charging Peugeot 307 Break 2002 Owner's Manual

Battery charge warning light This comes on each time the ignition is switched on.
If it comes on with the engine run-ning, it is accompanied by an audiblesignal and a message "Low battery
charge" on the multifunction display.
It can indicate
- faulty operation of the charging cir- cuit,
- loose battery or starter terminals,
- a cut or slack alternator belt,
- an alternator fault. Contact a PEUGEOT dealer.
ABS warning light This light comes on for 3 se- conds each time the ignitionis switched on.
If it remains on or comes on above 8 mph (12 kmh), this indicates a mal-
function of the ABS.
However, the vehicle retains conven- tional servo-assisted braking. Illumination of this light is accompa- nied by an audible signal and a mes-sage ''ABS system problem'' on
the multifunction display.
Contact a PEUGEOT dealer. Electronic stability programme (ESP/ASR)* warning light This comes on for 3 seconds each time the ignition is switched on. The light, which remains on or comes on when the engine is running and the vehicle is moving, is accompanied by an audible signal and a
message ''ESP/ASR system not operational" on the multifunction display; contact
a PEUGEOT dealer. It flashes when the system is switched on and is lit continuously while the sys-
tem is switching off.
Diesel pre-heat light This comes on each time the ignition is switched on.
Wait until it goes out before trying the starter.
Water in diesel filter warning light* (according to country) Illumination of this warning light is accompanied by an audible signal and the message ''Water in diesel filter'' on the multifunction display.
There is a risk of damage to the injection system.
Contact a PEUGEOT dealer a soon as possible. * According to specification.
Engine auto-diagnostics warning light This comes on each time the ignition is switched on. The warning light showing clogging of the particle emission filter is lin- ked to the engine autodiagnostics warning light.
If it comes on with the engine running, accompanied by an audible signal and themessage "Emission control system problem" on the multifunction display, it
indicates a malfunction in the emission control system. - "Diesel additive low level" or "Risk of clogging of particle emission filter"
indicates a malfunction in the particle emission filter.
If it flashes when the engine is running, accompanied by an audible signal and the message "Catalytic converter faulty" on the multifunction display, it indi-
cates a malfunction in the injection or ignition system. There is a risk of dama-ge to the catalytic converter (petrol engines only).
Contact a PEUGEOT dealer as soon as possible.
INSTRUMENTS AND CONTROLS 31

CHANGING A WINDSCREEN WIPER BLADE Placing the wiper blades in the maintenance position Within one minute of switching
off the ignition, activate the wind-screen wiper stalk to position theblades in the centre of the wind-screen (maintenance position).
Replacing a blade Lift the arm, then unclip the blade and remove it.
Fit the new blade and fold downthe arm.
Note: the shortest blade is fitted to
the wiper arm on the right side of thevehicle.
To park the blades, switch on the ignition and operate the wind-screen wiper stalk. ECONOMY MODE FUNCTION After the engine has stopped, certain
functions (windscreen wiper, electricwindows, sunroof*, courtesy lights,audio equipment etc.) can only beused for a total time of thirty minutes,
to prevent discharging the battery.
Once the thirty minutes are over, the message
"Economy mode active"
appears on the multifunction displayand the active functions are put on
standby.
To resume use of these functions, start the engine and allow it to run fora few seconds.
WARNING: a flat battery will prevent
the engine from starting. LOAD REDUCTION When driving, certain functions (air conditioning*, heated rear screen,heating system for passenger com-partment of diesel vehicles, etc.)
may be switched off temporarily,depending on the level of batterycharge. Reactivation of these functions is automatic, once the battery charge is
sufficient. Note:
at the risk of discharging the
battery, the functions switched off
may be reactivated manually.
* According to specification.
PRACTICAL INFORMATION
110