time Peugeot 508 2011 Owner's Manual

18
i
!
Familiarisation
Driving safely


Stop & Start


Going into engine STOP mode


114

The "ECO"
warning lamp comes
on in the instrument panel and the
engine goes into standby; with an
electronic gear control gearbox
and speeds
below 4 mph (6 km/h), press the brake pedal or
put the gear lever in position N
.


Going into engine START mode

Deactivation/Reactivation

You can deactivate the system at any time by
pressing the "ECO OFF"
button; the button's
warning lamp comes on.

115



115


The system is automatically reactivated
every time the engine is star ted with
the key.
Before refuelling or doing anything
under the bonnet, you must switch off
the ignition with the key. The "ECO"
warning lamp goes off
and the engine restar ts with an
electronic gear control gearbox
:


- with the gear lever in position A
or M

release the brake pedal,

- or with the gear lever in position N
and
brake pedal released, move the gear lever
to position A
or M
,

- or engage reverse.
In certain circumstances, the STOP mode
may not be available; the "ECO"
warning lamp
flashes for a few seconds, then goes off. In certain circumstances, START mode may be
invoked automatically; the "ECO"
warning lamp
flashes for a few seconds, then goes off.

28
Instruments and controls


Warning/indicator lamp



State



Cause



Action/Observations








Dynamic
stability control
(ESP/ASR)


flashing. The ESP/ASR regulation is active. The system optimises traction and improves the
directional stability of the vehicle.

fixed. Unless it has been deactivated
(button pressed and its indicator lamp
on) the ESP/ASR system has a fault. Have it checked by a PEUGEOT or a qualified
workshop.





Engine
autodiagnosis
system


fixed. The emission control system has a
fault. The warning lamp should go off when the engine is star ted.
If it does not go off, contact a PEUGEOT dealer or
qualified workshop without delay.

flashing. The engine management system has
a fault. Risk of destruction of the catalytic conver ter.
Have it checked by a PEUGEOT dealer or a qualified
workshop.





Low fuel level


fixed with the needle
in the red zone. When it first comes on there remains
approximately 7 litres
of fuel in the
tank.
At this point, you begin to use the fuel
reser ve. Refuel as soon as possible to avoid running out of
fuel.
This warning lamp will come on every time the ignition
is switched on, until a sufficient addition of fuel is
made.
Never continue to drive until you run out of fuel, as
this could damage the emission control and injection
systems.





Anti-lock
Braking System
(ABS)


fixed. The anti-lock braking system has a
fault. The vehicle retains conventional braking.
Drive carefully at reduced speed and contact a
PEUGEOT dealer or a qualified workshop without
delay.

32
i
Instruments and controls

* According to country.


CHECK (vehicle autotest)


Automatic CHECK

With the key in the ignition on position, all of the
warning lamps for the functions tested are displayed.
They are switched off after a few seconds.
At the same time, an automatic CHECK
(vehicle autotest) is carried out.

In the presence of a fault

A "minor" fault has been detected: the warning
lamp(s) are displayed then go off.
You can start your vehicle; however, contact a
PEUGEOT dealer or a qualified workshop as
soon as possible.
A "major" fault has been detected: the
associated warning lamps(s) remain on
accompanied by the STOP or SERVICE
warning lamp.
Do not start your vehicle.
Call a PEUGEOT dealer or a qualified
workshop without delay.


Manual CHECK

Pressing the "CHECK

"
button on the instrument
panel star ts the manual CHECK (vehicle autotest).
This function enables you to recall at any time (with
the key in the ignition on position or with the engine
running), the aler ts present.
The passenger's airbag deactivated
warning lamp * remains on while the
airbag is deactivated.

With the engine running and the vehicle
moving, the instrument panel displays
the
warning lamps (in the event of a fault). If no "major" fault is found, you can start your
vehicle.


Lighting dimmer control

With the headlamps on, press button B
to
increase the brightness of the instruments and
controls and the interior mood lighting or button A

to reduce it.
As soon as the lighting reaches the required
level of brightness, release the button.

1
33
i
Instruments and controls






Service indicator


More than 1 800 miles (3 000 km)
remain before the next service is due
When the ignition is switched on, no ser vice
information appears in the screen. System which informs the driver when the
next ser vice is due, in accordance with the
manufacturer's servicing schedule.
The point at which the ser vice is due is
calculated from the last indicator zero reset. It
is determined by two parameters:


- the distance travelled,

- the time elapsed since the last ser vice.


Between 600 miles (1 000 km)
and 1 800 miles (3 000 km) remain
before the next service is due
For 5 seconds after the ignition is switched on, the
spanner symbolising the ser vice operations comes
on. The distance recorder display line indicates the
distance remaining before the next ser vice is due.

Example:
1 700 miles (2 800 km) remain before
the next ser vice is due.
For 5 seconds after the ignition is switched on, the
screen indicates:
5 seconds after the ignition is switched on,
the spanner goes off
; the distance recorder
resumes its normal operation. The screen then
indicates the total and trip distances.


Less than 600 miles (1 000 km)
remain before the next service is due

Example:
560 miles (900 km) remain before
the next ser vice is due.
For 5 seconds after the ignition is switched on,
the screen indicates:
5 seconds after the ignition is switched on,
the distance recorder resumes its normal
operation. The spanner remains on
to
indicate that a ser vice must be carried out
soon.

Illumination of the key is accompanied
by a message in the instrument panel
screen.

34
i
i
Instruments and controls

Service overdue

For 5 seconds after the ignition is switched on,
the spanner flashes
to indicate that the service
must be carried out as soon as possible.

Example:
the ser vice is overdue by 186 miles
(300 km).
For 5 seconds after the ignition is switched on,
the screen indicates:
The distance remaining may be
weighted by the time factor, depending
on the driving conditions.
Therefore, the spanner may also come
on if you have exceeded the two year
ser vice inter val.
Following this operation, if you wish to
disconnect the battery, lock the vehicle
and wait at least five minutes for the
zero reset to be taken into account. 5 seconds after the ignition is switched on,
the distance recorder resumes its normal
operation. The spanner remains on
.








Service indicator zero reset

After each ser vice, the ser vice indicator must
be reset to zero.
The procedure for resetting to zero is as
follows:


)
switch off the ignition,

)
press and hold the trip distance recorder
zero reset button,

)
switch on the ignition; the distance recorder
display begins a countdown,

)
when the display indicates "=0"
, release
the button; the spanner disappears.


Retrieving the service
information
You can access the ser vice information at any
time.


)
Press the trip distance recorder zero reset
button.
The ser vice information is displayed for a
few seconds, then disappears.

36
Instruments and controls
System which provides current information
concerning the trip (range, fuel consumption…).








Tr i p c o m p u t e r


Instrument panel screen
Information display




)
Press the steering mounted control
to
display the various trip computer tabs in
succession.


- The current information tab
with:


●
the range,

●
the current fuel
consumption,

●
the Stop & Star t time
counter.





- The trip "1"
tab with:


●
the average speed,
for the first trip.

●
the average fuel
consumption,

●
the distance travelled,





- The trip "2"
tab with:


●
the average speed,
for the second trip.

●
the average fuel
consumption,

●
the distance travelled,




)
Or on the end of the wiper stalk.

38
Instruments and controls







Stop & Start time
counter
(minutes /sec onds or hour s /
minutes)
If your vehicle is fitted with Stop &
Star t, a time counter calculates
the time spent in STOP mode
during a journey.
It resets to zero every time the
ignition is switched on with the
key.

2
39
i
Access
System which permits central unlocking or locking of the vehicle using the lock or from a distance. It is also used to locate and start the vehicle, as well
as providing protection against theft.
























Remote control key


Unfolding the key



)
First press this button to unfold the key.



"Keyless Entry and
Starting" system

System that allows the opening, closing
and star ting of the vehicle while keeping the
electronic key on your person. It can also be
used as a remote control.


Unlocking the vehicle
Complete unlocking



Using the key



)
Turn the key to the front of the vehicle to
unlock the vehicle.



Using the remote control



)
Press the open padlock to unlock
the vehicle.
Holding this button down opens the
windows automatically.


Using the electronic key



)
With the electronic key on your person and
in the defined zone, pass your hand behind
the door handle to unlock the vehicle, then
pull on the handle to open the door.
Your passengers can also open their doors,
as soon as the electronic key is in the
defined zone around the vehicle.


Unlocking is confirmed by rapid
flashing of the direction indicators for
approximately two seconds.
According to version, the door mirrors
unfold at the same time.

40
i
Access









Selective unlocking



)
To unlock the driver's door only
press the open padlock once.

Using the remote control

This is set via the instrument panel
screen configuration menu.
Complete unlocking is activated by
default.
Using the electronic key



)
To unlock only the driver's door with the
electronic key on your person, pass your
hand behind the driver's door handle then
pull the handle to open the door.

)
To unlock the vehicle completely, pass your
hand behind one of the passenger door
handles, on the side of the vehicle where
the electronic key is located, then pull the
door handle.


Each unlocking is confirmed by rapid
flashing of the direction indicators for
approximately two seconds.
According to version, the door mirrors
unfold at the same time as the first
unlocking action.
















Unlocking the boot


Using the remote control



)
Press this button to unlock the
vehicle and open the boot.



Using the electronic key



)
With the electronic key in the defined zone,
press button 1
(Saloon) or lift lever 2
(SW)
to unlock the vehicle and open the boot.

)
To unlock the other doors and the boot,
press the open padlock again.

42
i
!i!
Access

As a safety measure (children on
board), never leave the vehicle without
taking your key, even for a short period.
Guard against theft when the electronic
key is in the defined zone with the
vehicle unlocked.
Locking is confirmed by fixed
lighting of the direction indicators for
approximately two seconds.
According to version, the door mirrors
fold at the same time.
If one of the doors or the boot is still
open or if an electronic key has been
left inside the vehicle, the central
locking does not take place.
When the vehicle is locked, if it is
unlocked inadvertently, it will relock
automatically after about thir ty seconds
unless a door is opened.
It is not possible to lock the vehicle if an
electronic key is left inside the vehicle.
After a long period of parking, the
automatic detection functions of the
electronic key are inhibited so as to not
discharge the vehicle's battery. You
should then use the remote control
function of the electronic key to unlock
the vehicle. The folding and unfolding of the door
mirrors by the remote control can be
deactivated by a PEUGEOT dealer.








Deadlocking

Deadlocking renders the exterior and
interior door controls inoperative.
It also deactivates the manual central
control button.
Therefore, never leave anyone inside
the vehicle when it is deadlocked.



Using the key



)
Turn the key to the rear in the driver's door
lock to lock the vehicle completely.

)
Turn the key to the rear again within five
seconds to deadlock the vehicle.