Peugeot 407 C 2008 Owner's Guide

Page 31 of 211

1
32
Press the "MENU" button to gain ac-
cess to the general menu.
Select the "Trip computer" or

"Vehicle diagnostics" application us-
ing the navigator, then confi rm or press
the "MODE" button until you reach the
trip computer screen, then confi rm us-
ing "OK" .
The "Trip computer" or "Vehicle diag-
nostics" menu offers various options:
- Warnings log,
- Status of the functions,
- Inputting of the distance to be trav- elled.
Warnings log
This summarises the active warning
messages, displaying them on the
multifunction display in succession.
Status of the functions
This summarises the active or inactive
status of the functions present on the
vehicle.
Distance remaining
When guidance is not activated, this
enables you to enter an approximate
distance to be travelled value.
Display on the instrument panel screen
All of the various items of trip computer
information also appear on the instru-
ment panel screen at the same time.
Distance remaining to be travelled (km or miles)
Average speed (km/h or mph)
Average consumption (l/100 or km/l or mpg)
Distance travelled (km or miles)
This is the average speed calculated
since the computer was last set to
zero (with the ignition on).
This is the distance remaining to the
destination, either calculated at any
time by the navigation if guidance is
activated or entered by the user, mi-
nus the distance covered since the
distance was entered.
If digits are missing, dashes are dis-
played in their place.
This is the average fuel consumption
since the computer was last set to zero.
This indicates the distance travelled
since the computer was last set to zero.
Access via the general menu
"TRIP" (Route) menu

Page 32 of 211

2
33
COLOUR SCREEN C
This displays the following informa-
tion, via the WIP Sound audio system
control pad:
- the time,
- the date,
- the exterior temperature (the value displayed fl ashes if there is a risk
of ice),
- the accesses check,
- the warning messages,
- the audio functions,
- the trip computer information,
-
the personalisation and confi guration
displays,
- the air conditioning parameters,
-
the front and rear parking assistance
display,
- the hands-free kit displays. Management of the displays
General menu
Press the
"MENU" button to gain ac-
cess to the general menu and select
one of the following functions:
- "Audio functions",
- "Trip computer",
- "Personalisation-Confi guration",
- "Air conditioning",
- "Telephone". "Personalisation-Confi guration"
menu
This provides access to successive
confi rmation windows.
Defi ning the vehicle parameters
This enables you to activate or de-
activate certain driving and comfort
elements:
-
"Automatic switching on of the lights", - "Follow-me-home lighting" and
"Duration",
- "Remote control action",
- "Permanent locking of the boot",
- "Directional headlamps".
Example: "Automatic switching on of
the lights"
The
"AUDIO" , "TRIP" , "CLIM" and

"TEL" buttons on the RD4 audio
equipment control pad permit display-
ing in the main window.
Example: "TRIP"
Example: "Audio functions"

Page 33 of 211

2
34
Selection of the language
German, Spanish, French, English,
Italian, Dutch, Turkish, Portuguese
and Brazilian Portuguese.
Confi guration of the display
- "Setting the brightness-video".
- "Setting the date and time".
- "Selection of the units".
- "Selection of the colours". Changing the date and time
From the
general menu , select the

" P e r s o n a l i s a t i o n - C o n f i g u r a t i o n "
icon using the navigator, then confi rm.
From the list displayed, select

"Confi guration of the display" , then
confi rm.
From the list displayed, select "Setting
the date and time" , then confi rm. Set the parameters one by one:
- the zone selected is displayed on
the screen,
- use the navigator to move from one zone to another,
- your new parameters are con- fi rmed one by one, by pressing the
navigator button,
- all of the changes are saved, if you click on "OK" on the screen, or
cancelled, if you press the "ESC"
button on the control pad.
For safety reasons, confi gura-
tion of the multifunction dis-
plays by the driver must be
carried out while stationary.

Page 34 of 211

2
35
16/9 COLOUR SCREEN DT
This displays the following information,
via the WIP Com audio and telematics
system control panel:
- the time,
- the date,
- the outside temperature (the value displayed fl ashes if there is a risk
of ice),
- the status of the accesses,
- the warning messages or vehicle function status messages,
displayed temporarily,
- the audio functions,
- the telematic systems display (telephone, services, ...),
- the trip computer information,
- the personalisation and confi guration displays,
- the air conditioning parameters,
- the front and rear parking assistance display,
- the satellite navigation system information. General menu
Press the
"MENU" button to access
the general menu and select one of
the following functions:
- "Navigation - guidance",
- "Map",
- "Traffi c information",
- "Audio functions",
- "Telematics",
- "Confi guration",
- "Video",
- "Vehicle diagnostics",
- "Air conditioning". "Confi guration" menu
This provides access to the following
functions:
- "Display confi guration",
- "Sound",
- "Select language",
- "Defi ne the vehicle parameters".

Page 35 of 211

2
36
Display confi guration
- "Choose colour",
- "Adjust brightness",
- "Adjust date and time",
- "Select units". "Video" menu
Defi ne the vehicle parameters
This enables you to activate or deacti-
vate certain driving and comfort func-
tions:
- "Automatic switching on of the
headlamps",
- "Follow-me-home lighting" and "Duration",
- "Remote control action",
- "Directional headlamps",
- "Permanent locking of the boot".
Example: "Automatic switching on of
the headlamps"
You can connect video equipment
(camcorder, digital camera, DVD
player, ...) to the three video sockets, l
ocated in the glove box.

Videos can only be displayed when
stationary.
Select the "Video" menu from the

general menu :
- "Activate video mode" to activate/ deactivate the video,
- "Video parameters" to set the dis- play format, the brightness, the
contrast and the colours.
Pressing the "DARK" button discon-
nects the display from the video.
Successive presses on the "SOURCE"
button permit the selection of an audio
source other than that of the video.
For safety reasons, confi gura-
tion of the multifunction dis-
plays by the driver must take
place when stationary.

Page 36 of 211

2
36
Display confi guration
- "Choose colour",
- "Adjust brightness",
- "Adjust date and time",
- "Select units". "Video" menu
Defi ne the vehicle parameters
This enables you to activate or deacti-
vate certain driving and comfort func-
tions:
- "Automatic switching on of the
headlamps",
- "Follow-me-home lighting" and "Duration",
- "Remote control action",
- "Directional headlamps",
- "Permanent locking of the boot".
Example: "Automatic switching on of
the headlamps"
You can connect video equipment
(camcorder, digital camera, DVD
player, ...) to the three video sockets, l
ocated in the glove box.

Videos can only be displayed when
stationary.
Select the "Video" menu from the

general menu :
- "Activate video mode" to activate/ deactivate the video,
- "Video parameters" to set the dis- play format, the brightness, the
contrast and the colours.
Pressing the "DARK" button discon-
nects the display from the video.
Successive presses on the "SOURCE"
button permit the selection of an audio
source other than that of the video.
For safety reasons, confi gura-
tion of the multifunction dis-
plays by the driver must take
place when stationary.

Page 37 of 211

3
38
windscreen, the vents, the air outlets
under the front seats and the air
extractor located behind the fl aps in
the boot.
In certain cases of particularly arduous
use (towing the maximum load on a
steep gradient in hot weather), cutting
off the air conditioning permits recovery
of the engine power and therefore
improvement of the towing capacity.
Close the windows to benefi t from the
full effectiveness of the air conditioning.
Ensure that the passenger compart-
ment fi lter is in good condition. Have
the fi lter elements replaced periodical-
ly. If you drive in a dusty environment,
replace it twice as often.
The air conditioning system does not
contain chlorine and is not harmful to
the ozone layer.
Operate the air conditioning system
for 5 to 10 minutes, once or twice a
month, to keep it in perfect working
order.
The water formed by the air conditioning
condensation is discharged via an open-
ing provided for this purpose. Therefore,
a puddle of water may form underneath
the vehicle when stationary.
If the system does not produce cold air,
do not use it and contact a PEUGEOT
dealer.
1. Centre panel vents.

2. Adjustment of the glove box air
fl ow (see section "Interior layout").

3. Air outlet to passenger footwells.

4. Two ventilation vents at the rear at
the base of the centre console be-
tween the passengers.

5. Side vents.

6. Front windows de-icing or demist-
ing vents.

7. Windscreen de-icing or demisting
vents.

8. Sunshine sensor.

9. Air diffuser grille. AUTOMATIC REGULATION OF THE AIR CONDITIONING
Air diffuser
The air diffuser grille, located at the
top of the centre console, signifi cantly
improves distribution and fl ows and
prevents air currents, while maintain-
ing an optimum temperature inside the
passenger compartment.
Advice on operation
To obtain even ventilation,
avoid closing the air diffuser
grille 9 .
In hot weather, in order to obtain in-
tense ventilation, you can close the air
diffuser grille 10 and use vents 1 and
5 only.
If, when the vehicle has been parked
in the sun for a long time, the interior
temperature remains very high, do not
hesitate to ventilate the passenger
compartment for a few minutes.
For even air distribution, take care
not to obstruct the exterior air intake
grille located at the bottom of the
Use of the automatic regulation of the
air conditioning is recommended. It
permits automatic and optimised con-
trol of all of the following functions: air
fl ow, passenger compartment temper-
ature and air distribution, by means
of various sensors, so preventing the
need for you to change your refer-
ence settings other than the value dis-
played.
Do not cover the sunshine sensor
8 .
It is required for regulation of the air
conditioning.

Page 38 of 211

3
39

Page 39 of 211

3
40
AUTOMATIC AIR CONDITIONING (DUAL ZONE)

Dual zone: this is the differentiated
regulation of the temperature and air
distribution on the driver's side and the
front passenger side.
The driver and his front passenger can
each adjust the temperature and the
distribution of the air to suit their re-
quirements.
The symbols and messages associat-
ed with the automatic air conditioning
controls appear on the multifunction
display.
Control by the Auto programme Automatic
programme - driver
and passenger
comfort (1)
Press the "AUTO" button. The indica-
tor light comes on. The "AUTO" sym-
bol is displayed on the multifunction
display.
Adjustment of the
temperature on the
driver's side (2)
Adjustment of the temperature
on the passenger side (3)

 Press the up or down arrow to
change the temperature on the
driver's side 2 or passenger side 3 .
The value indicated on the display cor-
responds to a level of comfort and not
to a temperature in degrees Celsius or
Fahrenheit, depending on the choice of
confi guration validated on the display.
A setting around the value 21 makes
it possible to obtain optimum comfort.
However, depending on your require-
ments, a setting between 18 and 24
is usual.
Depending on the level of comfort selected,
the system controls the air distribution, fl ow,
temperature and intake of air in order to
guarantee comfort and an adequate circu-
lation of air in the passenger compartment.
You do not have to make any adjustments.
When the engine is cold, to
prevent too great a distribution
of cold air, the ventilation will
only reach its optimum level
progressively.

Page 40 of 211

3
Blower (4)
Air fl ow
 Turn dial 4 to the
right to increase the
air fl ow or to the left
to reduce it.

 Turn the dial 4 to the
left until the fl ow of
air stops.
The "OFF" symbol is displayed on the
multifunction display.
This action switches off the display
and the indicator lights.
It deactivates all of the system's func-
tions, with the exception of the rear
screen demisting.
The temperature-related comfort is no
longer controlled (temperature, humid-
ity, odour, condensation).
Avoid driving for too long with the air
conditioning off.
Switching off the ventilation
The
"AUTO" button indicator light is
switched off.
The air fl ow symbol (fan) is displayed
on the multifunction display and is fi lled
in in relation to the value required.
To prevent condensation and dete-
rioration of the quality of the air in the
passenger compartment, ensure that
an adequate fl ow of air is maintained. Adjustment of
the driver's air
distribution (5)
Successive or continuous pressure on
button 5 or 6 enables you to direct the
fl ow of air on the driver's side or on the
passenger side independently.
The "AUTO" button indicator light is
switched off.
The symbol (arrows) corresponding to
the chosen direction 5 or 6 is displayed
on the multifunction display.

 Windscreen and front side windows.

 Front and rear ventilation.

 Front and rear footwells.
AUTO Automatic distribution. Adjustment of
the passenger air
distribution (6)
Control via the manual controls
It is possible to adjust one or more
functions manually while leaving the
other functions in automatic mode.
Switching to manual mode may result
in discomfort (temperature, humidity,
odour, condensation) and is not ad-
vantageous (comfort).
To return to automatic mode, press the

"AUTO" button.
On entering the vehicle, the
interior temperature may be
much colder (or warmer) than
is comfortable. There is no
need to change the temperature dis-
played in order to obtain rapidly the
level of comfort required.
The automatic regulation of the air
conditioning will use its maximum
performance settings to correct the
temperature difference as quickly as
possible.

To reactivate the air conditioning:

 Press button 1 .

Page:   < prev 1-10 11-20 21-30 31-40 41-50 51-60 61-70 71-80 ... 220 next >