Peugeot 307 Break 2002.5 Service Manual

09-09-2002
Manual station search
Press the "MAN" button.
Briefly press button Ior Jto increase or decrease the frequency displayed.
By continuing to press the button in the direction selected, you will obtain continuous scrolling of the frequency.
The scrolling stops at the first station found as soon as the button is released.
Pressing the " MAN" button again returns you to automatic station search.
Manual storing of stations in the memory
Select the station required.
Press one of the buttons " 1" to " 6" for more than two seconds.
The sound stops then becomes audible again, confirming that the station has been stored in the memory.
Automatic storing of FM stations in the memory (autostore)
Audio RB3:press and hold the "BND/AST" button for more than two seconds.
Audio RD3: press and hold button "P" for more than two seconds.
Your radio automatically stores the 6 stations with the stronge st signal in FM. These stations are stored in the FMast wave
band.
If it is not possible to find 6 stations, the remaining memo ries are empty.
Recalling stations stored in the memory
For each waveband, briefly press buttons " 1" to " 6" to recall the corresponding station.
YOUR 307 IN DETAIL 45

09-09-2002
RDS
Using the RDS (Radio Data System) function on FM
Radio Data System allows you to continue listening to the same station, whatever frequency it is using for the region you a re
going through.
Briefly press the " RDS" button to switch the function on or off.
The multi–function display wil show:
"RDS" if the function is selected.
"(RDS)" if the function is selected but not available.
RDS station following
The display indicates the name of the station selected. The radio is continually searching for the station which has the best
reception and which is transmitting the same programme.
Traffic information programme
Press the "TA" button to switch the function on or off.
The multi–function display will show:
" TA " if the function is selected,
"(TA)" if the function is selected but not available.
Any traffic information flash will be given priority, whatever source you are listening to (radio, cassette or CD changer).
If you wish to interrupt a message, press the " TA" button; this switches the function off.
Note: the volume of traffic information announcements is inde pendent of the volume of normal radio listening. You
can adjust it using the volume button. The setting will be stored and will be used when the next messages are broad
cast.
Regional following mode
When they are part of a network, certain stations broadcast regi onal programmes in the various areas they serve. With
regional following mode you can keep listening to the same programme.
Press the " RDS" button for more than two seconds to switch the function on or off.
YOUR 307 IN DETAIL
46

09-09-2002
CASSETTE: AUDIO RB3
Selecting cassette modeWhen a cassette is inserted, the cassette player will start auto matically.
If a cassette is already inserted, press the "SRC"button until cassette mode is selected.
Note: before inserting the cassette, ensure that the tape is taut.
Ejecting the cassette Fully press buttons C and Dto eject the cassette from the player.
Direction of play
The player will play sides 1 and 2 of the cassette alternate ly, by automatically reversing the direction of play at the en d of a
side.
To manually reverse the direction of play, press buttons Cand D half–way.
Fast forward/rewind
Fully press button Cor D to fast forward or rewind the cassette. At the end of the fa st forward/rewind, the set plays the cur
rent side.
Recommendations for using casssettes
Use good quality cassettes.
Avoid the use of cassettes which play for longer than 90 minu tes.
Never expose the cassettes to heat or the direct rays of the sun.
Retighten the tape if necessary before inserting the cassette into the player.
Clean the playing head regularly with a damp–type cleanin g cassette.
YOUR 307 IN DETAIL
48

09-09-2002
CD CHANGER
Selecting CD changer modeAudio RB3:press the"SRC" button several times in succession.
Audio RD3: press button R.
Selecting a disc
Press buttons " 1" to " 5" of the CD changer or the radio to select the corresponding d isc.
Selecting a track Press button Ito select the next track.
Press button Jto return to the start of the current track or to select the previ ous track.
Accelerated play
Press and hold button Ior Jfor forwards or backwards accelerated play.
Accelerated play stops as soon as the button is released.
Shuffle (RDM)
When the CD changer is selected:
audio RB3: press and hold the "SRC" button for two seconds;
audio RD3: press and hold button R for two seconds.
The tracks will be played in random sequence. Pressing the butto n again for two seconds returns you to normal play.
YOUR 307 IN DETAIL
50

09-09-2002
YOUR 307 IN DETAIL
40
AUDIO RD3
Function Stalk movement
1 – Press (behind) Increase volume.
2 – Press (behind) Decrease volume.
1 + 2 –
Simultaneous pressSound cutoff (mute); restoring of the sound by pressing any butto n.
3 – Press Automatic search of higher frequencies (radio)
Selection of the next track (CD).
4 – Press Automatic search of lower frequencies (radio)
Selection of the previous track (CD).
5 – Press the end Change of source (radio/cassette/CD changer).
6 – Rotation (clockwise) Selection of next station stored in the memo ry (radio)
Selection of following CD.
7 – Rotation Selection of previous station stored in the memory (rad io)
(anticlockwise) Selection of previous CD.

09-09-2002
YOUR 307 IN DETAIL41
Button
Function
A RDS RDS function on / off.
Press for more than 2 seconds: regional following mode on/off.
BT ATraffic information priority on/off.
Press for more than 2 seconds: PTY function on/off.
E Increase setting of functions associated with button G.
F Decrease setting of functions associated with button G.
G Adjustment of bass, treble, loudness
,sound distribution and automatic
volume correction.
I Manual and automatic search of higher frequency.
Selection of next CD track and PTY (radio).
J Manual and automatic search of lower frequency.
Selection of previous CD track and PTY (radio).
K MAN Manual/automatic operation of buttons Iand J.
M Radio on/off. N –
Decrease volume.
O +Increase volume.
P Radio Selection of the radio. Selection of FM1, FM2, FMast and AM wa vebands.
Press for more than 2 seconds: automatic storing of stations in the memory (autostore).
QC DSelection of the CD.
Press for more than 2 seconds: shuffle.
R CH. CD Selection of the CD changer.
Press for more than 2 seconds: shuffle.
S
Ejection of the CD.
1 to 6 123456 Selection of station stored in the memory.
Press for more than 2 seconds: storing of a station in the memory.
1 to 5 12345 Selection of a CD changer disc.

09-09-2002
RADIO
Notes on radio reception
Your car radio is subject to phenomena which do not affect domestic radio sets. Both AM (MW/LW) and FM reception are
subject to various forms of interference. This is no reflection on the quality of the equipment, but is due to the nature of the
signals and the way in which they are transmitted.
On MW/LW, interference may be noticed when passing under high voltage power lines or bridges, or in tunnels.
On FM, interference may be the result of increasing distance from the transmitter, deflection of the signals by obstacles
(mountains, hills, buildings, etc.), or of being in an area which is not covered by a transmitter.
Selecting radio mode
Audio RB3:press the"SRC" button several times in succession.
Audio RD3: press button P.
Selecting a waveband
Audio RB3:briefly press the "BND/AST"button to select the FM1, FM2, FMast and AM wavebands.
Audio RD3: briefly press button Pto select the FM1, FM2, FMast and AM wavebands.
Automatic station search Briefly press button Ior Jto search for the station immediately above or below. By continu ing to
press the button in the direction selected, you will obtain continuous scrolling of the frequency.
The scrolling stops at the first station found as soon as the button is released.
If the TAtraffic programme is selected, only stations broadcasting this type of programme are
selected.
Searching for a station occurs first in " LO" sensitivity (selection of the most powerful transmitters) during scan ning of the
waveband, then in " DX" sensitivity (selection of the weakest and most distant transmitte rs).
To make a direct search in " DX" sensitivity, press button I or Jtwice.
YOUR 307 IN DETAIL
44

09-09-2002
Manual station search
Press the "MAN" button.
Briefly press button Ior Jto increase or decrease the frequency displayed.
By continuing to press the button in the direction selected, you will obtain continuous scrolling of the frequency.
The scrolling stops at the first station found as soon as the button is released.
Pressing the " MAN" button again returns you to automatic station search.
Manual storing of stations in the memory
Select the station required.
Press one of the buttons " 1" to " 6" for more than two seconds.
The sound stops then becomes audible again, confirming that the station has been stored in the memory.
Automatic storing of FM stations in the memory (autostore)
Audio RB3:press and hold the "BND/AST" button for more than two seconds.
Audio RD3: press and hold button "P" for more than two seconds.
Your radio automatically stores the 6 stations with the stronge st signal in FM. These stations are stored in the FMast wave
band.
If it is not possible to find 6 stations, the remaining memo ries are empty.
Recalling stations stored in the memory
For each waveband, briefly press buttons " 1" to " 6" to recall the corresponding station.
YOUR 307 IN DETAIL 45

09-09-2002
RDS
Using the RDS (Radio Data System) function on FM
Radio Data System allows you to continue listening to the same station, whatever frequency it is using for the region you a re
going through.
Briefly press the " RDS" button to switch the function on or off.
The multi–function display wil show:
"RDS" if the function is selected.
"(RDS)" if the function is selected but not available.
RDS station following
The display indicates the name of the station selected. The radio is continually searching for the station which has the best
reception and which is transmitting the same programme.
Traffic information programme
Press the "TA" button to switch the function on or off.
The multi–function display will show:
" TA " if the function is selected,
"(TA)" if the function is selected but not available.
Any traffic information flash will be given priority, whatever source you are listening to (radio, cassette or CD changer).
If you wish to interrupt a message, press the " TA" button; this switches the function off.
Note: the volume of traffic information announcements is inde pendent of the volume of normal radio listening. You
can adjust it using the volume button. The setting will be stored and will be used when the next messages are broad
cast.
Regional following mode
When they are part of a network, certain stations broadcast regi onal programmes in the various areas they serve. With
regional following mode you can keep listening to the same programme.
Press the " RDS" button for more than two seconds to switch the function on or off.
YOUR 307 IN DETAIL
46

09-09-2002
PTY function: Audio RD3
This allows you to listen to stations broadcasting a specific t ype of programme (news, culture, sport, rock etc.).
With FMselected, press the " TA" button for two seconds to switch this function on or off.
To search for a PTYprogramme:
select the PTYfunction,
briefly press button Ior Jto scroll down the list of the various types of programmes offered .
when the programme of your choice is displayed, keep button Ior Jpressed for two seconds
to carry out an automatic search (after an automatic search the PTYfunction is switched off).
In PTY mode the different types of programmes can be stored in the memory . To do this, press the preselection buttons "1"
to " 6" for two seconds.
Briefly press the corresponding button to recall the type of prog ramme stored in the memory.
EON system: Audio RD3
This connects stations which are part of the same network. It en ables the broadcast of traffic information, by a station that is
part of the same network as the station to which you are liste ning.
This service is available when you have selected the TAtraffic information programme or the PTYfunction.
YOUR 307 IN DETAIL 47