Peugeot 407 Dag 2010 Manual PDF

4ACCESS
64
Anti-theft protection
Do not make any modifi ca-
tions to the electronic engine
immobiliser system; this could
cause malfunctions. CHILD LOCK
Electric mode Always remove the ignition
key when leaving the vehicle,
even for a short time.
It is advisable to check the ac-
tivation of the child lock each time the
ignition is switched on.
In the event of a serious impact, the
electric child lock is deactivated auto-
matically to permit the exit of the rear
passengers.
This prevents opening of both of the
rear doors from the inside.
With the ignition on, press the button.
A message appears on the multifunc-
tion screen.
This system is independent and does
not take the place of the central lock-
ing control in any circumstances.
This prevents each of the rear doors
from being opened from inside.

 Turn the switch on the edge of the
door a quarter of a turn using the
ignition key.
Manual mode
When purchasing a second-
hand vehicle
Have the key codes memorised by a
PEUGEOT dealer, to ensure that the
keys in your possession are the only
ones which can start the vehicle. Do not throw the remote con-
trol batteries away, they con-
tain metals which are harmful
to the environment.
Take them to an approved col-
lection point.

4ACCESS
65
ALARM
For all work on the alarm system, con-
tact a PEUGEOT dealer.
- Exterior perimeter
The system checks for opening of the
vehicle.
The alarm is triggered if anyone tries
to open a door, the boot, the bonnet...
- Interior volumetric
The system checks for any variation in
the volume in the passenger compart-
ment.
The alarm is triggered if anyone breaks
a window, enters the passenger com-
partment or moves inside the vehicle.
Self-protection function
The system checks for the
putting out of service of its
components.
The alarm is triggered if the battery, the
central control or the wires of the siren
are put out of service or damaged. Locking the vehicle with full
alarm system
Activation

 Switch off the ignition and get out
of the vehicle.

 Press the locking button on the re-
mote control.
The monitoring system is active: the
indicator lamp on the button fl ashes
once per second.
After the locking button on the remote
control is pressed, the exterior perime-
ter monitoring is activated after a delay
of 5 seconds and the interior volumet-
ric after a delay of 45 seconds.
If an opening (door, boot...) is not
closed fully, the vehicle is not locked
but the exterior perimeter monitor-
ing will be activated after a delay of
45 seconds at the same time as the
interior volumetric monitoring.
System which protects and provides a
deterrent against theft and break-ins.
It provides the following types of moni-
toring.
Deactivation

 Press the unlocking button on the
remote control.
The alarm system is deactivated: the in-
dicator lamp on the button switches off.
Locking the vehicle with
exterior perimeter monitoring
only
Deactivate the interior volumetric pro-
tection to avoid unwanted triggering of
the alarm in certain cases such as:
- leaving a pet in the vehicle,
- leaving a window partially open,
- washing your vehicle,
- changing a wheel,
- having your vehicle towed,
- transport by sea.
Deactivation of the interior
volumetric monitoring

 Switch off the ignition.

 Within ten seconds, press the but-
ton until the indicator lamp is lit
continuously.

 Get out of the vehicle.

 Press the locking button on the re-
mote control immediately.
The exterior perimeter monitoring alone
is activated: the indicator lamp on the
button fl ashes once per second.
To be effective, this deactivation must
be carried out each time the ignition is
switched off.

4ACCESS
66
Reactivation of the interior
volumetric monitoring

 Press the unlocking button on the
remote control to deactivate the
exterior perimeter monitoring.

 Press the locking button on the
remote control to activate all the
monitoring functions.
The indicator lamp on the button again
fl ashes once per second. Triggering of the alarm
This is indicated by sounding of the
siren and fl ashing of the direction indi-
cators for thirty seconds.
The monitoring functions remain ac-
tive until the alarm has been triggered
eleven times in succession.
When the vehicle is unlocked using
the remote control, rapid fl ashing of
the indicator lamp on the button in-
forms you that the alarm was triggered
during your absence. When the igni-
tion is switched on, this fl ashing stops
immediately.
Failure of the remote control
To deactivate the monitoring functions:

 Unlock the vehicle using the key in
the driver's door lock.

 Open the door; the alarm is trig-
gered.

 Switch on the ignition; the alarm
stops. The indicator lamp on the
button switches off. Locking the vehicle without
activating the alarm

 Lock or deadlock the vehicle using
the key in the driver's door lock.
Malfunction
When the ignition is switched on, fi xed
lighting of the indicator lamp on the
button indicates a malfunction of the
system.
Have it checked by a PEUGEOT dealer.
* According to country.
Automatic activation *
2 minutes after the last door or the
boot is closed, the system is activated
automatically.

 To avoid triggering the alarm on
entering the vehicle, fi rst press the
unlocking button on the remote
control.

4ACCESS
67
ELECTRIC WINDOWS
Automatic operation:
To open or close the window, press or
pull switch fully: the window opens or
closes completely when the switch is
released. Pressing the switch again
stops the movement of the window.
The electric window switches remain
operational for approximately one min-
ute after the key has been removed
from the ignition.
Once this time has elapsed, the elec-
tric windows will not operate. To re-
activate them, switch the ignition on
again.
Always remove the key from
the ignition when leaving the
vehicle, even for a short time.
In the event of contact during
operation of the windows, you must re-
verse the movement of the window. To
do this, press the switch concerned.
When the driver operates the passen-
ger electric window switches, he must
ensure that no one is preventing cor-
rect closing of the windows.
The driver must ensure that the pas-
sengers use the electric windows cor-
rectly.
Be aware of children when operating
the windows. REINITIALISATION OFTHE ELECTRIC WINDOWS
Following reconnection of the battery,
the safety anti-pinch function must be
reinitialised: the safety anti-pinch func-
tion is not active during these opera-
tions.
- lower the window completely, then raise it, it will rise in steps of a few
centimetres each time the switch is
pressed. Repeat the operation un-
til the window closes completely,
- continue to press the switch for at least one second after reaching
this position, window closed.
Safety anti-pinch
When the window rises and meets an
obstacle, it stops and immediately par-
tially lowers again.
In the event of unwanted opening
of the window on closing, press the
switch until the window opens com-
pletely, then pull the switch immediate-
ly until the window closes. Continue to
hold the switch for approximately one
second after the window has closed.
The safety anti-pinch function is not
active during this operation.
Deactivating the rear window
controls
For the safety of your children, press
switch 5 to prevent operation of the rear
windows irrespective of their position.
When the button is pressed down, the
switches are deactivated. When the but-
ton is raised, the switches are active.

Manual operation:
To open or close the window, press
or pull the switch gently. The win-
dow stops as soon as the switch is
released.

1. Driver's electric window switch.

2. Passenger's electric window
switch.

3. Rear right electric window
switch.

4. Rear left electric window
switch.

5. Deactivating the rear electric
window switches (child safety).

4ACCESS
68
BOOT (SALOON) TAILGATE AND REAR SCREEN (407SW) Partial opening of the rear screen
Opening the tailgate and rear
screen

The tailgate and rear screen cannot
be opened at the same time.
With the rear screen closed, to open
the tailgate , operate the handle A ,
then lift the tailgate.
With the tailgate closed, to open the

rear screen , operate the handle B ,
then lift the rear screen.
The boot lighting is controlled by open-
ing the tailgate or the rear screen.
If the permanent locking of the
boot is activated, opening is
only possible by pressing the
remote control button.

Notes: the tailgate and rear
screen lock automatically when
driving at 6 mph (10 km/h) and
unlock when one of the doors
is opened.
When the rear wiper is in a wiping
position, the rear screen cannot be
opened until the end of the cycle.
Close the rear screen using the wiper
arm or by pressing the centre of the
glass.
To open the boot, press the push button
and raise the tailgate.
The locking or unlocking of the tailgate
and rear screen is simultaneous with
that of the doors. With the tailgate closed, to partially
open the
rear screen , press and hold
the unlocking button C on the remote
control.

4ACCESS
68
BOOT (SALOON) TAILGATE AND REAR SCREEN (407SW) Partial opening of the rear screen
Opening the tailgate and rear
screen

The tailgate and rear screen cannot
be opened at the same time.
With the rear screen closed, to open
the tailgate , operate the handle A ,
then lift the tailgate.
With the tailgate closed, to open the

rear screen , operate the handle B ,
then lift the rear screen.
The boot lighting is controlled by open-
ing the tailgate or the rear screen.
If the permanent locking of the
boot is activated, opening is
only possible by pressing the
remote control button.

Notes: the tailgate and rear
screen lock automatically when
driving at 6 mph (10 km/h) and
unlock when one of the doors
is opened.
When the rear wiper is in a wiping
position, the rear screen cannot be
opened until the end of the cycle.
Close the rear screen using the wiper
arm or by pressing the centre of the
glass.
To open the boot, press the push button
and raise the tailgate.
The locking or unlocking of the tailgate
and rear screen is simultaneous with
that of the doors. With the tailgate closed, to partially
open the
rear screen , press and hold
the unlocking button C on the remote
control.

4ACCESS
69
"Rear screen open" warning

When the engine is running , if the
rear screen is not fully closed, you are
warned by a message on the multi-
function screen.

When the vehicle is moving (speed
greater than 6 mph (10 km/h)), if the
rear screen is not fully closed, you are
warned by an audible signal, a mes-
sage on the multifunction screen and
lighting of the service warning lamp. Tailgate release
This enables the tailgate to be un-
locked in the event of a central locking
fault.
- Fold back the rear seats to gain
access to the lock from inside the
boot.
- Insert a small screwdriver into hole A
of the lock to unlock the tailgate.

4ACCESS
70
Notes:
After reconnecting the battery, you
must reinitialise the safety anti-pinch:
- place the control in the maximum partial opening position (3rd notch
to the right),
- wait until the roof is in the maxi- mum partially open position,
- press the control for at least one second.
In the event of unwanted opening of
the roof on closing (for example, in the
presence of ice), and immediately af-
ter the roof stops:
- move the control to the "O" posi- tion and press the control immedi-
ately,
- continue to press the control until the roof is fully closed. SUNROOF (SALOON) Always remove the key from
the ignition when leaving the
vehicle, even for a short time.
In the event of contact during
operation of the roof, you must reverse
the movement of the roof. To do this,
press the switch concerned.
When the driver operates the roof
switch, they must ensure that no one
is preventing correct closing of the
roof.
The driver must ensure that passen-
gers use the sunroof correctly.
Be aware of children when operating
the roof.
- To partially open the roof: Turn the switch to the right (three possible
settings).
- To open the roof completely: Turn the switch to the left (six possible
settings).
- To close it completely: Turn the switch back to position "O".
- Safety anti-pinch: When the sun- roof is closing and meets an ob-
stacle, it stops then partially opens
again.
The sunroof blind is manual.

4ACCESS
71
Safety anti-pinch
If the blind encounters an obstacle
during closing, it stops and partially
opens again.
You must reinitialise the safety anti-
pinch within a maximum of fi ve sec-
onds after the blind has stopped:
- press part A of the control until the
blind is completely closed (closing
in stages of a few centimetres). PANORAMIC SUNROOF (407SW) In the event of contact du-
ring operation of the blind, you
must reverse its movement.
To do this, press the control
concerned.
When the driver operates the blind-
control, they must ensure that no one
is preventing the blind from closing
correctly.
The driver must ensure that the pas-
sengers use the blind correctly.
Pay attention to children during opera-
tion of the blind.

Notes :
Following reconnection of the battery,
in the event of a blind malfunction
while it is moving or immediately after
it has stopped, you must reinitialise
the safety anti-pinch:
- place the control in the fully open position (position "0"),
- wait until the blind is in the fully open position,
- press section A of the control for at
least three seconds.
In the event of unwanted opening of
the blind on closing, and immediately
after the blind has stopped:
- move the control to the fully closed position (9th setting to the left) then
press part A of the control straight
away,
- continue to press the control until the blind is fully closed.

The safety anti-pinch function is not
active during these operations.
Your vehicle is fi tted with a tinted glass
panoramic sunroof which increases
the light and visibility in the passen-
ger compartment. Its electric blind im-
proves temperature conditions.

The blind is controlled electrically by
a dial with nine opening positions.

To close: turn the dial to the left (nine
possible settings).

To open: return the dial to the initial
position "0" .

4ACCESS
72
FUEL TANK
The capacity of the tank is approxi-
mately 67 litres. When the low fuel level is
reached, this warning lamp
comes on in the instrument
panel, accompanied by an au-
dible signal and a message on the mul-
tifunction screen. When it fi rst comes
on, about 6 litres of fuel remains in
the tank.
If you run completely out of fuel
(Diesel), refer also to the "Checks"
section.
A label fi tted to the inside of the fuel
fi ller fl ap indicates which type of fuel
to use.
Additions of fuel must be of at least
5 litres to be taken into account by the
fuel gauge.
Opening the fuel fi ller may produce the
noise of an inrush of air. This vacuum
is entirely normal and results from the
sealing of the fuel system.
Low fuel warning
To refuel in complete safety:

 you must switch off the engine,

 open the fuel fi ller fl ap.

 turn the cap to the left.

 remove the cap and hang the end
on the hook located on the inside
of the fl ap.

 fi ll the tank, but do not continue
after the third cut-off of the noz-
zle ; this may cause malfunctions.
After fi lling the tank:

 refi t the cap,

 close the fl ap.
Operating fault
A fuel gauge fault is indicated by the
fuel guage needle returning to zero.
Have it checked by a PEUGEOT dealer.
Refuelling