Peugeot 307 SW Dag 2003 Owner's Manual

14-04-2003
YOUR 307 SW IN DETAIL119
SUN VISOR WITH ILLUMINATED
COURTESY MIRROR With the ignition on, the mirror is automatically lit up when the flap isopened.
AREAS FOR TOLL CARDS /
CAR PARK TICKETS The athermic windscreen has two non-reflective zones located either
side of the base of the interior mirror.
They are intended for affixing toll cards and/or car park tickets.
Automatic day/night interior mirror This automatically and gradually changes between the day and night positions.
To prevent dazzling, the glass of the mirror darkens automatically depending onthe intensity of the light from behind. It clears as the light (headlamps of following
vehicles, sunlight) decreases, ensuring maximum visibility. Operation Switch on the ignition and press switch 1:
- Indicator light 2lit (switch pressed): automatic operation.
- Indicator light 2off: automatic system off. The mirror remains at its most clear.
Special feature
To ensure maximum visibility during manoeuvres, the mirror clears automatically when reverse gear is engaged.

14-04-2003
ADJUSTING THE HEADLAMPS Depending on the load in your vehicle, adjusting the beam of theheadlamps is recommended as fol-lows. 0 1 or 2 people in the front seats.
- 3 people.
1 5 or 7 people.
2 5 or 7 people + maximum authori- sed load.
3 Driver + maximum authorisedload.
Initial setting is position 0. HAZARD WARNING LIGHTS Press the button, the direction indi- cators flash. They can operate with the ignition
off. Automatic lighting of hazard warning lights*
When braking in an emergency, depending on the force of decelera-tion, the hazard warning lights come
on automatically. They switch offautomatically the first time you acce-lerate.
It is also possible to switch them off by pressing the button.
* According to destination.STEERING WHEEL HEIGHT
AND DEPTH ADJUSTMENT
When the vehicle is stationary, unlock the steering wheel by pullinghandle
A.
Adjust the height and depth of thesteering wheel, then lock it bypushing handle Adown fully.
HORN Press one of the spokes or the centre of the steering wheel.
YOUR 307 SW IN DETAIL
120

14-04-2003
COURTESY LIGHTS
1 - Front courtesy light
2 - Front map reading lights
3 - 2nd row rear reading lights
4 - 3rd row rear courtesy light With the key in the accessories position (1st notch) or with the ignition on, operate the relevant switch. The front and rear courtesy lights come on when the ignition key is removed, on unlocking the vehicle or on opening one of the doors.
They gradually go off after the ignition has been switched on or the vehicle is locked.In addition, when the vehicle is moving, the front and rear courtesy lights flash if a door or the tailgate is not closed properly.
 Pressing switch 1turns on the front and rear courtesy lights for a duration of ten minutes.
 Pressing switch 3or 4turns on the reading light concerned or the rear courtesy light for a duration of ten minutes.
Note: The courtesy lights can be deactivated by pressing switch 1for more than three seconds. However, a short press on
switch 1switches the front courtesy light on and off.
The map reading lights are not affected by this and may be switched on.  To re-activate the lights, press the switch for more than three seconds.
YOUR 307 SW IN DETAIL 121

14-04-2003
YOUR 307 SW IN DETAIL
122

14-04-2003
INTERIOR LAYOUT
1. Glove boxThis is fitted with a lock.
To open the glove box, lift the handle.The glove box lights when the lid is opened.It contains a ventilation nozzle that can be closed, distributing the same conditioned air as the vents of the passenger compartment, and three sockets for connecting video equipment. The layout allows storage of a water bottle, a pen, the vehicle handbook, a pair of spectacles, tokens etc.
2. Front ashtray Pull the lid to open the ashtray.
To empty it after opening, press the tab and extract the ashtray.
3. Storage
4. 12 volt accessories socket This is a lighter type socket, fitted with a cap. It is supplied with current from the accessories position (1st notch).
5. Door tray
6. Storage/Can holder
7. Waste container To empty, open it fully (past the point of resistance) then pull on the receptacle to remove it.
To refit, lock it in place on the cover.
YOUR 307 SW IN DETAIL 123

14-04-2003
YOUR 307 SW IN DETAIL
124

14-04-2003
YOUR 307 SW IN DETAIL125
BOOT LAYOUT
1. Grab handles and coat hooks
2. High load retaining net fastenings The high load retaining net can be fitted in the 2nd or
3rd row. Open the covers of the corresponding upper faste- nings. Fit the ends of the metal bar in these fastenings.Secure the two opaque material strap hooks in the sto-
wing rings on the floor. The rings are located directly below the corresponding upper fastenings. Pull the two straps taut.Secure the two hooks on the elastic parts of the opaque material in these rings. Note: the net must be positioned so that the label can
be seen from the boot. This ensures that the central
seat belt is routed correctly.
3. 12V Socket for accessories This is a 12 volt socket (lighter type), installed on theload space cover left support.
It is supplied with the ignition off.
4. Rear armrests with grab handle
5. Storage nets One of them contains the luggage retaining net.
6. Load space cover To install it:
Ð position one end of the cover roller in the 2nd row, Ð compress the opposite end of the roller and position
it,
Ð release it to allow it to engage,
Ð unroll the cover as far as the boot pillars,
Ð insert the cover guides in the rails in the pillars, To remove it:
Ð remove the cover guides from the pillar rails,
Ð return the cover into its roller,
Ð compress it and remove it from its support at the 2nd row,
To store it, pull it back and place it with the two storage nets, already lowered. Note: the roller has two hooks for securing the lugga-
ge retaining net depending on where it is installed.
7. Luggage retaining net Secure the net's seven hooks in the stowing rings and
the fastenings on the floor.
8. Luggage retaining net fastenings ("hammock" version) in the tailgate Fold the net in two. Secure the two centre hooks in the stowing rings on the
floor. Secure the net's remaining four hooks on the boot pillars.
See configuration of the nets (next page)

14-04-2003
YOUR 307 SW IN DETAIL
126
Example of installation of the nets:
Luggage retaining net, "folded" version Luggage retaining net, "hammock"version in the tailgate Luggage retaining net, "hammock" version at the rollerHigh load retaining net in the 2ndrow
Luggage retaining net, "L" version
Load space cover stored with the two storage nets

14-04-2003
S: sport programme.


: snow programme.
P ark: to immobilise the vehicle or start the engine ,
with the handbrake on or off.
R everse: to reverse (select this function with the
vehicle stationary, engine at idle). N eutral: to start the engine and to park, with the hand-
brake on. Note: if function Nis engaged inadvertently while dri-
ving, allow the engine to return to idle before engaging function Dto accelerate.
D rive : for driving in automatic mode.
M anual: for driving in manual mode.
YOUR 307 SW IN DETAIL 127
Moving off
With the engine running, to move off from position P:
 it is essential to press the
brake pedal to exit position P,
 select function R, D or M, then
gradually release the pressureon the brake pedal; the vehicle
moves off immediately.
You can also move off from position N:
 release the handbrake, with yourfoot on the brake,
 select function R, D or M, then
gradually release the pressureon the brake pedal; the vehicle
moves off immediately.
WARNING When the engine is at idle, brakes not applied, if function R, D or Mis
selected the vehicle moves evenwithout the accelerator being pres-sed. For this reason, do not leave
children unsupervised inside thevehicle, with the engine running .
When maintenance operations needto be carried out with the engine run-ning, apply the handbrake and selectposition P.
"PORSCHE TIPTRONIC SYSTEM" AUTOMATIC GEARBOX The four speed automaticgearbox offers a choice between the comfort of
integral automatic operation , enhanced by a sport and a snow programme,
or the pleasure of manual gear changing .
Gear selection gate  Move the lever in the gate to select a function. Once the function is selected, the corresponding indicator light appears on
the instrument panel display.

14-04-2003
Automatic operation Automatic changing of the four
gears:  select function Din the gate.
The gearbox always selects the most suitable gear according to the follo-wing parameters: - the style of driving,- the road profile,- the vehicle load. The gearbox is then operating in auto-adaptive mode, without anyaction on your part.
WARNING Never select function Nwhen the
vehicle is moving. Never select functions Por R unless
the vehicle is stationary.Never change between functions to optimise braking on a slippery surface. Notes For immediate maximum accelera-
tion without touching the gear lever,press the accelerator pedal down as
far as it will go (kickdown). The gear-box will automatically change downor maintain the gear selected untilmaximum engine speed is reached. When braking, the gearbox will auto- matically change down in order to
provide efficient engine braking. If you take your foot off the accelera-
tor suddenly, the gearbox will notchange to a higher gear for reasons
of safety.
Sport and snow programme In addition to the auto-adaptive pro- gramme, there are two special pro-grammes. The programme is displayed on the instrument panel screen. Sport programme  Press button Sonce the vehicle
has been started and function D
selected.
The gearbox automatically favours sporty driving and more dynamicacceleration. Snow programme This programme improves starting
and drive when traction is poor.  Press button

once the vehicle
has been started and function D
selected.
The gearbox adapts to driving on slippery roads. Note: you can return to the auto-
adaptive programme at any time.  Press button Sor

again to
switch off the programme you are in. Manual operation Manual changing of the
four gears:
 select function Min the gate,
 push the lever to the +sign to
change to a higher gear,
 pull the lever to the -sign to
change to a lower gear.
You can change from position D
(driving in automatic mode) to posi- tion M(driving in manual mode) at
any time. Note Note It is only possible to change from one gear to another if the vehicle speedand engine speed permit. If they donot, the vehicle will operate tempora-rily in automatic mode. When the vehicle is stationary or
moving very slowly, the gearboxautomatically selects gear M1.
Programme S (sport) and

(snow)
do not operate in manual mode.
YOUR 307 SW IN DETAIL
128