Peugeot 308 CC 2010.5 Owner's Manual

10
!
146
PRACTICAL INFORMATION
Rear lamps

1. Brake lamps (
LEDs
).

2. Sidelamps (
LEDs
).

3. Direction indicators (
LEDs
).

4. Foglamp
(P
21 W
).

5. Reversing
lamp
(P 21 W
). Changing the foglamp and reversing
lamp bulbs
These two bulbs are changed from out-
side the rear bumper:
On the left-hand side, take care not
to touch the silencer; risk of burns,
if you change the bulb after switch-
ing off the ignition.

 turn the bulb holder one quarter of a
turn and remove it,

 turn the bulb one quarter of a turn
and change it.
To refi t, carry out these operations in
reverse order.
Changing brake lamps, sidelamps
and direction indicators
For the replacement of this type of LED
lamp, contact a PEUGEOT dealer.

10
!
147
PRACTICAL INFORMATION
Changing the third brake lamp
(LEDs)
For the replacement of this type of LED
lamp, contact a PEUGEOT dealer. Changing the number plate lamp
bulbs (W 5 W)

 Insert a thin screwdriver in one of
the exterior holes of the lens.

 Push it towards the outside to unclip it.

 Remove the lens.

 Pull the bulb and change it.
High pressure washing
When using this type of washing
on stubborn dirt, do not persist on
the headlamps, the lamps and their
surrounds to avoid damaging their
protective coating and seals.

10
!
i
148
PRACTICAL INFORMATION
PEUGEOT will not accept responsi-
bility for the cost incurred in repairing
your vehicle or for rectifying malfunc-
tions resulting from the installation
of accessories not supplied and not
recommended by PEUGEOT and
not installed in accordance with its
instructions, in particular when the
combined consumption of all of the
additional equipment connected ex-
ceeds 10 milliamperes.
Installing electrical accessories
Your vehicle’s electrical system is
designed to operate with standard
or optional equipment.
Before installing other electrical equip-
ment or accessories on your vehicle,
contact a PEUGEOT dealer.
CHANGING A FUSE
Access to the tools
The extraction tweezer and the spare
fuses are fi xed on the back of the dash-
board fusebox cover.
To gain access to them:

 open the glove box lid,

 push the opening guide to the left
past the fi rst notch,

 open the glove box lid fully,

 turn the screw a quarter of a turn to
the left,

 unclip the fusebox cover by pulling
the top right,

 disengage the fusebox cover com-
pletely and turn it over,

 extract the support, on the back of
which are fi xed the tweezer and the
replacement fuses. Changing a fuse
Before changing a fuse, it is necessary
that:

 the cause of the failure be identifi ed
and rectifi ed,

 all electrical consumers be switched
off,

 the vehicle be immobilised and the
ignition switched off,

 the failed fuse be identifi ed using
the allocation tables and drawings
in the following pages.

Good Failed
Tweezer
To change a fuse, you must:

 use the special tweezer to extract
the fuse from its housing and check
the condition of its fi lament,

 always replace the failed fuse with a
fuse of the same rating (same colour);
a different rating may cause malfunc-
tions (risk of fi re).
If the fault occurs again soon after re-
placing the fuse, have the electrical sys-
tem checked by a PEUGEOT dealer.

10
149
PRACTICAL INFORMATION
Dashboard fuses
The fusebox is located in the lower left
of the dashboard.
Access to the fuses

 refer to the paragraph "Access to
the tools". Fuse tables

Fuse N° Rating Functions

F1 - Not used.

F2 30 A Locking and deadlocking earth.

F3 5 A Airbags and pretensioners control unit.

F4 10 A Clutch pedal and dual-function brake switches,
electrochromatic rear view mirror, air conditioning,
steering wheel angle sensor, automatic gearbox,
switching and protection unit.

F5 30 A Front one-touch electric windows, folding mirrors
supply.

F6 30 A Rear one-touch electric windows, exterior door
opening controls.

F7 5 A Front and rear courtesy lamps, map reading lamps,
sun visor lighting, glove box lighting.

F8 20 A
Audio equipment, audio/telephone, multifunction sc reen,
tyre under-infl ation detection, interior storage co mpartments.

F9 30 A Front 12 V socket, cigar lighter.

F10 15 A Steering mounted controls, alarm siren, alarm
control unit.

F11 15 A Low current ignition switch.

10
150
PRACTICAL INFORMATION

Fuse N° Rating Functions

F12 15 A Instrument panel, seat belt and passenger’s front
airbag warning lamps display, air conditioning,
driver’s seat memory unit, retractable roof unit.

F13 5 A Engine fusebox, airbags.

F14 15 A Multifunction screen, amplifi er, hands-free kit,
rain/sunshine sensor, parking sensors control unit,
passenger’s seat memory unit.

F15 30 A Locking and deadlocking.

F17 40 A Rear screen and door mirrors demist/defrost.

SH - PARC shunt.

Fuse N° Rating Functions

G36 30 A Driver and passenger heated seats.

G37 5 A Trailer fusebox.

G38 30 A Driver’s seat memory unit.

G39 - Not used.

G40 30 A Hi-Fi amplifi er, passenger’s seat memory unit.

10
151
PRACTICAL INFORMATION
Engine compartment fuses
The fusebox is placed in the engine
compartment near the battery (left-hand
side).
Access to the fuses

 Unclip the cover.

 Change the fuse (see correspond-
ing paragraph).

 When you have fi nished, close the
cover carefully to assure the sealing
of the fusebox. Fuse table

Fuse N° Rating Functions

F1 20 A Engine control unit supply, injection pump and EGR
electrovalves (2 litre HDI), injectors (2 litre HDI).

F2 15 A Horn.

F3 10 A Front wash-wipe.

F4 20 A Headlamp wash.

F5 15 A Purge canister, turbine discharge and Turbo
pressure regulation electrovalves (1.6 l THP 16V),
oil vapour heater (1.6 litre THP 16V), Diesel heater
(1.6 litre HDI).

F6 10 A Vehicle speed sensor, ABS/ESP control unit.

F7 10 A Power steering control unit, automatic gearbox,
engine coolant level detector.

F8 25 A Starter motor control.

F9 10 A Diagnostic socket, directional headlamps, air
fl ow sensor (Diesel), particle emission fi lter pump
(Diesel), door mirror controls.

F10 30 A Engine control unit actuators (petrol: ignition co
ils,
electrovalves, oxygen sensors, injectors, heaters, fuel
pump, electronic thermostat) (Diesel: electrovalves ,
heaters).

F11 40 A Air conditioning blower.

10
152
PRACTICAL INFORMATION

Fuse N° Rating Functions

F12 30 A Windscreen wipers slow/fast speed.

F13 40 A Built-in systems interface supply (ignition positive).

F14 - Not used.

F15 10 A Right-hand main beam headlamp.

F16 10 A Left-hand main beam headlamp.

F17 15 A Left-hand dipped headlamp.

F18 15 A Right-hand dipped headlamp.

F19 15 A Oil vapour heater (1.6 litre VTi 16V), purge canister
electrovalve (1.6 litre VTi 16V), oxygen sensors
(petrol), air cooling electrovalves (Diesel).

F20 10 A Electronic thermostat, variable timing electrovalves,
Turbo pressure regulation electrovalve (Diesel),
engine coolant level detector (Diesel).

F21 5 A Fan assembly relay supply, Valvetronic relay
control (1.6 litre VTi 16V), Turbo cooling
(1.6 litre THP 16V), air fl ow sensor (1.6 litre HDI).

10
153
PRACTICAL INFORMATION
* The midi-fuses and maxi-fuses pro-vide additional protection for the
electrical systems. All work on these
types of fuse must be carried out by a
PEUGEOT dealer.
Fuse N° Rating Functions

F1 - Not used.

F2 5 A Dual-function brake switch.

F3 5 A Battery charge unit.

F4 25 A ABS/ESP electrovalves.

F5 - Not used.

F6 15 A Automatic gearbox.

F7 * 80 A Power steering electropump assembly.

F8 * 60 A Fan assembly.

F9 * 70 A/30 A Pre-heat unit (Diesel)/Valvetronic electric motor
(1.6 litre THP 16V).

F10 * 40 A ABS/ESP electropump assembly.

F11 * 100 A Switching and protection unit.

F12 * - Not used.
Table of maxi-fuses

Fuse N° Rating Functions

MF1 * - Not used.

MF2 * 30 A Trailer fusebox.

MF3 * 50 A Passenger compartment fusebox.

MF4 * 80 A Built-in systems interface.

MF5 * 80 A Built-in systems interface.

MF6 * - Not used.

MF7 * 30 A Heated seats.

MF8 * 20 A Headlamp wash.
Table of mini and midi-fuses over the battery

10
i
154
PRACTICAL INFORMATION
BATTERY
Access to the battery Starting using another battery

 Connect the red cable to the posi-
tive terminal (+) of the fl at battery A ,
then to the positive terminal (+) of
the slave battery B .
The battery is located under the bonnet.
For access to it:

 open the bonnet using the interior
release lever, then the exterior safety
catch,

 secure the bonnet stay,

 remove the plastic cover to gain
access to the two terminals,

 unclip the fusebox to remove the
battery, if necessary. Disconnecting the cables

 Raise the locking tab fully.
Reconnecting the cables

 Position the open clip 1 of the cable
on the positive terminal (+) of the
battery.

 Press vertically on the clip 1 to posi-
tion it correctly against the battery.

 Lock the clip by lowering the tab 2 .
Do not force the tab as locking will
not be possible if the clip is not po-
sitioned correctly; start the proce-
dure again.

10
!
i
155
PRACTICAL INFORMATION

 Connect one end of the green or black cable to the negative terminal (-)
of the slave battery B .

 Connect the other end of the green
or black cable to the earth point C
on the broken down vehicle.

 Operate the starter, let the engine
run.

 Wait until the engine returns to idle
and disconnect the cables. Do not disconnect the terminals
while the engine is running.
Do not charge the batteries without
disconnecting the terminals fi rst.
The batteries contain harmful sub-
stances such as sulphuric acid and
lead. They must be disposed of in
accordance with regulations and
must not, in any circumstances, be
discarded with household waste.
Take used remote control batteries
and vehicle batteries to a special
collection point.
Charging the battery using
a battery charger

 Disconnect the battery from the
vehicle.

 Follow the instructions for use pro-
vided by the manufacturer of the
charger.

 Reconnect starting with the nega-
tive terminal (-).


Check that the terminals and connec-
tors are clean. If they are covered with
sulphate (whitish or greenish deposit),
remove them and clean them.

To avoid discharging the battery,
do not leave the lights on repeat-
edly with the ignition off (refer to
the "Energy economy mode" para-
graph).
It is advisable to disconnect the
battery if the vehicle is to be left un-
used for more than one month. Before disconnecting the battery
Wait 2 minutes after switching off
the ignition before disconnecting
the battery.
Close the roof, the windows and
the doors before disconnecting the
battery.
Following reconnection of the
battery

Following reconnection of the bat-
tery, switch on the ignition and wait
1 minute before starting to permit
initialisation of the electronic sys-
tems. However, if slight diffi culties
are encountered following this ope-
ration, contact a PEUGEOT dealer.

Referring to the corresponding sec-
tion, you must yourself reinitialise:
- the remote control key,
- the electric windows and the automatic partial opening of the
door windows,
- the GPS satellite navigation system.