headlamp Peugeot 407 2010 Owner's Guide

1010PRACTICAL INFORMATION
116
CHANGING A FRONT BULB
Handle the bulbs with a dry cloth.
2 - Main beam headlamps: H7-55W.

 Remove the protective cover cor-
responding to the faulty bulb.

 Disconnect the connector.

 Press the end of the securing clips
to free the bulb. Change the bulb.

 When fi tting the new bulb, ensure
that the direction notches are po-
sitioned correctly and the securing
clips are fi xed properly.

 Reconnect the connector.

 Refi t the protective cover.

4 - Direction indicators:
PY21W (amber).

 Turn the bulb holder a quarter turn
and remove it.

 Change the bulb.

WARNING: RISK OF ELEC-
TROCUTION
Front lamps
In the engine compartment, remove
the cover secured by one or two but-
terfl y screws, a plastic retainer clip and
two quarter turn screws.

1 - Dipped beam headlamps: H1-55W
or D2S-35W xenon bulb.
Xenon bulbs must be replaced by a
PEUGEOT dealer. Amber coloured bulbs (direc-
tion indicators and side re-
peaters) must be replaced
with bulbs of identical specifi -
cation and colour.
5 - Front foglamps: H11 - 55W.
Turn the wheels to full lock.
Access to the bulb is via the fl ap in the
front mud fl ap.
Consult a PEUGEOT dealer.
The headlamps are fi tted with polycar-
bonate glass with a protective coating.
Do not clean them with a dry or abra-
sive cloth, nor with a detergent or sol-
vent product.
Ensure that the liquid used to fi ll the
wash-wipe and headlamp wash reser-
voir is of good quality.

High pressure washing :
when using a high pressure
washer on stubborn dirt, do
not persist on the headlamps,
the other lamps and their surrounds
to avoid damaging their coating and
seals.
In certain climatic conditions (low tem-
perature, humidity), condensation on
the inside surface of the headlamp
glass and rear lights glass is normal;
it disappears a few minutes after the
lighting is switched on.

3 - Sidelamps: W5W.

 Remove the protective cover, dis-
connect the connector and then
remove the bulb and change it.

 Put the connector back in place.

 Reconnect the connector.

 Refi t the protective cover.

1010PRACTICAL INFORMATION
118
CHANGING A REAR BULB (407SW)
Left and right foglamps: P21W.

 Carefully unclip the tailgate interior
trim.

 Detach the sealing fi lm located be-
hind the lamp in question.

 Remove the bulb holder turning it a
quarter of a turn.

 Change the faulty bulb.
When refi tting, ensure that the bulb is
positioned correctly in the bulb holder.

 Unclip the lamp (2 clips).

 Disconnect the connector and re-
move the lamp.

 Unclip the bulb holder moving
aside the 4 tabs.

 Unscrew the bulb and change it.

 Reconnect the connector.

 Refi t the bulb holder. When refi tting
it, ensure that the lamp is correctly
positioned and secured, reclipping
the rear part then the front part.

Number plate lamps: W5W.

 Insert a thin screwdriver in one of
the exterior holes of the transpar-
ent cover.


Push it towards the outside to unclip it.

 Remove the transparent cover.

 Change the faulty bulb. Third brake lamp (diodes)
All work on the diode lamps must be
carried out by a PEUGEOT dealer.
Wing lamps

1. Brake lamps/sidelamps: P21/5W.

2. Reversing lamps: P21W.

3. Direction indicators: P21W.
These three bulbs are changed by re-
moving the lamp.

 Remove the corresponding boot
side fl ap to gain access to the
lamp.

 Remove the lamp fi xing nut inside
the boot.
Note: if necessary, use the wheelbrace
to remove the nuts. In some climatic conditions
(e.g. low temperature or hu-
midity), the presence of misting
on the internal surface of the
glass of the headlamps and rear lamps
is normal; it disappears after the lamps
have been on for a few minutes.

1010PRACTICAL INFORMATION
122
Engine compartment fuses
To access the fuses located in the
engine compartment (next to the bat-
tery), remove the battery cover and
unclip the fuse box cover.
Close the fuse box cover carefully and
refi t the battery cover when you have
fi nished.
Fuse N°
Rating

A
Functions

1 20 Engine management control unit.

2 15 Horn.

3 10 Front and rear wash-wipe.

4 20 Headlamp wash.

5 15 Engine management actuators (fuel pump,
purge canister solenoid valves, ...).

6 10 Automatic gearbox control unit.

7 10 Switching and protection unit, intake air fl ow
sensor, clutch switch, six-speed automatic gear-
box switch, STOP switches, electrochromatic
mirror, panoramic roof concealing fl ap controls
(407SW).

8 20 Starter coil.

9 10 Xenon bulb electronic supply, STOP switch,
power steering electropump assembly, four-
speed automatic gearbox control unit, automatic
gearbox locking relay.

10 30 Engine management actuators (ignition coil,
solenoid valves, oxygen sensors).

11 40 Air conditioning blower or not used.

12 30 Windscreen wipers.

13 40 Built-in systems interface supply (ignition pos itive).

14 30 Air pump.