display Peugeot 406 2002.5 Owner's Manual

Page 2 of 174

29-07-2002
10 Instrument dials.
11 Driver's air bag.
Horn.
12 Windscreen washwipe
stalk.
Trip computer stalk.
13 Radio remote control stalk.
14 Steering lock and ignition.
15 Electric mirror controls.
Window controls.
Rear window locking
control.
16 Electronic Stability
Programme (ASR/ESP)
switch.
17 Headlamp height adjust
ment.
18 Fuse box. 19
Steering wheel adjustment.
20 Cruise control
21 Rear ashtray.
22 Cupholder.
23 Handbrake.
24 Heated seat switches.
Passenger air bag
disarming switch.
Alarm button
25 Lighter.
26 Rear footwell heating vent.
27 Front ashtray.
28 Gear lever.
29 Radio.
30 Heating/ventilation controls.
31 Multifunction display.
YOUR 406 AT A GLANCE
3
1 Speaker (tweeter) location.
2 Window demisting vent.
3 Side adjustable heating/
ventilation vent and air flow
regulation.
4 Glove box.
5 Passenger air bag.
6 Windscreen demisting vents.
7 Central adjustable heating/
ventilation vents and air flow
regulation.
8 Hazard warning lights switch.
9 Lights and direction indica
tors stalk.
Arming/disarming of auto
matic switching on of lights.

Page 6 of 174

YOUR 406 AT A GLANCE
8
SIDE AIR BAGS
Side air bags are incorporated
into the backs of the front seats,
on the door side.
They are triggered individually,
on whichever side the collision
occurs.
Operating check
This is by means of the warning
light on the instrument panel.
It comes on for 6 seconds when
the ignition is switched on.
If the warning light :
does not come on when the ignition is switched on or,
does not go out after six seconds,
contact a Peugeot dealer.
Passenger air bag precautions
For a vehicle fitted with a disar
ming switch:
disarm the airbag if you ins
tall a rear
facing child
seat.
arm the air bag for an
adult passen
ger.
For a vehicle not fitted with a
disarming switch: do not install rearfacing child seats
on the front passen
ger seat.
Never place your feet or any
object on the fascia.
FRONT AIR BAGS
Disarming the passenger
air bag
 Insert the ignition key in switch
1and turn it:
to the "ON"position, the pas
senger air bag is armed
to the "OFF"position, the pas
senger air bag is disarmed.
Operating check
This symbol lights for approxima
tely six seconds when the igni
tion is switched on.
With the ignition on (2nd notch),
illumination of this warning light
accompanied by an audible signal
and the message "Passenger air
bag disarmed" on the multifunc
tion display indicates that the pas
senger air bag is disarmed (swit
ch in the "OFF"position).
The warning light remains on
throughout the disarming process.
29-07-2002
151

Page 16 of 174

29-07-2002
SERVICE INDICATOR
This is a visual reminder of when the
next service is due. This service is to
be carried out according to the man
ufacturer's servicing schedule.
Operation
As soon as the ignition is switched
on and for 5 seconds, the spanner
symbolising ''service operation'' is lit.
The trip recorder display shows you
the distance remaining (in round fig
ures) before the next service.
Example:4,800 miles remain before
the next service is due. When the
ignition comes on and for 5 seconds
the display indicates:
5 seconds after the ignition is
switched on, the total distance
recorder resumes normal operation
and the display shows the total or trip
distances.The distance remaining before the
next service is less than 1,000 miles.
Example: 900 miles remain before
the next service is due.
When switching on the ignition and
for 5 seconds, the display shows:
5 seconds after the ignition is
switched on, the total distance
recorder resumes normal operation
and the symbol remains lit.
This indicates that a service should
be carried out shortly. The display
shows the total or trip distances. The service is overdue
Each time the ignition is switched on
and for 5 seconds, the symbol and
the excess distance flash.
Example:
the service is overdue by
300 miles. The service should be
carried out very shortly.
When the ignition is switched on and
for 5 seconds, the display shows:
5 seconds after the ignition is
switched on, the total distance
recorder resumes normal operation
and the symbol remains lit. The dis
play shows the total or trip distances.
YOUR 406 IN DETAIL
133

Page 17 of 174

29-07-2002
Resetting the service indicator
Your PEUGEOT dealer carries out
this operation after each service.
However, if you carry out the service
yourself, the reset procedure is as
follows: – Switch off the ignition.
– Press and hold button 1.
– Switch on the ignition.
The display begins a 10 second
countdown. – Keep button 1pressed for
10 seconds.
The display shows [= 0] and the ser
vice symbol disappears.
YOUR 406 IN DETAIL
134

Page 28 of 174

WARNING LIGHTS AND INDICATORS
A permanently lit warning light, or flashing with the engine running, is an
indication of a malfunction in the relevant unit. Some warn ing lights may
be linked to buzzers and a message on the multi–function display. Do n ot
ignore this warning: contact a PEUGEOT dealer as quickly a s possible.
If the Central (STOP) warning light comes on when you are d riving, stop
your vehicle immediately where it is safe to do so.
Central (STOP) warning light
Linked to the "engine oil pressure", ''the low brake fluid l evel'', '' the
coolant temperature gauge'' and ''electronic brake force distrib u
tion system fault'' warning lights.
It comes on each time the ignition is switched on.
Stop immediately if it flashes with the engine running.
Contact a PEUGEOT dealer.
Engine oil pressure warning light
Linked to the central (STOP) warning light.
Stop immediately if it comes on with the engine running.
It indicates either:
– insufficient oil pressure,
– lack of oil in the lubrication circuit. Top up the oil le vel.
Contact a PEUGEOT dealer as soon as possible. Low coolant level
warning light
Stop immediately.
Allow the engine to cool before top
ping up.
The cooling system is pressurised.
In the event of a breakdown and to
prevent the risk of scalding, turn the
cap to the first notch to allow the
pressure to drop.
Once the pressure has dropped,
remove the cap and top up the level.
Contact a PEUGEOT dealer.
Fuel filler cap warning
light
This comes on if the fuel
cap is not correctly screwed
on or is missing.
YOUR 406 IN DETAIL
128
29-07-2002

Page 29 of 174

Handbrake, low brake fluid level and electronic brake force
distribution warning light.
This comes on each time the ignition is switched on.
It indicates either:
– that the handbrake is on or has not been released correctly,
and when coupled with the central (STOP) warning light:
– an excessive drop in the brake fluid level (if the light remai ns on even with the
handbrake released),
– lit at the same time as the ABS warning light, it indicates a malfunction of the
electronic brake force distribution system.
Stop immediately.
Contact a PEUGEOT dealer.
Antilock braking system (ABS) warning light
This comes on for 3 seconds each time the ignition is switched o n.
If it comes on at over 8 m.p.h. (12 km/h), it indicates a malfun ction of the
ABS.
However, the vehicle retains conventional servoassisted braking.
Contact a PEUGEOT dealer.
Clogging of the
particulate emission
filter warning light
(diesel engine)
Display of this warning light is
accompanied by an audible signal.
The flashing of this light while the
engine is running is caused either by
the particulate emission filter being
overloaded or by the engine running
too long at idle (white smoke from
the exhaust). There is a risk of the fil
ter clogging if the same conditions of
operation are maintained.
As soon as possible, drive for at
least three minutes at a speed
exceeding 37 m.p.h. (60 km/h), if dri
ving conditions allow this.
If the light comes on, contact a
PEUGEOT dealer as soon as
possible. Front brake pad wear warning light
For your safety, have the pads replaced as soon as this light co
mes on.
YOUR 406 IN DETAIL 129
ESP Electronic
Stability Programme
operation indicator
light
This flashes when the system is
operating.
It is lit continuously if disarmed or if
there is a fault.
29-07-2002

Page 30 of 174

29-07-2002
Passenger air bag
disarming
warning light
Illumination of this warning
light is accompanied by an audible
signal and a message on the multi
function display.
If the passenger air bag is disarmed,
the indicator light comes on when
the ignition is switched on and
remains on.
In all cases, if the warning light flash
es, contact a PEUGEOT dealer.
Air bag warning light
The warning light comes on
for 6 seconds when the igni
tion is switched on.
Illumination of this warning light, with
the engine running, is accompanied
by an audible signal and a message
on the multifunction display indicat
ing the cause of the front or side air
bag fault.
Contact a PEUGEOT dealer.
Water in diesel filter warning light
(according to destination)
Contact a PEUGEOT dealer as soon as possible.
There is a risk of damage to the injection system.
Diesel preheating indicator light
If the engine is warm enough, the light will not come on
and you can
start the engine without waiting.
If the light comes on, wait until it goes out before tryin g the starter.
Engine diagnostics warning light
This comes on each time the ignition is switched on.
If it is lit continuously with the engine runnning, this
indicates a fault in
the emission control system.
If it flashes with the engine running, this indicates a ma lfunction in the injection
or ignition system. There is a risk of damage to the catalytic con verter (petrol
engine only).
Contact a PEUGEOT dealer as soon as possible. Battery charge warning light
This comes on each time the ignition is switched on.
If it comes on with the engine running it can indicate:
– faulty operation of the charging circuit,
– loose battery or starter terminals,
– a cut or slack alternator belt,
– an alternator fault.
Contact a PEUGEOT dealer. YOUR 406 IN DETAIL
130

Page 33 of 174

29-07-2002
PETROL / LPG DUALFUEL VERSION165
Operation
The twin fuel system allows either
petrol or liquid petroleum gas (LPG)
to be used.
Press switch 1 in the centre of the
centre console.
Different statuses of indicator light
2 :
– flashing; request for operation using LPG,
– fixed; operating using LPG,
– off; operating using petrol.
Starting
Irrespective of the position of switch 1, the engine starts using petrol.
The switch to operation using LPG will take place if switch 1 is in the LPG
position. The LPG indicator light flashes until the engine reaches an adequa te
temperature.
The switch from one fuel to the other is displayed by the swi tching on/switching
off of indicator light 2.
When the minimum LPG level is reached, while driving, this is i ndicated by flashing
of switch 2; the system then switches to operation using petrol automatica lly.
It is advisable to drive in petrol mode from time to time to keep the petrol
injection system in good condition. If switch
2 flashes rapidly, move switch 1 to the petrol position, then
return to LPG mode.
If switch 2 still flashes rapidly, consult a PEUGEOT dealer.

Page 34 of 174

29-07-2002
Lighting
rheostat
With the lights on, press the button to
vary the intensity of the lighting of the
instruments and controls. When the
lighting reaches the minimum (or
maximum) setting, release the but
ton then press it again to increase (or
reduce) the brightness.
As soon as the lighting is of the
required brightness, release the
button.
Trip recorder
zero reset
With the ignition on, press the button. Instrument panel display
After switching on the ignition, three functions are shown i
n succession:
engine oil level indicator,
service indicator,
total distance recorder.
Engine oil level
When the ignition is switched on, the engine oil level indicator is displayed
for approximately five seconds, then the service indicator is displa yed for
five seconds.
Maximum
Use the dipstick to confirm the level on the indicator; a surpl us of
oil can cause damage to the engine.
Contact a PEUGEOT dealer as soon as possible.
Minimum
Check the level with the dipstick and top it up. The indi cation is
only correct if the vehicle has been on stable, level ground, with
the engine stopped, for 10 minutes.
No oil
It is essential to top up the oil to the correct level, oth erwise there
is a risk engine will be damaged.
YOUR 406 IN DETAIL
132

Page 35 of 174

29-07-2002
Display BThis enables the following information to be displayed:
– the time,
– the date,
– the outside temperature (the °C symbol flashes when there is a risk of ice),
– the radio displays,
– the status of the doors. The display shows you whether a doo r, the boot or the
bonnet is open and if the fuel filler cap is missing.
– the warning messages (e.g. ''battery low'') or information messa ges (e.g. "top
up fuel tank''), displayed temporarily, can be cleared by pressin g button 1or 2
– the trip computer.
Setting the parameters
Press button 1for two seconds to access the settings. The information flashes
to show it is ready to be modified.
Then, individual presses on button 1 allow you to scroll through the various data
in the following sequence:
– language in which the information is displayed,
– unit of distance (kms or miles),
– unit of temperature (Celsius or Fahrenheit),
– time format (12 then 24 hour mode)
– hour,
– minutes,
– year,
– month,
– day,
Pressing button 2allows you to change the information selected. Maintain the
pressure for rapid scrolling.
After ten seconds without action, the display returns to the ma in screen and the
modified data are recorded.
YOUR 406 IN DETAIL 135

Page:   1-10 11-20 21-30 31-40 41-50 ... 50 next >