Peugeot 308 Dag 2007.5 Owner's Guide

23
Engine autodiagnostics system.
If this comes on, it indicates the occurrence of a fault in the en-gine management system.
If it flashes, it indicates the occurrence of a fault in the emission control sys-tem.
Low fuel level.
If this comes on, it indicates that you only have enough fuel left to drive approximately 30 miles (50 km).
The capacity of the tank is approximate-ly 60 litres.
Maximum coolant temperature.
If this comes on, it indicates that the temperature in the cooling system is too high. Stop the vehicle im-mediately and as safely as possible.
Air bags.
If this comes on, it indicates the occurrence of a fault in one of the air bag or seat belt preten-sioner systems.
Seat belt not fastened/unfastened.
If this comes on, it indicates that the driver and/or the front passenger has not fastened or has un-fastened his seat belt.
It also indicates that one or more rear passengers have unfastened their seat belt.
Water in diesel.
If this comes on, it indicates the presence of water in the diesel filter.
There is a risk of damage to the injection system on Diesel engines.
Door open.
A door, the boot or the bonnet* is open:
- if the speed is below 6 mph (10 km/h), this warning light comes on continuously.- if the speed is higher than 6 mph (10 km/h),this warning light comes on continuously, accompanied by an audible signal.
Battery charge.
If this comes on, it indicates the occurrence of a fault in the battery charging circuit (dirty or loose terminals, slack or cut alternator belt, ...).
Engine oil pressure.
If this comes on, it indicates the occurrence of a fault in the en-gine lubrication circuit. Stop the vehicle immediately and as safely as possible.
Specific warning lights
* Only with alarm.

i
!
24
Specific warning lights
The other warning lights appear on the large display, located in the centre of the instrument panel.
Depending on the seriousness of the fault, they may be displayed in orange or red.
Directional headlamps.
If this flashes, it indicates the occurrence of a fault in the di-rectional headlamps system.
Engine oil pressure.
If this is displayed, it indicates the occurrence of a fault in the engine lubrication circuit. Stop the vehicle immediately and as safely as possible.
Service.
If this is displayed, it indicates the occurrence of a fault in one of the following:
- the engine management system,- the emission control system,- the lane departure warning system.
Engine autodiagnostics system.
If this is displayed, it indicates the occurrence of a fault in the engine management system.
Engine oil level.
If this is displayed, it indicates an insufficient level of oil in the engine. Stop the vehicle imme-diately and as safely as possible.
Coolant temperature.
If this is displayed, it indicates that the temperature in the cooling system is too high. Stop the vehicle immediately and as safely as possible.
Coolant level.
If this is displayed, it indicates an insufficient level of coolant in the circuit. Stop the vehicle im-mediately and as safely as possible.Battery charge.
If this is displayed, it indicates the occurrence of a fault in the battery charging circuit (dirty or loose terminals, slack or cut alternator belt, ...).

Air bags.
If this is displayed, it indicates the occurrence of a fault in one of the air bag or pretensioning seat belt systems.
Braking.
If this is displayed, it indicates the occurrence of a fault in one of the braking systems:
- significant drop in the level in the cir-cuit,- electronic brake force distribution (EBFD) faulty (simultaneous lighting of the ABS warning light). Stop the vehicle immediately and as safely as possible.
If the vehicle is moving, check that the handbrake is released fully.
Anti-lock braking system (ABS).
If this is displayed, it indicates the occurrence of a fault in the anti-lock braking system.
However, this does not prevent opera-tion of the vehicle’s assisted braking.
Dynamic stability control (ESP/ASR).
The ESP/ASR system is put into service automatically when the vehicle is started.Unless the system has been deacti-vated, if this warning light and the indi-Unless the system has been deacti-Unless the system has been deacti-
cator light on the button come on, this indicates the occurrence of a fault in the cator light on the button come on, this cator light on the button come on, this
ESP/ASR system or in the hill start as-sistance.
Power steering.
If this is displayed, it indicates the occurrence of a fault in the power steerin. Stop the vehicle immediately and as safely as possible.
Door open.
A door, the boot or the bonnet* is open:
- if the speed is below 6 mph (10 km/h), this warning light is displayed in or-ange,- if the speed is higher than 6 mph (10 km/h),this warning light is displayed in red.
Ice warning.
If this is displayed, it indicates that there is risk of the forma-tion of ice on the road below a temperature of 3 °C.
Drive carefully.
Handbrake.
If this is displayed, while the ve-hicle is moving, it indicates that the handbrake has not been re-leased fully.
Electronic immobiliser.
If this is displayed, it indicates the occurrence of a fault in the electronic engine immobiliser system or that the remote control bat-tery is flat.
* Only with alarm.
Fuel level.
If this is displayed, it indicates that there is only enough fuel If this is displayed, it indicates If this is displayed, it indicates
remaining to drive approximate-ly 30 miles (50 km).remaining to drive approximate-remaining to drive approximate-
The capacity of the tank is approximate-ly 60 litres.
Screenwash fluid level.
If this is displayed, following an action on the wipers stalk, it in-dicates an insufficient level of fluid.
Fill the screenwash/headlamp wash flu-id reservoir when you stop.

26
Water in diesel.
If this is displayed, it indicates the presence of water in the diesel filter.
There is a risk of damage to the injec-tion system on Diesel engines.
Automatic headlamp adjustment.
If this is displayed, it indicates the occurrence of a fault in the automatic headlamp adjust-ment.
Particle emission filter (Diesel).
If this is displayed, linked with the service warning light, it indi-cates the start of saturation of the parti-cle emission filter or a low diesel additive reservoir level.
As soon as traffic conditions permit, re-generate the filter by driving at a speed of at least 40 mph (60 km/h) until the service warning light is switched off.
If the service warning light is still dis-played, the additive level is low. Have it topped up by a PEUGEOT dealer with-out delay.
Deflated wheel.
If this is displayed, it indicates an insufficient pressure in one or more wheels.
Check the pressure of the tyres as soon as possible.
Punctured wheel.
If this is displayed, it indicates that one or more wheels are punctured. Stop the vehicle im-mediately and as safely as possible.
Change the damaged wheel and have it repaired by a PEUGEOT dealer.
Tyre under-inflation detection.
If this is displayed, it indicates the occurrence of a fault on one of the sensors or in the tyre under-infla-tion detection system.
It may also indicate the absence of a sensor when the spare wheel, which does not have a sensor, is fitted in place of a puntured wheel.
Automatic switching on of the lights.
If this comes on, it indicates the occurrence of a fault in the au-tomatic switching on of the lights.
Use the other positions of the lights stalk.
Visual and/or audible parking assistance.
If this comes on, in forward and/or reverse gear, it indicates a fault in the parking assistance system.
6-speed piloted manual gearbox or automatic gearbox.
If this is displayed, it indicates the occurrence of a fault in the 6-speed piloted manual gearbox or automatic gearbox. The gearbox will then oper-ate in down-grade mode, locked on 3rd gear.
Invalid value.
If this is displayed, it indicates the occurrence of a fault in the programme of the 6-speed pi-loted manual gearbox or auto-matic gearbox.
Position P or N.
If this is displayed, it indicates that the gear lever must be placed in position P or N in or-der to start the engine.

27
Coolant temperature indicator
System which informs the driver of the changes in the temperature of the en-gine coolant while driving.
With the engine running, when the nee-dle is:
- in zone A, the temperature is correct,- in zone B, the temperature is too high; the max temperature warning light 1and the central STOP warning light come on, accompanied by an audible signal and a message on the multi-function display.You MUST stop as soon as it is safe to do so.
Wait a few minutes before switching off the engine.
Contact a PEUGEOT dealer.
After driving for a few minutes, the tem-perature and pressure in the cooling system increase.
To top up the level:
 wait for the engine to cool,
 unscrew the cap by two turns to al-low the pressure to drop,
 when the pressure has dropped, re-move the cap,
 top up the level to the "MAX" mark.
Manual CHECK
System which informs the driver of the warnings present and of the activated or deactivated status of the functions.
 With the engine running, to start a manual check, press the "CHECK/000" button on the instrument panel.
If no "major" faults have been detected, "CHECK OK" appears on the large in-strument panel display.
If a "minor" fault has been detected, the warning lights concerned then "CHECK OK" appear on the large instrument panel display. Contact a PEUGEOT dealer as soon as possible.
If a "major" fault has been detected, only the warning lights concerned appear on the large instrument panel display. Con-tact a PEUGEOT dealer without delay.

28
Service indicator
System which informs the driver when the next service is due, in accord-ance with the manufacturer’s servicing schedule.
The point at which the service is due is calculated from the last indicator zero re-set. It is determined by two parameters:
- the distance travelled,- the time elapsed since the last service.
Between 600 miles (1 000 km) and 1 800 miles (3 000 km) remain before the next service is due
For 5 seconds after the ignition is switched on, the spanner symbolising the service operations comes on. The distance recorder display line indicates the distance remaining before the next service is due.
Example: 2 800 km remain before the next service is due.
For 5 seconds after the ignition is switched on, the display indicates:
5 seconds after the ignition is switched on, the spanner is switched off; the distance recorder resumes its normal operation. The display then indicates the total and trip distances.
Less than 600 miles (1 000 km) remain before the next service is due
Example: 900 km remain before the next service is due.
For 5 seconds after the ignition is switched on, the display indicates:
5 seconds after the ignition is switched on, the distance recorder resumes its normal operation. The spanner re-mains on to indicate that a service must be carried out soon.
More than 1 800 miles (3 000 km) remain before the next service is due
When the ignition is switched on, no service information appears on the dis-play.

i
i
29
Service indicator zero reset
After each service, the service indicator must be reset to zero.
To do this, carry out the following pro-cedure:
 switch off the ignition,
 press and hold the trip distance re-corder zero reset button,
 switch on the ignition; the distance recorder display begins a count-down,
 when the display indicates "=0", re-lease the button; the spanner disap-pears.
Service overdue
For 5 seconds after the ignition is switched on, the spanner flashes to indicate that the service must be carried out as soon as possible.
Example: the service is overdue by 300 miles (km).
For 5 seconds after the ignition is switched on, the display indicates:
5 seconds after the ignition is swit-ched on, the distance recorder resu-mes its normal operation. The spanner remains lit.
Retrieving the service information
You can access the service information at any time.
 Press the trip distance recorder zero reset button.
The service information is displayed for a few seconds, then disappears.

i
30
Engine oil level indicator
System which informs the driver of the validity or invalidity of the engine oil level.
This information is indicated for a few seconds when the ignition is switched on, after the service information.
Oil level correct
Lack of oil
Oil level gauge fault
Dipstick
This is indicated by the flashing of "OIL", linked with the service warning light, ac-companied by an audible signal and a message on the multifunction display.
If the lack of oil is confirmed by a check using the dipstick, it is essential that the level is topped up to prevent damage to the engine.
This is indicated by the flashing of "OIL --". Contact a PEUGEOT dealer.
Refer to the "Checks" section to locate the dipstick and the oil filler cap on your engine.
There are 2 marks on the dipstick:
- A = max; never exceed this level,- B = min; top up the level via the oil filler cap, using the type of oil suited to your engine.

31
Total distance recorder
System which measures the total dis-tance travelled by the vehicle during its life.
Lighting rheostat
System for manual adjustment of the brightness of the instruments and con-trols in relation to the exterior bright-ness.
The total and trip distances are dis-played for thirty seconds when the ig-nition is switched off, when the driver’s door is opened and when the vehicle is locked or unlocked.
Trip distance recorder
System which measures a distance travelled during a day or other period until it is reset to zero by the driver.
 With the ignition on, press the button until zeros appear.
Activation
When the lights are on:
 press the button to change the brightness of the instruments and controls,
 when the lighting reaches the mini-mum setting, release the button, then press again to increase it,
or
 when the lighting reaches the maxi-mum setting, release the button, then press again to reduce it,
 when the lighting reaches the level of brightness required, release the button.
Deactivation
When the lights are off, or in day mode on vehicles fitted with daytime lights, pressing the button does not have any effect.

32
Displays on the screen
This displays the following information:
- the time,- the date,- the outside temperature* (this flashes if there is a risk of ice),- the status of the accesses (doors, boot, ...),- the trip computer (refer to the end of the section).
Warning messages (e.g.: "Emission control system faulty") or information messages (e.g.: "Boot open") may ap-pear temporarily. These can be cleared by pressing the "ESC" button.
MONOCHROME SCREEN A
(without RD4 audio equipment)ControlsGeneral menu
There are three display control buttons:
- "ESC" to abandon the operation in progress,- "MENU" to scroll through the menus or sub-menus,- "OK" to select the menu or sub-menu required.
 Press the "MENU" button to scroll through the various menus of the general menu:
- vehicle configuration,
- options,
- display settings,
- languages,
- units.
 Press the "OK" button to select the menu required.
* With air conditioning only.