Peugeot 307 SW 2003.5 Owner's Manual

29-09-2003




 



  

 



!"
#


$!%
The design of your vehicle and of its seats offers multiple seat configurations. There are
 &

which can be installed in the 2nd or 3rd
row, on the right or on the left.
Once the centre seat has been removed from the 2nd row, you can recentre the side seats for more comfort. There is also a '(
, fitted in the central position of the
2nd row, which can also be installed in the left position in the
3rd row. In this case, you must use the 3rd row rear left seat belt with- out passing it through the strap guide.
You can add up to two &&  
in the 3rd row, on the
right or on the left.
The various operations resulting in modification of the existing configuration must be carried outwhen the vehicle is stationary (see "Seats" section). )*

+
,( &
((-*
'*  -
'*+(
&

(' ' ./

29-09-2003

!"
#

$!


 

 &




(&
(
& -
+

(-
,0*


 

'(




(&
(
(
( 
+
-
1'

29-09-2003

!"
#


$!
"

 


&&  



 


+&&
&&  


2

 


&&  

&


'(




(&
(


 



  
&

&&  


3
4 The keys allow you to switch on the ignition and to independently operatethe locks on the front doors, the fuelfiller cap, the glove box and the pas-senger air bag disarming switch.
(
'5 -
From the driver's door, the keys allow you to lock, deadlock or unlock thedoors and tailgate, as well as fold backthe exterior mirrors. If one of the doors or the boot is open, the central locking does not work; anaudible signal indicates this when locking by remote control.


(*
'(

(+(*


*
+0' 


& '6

(*
'( '5 -Press button
to lock the vehicle.
This is confirmed by fixed lighting of the direction indicators for approxi-mately two seconds. /
a long press on button , in
addition to locking, automatically closes the windows.
7
'
+ &
 

&&'5 -
Warning: deadlocking renders the
internal and external door locking controls inoperative.


( on button deadlocks
the vehicle.This is confirmed by fixed lighting of the direction indicators for approxi-mately two seconds. / a long press on button , in
addition to deadlocking, automatically closes the windows.
 '&

( on button within
five seconds of deadlocking changes this to normal locking. This is confirmed by fixed lighting of the direction indicators for approxi-mately two seconds. '5 - Press button
8to unlock the vehicle.
This is confirmed by rapid flashing of the direction indicators. /
if the vehicle is locked and
unlocking is activated inadvertently without the doors being opened with-in 30 seconds, the vehicle will lock
itself automatically.
' -
.0(
,
'
To locate your car, if you have locked it, in a car park:  press button , the courtesy
lights come on and the direction indicators flash for a few sec-onds.

!"
#

 $!
29-09-2003

+ & 
'(&
The confidential card contains the identification code necessary for anywork carried out by a PEUGEOTdealer on the electronic immobiliser
system. This code is hidden by afilm, which should be removed only if
necessary.
4

.0(
'(&


+

'9
,(
 &


,
'6
4.

-  
A buzzer sounds on opening the dri-
ver's door, if the key has been left inthe ignition.
- -


(.
+


(*
'(
Warning that the battery is flat is given by an audible signal accompa-nied by the message
::*
';
(
(.
::
on the multi-func-
tion display.
To replace the battery, remove the screw then unclip the casing using acoin at the ring (CR 2016/3 volt battery). If the remote control does not work after the battery has been changed,reprogramme the remote control.
<(-(** -


(* '(
 Switch off the ignition.
 Switch the ignition on again.
 Immediately press button .
 Switch off the ignition and remove the remote control key
from the ignition lock. The remotecontrol is now working again.

!"
#


$!2


8 This locks the engine control system as soon as the ignition has been
switched off and therefore preventsstarting of the vehicle by anyone
who does not have the key. The ignition key has an electronic chip which has a special code.When the ignition is switched on, thecode must be recognised for startingto be possible.
+


.*
&

+0'  '(('. , the central locking button
indicator light, situated in the centreof the fascia, flashes rapidly whenthe ignition is switched on (2ndnotch), accompanied by an audiblesignal and the message = ;
+
&, '
+0.= on the multi-function
display. In this case your vehicle will not start.
Contact a PEUGEOT dealer as soon as possible.
29-09-2003

29-09-2003
Make a careful note of the number on each key. The key number is coded on the label attached to the key. If the keys are lost, your PEUGEOT dealer can rapidly supply you with new keys.The high frequency remote control is a sensitive system; do not operate it while it is in your pocket as there is a possibility that it may unlock your vehicle, without you being aware of it.
The remote control does not operate when the key is in the ignition, even when the ignition is switched off, except forreprogramming. Do not operate the deadlocking function if there is anyone inside the vehicle.Driving with the doors locked may make access to the passenger compartment by the emergency services more difficult
in an emergency. As a safety precaution (with children on board), remove the ignition key when you leave the vehicle, even for a short time.
Do not repeatedly press the button of your remote control out of range of your vehicle. You run the risk of stopping it from working and the remote control would have to be reprogrammed. When purchasing a second-hand vehicle: Ð ensure that you are given the confidential card;
Ð have the key codes memorised by a PEUGEOT dealer, to ensure that the keys in your possession are the only ones which can start the vehicle.
Do not make any modifications to the electronic engine immobiliser system.

!"
#

 $!"

+ & 
'(&
The confidential card contains the identification code necessary for anywork carried out by a PEUGEOTdealer on the electronic immobiliser
system. This code is hidden by afilm, which should be removed only if
necessary.
4

.0(
'(&


+

'9
,(
 &


,
'6
4.

-  
A buzzer sounds on opening the dri-
ver's door, if the key has been left inthe ignition.
- -


(.
+


(*
'(
Warning that the battery is flat is given by an audible signal accompa-nied by the message
::*
';
(
(.
::
on the multi-func-
tion display.
To replace the battery, remove the screw then unclip the casing using acoin at the ring (CR 2016/3 volt battery). If the remote control does not work after the battery has been changed,reprogramme the remote control.
<(-(** -


(* '(
 Switch off the ignition.
 Switch the ignition on again.
 Immediately press button .
 Switch off the ignition and remove the remote control key
from the ignition lock. The remotecontrol is now working again.

!"
#


$!2


8 This locks the engine control system as soon as the ignition has been
switched off and therefore preventsstarting of the vehicle by anyone
who does not have the key. The ignition key has an electronic chip which has a special code.When the ignition is switched on, thecode must be recognised for startingto be possible.
+


.*
&

+0'  '(('. , the central locking button
indicator light, situated in the centreof the fascia, flashes rapidly whenthe ignition is switched on (2ndnotch), accompanied by an audiblesignal and the message = ;
+
&, '
+0.= on the multi-function
display. In this case your vehicle will not start.
Contact a PEUGEOT dealer as soon as possible.
29-09-2003

29-09-2003
Make a careful note of the number on each key. The key number is coded on the label attached to the key. If the keys are lost, your PEUGEOT dealer can rapidly supply you with new keys.The high frequency remote control is a sensitive system; do not operate it while it is in your pocket as there is a possibility that it may unlock your vehicle, without you being aware of it.
The remote control does not operate when the key is in the ignition, even when the ignition is switched off, except forreprogramming. Do not operate the deadlocking function if there is anyone inside the vehicle.Driving with the doors locked may make access to the passenger compartment by the emergency services more difficult
in an emergency. As a safety precaution (with children on board), remove the ignition key when you leave the vehicle, even for a short time.
Do not repeatedly press the button of your remote control out of range of your vehicle. You run the risk of stopping it from working and the remote control would have to be reprogrammed. When purchasing a second-hand vehicle: Ð ensure that you are given the confidential card;
Ð have the key codes memorised by a PEUGEOT dealer, to ensure that the keys in your possession are the only ones which can start the vehicle.
Do not make any modifications to the electronic engine immobiliser system.

!"
#

 $!"

29-09-2003
3
 This provides two types of protection: Ðexterior protection: it sounds if a
door, the boot or the bonnet is opened.
Ð interior protection: it sounds if
the volume inside the passengercompartment changes (breaking ofa window or a movement insidethe vehicle).
 -


(*  Switch off the ignition and get out of the vehicle.
 Set the alarm, by locking ordeadlocking using the remotecontrol (button indicator light
flashes once per second).
/
if you wish to lock your vehicle
without setting the alarm, use thedoor lock. When the alarm is triggered, thesiren sounds and the direction indi-cator lights flash for thirty seconds. After triggering, the alarm remains set.
#( -/
if the alarm has been
triggered ten times in succession, on the eleventh time it becomesinactive. / if button indicator light flash-
es rapidly, the alarm has been trig- gered while you were away fromyour vehicle.
 (* - Unlock the vehicle with the remote control key (button indicator light
goes out). / if the alarm has been triggered
while you were away from your vehi- cle, the rapid flashing of the indicatorlight will stop when you switch on theignition.




(*
 

)( (
(' 
. If, while you are away from the vehi- cle, you wish to leave a window par-tially open or a pet inside the vehicle,you should choose exterior protec-
tion only.  Switch off the ignition,
 In the next ten seconds, press button until the indicator light is
on continuously,
 Get out of the vehicle, 
Set the alarm by locking or dead-locking using the remote control(button indicator light flashes
once a second).
/
when the alarm is set but the
remote control does not operate:  Unlock the doors with the key
and open the door. The alarm istriggered.
 Switch on the ignition. The alarmis disarmed.
'(('

(  When the ignition is switched on, if button lights for ten seconds, there
is a fault in the siren connection.
Contact a PEUGEOT dealer to have the system checked.
0* '
' , > The alarm is activated automatically two minutes after the last closure ofa door or the boot. In order to avoid accidental triggering of the alarm when a door or the bootis opened, it is essential to first pressthe unlocking button on the remotecontrol.
* According to destination.

!"
#


$!?

29-09-2003
3


 -


&(
+(* 0 &

 -


&(
+(*  & The front door opening controls per- mit complete unlocking of the vehi-cle.
However, the rear door opening controls only unlock the door concerned. /the door opening controls do
not function when the vehicle is deadlocked. '5 -@'5 -
+(*

  & Press button
.
This allows locking or unlocking of the doors and the tailgate. / if the vehicle is deadlocked,
button does not function. In this
case use the remote control for unlocking.
=(

=
( With the engine running, an audible signal and a diagram locating thedoor briefly displayed on the multi-function display warn you that a dooris not properly closed. In addition, if the vehicle is moving, the courtesy lights flash. 
&
+. This prevents either of the rear doors being opened from inside. 
Turn the switch a quarter of a
turn using the ignition key.

!"
#

 $!A