height Peugeot 407 2009 Owner's Manual

Page 5 of 250

FAMILIARISATION INSTRUMENTS AND CONTROLS
1. Audio equipment steering wheel
stalk.

2. Steering lock and ignition.

3. Steering wheel height and depth
adjustment.

4. Cruise control/speed limiter stalk.

5. Lights/Direction indicator stalk.

6. Air conditioned glove box.
Fuse box.

7. Bonnet release.

8. Passenger-operated electric
window control.

9. Speakers (tweeters).

10. Air diffuser vent grille.

11. Instrument panel.

12. Wiper/Wash-wipe/Trip computer
stalk.

13. Headlamp height adjustment.

14. Storage compartment
(driver's side).

Page 7 of 250

FAMILIARISATION

 50
Forwards-backwards Height and angle of the driver'
s seat
cushion Seat back angle
Front seat adjustments

Page 9 of 250

FAMILIARISATION
Front seat belt

1. Fastening.

2. Height adjustment.
1. Stop position.

2. Ignition position.

3. Starting position.

 67
Electric window controls

1. Driver's electric window switch.

2. Passenger electric window switch.

3. Rear right electric window switch.

4. Rear left electric window switch.
Ignition switch

 87
Also...

5. Deactivation of the electric
window switches located in
the rear (child safety).
A heavy object (key fob...), at-
tached to the key and weighing
down on its shaft in the ignition
switch, could cause a malfunction.

Page 22 of 250

1INSTRUMENTS and CONTROLS
23
Tyre under-infl ation detection
system warning light
This indicates the absence or mal-
function of one or more tyre pressure
sensors or a system fault.
Consult a PEUGEOT dealer.
Electronic engine
immobiliser warning light
This indicates an electronic engine im-
mobiliser system malfunction.
Consult a PEUGEOT dealer. Front brake pads wear
warning light
This indicates that the brake pads are
worn.
For your safety, have them replaced
by a PEUGEOT dealer.
Fuel tank cap warning light
(according to version)
With the engine running, this indicates
that the fuel tank cap is incorrectly se-
cured or absent.
It comes on in orange if the vehicle
speed is below 6 mph (10 km/h) and
in red if the vehicle speed is above
6 mph (10 km/h).
Water in diesel fi lter
warning light
This indicates the presence of water
in the diesel fi lter. There is a risk of
damage to the injection system.
Contact a PEUGEOT dealer as soon
as possible. Door/boot open warning
light
With the engine running, this indicates
that an access has not been closed
correctly.
An illustration on the multifunction
display identifi es the access(es) con-
cerned.
It comes on in orange if the vehicle
speed is below 6 mph (10 km/h) and
in red if the vehicle speed is above
6 mph (10 km/h). Air bags warning light
This indicates an air bag fault.
Consult a PEUGEOT dealer.
Automatic headlamp beam
adjustment system warning
light
This indicates that the automatic
headlamp height adjuster is faulty.
Consult a PEUGEOT dealer.
Engine oil pressure warning
light
This indicates that the engine oil
pressure is too low.
It is linked with the STOP warning
light.

Stop immediately if it comes on while
the engine is running.
If there is a lack of oil in the lubrication
circuit, top up the level and contact a
PEUGEOT dealer as soon as possible.

Page 50 of 250

3COMFORT
49
Operation
Switch on the ignition and press switch 1 : - indicator light 2 lit (switch pressed):
automatic operation.
- indicator light 2 off: automatic
system off. The mirror remains at
its most clear.
Manual interior mirror
The interior mirror has two positions:
- day (normal),
- night (anti-dazzle).
To change from one to the other, push
or pull the lever on the lower edge of
the mirror. Special feature
To ensure maximum visibility
during manoeuvres, the mirror
clears automatically when re-
verse gear is engaged.
MANUAL STEERING WHEEL HEIGHT AND DEPTH ADJUSTMENT
When the vehicle is stationary, unlock
the steering wheel by pushing the
control forwards.
Adjust the height and depth of the
steering wheel then lock by pulling the
control fully.

Page 51 of 250

3COMFORT
49
Operation
Switch on the ignition and press switch 1 : - indicator light 2 lit (switch pressed):
automatic operation.
- indicator light 2 off: automatic
system off. The mirror remains at
its most clear.
Manual interior mirror
The interior mirror has two positions:
- day (normal),
- night (anti-dazzle).
To change from one to the other, push
or pull the lever on the lower edge of
the mirror. Special feature
To ensure maximum visibility
during manoeuvres, the mirror
clears automatically when re-
verse gear is engaged.
MANUAL STEERING WHEEL HEIGHT AND DEPTH ADJUSTMENT
When the vehicle is stationary, unlock
the steering wheel by pushing the
control forwards.
Adjust the height and depth of the
steering wheel then lock by pulling the
control fully.

Page 52 of 250

3COMFORT
50
FRONT SEATS

Manual mode
Longitudinal adjustment
Lift the control bar and slide the seat
forwards or backwards. Driver's seat cushion height and
angle adjustment
Pump up or down to the required
position. Seat back angle adjustment
Operate the lever for your comfort.

Page 53 of 250

3COMFORT
51
Electric mode
Longitudinal adjustment
Push the control forwards or back-
wards to slide the seat. Driver's seat cushion height and
angle adjustment

Height: tilt the rear of the control up
or down.

Tilt: tilt the front of the control up or
down. Seat back angle adjustment
Tilt the control forwards or backwards
for your comfort.
The electrical functions of the driver's seat are deactivated o ne minute after the ignition is switched off.
To reactivate them, open the door or switch on the ignitio n.

Page 54 of 250

3COMFORT
52
Head restraint height and angle
adjustment Front seat active head restraint
This system prevents "whiplash".
In the event of a rear impact, the action
of the body on the seat back moves
the head restraint forwards and up-
wards preventing the head from being
thrown back.
Front armrest Driver's seat lumbar adjustment
Heated seats adjustment


0
: Off.

1
: Low.
2
: Medium.

3
: High.
The adjustment is correct when
the top of the head restraint is
aligned with the top of the head
of the occupant of the seat.


Never drive with the head re-
straints removed and stored in
the vehicle. This is dangerous
and they may be thrown in the
event of sharp braking. They must be
in place and adjusted correctly.

To change the position of the armrest:

 Lift the handle 1 .
The armrest folds forwards and up-
wards.
To return to the initial position, push
the armrest backwards and press it to
engage.
Operate the lever to obtain the correct
position. To raise or lower the head restraint,
pull it forwards then slide it.
To tilt the head restraint, tilt the lower
part forwards or backwards.
To remove the head restraint, move it
almost to the highest position, lift the
tab using a coin and pull it forwards
and upwards at the same time.
To refi t the head restraint, engage the
stalks in the holes keeping in line with
the seat back.


With the engine running, turn the dial.
The temperature of the seat is regulated
automatically.

Page 104 of 250

7SAFETY
87
SEAT BELTS
Detection of fastening of the front
seat belts

When the ignition is switched on , if a
front passenger has not fastened his seat
belt and if the vehicle speed is below
13 mph (20 km/h) , you are warned by
lighting of the seat belt warning light .
The warning light switches off when the
seat belt(s) concerned is(are) fastened.
If the vehicle speed is above 13 mph
(20 km/h) , you are warned by fl ashing
of the seat belt warning light , an
audible signal and a message on the
multifunction display locating the un-
fastened seat belt(s).
Front seat belts with
pre-tensioner and force
limiter
In the event of a serious front impact,
the pre-tensioning system instantly
tightens the seat belts fi rmly against
the bodies of the occupants.
The pre-tensioning seat belts are
armed when the ignition is on.
The force limiter reduces the pressure
of the seat belt against the chest of the
occupant, so increasing his protection.
Rear seat belts
The rear seats are all fi tted with a
three-point inertia reel seat belt.
The rear side seat belts have a force
limiter and may be fi tted with a pre-
tensioning inertia reel.

To fasten the seat belts

 Pull the strap, then insert the
tongue into the buckle.

 Check that the seat belt is secured
correctly by pulling the strap.

To unfasten the seat belts

 Press the red button on the buckle. Before folding the seat back, pull the
strap and insert the seat belt tongue
into the buckle. This precaution will
ensure that each seat belt is in place
when the rear seats are lifted again.

Note: a bag or an animal
placed on the front passenger
seat may trigger the lighting of
the warning light.
The audible signal ceases and the
warning light switches off when the
seat belt concerned is fastened.
After two minutes without any action on
the seat belts, the fl ashing warning light
remains on permanently and the audible
signal ceases. All of the warnings cease
when a door is opened or when the
engine is switched off.
Front seat belt height adjustment:

 To lower the attachment point,
squeeze control 1 and slide it
downwards,

 To raise the attachment point, slide
control 1 upwards.

Page:   1-10 11-20 next >