Peugeot 407 C 2010.5 Manual PDF

4
67

Make a careful note of the
number on each key. The
key number is coded on the
label attached to the key.

If the keys are lost, a PEUGEOT
dealer can rapidly supply you with
new keys.

The high frequency remote control is
a sensitive system; do not operate it
while it is in your pocket as there is
a possibility that it may unlock your
vehicle, without you being aware of it.

The remote control does not oper-
ate when the key is in the ignition,
even when the ignition is switched
off, except for reprogramming.
Do not operate the deadlocking
function if there is anyone inside
the vehicle.

Driving with the doors locked may
make access to the passenger com-
partment by the emergency services
more diffi cult in an emergency.

As a safety precaution (with chil-
dren on board), remove the ignition
key when you leave the vehicle,
even for a short time.

Do not repeatedly press the button
of your remote control out of range
and out of sight of your vehicle.
You run the risk of stopping it from
working and the remote control
would have to be reprogrammed.
When purchasing a second-hand
vehicle, have the key codes memo-
rised by a PEUGEOT dealer to
ensure that the keys in your pos-
session are the only ones which
can start the vehicle.

Do not make any modifi cations to
the electronic engine immobiliser
system.

4
When the windows are closed
automatically using the remote
control, ensure that no one is
preventing them from closing
correctly.
The folding and unfolding of the
door mirrors can be deactivated by a
PEUGEOT dealer. The complete or selective
unlocking can be confi g-
ured via the multifunction
screen "Personalisation-
Confi guration" menu.
Unlocking and opening of the boot

 Press button D to unlock and open
the boot.
This action also unlocks the doors.
If the permanent locking of the boot is
activated, opening is only possible via
button D on the remote control.
When the vehicle is locked,
if unlocking is activated inad-
vertently, without a door being
opened within 30 seconds, the
vehicle will lock automatically.
This function can be con-
fi gured via the multifunction
screen "Personalisation -
Confi guration" menu.
Key in ignition
A buzzer sounds on opening the driver's
door, if the key has been left in the ignition.
LOCATING YOUR VEHICLE
To locate your vehicle, if you have
locked or deadlocked it, in a car park:

 press button B on the remote con-
trol, the courtesy lamps come on
and the direction indicators fl ash
for a few seconds.
Unlocking
Selective (if activated)

 Press button C to unlock the driv-
er's door only.

 Press the button again to unlock
the passenger door and the boot.
Each action is confi rmed by rapid
fl ashing of the direction indicators for
approximately two seconds.
The door mirrors unfold at the same
time.
Complete

 Press button C for complete un-
locking of the vehicle.
This is confi rmed by rapid fl ashing of
the direction indicators for approxi-
mately two seconds.
The door mirrors unfold at the same
time.

4
66
CHANGING THE REMOTE CONTROL BATTERY
Battery ref.: CR1620/3 volts.
To change the battery, unclip the cas-
ing using a coin at the notch.
REINITIALISATION

 Switch off the ignition.

 Switch the ignition on again.

 Press the remote control locking but-
ton immediately for a few seconds.

 Switch off the ignition and remove
the remote control key from the ig-
nition lock. The remote control is
now working again.
ELECTRONIC ENGINE IMMOBILISER
This locks the engine control system
a few moments after the ignition has
been switched off and therefore pre-
vents starting of the vehicle by anyone
who does not have the key.
The ignition key has an electronic chip
which has a special code. When the
ignition is switched on, the code is
recognised and starting is possible.

If the system does not
function correctly , the
warning lamp comes on in
the instrument panel screen,
accompanied by an audible
signal and a message in the
multifunction screen.
In this case, your vehicle will not start.
Contact a PEUGEOT dealer as soon
as possible.
If the remote control does not work
after the battery has been changed,
reinitialise the remote control.

4
66
CHANGING THE REMOTE CONTROL BATTERY
Battery ref.: CR1620/3 volts.
To change the battery, unclip the cas-
ing using a coin at the notch.
REINITIALISATION

 Switch off the ignition.

 Switch the ignition on again.

 Press the remote control locking but-
ton immediately for a few seconds.

 Switch off the ignition and remove
the remote control key from the ig-
nition lock. The remote control is
now working again.
ELECTRONIC ENGINE IMMOBILISER
This locks the engine control system
a few moments after the ignition has
been switched off and therefore pre-
vents starting of the vehicle by anyone
who does not have the key.
The ignition key has an electronic chip
which has a special code. When the
ignition is switched on, the code is
recognised and starting is possible.

If the system does not
function correctly , the
warning lamp comes on in
the instrument panel screen,
accompanied by an audible
signal and a message in the
multifunction screen.
In this case, your vehicle will not start.
Contact a PEUGEOT dealer as soon
as possible.
If the remote control does not work
after the battery has been changed,
reinitialise the remote control.

4
67

Make a careful note of the
number on each key. The
key number is coded on the
label attached to the key.

If the keys are lost, a PEUGEOT
dealer can rapidly supply you with
new keys.

The high frequency remote control is
a sensitive system; do not operate it
while it is in your pocket as there is
a possibility that it may unlock your
vehicle, without you being aware of it.

The remote control does not oper-
ate when the key is in the ignition,
even when the ignition is switched
off, except for reprogramming.
Do not operate the deadlocking
function if there is anyone inside
the vehicle.

Driving with the doors locked may
make access to the passenger com-
partment by the emergency services
more diffi cult in an emergency.

As a safety precaution (with chil-
dren on board), remove the ignition
key when you leave the vehicle,
even for a short time.

Do not repeatedly press the button
of your remote control out of range
and out of sight of your vehicle.
You run the risk of stopping it from
working and the remote control
would have to be reprogrammed.
When purchasing a second-hand
vehicle, have the key codes memo-
rised by a PEUGEOT dealer to
ensure that the keys in your pos-
session are the only ones which
can start the vehicle.

Do not make any modifi cations to
the electronic engine immobiliser
system.

4
68
ALARM
This provides two types of monitoring:
- exterior perimeter protection: it
sounds if a door, the boot or the
bonnet is opened.
- interior volumetric protection:
it sounds if the volume inside the
passenger compartment changes
(breaking of a window or a move-
ment inside the vehicle). When the alarm is triggered, the siren
sounds and the direction indicators
fl ash for approximately thirty seconds.
After triggering, the alarm remains set,
ten times in succession.
On the eleventh time it will become
inactive again, until the next cycle of
deactivating then setting of the alarm.

Warning: if button A indicator lamp
fl ashes rapidly, the alarm has been
triggered while you were away from
your vehicle.
Operating fault
When the ignition is switched on, if the
lamp button A comes on for ten seconds,
there is a fault in the siren connection.
Contact a PEUGEOT dealer to have the
system checked.
Remote control failure, alarm set

 Unlock the doors with the key and
open the door. The alarm is trig-
gered.

 Switch on the ignition. The alarm is
deactivated.
* According to country.
Setting the alarm

 Switch off the ignition and get out
of the vehicle.

 Set the alarm, by locking or dead-
locking using the remote control
(button A indicator lamp fl ashes
once per second).
If you wish to lock or deadlock your ve-
hicle without setting the alarm, lock it
(one turn of the key) or deadlock it (a
second turn within fi ve seconds maxi-
mum) using the lock.
The alarm is activated automatically
two minutes after the last closure of a
door or the boot.
In order to avoid accidental triggering
of the alarm when a door or the boot
is opened, it is essential to press the
unlocking button on the remote control
again.
Before setting the alarm, en-
sure that all of the openings
(doors, bonnet, boot) are
closed correctly.
Deactivation
Unlock the vehicle with the remote
control key.
The alarm is deactivated, indicator
lamp A goes out when the ignition is
switched on.
To set the alarm with exterior protection only
If, while you are away from the vehi-
cle, you wish to leave a window par-
tially open or a pet inside the vehicle,
you should choose exterior protection
only.

 Switch off the ignition,

 In the next ten seconds, press but-
ton A until the indicator lamp is on
continuously,

 Get out of the vehicle,

 Set the alarm by locking or dead-
locking using the remote control
(button A indicator lamp fl ashes
once a second).

4
69
ELECTRIC WINDOWS

1. Driver's electric window switch.

2. Passenger's electric window
switch. Automatic operation:
To open or close the window, press or
pull the switch fully: the window opens
or closes completely when the switch
is released. Pressing the switch again
stops the movement of the window.
The electric window switches remain
operational for approximately one min-
ute after the key has been removed
from the ignition.
Once this time has elapsed, the elec-
tric windows will not operate. To re-
activate them, switch the ignition on
again.
Safety anti-pinch
When the window rises and meets an
obstacle, it stops and immediately par-
tially lowers again.
In the event of unwanted opening
of the window on closing, press the
switch until the window opens com-
pletely, then pull the switch immediate-
ly until the window closes. Continue to
hold the switch for approximately one
second after the window has closed.
The safety anti-pinch function is not
active during this operation.
WINDOWS
Following reconnection of the battery,
the safety anti-pinch function must be re-
initialised: the safety anti-pinch function
is not active during these operations.
- with the door closed, lower the win-
dow completely, then raise it, it will
rise in steps of a few centimetres
each time the switch is pressed.
Repeat the operation until the win-
dow closes completely,
- continue to press the switch for at least one second after reaching
this position, window closed.
Always remove the key from
the ignition when leaving the
vehicle, even for a short time.
In the event of contact during
operation of the windows, you must re-
verse the movement of the window. To
do this, press the switch concerned.
When the driver operates the passen-
ger electric window switch, he must
ensure that no one is preventing cor-
rect closing of the window.
The driver must ensure that the pas-
sengers use the electric windows cor-
rectly.
Be aware of children when operating
the windows.
Manual operation:
To open or close the window, press
or pull the switch gently. The window
stops as soon as the switch is re-
leased.

4
70
DOORS
Opening the doors from outside
Opening the doors from inside
Locking/unlocking from the inside

 Press the button.
This allows the doors and the boot to
be locked or unlocked.
To make it easier to open the door, the
window lowers automatically by a few
centimetres.
It rises and adjusts automatically on
closing to ensure perfect sealing.
Before carrying out any work
which requires disconnection
of the battery, lower the win-
dows to permit opening and
closing of the doors.
In the event of battery disconnection or
if the automatic lowering fails (window
iced up for example), it is still possible
to open the doors. However, the doors
must not be slammed when closing.
The safety anti-pinch is inoperative
during the automatic raising of the
windows.
Contact a PEUGEOT dealer as soon
as possible.
When using a high pressure washer
on your vehicle, it is recommended
that the end of the gun is kept at least
50 cm away from the windows and
door seals. If the vehicle has been locked
or deadlocked using the key
or the remote control, the but-
ton is inoperative.
In this case, use the key or the remote
control to unlock.
Unlocking from the doors
You can unlock from the inside by oper-
ating a door opening control.
If the "Vehicle access" function is ac-
tivated via the multifunction screen
menu, opening:
- the driver's door, unlocks the door
concerned.
- the passenger ' s door, unlocks the
doors and the boot.

4
71
MANUAL LOCKING (BACK-UP MODE)
Automatic central locking of the
doors
The doors and boot can lock automati-
cally while driving (speed above 6 mph
[10 km/h]).
You can activate or deactivate this
function by pressing and holding the
button.
BOOT
To open the boot, press the push but-
ton and raise the boot lid.
Tailgate release
This enables the tailgate to be un-
locked in the event of a central locking
fault.
- Fold back the rear seats to gain access to the lock from inside the
boot.
- Insert a small screwdriver into hole A of the lock to unlock the tail-
gate.

Note: driving with the doors
locked may make access to
the passenger compartment by the emergency services more
diffi cult in an emergency.
If the permanent locking of the boot is activated, opening is
only possible by pressing the
remote control button.
Passenger door
To lock, insert the key in the control
located on the edge of the door then
push to the left.
Driver's door
Insert the key in the lock to lock or un-
lock the door.

4
71
MANUAL LOCKING (BACK-UP MODE)
Automatic central locking of the
doors
The doors and boot can lock automati-
cally while driving (speed above 6 mph
[10 km/h]).
You can activate or deactivate this
function by pressing and holding the
button.
BOOT
To open the boot, press the push but-
ton and raise the boot lid.
Tailgate release
This enables the tailgate to be un-
locked in the event of a central locking
fault.
- Fold back the rear seats to gain access to the lock from inside the
boot.
- Insert a small screwdriver into hole A of the lock to unlock the tail-
gate.

Note: driving with the doors
locked may make access to
the passenger compartment by the emergency services more
diffi cult in an emergency.
If the permanent locking of the boot is activated, opening is
only possible by pressing the
remote control button.
Passenger door
To lock, insert the key in the control
located on the edge of the door then
push to the left.
Driver's door
Insert the key in the lock to lock or un-
lock the door.