PEUGEOT 307 CC DAG 2007 Owners Manual

10
105
PRACTICAL INFORMATION
CHANGING A FUSE
The fuse boxes are placed in the
lower part of the fascia (driver's side)
and in the engine compartment (left-
hand side). Correct Incorrect Unscrew the bolt a quarter of a turn
using a coin (1), then unclip the l ap,
pulling at the top right (2).
Replacing a fuse
Before replacing a fuse, the cause of
the incident must be found and recti-
i ed. The fuse numbers are indicated
on the fuse box.
Always replace a faulty fuse with a fuse
of the same rating (same colour).
Use the special pliers located on the
inside of the fascia fuse box cover,
this support also contains the re-
placement fuses.
Fascia fuses

Fuse N° Rating Functions

F36 20 A Hi-Fi amplii er.

F39 20 A Driver and passenger heated seats.

F40 30 A Retractable roof pump supply.

10
105
PRACTICAL INFORMATION
CHANGING A FUSE
The fuse boxes are placed in the
lower part of the fascia (driver's side)
and in the engine compartment (left-
hand side). Correct Incorrect Unscrew the bolt a quarter of a turn
using a coin (1), then unclip the l ap,
pulling at the top right (2).
Replacing a fuse
Before replacing a fuse, the cause of
the incident must be found and recti-
i ed. The fuse numbers are indicated
on the fuse box.
Always replace a faulty fuse with a fuse
of the same rating (same colour).
Use the special pliers located on the
inside of the fascia fuse box cover,
this support also contains the re-
placement fuses.
Fascia fuses

Fuse N° Rating Functions

F36 20 A Hi-Fi amplii er.

F39 20 A Driver and passenger heated seats.

F40 30 A Retractable roof pump supply.

10
106
PRACTICAL INFORMATION

Fuse N° Rating
Functions

F1 - Not used.

F2 30 A Locking and deadlocking.

F3 5 A Air bags and pre-tensioners unit.

F4 10 A Brake and clutch pedal switches, engine coolant level switch,
steering wheel angle sensor,
diagnostic socket, ESP sensor, particle emission i lter pump, electro chromatic mirror.

F5 30 A Front electric windows and heated mirrors supply.

F6 30 A Rear electric windows supply, hinged l aps motor.

F7 5 A Front and rear courtesy lights, map reading lights, glove box l ight.

F8 20 A Multifunction display supply, audio equipment, audio/tel
ephone, alarm siren, alarm control
unit, trailer fuse box, steering wheel stalks supply.

F9 30 A 12 V front socket, 12 V rear socket.

F10 15 A Automatic gearbox control unit, brake switch, tyre under-inl atio n detection control unit.

F11 15 A Diagnostic socket, particle emission i lter control unit, low cu rrent ignition switch.

F12 15 A Rear parking assistance, Hi-Fi amplii er.

F13 5 A Engine fuse box supply, rain and brightness sensor.

F14 15 A Trailer fuse box, instrument panel, automatic air conditionin
g, air bags, pre-tensioners and
rear protective pop-up roll-over hoops unit, hands-free kit.

F15 30 A Locking and deadlocking supply.

F16 - PARC shunt.

F17 40 A Heated rear screen.

10
107
PRACTICAL INFORMATION
Engine compartment fuses
To access the fuses located in the
engine compartment (next to the bat-
tery), unclip the fuse box lid.
When you have i nished, close the lid
carefully to guarantee the sealing of
the fuse box.
Fuse N° Rating
Functions

F1 20 A Fan assembly relay control, engine control unit control.

F2 15 A Horn.

F3 10 A Front wash-wipe.

F4 20 A Headlamp wash.

F5 15 A Fuel pump and purge canister solenoid valve (2 litre petrol).

F6 10 A Four speed automatic gearbox control unit, automatic gearbox l
ever locking control, push
control switch, fan assembly high speed relay, right and left xenon headlamps.

F7 10 A ABS/ESP control unit, power steering control unit.

10
108
PRACTICAL INFORMATION
Fuse N° Rating Functions

F8 25 A Starter control.

F9 10 A Additional heating unit (Diesel), engine coolant level sw itch.

F10 30 A Engine management actuators (ignition coil, solenoid valves, o
xygen sensors, control units,
injectors, heaters), purge canister solenoid valve (1.6 litre petro l).

F11 40 A Air conditioning blower.

F12 30 A Windscreen wipers low/high speed.

F13 40 A Built-in systems interface supply (ignition positive).

F14 30 A Air pump (2 litre petrol).

F15 10 A Right main beam headlamp.

F16 10 A Left main beam headlamp.

F17 15 A Left dipped headlamp.

F18 15 A Right dipped headlamp.

10
!
109
PRACTICAL INFORMATION

Fuse N° Rating
Functions

MF1 *
30 A 200 W fan unit.

50 A 400 W and 460 W fan unit.

MF2 * 30 A ABS/ESP pump.

MF3 * 30 A ABS/ESP solenoid valves.

MF4 * 80 A Built-in systems interface supply.

MF5 * 80 A Built-in systems interface supply.

MF6 * 80 A Passenger compartment fuse box.

MF8 * 70 A Power steering electro-pump unit.
* The maxi-fuses provide additional protection for the el ectrical systems. All work must be carried out by a PEUGEOT dealer.
The electrical system of your vehicle is designed to operate wit h standard or optional equipment.
Before installing other electrical equipment or accessories on yo ur vehicle, contact a PEUGEOT dealer.
PEUGEOT will not accept responsibility for the cost incurred in re pairing your vehicle or for rectifying the malfunctions
resulting from the installation of accessories not supplied and not recommended by PEUGEOT and not installed in
accordance with its instructions, in particular when the combined consumption of all of the additional equipment con-
nected exceeds 10 milliamperes.

10
!
110
PRACTICAL INFORMATION
Special front windscreen
wiper position

 Within one minute of switching off
the ignition, operate the wipers
stalk to position the wiper blades
in the centre of the windscreen
(maintenance position).
Changing a wiper blade

 Lift the wiper arm, then unclip the
blade and remove it.

 Fit the new blade and push back
the arm.

Note: the shortest blade is i tted on
the vehicle's right-hand windscreen
wiper arm.

To return the windscreen wipers to
their normal position, switch on the
ignition and operate the wiper stalk.
BATTERY
To charge the battery using a
battery charger:
- Disconnect the battery starting
with the negative (-) terminal,
- Follow the instructions for use given by the battery charger manu-
facturer,
- Check that the terminals and connectors are clean; if they are
covered with sulphate (white or
greenish deposit), disconnect
them and clean them,
- Reconnect the battery starting with the negative (-) terminal.

It is advisable to disconnect the
battery if the vehicle is not to be
used for a period of more than
one month.
To start the vehicle from
another battery:
- Connect the red cable to the posi-
tive (+) terminals of the two batter-
ies,
- Connect one end of the green or
black cable to the negative (-) ter-
minal of the slave battery,
- Connect the other end of the green or black cable to an earth point on
the broken down vehicle as far as
possible from the battery,
-
Operate the starter, let the engine run,
- Wait for the engine to return to idle, then disconnect the cables.
WIPER BLADE
Before disconnecting the bat-
tery, you must wait for 2 minutes
after switching off the ignition.
Never disconnect a terminal
when the engine is running.
Never charge a battery without
i rst disconnecting the terminals.
Close the windows, the retract-
able roof and the doors before
disconnecting the battery. If the
windows do not operate normal-
ly following reconnection of the
battery, they must be reinitialised
(see sections "Reinitialisation of
the electric windows" and "Reini-
tialisation of the automatic partial
opening of the door windows").
After every reconnection of the
battery, switch on the ignition
and wait 1 minute before starting
to allow the electronic systems to
be initialised. If slight difi culties
are experienced after this, please
contact a PEUGEOT dealer.
Following disconnection of the
battery, the remote control key
and the GPS satellite naviga-
tion system must be reinitialised
(see corresponding section).

10
!
110
PRACTICAL INFORMATION
Special front windscreen
wiper position

 Within one minute of switching off
the ignition, operate the wipers
stalk to position the wiper blades
in the centre of the windscreen
(maintenance position).
Changing a wiper blade

 Lift the wiper arm, then unclip the
blade and remove it.

 Fit the new blade and push back
the arm.

Note: the shortest blade is i tted on
the vehicle's right-hand windscreen
wiper arm.

To return the windscreen wipers to
their normal position, switch on the
ignition and operate the wiper stalk.
BATTERY
To charge the battery using a
battery charger:
- Disconnect the battery starting
with the negative (-) terminal,
- Follow the instructions for use given by the battery charger manu-
facturer,
- Check that the terminals and connectors are clean; if they are
covered with sulphate (white or
greenish deposit), disconnect
them and clean them,
- Reconnect the battery starting with the negative (-) terminal.

It is advisable to disconnect the
battery if the vehicle is not to be
used for a period of more than
one month.
To start the vehicle from
another battery:
- Connect the red cable to the posi-
tive (+) terminals of the two batter-
ies,
- Connect one end of the green or
black cable to the negative (-) ter-
minal of the slave battery,
- Connect the other end of the green or black cable to an earth point on
the broken down vehicle as far as
possible from the battery,
-
Operate the starter, let the engine run,
- Wait for the engine to return to idle, then disconnect the cables.
WIPER BLADE
Before disconnecting the bat-
tery, you must wait for 2 minutes
after switching off the ignition.
Never disconnect a terminal
when the engine is running.
Never charge a battery without
i rst disconnecting the terminals.
Close the windows, the retract-
able roof and the doors before
disconnecting the battery. If the
windows do not operate normal-
ly following reconnection of the
battery, they must be reinitialised
(see sections "Reinitialisation of
the electric windows" and "Reini-
tialisation of the automatic partial
opening of the door windows").
After every reconnection of the
battery, switch on the ignition
and wait 1 minute before starting
to allow the electronic systems to
be initialised. If slight difi culties
are experienced after this, please
contact a PEUGEOT dealer.
Following disconnection of the
battery, the remote control key
and the GPS satellite naviga-
tion system must be reinitialised
(see corresponding section).

10
i
!
111
PRACTICAL INFORMATION
ECONOMY MODE FUNCTION
After the engine has stopped, certain
functions (windscreen wiper, elec-
tric windows, courtesy lights, audio
equipment, telephone, dipped head-
lamps, etc.) can only be used for a
combined duration of approximately
thirty minutes, to prevent discharging
the battery.
Once the thirty minutes are over, a
switching to economy mode mes-
sage appears on the multifunction
display and the active functions are
put on standby.
These functions are reactivated au-
tomatically next time the vehicle is
driven.
In order to resume the use of these
functions immediately, the engine
must be started and left to run for a
few minutes.
The time available to you will then be
double the duration for which the en-
gine is left running. However, this pe-
riod will always be between i ve and
thirty minutes.
LOAD REDUCTION
FUNCTION
When driving, certain functions (air
conditioning, heated rear screen,
heating system for passenger com-
partment of diesel vehicles, etc.) may
be switched off temporarily, depend-
ing on the level of battery charge.
Reactivation of these functions is au-
tomatic, once the battery charge is
sufi cient.

Note: at the risk of discharging the
battery, the functions that have been
switched off may be reactivated
manually.
The batteries contain harmful
substances such as sulphuric
acid and lead. They must be
disposed of in accordance with
regulations and must never be
discarded with household waste.
Take used remote control and
vehicle batteries to an approved
collection point.

Note: if the telephone is be-
ing used when economy mode
starts, it will still be possible to
i nish the call.
A l at battery prevents the en-
gine from starting.

10
i
!
111
PRACTICAL INFORMATION
ECONOMY MODE FUNCTION
After the engine has stopped, certain
functions (windscreen wiper, elec-
tric windows, courtesy lights, audio
equipment, telephone, dipped head-
lamps, etc.) can only be used for a
combined duration of approximately
thirty minutes, to prevent discharging
the battery.
Once the thirty minutes are over, a
switching to economy mode mes-
sage appears on the multifunction
display and the active functions are
put on standby.
These functions are reactivated au-
tomatically next time the vehicle is
driven.
In order to resume the use of these
functions immediately, the engine
must be started and left to run for a
few minutes.
The time available to you will then be
double the duration for which the en-
gine is left running. However, this pe-
riod will always be between i ve and
thirty minutes.
LOAD REDUCTION
FUNCTION
When driving, certain functions (air
conditioning, heated rear screen,
heating system for passenger com-
partment of diesel vehicles, etc.) may
be switched off temporarily, depend-
ing on the level of battery charge.
Reactivation of these functions is au-
tomatic, once the battery charge is
sufi cient.

Note: at the risk of discharging the
battery, the functions that have been
switched off may be reactivated
manually.
The batteries contain harmful
substances such as sulphuric
acid and lead. They must be
disposed of in accordance with
regulations and must never be
discarded with household waste.
Take used remote control and
vehicle batteries to an approved
collection point.

Note: if the telephone is be-
ing used when economy mode
starts, it will still be possible to
i nish the call.
A l at battery prevents the en-
gine from starting.