change bulb Peugeot 207 CC 2010 Owner's Manual

Page 137 of 207

i
i
PRACTICAL INFORMATION
127
CHANGING A BULB
Procedure for replacing a faulty bulb
with a new bulb without the use of
tools.
1. Direction indicators
(PY21W amber).

2. Sidelamps (W5W).

3. Dipped beam headlamps
(H7-55W).

4. Main beam headlamps (H1-55W).

5. Directional headlamps (H7-55W).

6. Foglamps (H11-55W). Changing the direction indicator
bulbs

 Do not touch the bulb directly
with your fi ngers, use lint-free
cloths.
Changing a halogen bulb should
only be done after the headlamp
has been switched off for a few
minutes (risk of serious burns).
It is imperative to use only anti-ul-
traviolet (UV) type bulbs in order
not to damage the headlamp. Model with conventi
onal lamps
Amber coloured bulbs, such as
the direction indicators, must be
replaced with bulbs of identical
specifi cation and colour.

 Turn the bulb holder one quarter of
a turn and remove it.

 Pull the bulb then change it.
To refi t, carry out these operations in
reverse order.
The headlamps are fi tted with polycar-
bonate glass with a protective coating:

 do not clean them using a dry or
abrasive cloth, nor with a deter-
gent or solvent product,

 use a sponge and soapy water,

 when using a high pressure washer
on persistent marks, do not direct
at the lamps or their outlines for too
long, so as not to damage their pro-
tective coating and seals. Model with elliptical module dipped
beam headlamps and directional
headlamps
Front lamps

Page 138 of 207

PRACTICAL INFORMATION
128
Changing the integrated direction
indicator side repeaters
Changing the foglamp bulbs
For replacement of these bulbs, contact
a PEUGEOT dealer.

 Insert a screwdriver towards the
centre of the repeater between the
repeater and the base of the mirror.

 Tilt the screwdriver to extract the
repeater and remove the repeater.

 Disconnect the repeater connector.
To refi t, carry out these operations in
reverse order.
To obtain a replacement repeater, contact
a PEUGEOT dealer.
Changing the sidelamp bulbs

 Disconnect the main headlamp con-
nector.

 Remove the plastic protective cover
by pulling on the tab.

 Turn the bulb holder one quarter of
a turn and remove it.

 Pull the bulb and change it.
To refi t, carry out these operations in
reverse order.
Changing the dipped, main beam or
directional headlamp bulbs

 Disconnect the main headlamp
connector.

 Remove the corresponding plastic
protective cover by pulling on the tab.

 Disconnect the connector of the
corresponding lamp.

 Move aside the spring to release the
bulb and remove the bulb.
To refi t, carry out these operations in
reverse order.

Page 139 of 207

i
PRACTICAL INFORMATION
129
Rear lamps

1. Brake
lamps
(P 21 W).

2. Sidelamps
(diodes).

3. Foglamps
(P 21 W).

4. Direction indicators
(PY 21 W amber).

5. Reversing
lamps
(R 10 W). Changing bulbs
These bulbs (with the exception of the diode
lamps) are changed from outside the boot:

 fi rst open the fl ap to gain access to
the fi xing bolt,

 remove the lamp fi xing bolt,

 remove the lamp from the outside,

 disconnect the lamp connector,

 remove the lamp seal,

 press the four tabs and remove the
bulb holder,

 turn the bulb one quarter of a turn
and change it.
To refi t, carry out these operations in
reverse order.
Amber coloured bulbs, such as
the direction indicators, must be
replaced with bulbs of identical
specifi cation and colour.

Page 140 of 207

!
PRACTICAL INFORMATION
130
Changing the third brake lamp
(diodes)
For the replacement of this type of di-
odes lamp, contact a PEUGEOT dealer. Changing the number plate lamp
bulbs (W 5 W)

 Insert a thin screwdriver in one of
the exterior holes of the lens.

 Push it towards the outside to unclip it.

 Remove the lens.

 Pull the bulb and change it.
High pressure washing
When using this type of washing
on stubborn dirt, do not persist on
the headlamps, the lamps and their
surrounds to avoid damaging their
protective coating and seals.

Page 152 of 207

!
i
PRACTICAL INFORMATION
142
The fi tting of electrical equipment
or accessories which are not rec-
ommended by PEUGEOT may
result in a failure of your vehicle's
electronic system.
Please note this specifi c warning.
You are advised to contact a rep-
resentative of the Marque to be
shown the range of recommended
equipment and accessories.
ACCESSORIES
You can obtain a wide range of ac-
cessories and original parts from the
PEUGEOT network.
These accessories and parts have been
tested and approved for reliability and
safety.
They are all adapted to your vehicle and
benefi t from PEUGEOT's recommenda-
tion and warranty.
The product range offered by
PEUGEOT Accessories is structured
around 5 categories: PROTECTION -
TOURING - IN-CAR TECHNOLOGY -
STYLING - UNIVERSAL.
"Protection": anti-theft alarm, window etching,
security wheel bolts, breathalyz-
er, fi rst aid kit, warning triangle,
high visibility jacket, stolen ve-
hicle tracking system, puncture
repair kit, snow chains, anti-skid
covers. "Touring":
mats * , boot tray, fi xed coat
hook on head restraint, light-
er, aluminium door sills, rear
head rest.
For leisure pursuits: bicycle car-
rier on towbar ** , boot luggage
carrier, booster seats and child
seats, spectacles storage.
Trailer towbar which must be fi tted by
the PEUGEOT network.
"In-car technology":
audio systems, satellite
navigation systems, Blue-
tooth hands-free system,
CD changer, speakers, DVD
player, connection kit for MP3
player or portable CD player,
USB Box, front and rear park-
ing sensors. "Styling":
seat covers compatible with
lateral airbags, aluminium
gear lever knob, styling strips,
alloy wheels, trims.
"Universal": screenwash, interior and exte-
rior maintenance and cleaning
products.
* To prevent any risk of jamming the pedals:
- ensure that the mat is positioned and secured correctly,
- never fi t one mat on top of another. Depending on the country in which
the vehicle is sold, it is compulso-
ry to have a high visibility jacket,
warning triangle and spare bulbs
available in the vehicle.
** Precautions relating to the bicycle carrier on towbar:
- observe the manufacturer's recom- mendations for fi tting and use,
- refer to the "Technical data - § Weights and towed loads" section
for information regarding the recom-
mended nose weight.