Peugeot 407 2008 Workshop Manual

Page 51 of 204

3COMFORT
MANUAL STEERING WHEEL HEIGHT AND DEPTH ADJUSTMENT
ELECTRIC ADJUSTMENT OF THE HEIGHT AND DEPTH OF THE STEERING WHEEL
WELCOME FUNCTION
You can activate or deac-
tivate this function via the
"personalisation-configu-
ration" menu on the multi-
function display.
When the vehicle is stationary, unlock
the steering wheel by pushing the con-
trol forwards.
Adjust the height and depth of the
steering wheel then lock by pulling the
control fully.
When stationary, adjust the height or
depth of the steering wheel by moving
the control:

 forwards or backwards to adjust
the depth.

 up or down to adjust the height. When the driver’s door is opened with
the ignition off, the steering wheel ris-
es to make access to or exit from the
vehicle easier.
Reinitialisation
Following reconnection of the battery,
the welcome function must be reinitial-
ised:
- move the control in the direction of
the required adjustment,
- release the control,
- move the control again until it reaches its stop.
This procedure must be carried out for
all four directions.

Page 52 of 204

3COMFORT
53
FRONT SEATS
Manual mode
Longitudinal adjustment
Lift the control bar and slide the seat
forwards or backwards. Driver’s seat cushion height and
angle adjustment
Pump up or down to the required posi-
tion. Seat back angle adjustment
Operate the lever for your comfort.

Page 53 of 204

3COMFORT
54
Electric mode
Longitudinal adjustment
Push the control forwards or back-
wards to slide the seat. Driver’s seat cushion height and
angle adjustment

Height: tilt the rear of the control up
or down.

Tilt: tilt the front of the control up or
down. Seat back angle adjustment
Tilt the control forwards or backwards
for your comfort.
The electrical functions of the driver’s seat are deactivated one minute after the ignition is switched off.
To reactivate them, open the door or switch on the ignitio n.

Page 54 of 204

3COMFORT
55
Head restraint height and angle
adjustment Front seat active head restraint
This system prevents "whiplash".
In the event of a rear impact, the action
of the body on the seat back moves
the head restraint forwards and up-
wards preventing the head from being
thrown back.
Front armrest
Driver’s seat lumbar adjustment
Heated seats adjustment

0: Off.

1: Low.
2: Medium.

3: High. The adjustment is correct when
the top of the head restraint is
aligned with the top of the head
of the occupant of the seat.
Never drive with the head re-
straints removed and stored in
the vehicle. This is dangerous
and they may be thrown in the
event of sharp braking. They must be
in place and adjusted correctly. To change the position of the armrest:

 Lift the handle 1 .
The armrest folds forwards and up-
wards.
To return to the initial position, push
the armrest backwards and press it to
engage.
Operate the lever to obtain the correct
position.
To raise or lower the head restraint,
pull it forwards then slide it.
To tilt the head restraint, tilt the lower
part forwards or backwards.
To remove the head restraint, move it
almost to the highest position, lift the
tab using a coin and pull it forwards
and upwards at the same time.
To refi t the head restraint, engage the
stalks in the holes keeping in line with
the seat back.
With the engine running, turn the dial.
The temperature of the seat is regu-
lated automatically.

Page 55 of 204

3COMFORT
56
Memorising driving and mirror
positions Memorising using the controls on
the driver’s door
To memorise:

 Place the key in the ignition on po-
sition,

 Adjust your seat and mirrors,

 Press button M , then button 1 "fi rst
driving position" or button 2 "sec-
ond driving position" within four
seconds.
An audible signal confi rms that a posi-
tion has been memorised.
Memorising a new position cancels
the previous one. Recalling a memorised driving
position
Ignition on, vehicle stationary

 Briefl y press button 1 or 2 to recall
the corresponding memorised po-
sition. The end of the setting is in-
dicated by a bleep.
After recalling a memorised position
a few times in succession, the func-
tion will be cancelled until the engine
is started.
The electrical adjustments of the seat
and exterior mirrors are memorised.
Two driving positions can be memo-
rised using buttons M/1 and M/2 . Vehicle moving

 Keep button 1 or 2 pressed down
until the bleep indicates that setting
of the corresponding memorised
position is complete.

Page 56 of 204

3COMFORT
57
REAR SEATS (SALOON)

Note: the seat cushion 1 can be re-
moved with care to increase the vol-
ume of the load space.
Squeeze the seat cushion fi xings to
detach them from their fastenings.
When repositioning:

 fold up the seat back 2 and lock it
(the red marker of control 3 should
no longer be visible),

 fold up the seat 1 ,

 refi t the head restraints if they were
removed. Locking/unlocking the access
to the boot via the rear seats
Your vehicle’s boot can be isolated
from the passenger compartment.
The red indicator on the control
3
should no longer be visible. If it is,
push the seat fully.
Insert the ignition key in the lock 4 .
Take care not to trap the seat
belt and to position the buckle
of each strap correctly in its
respective clasp before folding
down the seat back. This will enable
you to reposition the seat backs with
their seat belts and clasps ready to ac-
commodate your rear passengers.
To fold down the rear left seat or the
rear right seat, always start with the
seat, never with the seat back (risk of
damage):

 move the front seat(s) forward if
necessary,

 place the head restraints in the low
position or remove them if neces-
sary,
Check that the seat belt strap is posi-
tioned correctly at the side of the seat
back,
Ensure that the side seat belt straps
are fastened in their clasp (the centre
seat belt must not be fastened),

 lift the front of the seat cushion 1 ,

 tilt the seat cushion 1 against the
front seat(s),

 pull control 3 forwards to unlock
the seat back 2 ,

 fold down the seat back 2 .

Page 57 of 204

3COMFORT
58
REAR SEATS (407 SW)

Note: the seat cushion 1 can be re-
moved with care to increase the vol-
ume of the load space.
Squeeze the seat cushion fi xings to
detach them from their fastenings.
When repositioning:

 fold up the seat back 2 and lock it
(the red marker of control 3 should
no longer be visible),

 fold up the seat 1 ,

 refi t the head restraints if they were
removed. Take care not to trap the seat
belt and to position the buckle
of each strap correctly in its
respective clasp before folding
down the seat back. This will enable
you to reposition the seat backs with
their seat belts and clasps ready to ac-
commodate your rear passengers.
To fold down the rear left seat or the rear
right seat, always start with the seat, nev-
er with the seat back (risk of damage):

 move the front seat(s) forward if
necessary,

 place the head restraints in the low
position or remove them if neces-
sary,
Check that the seat belt strap is posi-
tioned correctly at the side of the seat
back,
Ensure that the side seat belt straps
are fastened in their clasp (the centre
seat belt must not be fastened),

 lift the front of the seat cushion 1 ,

 tilt the seat cushion 1 against the
front seat(s),

 pull control 3 forwards to unlock
the seat back 2 ,

 fold down the seat back 2 .

Page 58 of 204

3COMFORT
59
TRANSPORTING LONG OBJECTS (407 SW)
Rear seat (see corresponding
paragraph):

 Tilt the seat cushion,

 Remove the head restraints,

 Tilt the seat back.
Note: when repositioning, en-
sure that the front and rear
seat backs are secured cor-
rectly.
Precautions
- The long object must be placed on the end of the front
seat back and on the rear
seat cushion.
- Do not place a load in excess of 30 kg on the front of the seat
back.
- Do not load blunt objects, this could damage the rear of the front
seat back (storage pocket).
Front passenger seat:

 Tilt the seat back approximately
25° towards the rear (in relation to
the vertical position) using the seat
back angle adjustment control (see
corresponding paragraph).

 Lift control A upwards to release
the seat back.

 Without releasing control A , press
on the top of the seat back and
move with it until it is folded.

Page 59 of 204

3COMFORT
60
"Forwards-facing"
INSTALLING A CHILD SEAT USING
A THREE POINT SEAT BELT
GENERAL POINTS RELATING TO CHILD SEATS
* The rules for transporting children are specifi c to each country. Consult the current legislation in your country.
Intermediate longitudinal
position
When a "rearwards-facing"
child seat is installed on the

front passenger seat , it is
essential that the passenger
air bag is disarmed. Otherwise, the
child would risk being seriously in-
jured or killed if the air bag were to
infl ate. When a "forwards-facing" child seat
is installed on the
front passenger
seat , adjust the vehicle’s seat to the
intermediate longitudinal position with
the seat back upright and leave the
passenger air bag armed.
"Rearwards-facing"
Although one of PEUGEOT’s main cri-
teria when designing your vehicle, the
safety of your children also depends
on you.
For maximum safety, please
follow these precautions:
- in accordance with Directive 2003/20, all children under the
age of 12 or less than one metre
fi fty tall must travel in approved
child seats suited to their weight ,
on seats fi tted with a seat belt or
ISOFIX mountings * ,
- statistically, the safest seats in
your vehicle for the transpor-
tation of children are the rear
seats,
- a child weighing less than 9 kg
must travel in the "rearwards-
facing" position both in the front
and in the rear.
PEUGEOT
recommends that chil-
dren should travel in the rear seats of
your vehicle:
- "rearwards-facing" up to the age
of 2,
-
"forwards-facing" over the age of 2.

Page 60 of 204

3COMFORT
61

Group 0: from birth to 10 kg
Group 0+: from birth to 13 kg

L1
"ROMER
Baby-Safe Plus"
Installed in the rear-facing position

Groups 1, 2 and 3: from 9 to 36 kg

L2
"KIDDY Life"
For the safety of young children (from 9 to 18 kg), PEUGEOT recommends use of
the restraining cushion.

Groups 2 and 3: from 15 to 36 kg

L3
"RECARO Start’’
L4
"KLIPPAN Optima" From the age of 6 years
(approximately
22 kg), the booster is used on its own.
CHILD SEATS RECOMMENDED BY PEUGEOT
PEUGEOT offers a complete range of recommended child seats which
are se-
cured using a three point seat belt :
Passenger air bag OFF

Page:   < prev 1-10 ... 11-20 21-30 31-40 41-50 51-60 61-70 71-80 81-90 91-100 ... 210 next >