engine PEUGEOT 107 2012 User Guide

1
Instruments and controls
23











Total/trip distance recorder
















Indicators

This indicates the quantity of fuel available:


- 1/1and six bars, the fuel tank is full.

- Rand one bar flashing, the fuel tank is on
the reserve.
When the i
gnition is switched on, the distance
recorder selected when the engine was switched off is displayed.
Press button 1to alternate the distance display:


- total with "ODO"displayed,

- trip with "TRIP"
displayed. To reset the trip recorder to zero, when it is
displayed, press and hold button 1.

Low fuel level

When the minimum level in the fuel tank is reached,
the last bar flashes accompanied b
y an audiblesignal.
In cer tain driving conditions and depending on the engine, the distance which can be travelled with the fuel remaining may be less than 30 miles (50 km). You have approximately 5 litres remaining.
When the frequency of the flashing increases, you
have approximately 3 litres remaining
.

At least 5 litres must be added after running out of fuel.



Fuel gauge

Instruments and controls
24
2 Tronic gearbox indicator
Lever on EASY mode (automatic mode)
Lever
in manual mode
"Neutral"

"Reverse"


1stgear
2 ndgear
3rdgear
4
th gear
5 thgear

I
f this warning lamp comes on with
the engine running, this indicates
a
fault with the 2 Tronic gearboxgearbox.
Contact a PEUGEOT dealer or a qualified
workshop.
"!" warning lamp
"M" is displayed when this operatingmode is selected.
It is switched off on switching to EASY mode.
"E"
is displa
yed when this operatingmode is selected.
It goes off on switching to manual
mode.

22
27 Access
Electronic engine immobiliser Chan
ging the remote
control battery
Reinitialising the remote
control
Following replacement of the remote control
batter
y or in the event of a remote control fault,it may be necessary to reinitialise the system. ) Switch off the ignition.)
Switch the ignition on again.)
Press one of the remote control buttons
immediately for a few seconds.) Switch off the ignition and remove the key
from the ignition lock.The remote control is now working again.If the fault persists, contact a PEUGEOT
dealer or a qualified workshop.
Do not discard the remote controlbatteries, they contain metals which are harmful to the environment. Take them to a PEUGEOT dealership,
or to any other approved collection point. Driving with the doors locked may make
access to the passenger compar tment
by the emergency ser vices more
difficult in an emergency.
As a safety measure (with children on
board), remove the key from the ignition
when leaving the vehicle, even for a
shor t time.
Do not make any modifications to the
electronic immobiliser system.

To change the battery, remove the screw then
unclip the housing using a coin inserted at
the rin
g.
Battery CR 2016/3 volts.
If the remote control does not work after thebattery has been changed, reinitialise it. The high frequency remote control is
a sensitive system; do not operate it
in your pockets as there is a risk that
it may unlock the vehicle without you
being aware of this.
Avoid pressing the buttons of your
remote control out of range of
your vehicle, you risk rendering it
inoperative. It would then have to be
reinitialised. This locks the engine management system as
soon as the ignition has been switched off and
therefore prevents star ting of the vehicle byanyone who does not have the key.
The ignition key has an electronic chip whichhas a special code. When the ignition is
switched on, the code must be recognised for
starting to be possible.
In the event of a malfunction, your vehicle willnot start.Contact a PEUGEOT dealer or a qualifiedworkshop.

30Access























Fuel tank
)
Open the fuel filler flap. )
Inser t the key in the filler cap, turn it slightly
to the left and then return to the right.
The key returns to its initial position and the filler cap is then unlocked.
Low fuel level

When the low fuel level is reached,
the last bar
flashes, accompanied byan audible signal.
Yo u h a v e a p p r o x i m a t e ly 5 litres
remaining.In cer tain driving conditions and depending on
t
he engine, the distance which can be travelled
with the fuel remaining may be less than30 miles (50 km).
When the frequency of the flashing increases, you have approximately 3 litres remaining . )Unscrew the cap with the key.

)Hang the filler cap on the bracket, located
on the inner face of the filler flap.


A label affixed on the inside of the flap reminds you which type of fuel to use.
When you fill the fuel tank, do not continue after
the 3rd cut-off of the pump. This could cause
malfunctions.
The capacity of the fuel tank isapproximately 35 litres.)After filling the fuel tank, screw the cap
back on fully to the right until it clicks
thenclose the flap.
The fuel tank must be filled with theengine switched off.
f
If you run out of fuel, the emissioncontrol system warning lamp may come on in the instrument panel. It will go off
automatically after the engine has been started a few times.

22
31 Access
Quality of the fuel used
for petrol engines

The petrol engines are perfectly compatible
with E10 or E24 type petrol biofuels (containing10 % or 24 % ethanol), conforming to Europeanstandards EN 228 and EN 15376.
E85 type fuels (containing up to 85 % ethanol)
are reser ved exclusively for vehicles marketed for the use of this type of fuel (BioFlex
vehicles). The quality of the ethanol mustcomply with European standard EN 15293.
For Brazil only, special vehicles are marketed
to run on fuels containing up to 100 % ethanol(E10 0 type).

3
33 Comfort

















Vent ilat ion
3.
Side vents.
4. Diffusion grille.
5. Air outlets to the footwells.
1.
Windscreen demisting/defrosting vent. 2.Side window demisting/defrosting vents.
The air conditioning system does not contain chlorine and does not presentany danger to the ozone layer.


Recommendations for use
If the interior temperature remains very high after a prolonged period parked in the sun, firstventilate the passenger compar tment for a few
minutes.For an even air distribution, make sure thatyou do not block the outside air inlet grille, thevents, the air passages and the air outlets tothe footwells.Ensure that the passenger compartment filter,located below the windscreen, in the engine compartment, is in good condition. Have thefilter elements replaced regularly. If you drive in dusty conditions, change them twice as often. Operate the air conditioning system for 5 to10 minutes, once or twice a month, to keep it in perfect working order. In order to ensure that your air conditioning system continues to operate correctly, you areadvised to have it checked regularly. The condensation created by the air conditioning results in a flow of water under the vehicle when stationary which is perfectly normal. If the system does not produce cold air, do not use it and contact a PEUGEOT dealer or aqualified workshop.

34Comfort






















Heating
1. Temperature adjustment
Turn the control from blue (cold) to red(hot) to adjust the temperature to suit your requirements.
2. Air fl ow adjustment
When the ignition is switched on, turn the control to obtain a flow of air which is sufficient
to ensure your comfort.
To maintain a certain level of comfort in thepassenger compar tment, avoid position 0whenever possible.
In position 0, a slight flow of air, due to themovement of the vehicle, can still be felt. Win
dscreen and side windows.


4. Rear screen demisting
With the engine running, press button 4
, the indicator lamp comes on.
The system demists the rear screen.
It is switched off by pressing control 4.

3. Air distribution adjustment
Footwells, diffusion grille and side
vents.
Di
ffusion grille and side vents.

Demisting and defrosting

To quickly demist or defrost the windscreen and side windows:


- set the air distribution to "Windscreen and side windows",

- place the temperature control 1
and the air
fl
ow control 2at maximum,

- close the side vents.
The air distribution can be adjusted byplacing the control in an intermediate
position.
Switch the system off as soon as you consider this necessary as a lower consumption of current reduces fuel consumption.
Windscreen, side windows and
f
ootwells.

Footwells.

3
35 Comfort

1. Air conditioning On/Off
With the engine running, press thebutton, the indicator lamp comes on.
1.
Air conditioning On/Off 2.Te m p e r a t u r e a djustment3.Air flow adjustment





























Air conditioning


2. Temperature adjustment

Turn the control from blue (cold) to red(hot) to adjust the temperature to suit your
requirements.
4. Air recirculation / Air intake
5. Air distribution adjustment 6.
Rear screen demisting


3. Air fl ow adjustment
When the ignition is switched on, turn the control to obtain a flow of air which is sufficient
to ensure your comfort.
To maintain a certain level of comfort in the
passenger compartment, avoid position 0whenever possible.
In position 0
, a slight flow of air, due to the
movement of the vehicle, can still be felt. The air conditionin
g will not operate if the air flow adjustment control 3 is in position 0.
To quickly obtain cooled air, you can use air recirculation for a few moments. Then return to exterior air intake.

42Driving
The position of the gear lever ( R
, N
, Eor M )
and the gear engaged (1 to 5 ) are displayed in
the instrument panel screen.




















2 Tronic gearbox
Reverse "R". This gear will beengaged when stationary or at a
speed below approximately 4 mph (6 km/h).
Engagement of reverse gear is accompanied
by an audible signal.


Moving off

With the parking brake applied, press the brakepedal then select position Nto star t the engine.
With your foot on the brake, select position R , Eor M.
Release the parking brake, take your foot off
the brake
pedal, then accelerate. The
five-speed 2 Tronic gearbox gearbox offersa choice between the ease of automated
operation
or the driving pleasure of manual
gear changing.
You can chan
ge from position Eto position Mand vice versa at any time.
Gear lever positions
Select the driving mode by moving the gear
lever.
N eutral "N".
Position the lever to the right inposition N, to star t the engine.
E
asy "E": automatic gear changing.
M
anual (+ / -) "M": manual gear changing.


Steering mounted control
paddles
Press behind the +steering mounted control
paddle to change up.
Press behind the -steering mounted control
paddle to change down.
With the engine running, in these three positions, an audible signal is heard when the driver's door is opened.

Display in the instrument panel

5
43 Driving

EASY mode (automatic
mode)
Select position E
using the gear lever.
The gear engaged is displayed in the
instrument panel screen.
The gearbox continuously selects the mostsuitable gear.
Manual mode
Place the gear lever in position M, then changeup or down using:
- the gear lever, pushing:


- rearwards, "+"to change up,

- forwards, "-"to change down.
- or the steering mounted controls paddles.
The gear engaged is displayed on the
instrument panel screen.
If the engine speed is too low, the gearbox automatically changes down to prevent stalling.
In the event of overheating of the clutch, position N is selected automatically and the
symbol N flashes accompanied by an audible
signal.


Operating fault
Stoppin
g the engine

Before switching off the engine, you can change to position Nto be in neutral.
In all cases, it is essential that you apply the
parking brake to immobilise the vehicle.
With the i
gnition on, illumination
of this warning lamp indicates a gearbox fault.

Contact a PEUGEOT dealer or a qualified
workshop.

Stopping - Moving off on a
slo
pe
The gearbox is an electronically controlledmanual gearbox without a clutch pedal.
To hold the vehicle on a slope, it is necessary
to use the brake pedal or the parkin
g brake and not the accelerator pedal.
When moving off on a slope, accelerateprogressively while releasing the parking brake.

Always press the brake pedal while starting the engine.
Never select neutral N
while the vehicle is moving.In all cases, it is essential to apply the parking brake to immobilise the vehicle.

On a slope, use the brake to immobilisethe vehicle and place the gear lever in position N , E
or R.
Do not keep the vehicle immobilisedusing the accelerator.

If you press the accelerator pedal beyond the point of resistance, the2 Tronic gearbox gearbox changes
down for sharper acceleration.
Te m p o r a r i ly taking control of gear changes
You can temporarily take control of gear changes using the "+"and "-"
steering
mounted controls; if the engine speed allows,
the
gear change command is acted on.
This function allows you to anticipate cer tain
situations such as over taking a vehicle or approaching a corner.
After a few moments with no action on thecontrols, the gearbox returns to automaticcontrol of the gears.