ignition Peugeot 207 CC 2012 Owner's Manual

ii
5
FAMILIARISATION
OPENING

Remote control key


A.
Unfolding/Folding the key.

B.
Unlocking the vehicle.

C.
Unlocking and partially opening the
boot.



65

Also...

D.
Normal locking
or
Deadlocking of the vehicle.



Fuel tank



1.
Opening the fuel fi ller fl ap.

2.
Opening and hooking the fuel fi ller
cap.
Capacity of the tank: approximately
50 litres (petrol) or 48 litres (Diesel).



77


Boot


From outside

From inside

1.
Unlocking the complete vehicle or
unlocking the boot and the vehicle.

2.
Opening the boot lid.



1.
Key in the ignition switch.

2.
Unlocking using the manual cen-
tralised control or the door opening
control.



76


On Diesel vehicles, the fuel fi ller
neck incorporates a misfuel preven-
tion device which prevents fi lling
with petrol.



79

! !
i
6
FAMILIARISATION
OPENING

Retractable roof

When washing your vehicle:


- lock the vehicle,

- avoid spraying the upper part
of the windows,

- keep the end of the high-pres-
sure nozzle at least 1 metre
from the windows and door
seals.
After washing the vehicle or fol-
lowing rain, wait until the roof has
dried before opening it. The roof is operated under the
sole responsibility of the driver.
During operation of the roof, to
avoid the risk of injury, ensure that
no one is in the vicinity of the mov-
ing parts.
You are strongly advised not to op-
erate the roof in strong winds. It is preferable to operate the roof
with the engine running.
The roof can be operated at
speeds below 6 mph (10 km/h).
It is only possible to carry out the
operation twice with the engine off,
to avoid discharging the battery.
Preliminary conditions


)
Switch on the ignition.

)
Ensure that:


- the vehicle is not in energy economy
mode (refer to the corresponding
section),

- the battery voltage is suffi cient
(switching on of the indicator lamp
on the roof control),

- the roof fuse is in good condition (re-
fer to the corresponding section),

- the electric windows are initialised
(refer to the corresponding section),

- the ambient temperature is above
-15 °C.

Precautions to be taken before
operating the roof


)
Park the vehicle on level ground.

)
Check that no object could hinder
the operation of the roof:


- nothing should be placed on the
moving rear shelf 1
or on the net 2
.

- if luggage is being carried in the
boot, it must not raise the net,

)
Ensure that the net 2
is secure.

)
Close the boot correctly.

Maintenance
Carry out a complete opening
and closing operation of the roof
at least once a month to keep it in
good working order.

i
!
!
7
FAMILIARISATION
OPENING

Retractable roof operation


Opening the roof


)
Pull this control until the roof
is fully open.

Closing the roof


)
Press this control until the
roof is fully closed.
Do not release the roof control
during operation of the roof.
However, in the event of danger,
release the control, the roof stops;
then, when the danger is no lon-
ger present, complete the required
operation.
If the operation has not completely
fi nished, you will be warned by an
audible signal and a message on
the multifunction screen. These will
be repeated as the vehicle passes
a number of speed thresholds.
Changing to "cabriolet"
confi guration:


- the four windows lower,

- the boot opens,

- the roof folds into the boot,

- the boot closes.

If you continue to pull or press this
control after the end of the opera-
tion, the four windows rise.
The electric window controls and
the control for the four windows
are deactivated during operation
of the roof.
The roof electronic control unit may
interrupt the operation in progress
as a precaution (for example: door
movement and roof operation in
quick succession). In this case,
release the control then operate
it again to complete the required
operation.

Operating fault
If a malfunction of the roof occurs,
apply the parking brake, switch
off the ignition, restart the engine,
then start the required operation
again.
If the problem persists, contact a
PEUGEOT dealer.
Changing to "coupé" confi guration:


- the four windows lower,

- the boot opens,

- the roof opens out and locks auto-
matically,

- the boot closes. The end of the operation is confi rmed
by an audible signal and a message on
the multifunction screen.
The end of the operation is confi rmed
by an audible signal and a message on
the multifunction screen.

10
FAMILIARISATION
INSTRUMENTS AND CONTROLS



1.
Steering lock and ignition.

2.
Audio equipment steering mounted
controls.

3.
Wiper/wash-wipe/trip computer
control stalk.

4.
Hazard warning lamps switch.

5.
Multifunction screen.
Seat belt fastening status warning
lamps.

6.
Sunshine sensor.

7.
Passenger's airbag.

8.
Glove box/Passenger's airbag
deactivation/Audio/video sockets.

9.
Heated seat control.

10.
12 V accessories socket.

11 .
USB port.

12.
Dynamic stability control
(ESP/ASR) button.
Central locking button.
Alarm button.

13.
Heating/air conditioning controls.

14.
Storage compartment.

15.
Audio and telematics system.

16.
Central adjustable air vents.

15
FAMILIARISATION
MONITORING

Instrument panel
Switch panel


A.
With the ignition on, the fuel gauge
needle should rise.

B.
With the engine running, the associ-
ated low level warning lamp should
switch off.

C.
With the ignition on, the oil level in-
dicator should display "OIL OK"
for
a few seconds.
If the levels are not correct, top up the
level which is low.



20
Lighting of the indicator lamp indicates
the status of the corresponding func-
tion.


A.
Deactivation of the ESP/ASR system.



97

B.
Central locking.



74

C.
Deactivation of the interior volumetric
protection alarm.



69



1.
With the ignition on, the orange and
red warning lamps come on.

2.
With the engine running, these
warning lamps should switch off.
If a warning lamp remains on, refer to
the page concerned.



21



Warning lamps

!
16
FAMILIARISATION

Front passenger's airbag
Ignition switch



1.
Open the glove box.

2.
Insert the key.

3.
Select position:
"ON"
(activation), with front passen-
ger or "forwards facing" child seat,

"OFF"
(deactivation), with "rear facing"
child seat.

4.
Remove the key keeping the switch
in the new position.



102


1.
Stop
position.

2.
Ignition
position.

3.
Starting
position.



67

A.
Front left seat belt not fastened or
unfastened warning lamp lit in red.

B.
Front right seat belt not fastened or
unfastened warning lamp lit in red.



98



Front seat belts


A heavy object (key fob...), attached
to the key and weighing down on
its shaft in the ignition switch, could
cause a malfunction.

PASSENGER SAFETY START

1INSTRUMENTS and CONTROLS
20
PETROL - DIESEL, MANUAL OR AUTOMATIC GEARBOX,
INSTRUMENT PANELS
Panel which groups together the vehicle operation dials and indicator lamps.

5.
Screen.


6.
Display zero reset button.


Resets the selected function to
zero (trip distance recorder or
service indicator).

7.
Instrument panel lighting button.


Adjusts the brightness of the
lighting of the instruments and
controls.

8.
Automatic gearbox.


Indicates the programme selected
and the gear engaged.


Dials



1.
Rev counter.


Indicates the speed of rotation of
the engine (x 1 000 rpm).

2.
Fuel gauge.


Indicates the quantity of fuel
remaining in the tank.

3.
Coolant temperature.


Indicates the temperature of the
engine coolant (°Celsius).

4.
Speedometer.


Indicates the current speed of the
moving vehicle (mph or km/h).

A.
Speed limiter


or
Cruise control.


(mph or km/h)

B.
Trip distance recorder.


(miles or km/h)

C.
Service indicator.


(miles or km/h) then,
Engine oil level indicator.



then
Distance recorder.


(km or miles)
These three functions are displayed
in succession when the ignition is
switched on.
For more information, refer to the section
which corresponds to the function and to
the display associated with it.

Screen

1
!
INSTRUMENTS and CONTROLS
21









Indicator and warning lamps

Visual indicators informing the driver that a system is in operation (operation or
deactivation indicator lamps) or of the occurrence of a fault (warning lamp).

When the ignition is switched on
Certain warning lamps come on for a few seconds when the vehicle's ignition is
switched on.
When the engine is started, these same warning lamps should go off.

If they remain on, before moving off, refer to the information on the warning lamp concerned.


Associated warnings
The illumination of certain warning lamps may be accompanied by an audible sig-
nal and a message in the multifunction screen. The warning lamps may come on
continuously (fi xed) or fl ash.
Certain warning lamps may come
on in two different modes. Only by
relating the type of illumination to
the operating status of the vehicle
can it be ascertained whether the
situation is normal or whether a
fault has occurred.

Operation indicator lamps
If one of the following indicator lamps comes on, this confi rms that the correspond-
ing system has come into operation.



Warning lamp



is on



Cause



Action/Observations




Left-hand
direction
indicato

r


fl ashing with
buzzer. The lighting stalk is pushed
down.


Right-hand
direction
indicator


fl ashing with
buzzer. The lighting stalk is pushed
up.


Dipped beam
headlamps


fi xed. The lighting stalk is in the
"Dipped beam headlamps"
position.


Main beam
headlamps


fi xed. The lighting stalk is pulled
towards you. Pull the stalk to return to dipped beam
headlamps.

1INSTRUMENTS and CONTROLS
22


Warning lamp



is on



Cause



Action/Observations




Front
foglamps


fi xed. The front foglamps are
switched on. Turn the ring on the stalk rearwards twice to
switch off the front foglamps.


Rear
foglamps


fi xed. The rear foglamps are
switched on. Turn the ring on the stalk rearwards to switch off
the rear foglamps.


Diesel engine
pre-heating


fi xed. The ignition switch is at the
2nd position (ignition on).
Wait until the warning lamp has switched off before starting.
The duration for which the warning lamp is on is
determined by the climatic conditions.


Parking brake


fi xed. The parking brake is
applied or not properly
released. Release the parking brake to switch off the
warning lamp, keeping your foot on the brake
pedal.
Observe the safety recommendations.
For further information on the parking brake, refer
to the "Driving" section.

1
!
INSTRUMENTS and CONTROLS
24










Warning lamps

When the engine is running or the vehicle is
being driven, the illumination of one of the fol-
lowing warning lamps indicates a fault which
requires action on the part of the driver. Any fault resulting in the illumination of a warning lamp must be investigated
further by reading the associated message in the multifunction screen.
If you encounter any problems, do not hesitate to contact a PEUGEOT dealer
or a qualifi ed workshop.



Warning lamp



is on



Cause



Action/Observations




STOP




fi xed, alone or
associated with
another warning lamp,
accompanied by an
audible signal and a
message on the screen.
Illumination of the warning
lamp is associated with a
serious braking system or
engine coolant temperature
problem. Stop as soon as it is safe to do so as the engine
may cut out when driving.
Park, switch off the ignition and call a PEUGEOT
dealer or a qualifi ed workshop.


Service


temporarily. Minor problems have
occurred for which there is
no specifi c warning lamp. Identify the problem by reading the message
shown in the screen, such as, for example:


- the engine oil level,

- the screenwash level,

- the remote control battery,

-
saturation of the particle emission fi lter on Diesel
vehicles (see "Checks - § particle emissions fi lter").

For any other faults, contact a PEUGEOT dealer
or a qualifi ed workshop.

fi xed. Major problems have
occurred for which there is
no specifi c warning lamp. Identify the problem by reading the message
shown in the screen and contact a PEUGEOT
dealer or a qualifi ed workshop.


Braking


fi xed, associated
with the STOP
warning lamp. The braking system fl uid
level is too low. You must stop as soon as it is safe to do so. Top
up with brake fl uid recommended by PEUGEOT.
If the problem persists, have the system checked
by a PEUGEOT dealer or a qualifi ed workshop.

+
fi xed, associated
with the STOP and
ABS warning lamp. The electronic brake force
distribution (EBFD) system
has a fault. You must stop as soon as it is safe to do so.
Have it checked by a PEUGEOT or a qualifi ed
workshop.