ECO mode Peugeot 206 P Dag 2009 User Guide

Page 72 of 113

!
67
Programming

 Turn dial 1 to the "LIMIT" position:
the speed limiter mode is selected
but is not switched on (OFF).
Exceeding the programmed speed
Pressing the accelerator pedal to exceed the programmed
speed will not have any effect unless you press the pedal

fi rmly past the point of resistance .
The speed limiter is deactivated temporarily and the pro-
grammed speed, which is still displayed, fl ashes.
Returning to the programmed speed, by means of int entional
or unintentional deceleration of the vehicle, automaticall y
cancels the fl ashing of the programmed speed. Return to normal driving

 Turn dial 1 to the "0" position: the
speed limiter mode is deselected.
The display returns to the distance
recorder.
You do not have to switch the speed
limiter on in order to set the speed.

 Switch the speed limiter off by pressing button 4 : the dis-
play confi rms that it has been switched off (OFF).

 Switch the speed limiter back on by pressing button 4
again.

 Set the speed value by pressing button 2 or 3 (e.g.:
55 mph (90 km/h)).
You can then change the programmed speed using buttons

2 and 3 :
- by + or - 1 mph (km/h) = short press,
- by + or - 5 mph (km/h) = long press,
- in steps of + or - 5 mph (km/h) = maintained press.

 Switch the speed limiter on by pressing button 4 . Operating fault
In the event of a speed limiter malfunc-
tion, the speed is cleared resulting in
fl ashing of the dashes.
Have the system checked by a PEUGEOT
dealer.
On a steep descent or in the event
of sharp acceleration, the speed
limiter will not be able to prevent
the vehicle from exceeding the pro-
grammed speed.
To avoid any risk of jamming of the
pedals:
- ensure that the mat is posi-tioned correctly,
- do not fi t one mat on top of an- other.

Page 92 of 113

!i
86
ECONOMY MODE FUNCTION
After the engine has stopped, with the
key in the accessories position, cer-
tain functions (windscreen wiper, cour-
tesy lights, audio equipment, dipped
headlamps, etc.) can only be used for
a maximum cumulative duration of ap-
proximately fi fteen minutes, to prevent
discharging of the battery.
Once the fi fteen minutes are over, the
message "Economy mode active" ap-
pears on the multifunction display and
the active functions are put on standby.
These functions will be reactivated au-
tomatically the next time the vehicle is
used.
To resume the use of these functions
immediately, start the engine and let it
run for a few minutes.
The time available will then be double
the time for which the engine is left run-
ning. However, this time will always be
between fi ve and fi fteen minutes.
A fl at battery will prevent the en-
gine from starting.
TOWING THE VEHICLE
Procedure for having your vehicle towed.
Towing your vehicle


On the front bumper, unclip the cover A
to gain access to the towing eye.

 Switch on the hazard warning lights
on the towed vehicle.

 Place the gear lever in neutral. Towing another vehicle
Failure to comply with this special
requirement may result in damage
to certain braking components and
the absence of braking assistance
the next time the engine is started.

Page 100 of 113

92

WEIGHTS AND TOWING LOADS (IN KG)

Petrol engines
1.1 litre 60 bhp 1.4 litre 75 bhp
Gearbox Manual
Model codes: 2LHFXA
2MHFXA 2LKFWA
2MKFWA
Kerb weight 945 952
Gross vehicle weight (GVW) 1 384 1 421
Gross train weight (GTW) 1 884 2 321
Unbraked trailer 485 510
Braked trailer * (within GTW limit) 750 1 178
Recommended nose weight 50 50
* The weight of the braked trailer can be increased, wit hin the GTW, if the GVW of the towing vehicle is reduced by an equal
amount; warning, towing using a lightly loaded towing ve hicle may have an adverse effect on its road holding.
The GTW and towing load values indicated are valid up t o a maximum altitude of 1 000 metres; the towing load menti oned
must be reduced by 10 % for each additional 1 000 metres of a ltitude. The speed of a towing vehicle must not exceed 60 mph
(100 km/h) (comply with the legislation in force in your country).
High exterior temperatures may result in a reduction of the perf ormance of the vehicle. To protect the engine when the exterior
temperature is above 37 °C, limit the towed weight.

Page 101 of 113

95
* The weight of the braked trailer can be increased, within the GTW, if the GVW of the towing vehicle is reduced by a n equal
amount; warning, towing using a lightly loaded towing ve hicle may have an adverse effect on its road holding.
The GTW and towing load values indicated are valid up t o a maximum altitude of 1 000 metres; the towing load menti oned
must be reduced by 10 % for each additional 1 000 metres of a ltitude.
The speed of a towing vehicle must not exceed 60 mph (100 km/ h) (comply with the legislation in force in your country).
High exterior temperatures may result in a reduction of the perfo rmance of the vehicle. To protect the engine when the exterior
temperature is above 37 °C, limit the towed weight.
WEIGHTS AND TOWING LOADS (ON KG)

Diesel engine
1.4 litre Turbo HDI 70 bhp
Gearbox Manual
Model codes: 2L8HZA
2M8HZA
Kerb weight 980
Gross vehicle weight (GVW) 1 476
Gross train weight (GTW) 2 376
Unbraked trailer 520
Braked trailer * (within GTW limit) 1 178
Recommended nose weight 50

Page 111 of 113

10
104
RDS *
Using the RDS on FM
The RDS (Radio Data System) allows
you to continue listening to the same
station, whatever frequency it is using
in the region you are travelling through. Press the "RDS" button
briefl y to switch the func-
tion on or off.
The multifunction display will indicate:
- "RDS" if the function is selected,
- "(RDS)" if the function is selected
but not available.
RDS station following
The display indicates the name of the
station selected. When the RDS is se-
lected, the radio searches continuously
for the transmitter which is broadcasting
the selected station with the best recep-
tion.
Traffi c information programme (TA) Regional following mode (REG)
When they are part of a network, cer-
tain stations broadcast regional pro-
grammes in the various areas they
serve. The regional following mode
allows you to continue listening to the
same programme.
To do this, press the
"RDS" button for
more than two seconds to switch the
function on or off.
Any traffi c information announcement
will be given priority, whatever source
you are listening to (radio, CD).
If you wish to interrupt a message,
press the
"TA" button; this switches the
function off.

Note: the volume of the traffi c infor-
mation is independent of the volume
of normal radio listening. You can
adjust it using the volume button.
The setting will be stored and will be
used for subsequent messages.
Search by type of programme (PTY)
This allows you to listen to stations broad-
casting a specifi c type of programme
(News, Culture, Sport, Rock...). When FM is selected,
press the "TA" button for
more than two seconds
to switch the function on
or off. To search for a
PTY programme:
- select the PTY function,
- press button J or L briefl y to scroll
down the list of the different types of
programme offered,
- when the programme of your choice is displayed, press button J or L for
more than two seconds to carry out
an automatic search (following an
automatic search, the PTY function
is switched off).
In PTY mode, the types of programme
can be stored. To do this, press the
preselection buttons "1" to "6" for more
than two seconds. Press the corre-
sponding button briefl y to recall the type
of programme stored.
EON system
This system connects stations which
are part of the same network. It permits
the broadcasting of TA traffi c informa-
tion or of a PTY programme broadcast
by a station which is part of the same
network as the station to which you are
listening.
This service is available when you have
selected the TA traffi c information pro-
gramme or the PTY search by type of
programme.
Press the
"TA" button to
switch the function on or
off.
The multifunction display will indicate:
- "TA" if the function is selected,
- "(TA)" if the function is selected but
not available.

Page 112 of 113

10
!
105
COMPACT DISC MODE
Selecting CD mode
Ejecting a disc Selecting a track
Press button
J to select the next track.
Press button L to return to the start of
the current track or to select the previous
track.
Accelerated play
Press and hold button J or L for for-
wards or backwards accelerated play.
Accelerated play stops as soon as the
button is released. Random play (RDM)
When the CD player is selected, press
button
N for two seconds. The tracks
will be played in random order. Pressing
button N again for two seconds returns
you to normal play.
The random play mode is switched
off each time the audio equipment is
switched off.
The use of copied compact discs
may cause faults.
Insert circular compact discs only.
Press button
D to eject
the disc from the player.
After inserting a disc,
printed face uppermost,
the player starts auto-
matically.
If the player already contains a disc,
press button N .

Page:   < prev 1-10 11-20