
The side lights and dipped beam headlamps switch on automatically if the light is poor and when the wind-screen wipers operate continuously. They switch off when the light be-comes bright enough or the wind-screen wipers are switched off.
In foggy weather or in snow, the brightness sen-sor can detect suffi cient light, the lights will not come on automatically.
Do not cover the brightness sensor, coupled with the rain sensor, located in the centre of the windscreen behind the interior mirror. It is used for automatic switching on of the lights.
Coupling with the Follow Me
Home lighting
The association with the automatic lighting function provides the follow me home lighting with the following additional options:
- selection of maintaining of the lighting for a duration of 15, 30 or 60 seconds in the vehicle parameters of the multifunction display confi guration menu (except in the case of the monochrome display A for which the duration is pre-set),
- automatic activation of the follow me home lighting when the automatic lighting function is in operation.
Activation
Turn the lighting control to the " AUTO " position.
Disarming
Turn the lighting control to a position other than " AUTO ".
Operating fault
If the brightness sensor does not function correctly, the lights come on accompanied by the service warning light, an audible signal and a message on the multifunction display.
Consult a PEUGEOT dealer.
Operating fault
If the brightness sensor does not function correctly, the lights come on accompanied by the service warning light, an audible signal and a messa-ge on the multifunction display.
Contact a PEUGEOT dealer.
Do not cover the brightness sensor, coupled with the rain sensor, located in the centre of the windscreen behind the interior mirror; the as-sociated functions would no longer be controlled.
This warning light comes on on the instrument panel.
The instruments and controls (ins-trument panel, multifunction display, air conditioning control panel, ...) are only lit on switching to the automa-tic switching on of the lights mode or when the lights are switched on ma-nually.
* According to country.

5
89
HEADLAMP ADJUSTMENT
To avoid causing a nuisance to other
road users, the height of the head-
lamps should be adjusted in relation
to the load in the vehicle.

0. 1 or 2 people in the front seats.

-. 3 people.

1. 4 people.

2. 4 people + maximum
authorised load.

3. Driver + maximum
authorised load.
The initial setting is position "0" .
WINDSCREEN WIPER STALK
Front windscreen wiper with
automatic wipe

2 Fast wipe (heavy rain).

1 Normal wipe (moderate
rain).

I Intermittent wipe.

0 Off.

AUTO  Automatic or single
wipe (press downwards).
In the I ntermittent position, the wiping
speed is in proportion to the speed of
the vehicle.
In AUTO mode, the wiping speed is in
proportion to the intensity of the rainfall.
The fi rst press of the stalk downwards
activates the automatic wipe.
Subsequent presses trigger a single
wipe.
Front windscreen wiper with
intermittent wipe

2 Fast wipe (heavy rain).

1 Normal wipe (moderate rain).

I Intermittent wipe.

0 Off.

 Single wipe (press downwards).
In the I ntermittent position, the wiping
speed is in proportion to the vehicle
speed.