Peugeot 207 CC 2007 User Guide

KEEPING YOUR PASSENGERS SAFE
Front passenger air bagIgnition switch
1. Open the glove box.
2. Insert the key.
3. Select position:
"ON" (activation), with front passenger or "forwards facing" child seat,
"OFF" (deactivation), with "rear facing" child seat.
4. Remove the key keeping the switch in this position.
 99
1.Stop position.
2.Ignition position.
3.Starting position.
 68
A. Front left seat belt not fastened or unfastened warning light lit in red.
B. Front right seat belt fastened warning light lit in green.
C. Rear left seat belt fastened warning light lit in green.
D. Rear right seat belt unfastened warning light lit in red.
 96
Front and rear seat belts
STARTING

DRIVING SAFELY
Speed limiterInstrument panel display
1. Selecting/Switching off speed limiter mode.
2. Decrease the programmed value.
3. Increase the programmed value.
4. Speed limiter on/off.
The values must be set with the engine running.
 106
The cruise control or speed limiter mode appears on the instrument panel when it is selected.
1. Selecting/Switching off cruise control mode.
2. Decrease the programmed value.
3. Increase the programmed value.
4. Cruise control on/off.
In order to be programmed or activated, the vehicle speed must be higher than 25 mph (40 km/h), with at least fourth gear engaged on the manual gearbox (second gear on the automatic gear-box).
 108
Cruise control
Cruise control
Speed limiter

22
PETROL - DIESEL MANUAL GEARBOX OR AUTOMATIC GEARBOX
INSTRUMENT PANELS
Panel which groups together the vehi-cle operation dials and indicator lights.5.Oil temperature.
Indicates the temperature of the oil in the engine (°Celsius).
6.Display.
7.Display zero reset button.
Resets the selected function to zero (trip distance recorder or service indicator).
8.Instrument panel lighting button.
Adjusts the brightness of the lighting of the instruments and controls.
9.Automatic gearbox.
Indicates the programme selected and the gear engaged.
Dials
1.Rev counter.
Indicates the speed of rotation of the engine (x 1000 rpm).
2.Fuel gauge.
Indicates the quantity of fuel remaining in the tank.
3.Cooling temperature.
Indicates the temperature of the engine coolant (°Celsius).
4.Speedometer.
Indicates the current speed of the moving vehicle (km/h or mph).
A.Speed limiter
or
Cruise control.
(km/h or mph)
B.Trip distance recorder.
(km or miles)
C.Service indicator.
(km or miles) then,
Engine oil level indicator.
then
Distance recorder.
(km or miles)
These three functions are displayed in succession when the ignition is switched on.
For further information, refer to the sec-tion which corresponds to the function and to the display associated with it.
Display

!
23
Indicator and warning lights
Visual indicators which inform the dri-ver when a system comes into opera-tion (operation or deactivation indicator lights) or of the occurrence of a fault (warning light).
Associated warnings
The lighting of certain indicator/warning lights may be accompanied by an audi-ble signal and a message on the multi-function display.
Operation indicator lights
The lighting of one of the following indi-cator lights confirms that the correspon-ding system has come into operation.
Left-hand direction indicator.
Handbrake applied.
Right-hand direction indicator.
Main beam headlamps.
Dipped headlamps.
Diesel engine pre-heating.
Wait until this switches off be-fore operating the starter.
Front fog lamps.
Rear fog lamps.
When the ignition is switched on
The warning lights come on for a few seconds when the vehicle ignition is switched on.
When the engine is started, these war-ning lights should switch off.
If they remain on, before moving off, consult the text relating to the warning light concerned.

24
Deactivation indicator lights
The lighting of one of the following in-dicator lights confirms that the corres-ponding system has been switched off intentionally.
Passenger air bag system disarmed.
The passenger air bag system is activated automatically when the vehicle is started.
A special switch, located in the glove box, permits the disarming of this system. This is confirmed by continuous lighting of this indicator light.
Deactivation of the dynamic stability control (ESP).
The ESP system is activated automatically when the vehicle is started.
A special button, located in the centre of the fascia, permits the deactivation of this system. This is confirmed by conti-nuous lighting of this indicator light and of the indicator light on the button.

!
25
When the engine is running or the vehi-cle is moving, the lighting of one of the following warning lights indicates the occurrence of a fault which requires ac-tion on the part of the driver.
Centralised alert.
Lighting of the centralised alert is associated with the lighting of another warning light:
- punctured wheel,- braking,- engine oil pressure,- coolant temperature.It is imperative that the vehicle is stop-ped as soon as it is safe to do so.
Service.
Lighting of the service warning light indicates the occurrence of a problem in one of the systems which does not have a specific warning light.
To identify the problem, consult the message on the multifunction display.
After checking:
- the remote control battery,- the engine oil level,- the screenwash level,for other cases, contact a PEUGEOT dealer.
Punctured tyre.
The lighting of this warning light indicates that one or more tyres are punctured. It is imperative that the vehicle is stopped as soon as it is safe to do so.
Change the damaged wheel and have it repaired by a PEUGEOT dealer.
Anti-lock braking system (ABS).
The lighting of this warning light indicates the occurrence of a fault in the anti-lock braking system.
However, this does not prevent the ope-ration of the vehicle’s assisted braking.
Warning lights

26
Air bags.
The lighting of this warning light indicates the occurrence of a fault in one of the air bags (front or side), pre-tensioning seat belts or roll-over bars systems.
Dynamic stability control (ESP).
The ESP system is activated automatically when the vehicle is started.
Unless the system has been deactiva-ted, continuous lighting of this warning light and flashing of the indicator light on the button indicate the occurrence of a fault in this system.
Engine autodiagnostics system.
The lighting of this warning light indicates the occurrence of a fault in the engine management system.
Flashing of this warning light indicates the occurrence of a fault in the emission control system.
Engine oil pressure.
The lighting of this warning light indicates the occurrence of a fault in the engine lubrication circuit. It is imperative that the vehicle is stopped as soon as it is safe to do so.
Battery charge.
The lighting of this warning light indicates the occurrence of a fault in the battery charging cir-cuit (dirty or loose terminals, slack or cut alternator belt, ...).
Braking.
The lighting of this warning light indicates the occurrence of a fault in one of the braking sys-tems:
- significant drop in the level in the cir-cuit,- electronic brake force distribution (EBFD) faulty (if lit at the same time as the ABS warning light).It is imperative that the vehicle is stop-ped as soon as it is safe to do so.
If the vehicle is moving, check that the handbrake has been released fully.
Low fuel level.The lighting of this warning light indicates that there is enough fuel left to drive approximately 30 miles (50 km).The capacity of the fuel tank is approxi-mately 50 litres.
Maximum coolant temperature.
The lighting of this warning light indicates an excessively high temperature in the cooling system. It is imperative that the vehicle is stopped as soon as it is safe to do so.
Door open.
A door, the boot or the bonnet is still open:
- if the speed is below 6 mph (10 km/h), this warning light comes on continuously,- if the speed is above 6 mph (10 km/h), this warning light comes on continuous-ly, accompanied by an audible signal.
Seat belt not fastened/unfastened.
The lighting of this warning light indicates that the driver* and/or the front passenger has not fastened his seat belt or has unfastened it.
It also indicates that one or more rear passengers have unfastened their seat belt.
Power steering.
The lighting of this warning light indicates the occurrence of a fault in the electric power steering.
Presence of water in diesel*.
The lighting of this warning light indicates the presence of water in the diesel filter.
There is a risk of damage to the injection system on Diesel engines.
Directional headlamps.
Flashing of this warning light indicates the occurrence of a fault in the directional head-lamps system.* According to country.

i
27
Coolant temperature indicator
System which informs the driver of the changes in the temperature of the en-gine coolant while driving.
With the engine running, when the needle is:
- in zone A, the temperature is correct,- in zone B, the temperature is too high; the max temperature warning light 1and the central STOP warning light come on, accompanied by an audible signal and a message on the multi-function display.You MUST stop as soon as it is safe to do so.
Contact a PEUGEOT dealer.
After driving for a few minutes, the tem-perature and pressure in the cooling sy-stem increase.
To top up the level:
 wait for the engine to cool,
 unscrew the cap by two turns to al-low the pressure to drop,
 when the pressure has dropped, re-move the cap,
 top up the level to the "MAX" mark.
Engine oil temperature indicator
System which informs the driver of the changes in the temperature of the en-gine oil while driving.
With the engine running, when the needle is:
- in zone C, the temperature is correct,- in zone D, the temperature is too high; the oil pressure warning light and the central STOP warning light come on, accompanied by an audible signal and a message on the multifunction display.You MUST stop as soon as it is safe to do so.
Contact a PEUGEOT dealer.

28
Service indicator
System which informs the driver when the next service is due, in accordance with the manufacturer’s servicing sche-dule.
The point at which the service is due is calculated from the last indicator zero reset. It is determined by two parame-ters:
- the distance travelled,- the time elapsed since the last ser-vice.
More than 500 miles (1 000 km) remain before the next service is due
For 5 seconds after the ignition is swit-ched on, the spanner symbolising the service operations comes on. The dis-tance recorder display line indicates the distance remaining before the next ser-vice is due.
Example: 4 800 miles/km remain be-fore the next service is due.
For 5 seconds after the ignition is swit-ched on, the display indicates:
5 seconds after the ignition is switched on, the spanner is switched off; the distance recorder resumes its normal operation. The display then indicates the total and trip distances.
Less than 500 miles (1 000 km) remain before the next service is due
Example: 400 miles (900 km) remain before the next service is due.
For 5 seconds after the ignition is switched on, the display indicates:
5 seconds after the ignition is switched on, the distance recorder resumes its normal operation. The spanner re-mains on to indicate that a service must be carried out soon.

i
i
29
Service indicator zero reset
After each service, the service indicator must be reset to zero.
To do this, carry out the following pro-cedure:
 switch off the ignition,
 press and hold the trip distance re-corder zero reset button,
 switch on the ignition; the distance recorder display begins a count-down,
 when the display indicates "=0", re-lease the button; the spanner disap-pears.
Service overdue
For 5 seconds after the ignition is switched on, the spanner flashes to indicate that the service must be carried out as soon as possible.
Example: the service is overdue by 300 miles (km).
For 5 seconds after the ignition is switched on, the display indicates:
5 seconds after the ignition is switched on, the distance recorder resumes its normal operation. The spanner re-mains lit.