engine Peugeot 208 2012 Owner's Guide

Page 49 of 328

47
2
Access
Electronic engine immobiliser
The key contains an electronic chip which has
a special code. When the ignition is switched on, this code must be recognised in order for star ting to be possible.
This electronic engine immobiliser locks theengine management system a few minutes
after the ignition is switched off and preventsstarting of the engine by anyone who does not
have the key.

Folding the key
)First press this button to fold the key.
)Press the closed padlock to
locate your locked vehicle in a car park.
Locating your vehicle
This is indicated by lighting of the cour tesy lamps and flashing of the direction indicators
for a few seconds.
Guide-me-home lighting
With the remote control
Make a long press this button to
operate the
guide-me-home lighting (switching on the sidelamps, dipped
beams and number plate lamps).
A second press be
fore the end of the timed period cancels the guide-me-home lighting.
Anti-theft protection
In the event of a fault, you are
informed by illumination of this
warning lamp, an audible signal and a message in the screen.
In this case, your vehicle will not start; contact
a PEUGEOT dealer as soon as possible.
If you do not press the button when folding the key, there is a risk of damageto the mechanism.

Keep safely the label attached to the keys given to you on acquisition of thevehicle.

Page 52 of 328

50
Access
Lost keys
Visit a PEUGEOT dealer with the vehicle's registration document, your personal identification documents and if possible the key code label.
The PEUGEOT dealer will be able to look up the key code and the transponder code required to order a new key.
Remote control
The high frequency remote control is a sensitive system; do not operate it while it is in your pocket as there is a possibility that it may unlock the vehicle, without you being aware of it.
Do not repeatedly press the buttons of your remote control out of range and out of sight of your vehicle. You run the risk of stopping it fromworking and the remote control would have to be reinitialised.The remote control does not operate when the key is in the ignition switch, even when the ignition is switched off, except for reinitialisation.
Locking the vehicle
Driving with the doors locked may make access to the passenger compar tment by the emergency services more difficult in an emergency. However, the vehicle unlocks automatically in the event of a serious impact causing airbag deployment.
As a safety precaution (with children on board), remove the key from the ignition switch when you leave the vehicle, even for a shor t time.
Anti-theft protection
Do not make any modifications to the electronic engine immobiliser system; this could cause malfunctions.
When purchasing a second-hand vehicle
Have the pairing of all of the keys in your possession checked by a PEUGEOT dealer, to ensure that only your keys can be used to open andstart the vehicle.

Page 61 of 328

59
3
Comfort
Heated seats control
With the engine running, the front seats can be heated separately.)Use the adjustment dial, placed on the side
of each front seat, to switch on and select
the level of heating required: 0
:
Off. 1:
Low. 2
:
Medium. 3
:
High.










Centre armrest Comfor t and storage system for the driver and front passenger.
Storage
)
For access to the closed storage box, lift
the lever to open the lid. ) For access to the open storage box below
the armrest, lift the complete armrest
towards the rear.

Page 65 of 328

63
3
Comfort




Mirrors

Each fitted with an adjustable mirror glass providing the lateral rearward vision necessaryfor overtaking or parking. They can also be folded for parking in confined spaces.


Door mirrors

The objects observed are, in reality,closer than they appear.
Take this into account in order tocorrectly judge the distance of vehiclesapproaching from behind.


Demisting - Defrosting

AdjustmentAdjustment Manual model
Folding
) When parked, fold the mirror manually to
protect it.
Unfolding
) Before moving off, unfold the mirror.









Electric mode
)
Move the lever in all four directions toadjust the mirror.)
Move control Ato the right or to the left
to select the corresponding mirror.) Move control Bin all four directionsto adjust. )
Return control A
to the central position.
Demistin
g-defrosting of the door
mirrors operates with the enginerunning, by switching on the heated rear screen (see "Rear screen
demist-defrost").

Page 69 of 328

67
3
Comfort
In order for these systems to be fully effective, follow the operation and maintenance guidelines below: )
To obtain an even air distribution, take care not to obstruct the exterior air intake grilles
located at the base of the windscreen, the nozzles, the vents and the air outlets, as wellas the air extractor located in the boot. )
Do not cover the sunshine sensor, located on the dashboard; this is used for regulation of the digital air conditioning system. )
Operate the air conditioning system for at least 5 to 10 minutes, once or twice a monthto keep it in per fect working order. )
Ensure that the passenger compar tment filter is in good condition and have the filter elements replaced regularly (refer to the "Checks" section). We recommend the use of a combined passenger compartment filter. Thanks to its special active additive, it contributes to the purification of the air breathed by theoccupants and the cleanliness of the passenger compartment (reduction of allergic symptoms, bad odours and greasy deposits).)
To ensure correct operation of the air conditioning system, you are also advised to haveit checked regularly as recommended in the ser vicing booklet. )
If the system does not produce cold air, switch it off and contact a PEUGEOT dealer or a qualified workshop.
When towing the maximum load on a steep gradient in high temperatures, switching off theair conditioning increases the available engine power and so improves the towing ability.











Recommendations for ventilation and air conditioning


If after an extended stop in sunshine, the interior temperature is very high, firstventilate the passenger compartment for
a few moments. Put the air flow control at a setting high enough to quickly change the air in the passenger compartment.

The air conditioning system does notcontain chlorine and does not present any danger to the ozone layer.


The condensation created by the air conditioning results in a dischargeof water under the vehicle which is perfectly normal.



Stop & Start
The heating and air conditioning systems only work when the engine is running. To maintaina comfor table temperature in the passenger compartment, you can temporarily deactivatethe Stop & Start system (see "Driving").

Page 70 of 328

68
Comfort
1. Temperature adjustment
)Turn the dial from blue (cold) to red (hot) to adjust
the temperature to your
requirements.

The air conditioning system only operates with the engine running.
2. Air fl ow adjustment
)Turn the dial from position 1to position 6to obtain acomfortable air flow.



If you put the air flow control in position 0
(system off), the temperature is no longer controlled. However,a slight flow of air can still be felt, resulting from the movement of thevehicle.

Manual air conditioning
Heating / Ventilation

Page 72 of 328

70
Comfort




















Dual-zone digital air conditioning The air conditioning can only operate with the engine running.
Automatic operation
1. Automatic comfort programme
Three modes are provided for the driver and for
the front passenger to select their desired level
o
f comfor t in the passenger compartment.
When the engine is cold, to prevent toogreat a distribution of cold air, the air flow will only reach its optimum levelgradually.
In cold weather, it favours thedistribution of warm air to the windscreen, the side windows and the footwells only.


2 - 3. Driver's - passenger's side
settings
The driver and front passenger can each set
the temperature to suit their requirements.

The value indicated in the screen corresponds
to a level of comfor t and not to a temperature in
degrees Celsius or Fahrenheit.
) press the button 2
or 3down(blue) reduce the value or up (red)
t
o increase it.
Offers the best compromise between
a comfor table temperature and quiet
operation. Provides so
ft and quiet operation by limiting air flow.
Provides stron
g and effective air flow.
)
Press the "AUTO"
button
repeatedly. The indicator lampcomes on at the first press; the
mode activated appears in the
di
gital air conditioning screen.

Page 75 of 328

73
3
Comfort
) Switch off the demisting/defrostingof the rear screen and door mirrorsas soon as appropriate, as lower current consumption results inreduced fuel consumption.


Front demist - defrost






Rear screen
demist - defrost
The control button is located on theair conditioning system control panel.
These markin
gs on the control panel indicate the control positions for rapid demisting or
defrosting of the windscreen and side windows.
With manual air
conditioning

Switching on

The rear screen demisting/defrosting can only operate when the engine is running. )
Press this button to demist/defrost the rear screen and (depending on version) the door mirrors. The indicator lamp associated with
the button comes on.

With Stop & Star t, when demisting hasbeen activated, the STOP mode is not available.


Switching off

The demisting/defrosting switches off automatically
to prevent an excessive consumption of current. ) It is possible to stop the demisting/defrosting operation before it is switched
off automatically by pressing the button
again. The indicator lamp associated withthe button goes off.
With dual-zone digital air
conditioning
Automatic visibility programme)Put the temperature and distributioncontrols to the dedicated marked position. )Switch on the air conditioning by pressing
the "A/C"button; the warning lamp in the button comes on.
) Select this programme to demist or defrost
the windscreen and side windows as quickly as possible.
The system automatically manages the air conditioning, air flow and air intake, and provides optimum distribution towards the windscreen and side windows.) To stop the programme, press either the "visibility"
button again or "AUTO", the
warning lamp on the button goes off and
the warning lamp in the "AUTO"buttoncomes on.
The system rever ts to the previous settings.

Page 83 of 328

81
4
Driving








Starting-stopping the engine
With a manual gearbox
, put the gear lever in neutral.
With an electronic gearbox
, put the gear lever on N
.
With an automatic gearbox
, put the gear lever on Por N.
)Inser t the key in the ignition switch.
The system recognises the star ting code. )Turn the key fully towards the dashboard toposition 3 (Starting).)When the engine star ts, release the key.

Starting the engine


A heavy object (key fob...), attached to the key and weighing down on its shaft in the ignition switch, could cause amalfunction.
Key left in the "Ignition on" position
On opening the driver's door, an aler t message is displayed, accompaniedby an audible signal, to remind you that the key is still in the ignition switch atposition 1 (Stop).
)
Immobilise the vehicle.)
Turn the key fully towards you to position 1 (Stop) .)
Remove the key from the ignition switch.
Switching the engine off

If the key has been left in the ignition
switch at position 2 (Ignition on),the ignition will be switched off automatically after one hour.
To switch the ignition back on, turn the key to position 1 (Stop)
, then back toposition 2 (Ignition on).
Free wheeling
For safety reasons, do not free wheel.If free wheeling, some vehicle functions will no longer be active.

Page 85 of 328

83
4
Driving
Only engage reverse gear when the
vehicle is stationary with the engine at idle.


As a safety precaution and to facilitate starting of the engine:


- always select neutral,

- press the clutch pedal.











6-speed manual
gearbox
) Press the gear knob trigger and move thegear lever to the left then forwards.
Engaging reverse gear

Only engage reverse gear when thevehicle is stationary with the engine at idle.
As a safety precaution and to facilitate star ting of the engine:


- always select neutral,

- press the clutch pedal.







5-speed manual
gearbox
)Push the gear lever to the right then backwards.

Engaging reverse gear Engaging 5th
or 6thgear
)
Move the lever fully to the right to engage 5thor 6 th
gear.

Page:   < prev 1-10 11-20 21-30 31-40 41-50 51-60 61-70 ... 90 next >